An Efficient Numerical Method for Computing Synthetic Seismograms for a Layered Half-space with Sources and Receivers at Close or Same Depths

— It is difficult to compute synthetic seismograms for a layered half-space with sources and receivers at close to or the same depths using the generalized R/T coefficient method (Kennett, 1983; Luco and Apsel, 1983; Yao and Harkrider, 1983; Chen, 1993), because the wavenumber integration converges very slowly. A semi-analytic method for accelerating the convergence, in which part of the integration is implemented analytically, was adopted by some authors (Apsel and Luco, 1983; Hisada, 1994, 1995). In this study, based on the principle of the Repeated Averaging Method (Dahlquist and Björck, 1974; Chang, 1988), we propose an alternative, efficient, numerical method, the peak-trough averaging method (PTAM), to overcome the difficulty mentioned above. Compared with the semi-analytic method, PTAM is not only much simpler mathematically and easier to implement in practice, but also more efficient. Using numerical examples, we illustrate the validity, accuracy and efficiency of the new method.     

Aseismic negative dislocation model and deformation analysis of crustal horizontal movement during 1999——2001 in the northeast margin of Qinghai-Xizang block

Through numerical simulation for GPS data, aseism/c negative dislocation model for crustal horizontal movement during 1999-2001 in the northeast margin of Qinghai-Xizang block is presented, combined with the spatial distri-bution of apparent strain field in this area, the characteristics of motion and deformation of active blocks and their boundary faults, together with the place and intensity of strain accumulation are analyzed. It is shown that: a) 9 active blocks appeared totally clockwise motion from eastward by north to eastward by south. Obvious sinistral strike-slip and NE-NEE relative compressive motion between the blocks separated by Qilianshan-Haiyuan fault zone was discovered; b) 20 fault segments (most of them showed compression) locked the relative motion between blocks to varying degrees, among the total, the mid-east segment of Qilianshan fault (containing the place where it meets Riyueshan-Lajishan fault) and the place where it meets Haiyuan fault and Zhuanglanghe fault, more favored accumulation of strain. Moreover, the region where Riyueshan-Lajishan fault meets north boundary of Qaidam block may have strain accumulation to some degree, c) Obtained magnitude of block velocities and locking of their boundaries were less than relevant results for observation in the period of 1993-1999.     

Gravity variation before Kunlun mountain pass western Ms=8.1 earthquake

The relation between the gravity variation features and Ms=8.1 earthquake in Qinghai-Xizang monitoring area is analyzed preliminarily,by using spatial dynamic variation results of regional gravity field from absolute gravity and relative gravity observation in 1998 and 2000.The results show that:1)Ms\8.1 earthquake in Kulun mountain pass westem occurred in the gravity variation high gradient near gravity‘s high negative variation;2)The Main tectonic deformation and emnergy accumulation before MS=8.1 earthquake are distributed at south side of the epicenter;3)The range of gravity‘s high negative variation at east of the MS=8.1 earthquake epicenter relatively coincides with that rupture region according to field geology investigation;4)Gravity variation distribution in high negative value region is just consistent with the second shear strain‘s high value region of strain field obtained from GPS observation.     

CDP mapping in tilted transversely isotropic (TTI) media. Part I: Method and effectiveness

Transverse isotropy with a tilted axis of symmetry (TTI) causes image distortion if isotropic models are assumed during data processing. A simple anisotropic migration approach needs long computational times and is sensitive to the signal-to-noise ratio. This paper presents an efficient, general approach to common-depth-point (CDP) mapping to image the subsurface in TTI media from qP-wave seismic data by adding anisotropic and dip parameters to the velocity model. The method consists of three steps: (i) calculating traveltimes and positions of the CDP points; (ii) determining CDP trajectories; (iii) CDP imaging. A crucial step is the rapid computation of traveltimes and raypaths in the TTI media, which is achieved by the Fermat method, specially adapted for anisotropic layered media. The algorithm can image the subsurface of a given model quickly and accurately, and is suitable for application to a bending reflector. The effectiveness of the method is demonstrated by comparing the raypaths, the traveltimes and the results of CDP mapping, when assuming isotropic media, transversely isotropic media with a vertical axis of symmetry (TIV), and TTI media.     

Dinosaur tracks from the Cretaceous of South Korea: Distribution, occurrences and paleobiological significance

Abstract   Abundant dinosaur fossils including dinosaur footprints, eggs and nests, teeth and bones have been found from the Cretaceous non-marine deposits of Korea. Among them, dinosaur tracks are the most distinctive, and some track sites are among the most famous in the world. Until now, 27 dinosaur track localities have been discovered from the Cretaceous strata in the Gyeongsang Basin and several small basins. Ornithopod tracks are most abundant at most Korean track sites, and most of them are identified as Caririchnium ; that is, large ornithopod footprints with wide hoof impressions. Most theropod tracks are found in Neungju Basin and they consist of various types of small or medium-sized bird-like footprints, and other large footprints. Sauropod tracks are also abundant in the Gyeongsang Basin. The sauropod tracks vary in size, shape, and pattern of trackway, and suggest that diverse sauropods existed in this area. These diverse tracks in South Korea suggest that various dinosaurs flourished at the margins of lakes distributed in the southern part of the Korean Peninsula during the Cretaceous.     

Relationship between light rare earth deposits and mantle processes in Panxi rift,China

Many light rare earth deposits, such as Maoniuping, Dalucao, Panzhihua deposits, are collectively distributed in Panxi rift of Sichuan Province, China, and closely associated with the aegirine quartz syenite-carbonatite complex. Carbon and oxygen isotope studies demonstrate that the carbonatites in the complex are of typical igneous origin related to mantle processes. Electronic microprobe studies show that the fluid-melt inclusions found in the complex are enriched in light rare earth elements (LREE), which suggests that the magma was rich in LREE and could serve as the ore source for the regional LREE mineralization. Both the aegirine quartz syenite-carbonatite complex and the LREE mineralization found therein were derived from the mantle. The rare gas isotope analyses also support that there is a genetic association between the LREE mineralization and mantle processes.

     

路基施工沉降观测精度要求及数据处理

本文通过对路基施工沉降观测的精度分析,提出了路基施工沉降观测的精度要求；根据路基施工沉降观测的特点，提出了相应的观测措施及数据处理方法。     

基于关系数据库的邻接域处理

本文就跨图幅的地物(邻接域)的管理问题作了一些有益的探讨，为了达到有效管理这个目的，本文采用Oracle公司提供的空间数据插件Spatial将空间数据和属性数据存入Oracle数据库中，这样不仅可以通过标准SQL语句可下裁任意区域的数据，而且数据库还会自动维护数据的完整性。因此，用空间数据库的管理方式使邻接域问题就不存在了。     

遥感技术在腾冲西南地区地热资源研究预测中的应用

利用TM数据,对滇西腾冲西南地区进行地质构造解译,阐明了该区多地热活动的原因.通过对TM6波段热红外异常信息的提取,经构造解译与地热异常分布区的叠加分析,发现了该区地热富集的规律性,提出了地热田的遥感影像模式.据此,预测出腾冲西南地区62处水热活动Ⅰ级异常区.     

利用信噪比削弱GPS多路径效应的研究

由于多路径误差的非时空相关性,使其成为双差模型中较难解除的误差源。本文利用观测值的信噪比对观测值质量进行评价,通过降低受多路径效应影响的观测值的权重,从而达到削减多路径误差的目的。最后通过实验数据解算结果的重复性验证了此方法的有效性和可靠性。