祁连山南坡灌丛草甸生物量变化与水热因子的关系研究

通过野外调研和室内实验,研究了祁连山南坡灌丛草甸地上生物量的生长季变化,并对地上生物量与水热因子的关系进行了探讨。结果表明：在不同区域群落结构有所不同,覆盖度越低,上层和下层的植物高度越低,丰富度和多样性越小。但均匀度还受草场退化阶段的影响,群落结构相对稳定,植物的均匀度越高;地上生物量的年内变化是单峰曲线,乌鞘岭和门源的地上生物量在7月份最大,祁连和野牛沟的地上生物量在9月份最大;地上生物量的积累与前1月和前2月的气温和降水正相关,与前4月的气温也正相关,并且对气温变化的敏感性大于降水,但与地温和土壤水分的相关性不明显,前1月表层地温较高对地上生物量的积累有积极作用;对于地上生物量积累,日气温、日相对湿度、降水量有直接正向作用,而日最高气温、日最低气温、日水汽压有直接负向作用,5 cm、20 cm地温和0~10 cm、20~30 cm土壤水分也有直接正向作用,而10 cm地温和10~20 cm土壤水分也有直接负向作用。     

Study on uncertainty of inversion and resolution limit in the presence of noise

This study analyzed the uncertainty of inversion and the resolution limit in the presence of noise by means of statistical experiments. The exhaustive method is adopted to obtain the global optimal solution in each experiment. We found that even with small level of noise, solutions fluctuate in a large range for the thin bed. The distribution of solutions in the presence of noise is closely related to the spread of the cost function in the absence of noise. As a result, the area of a certain neighborhood around the true solution on the spread of the cost function in the absence of noise is used to evaluate the uncertainty of inversion and the resolution limit in the presence of noise. In the case that the SNR (signal-to-noise ratio) is 5 in this study, solutions focus around the true solution with a very small uncertainty only when the bed thickness is greater than the reciprocal of the double predominant frequency of the convoluting wavelet.     

不同无机晶须/PVC复合材料力学性能的研究

采用溶液共混法制备出硼酸镁晶须(MBOw)、硼酸钙晶须(Ca BOw)、硼酸铜铝晶须(Cu Al BOw)、碱式硫酸镁晶须(MOSw)、碳酸钙晶须(Ca CO3w)及硫酸钙晶须(Ca SO4w)增强的PVC复合材料,研究不同晶须对PVC力学性能的影响。采用扫描电镜分析PVC复合材料的拉伸断面及晶须分散情况。结果表明,除MOS外其它晶须对PVC的拉伸强度和弹性模量有不同程度的提高,MBOw对PVC复合材料的增强效果最显著,当MBOw含量为20%时,所得复合材料力学性能最佳,拉伸强度和弹性模量与纯PVC比较分别提高了38.08%和71.43%。     

地层证据--对大别造山带汇聚历史的制约

大别造山带的汇聚演化历史一直存在不同的认识,来自扬子陆块和华北陆块显生宙以来的地层记录以及北淮阳地区的地层记录可能为两个陆块的汇聚模式提供制约。通过对扬子陆块与华北陆块显生宙以来岩相古地理进行比较,其中3个阶段相似, 2个阶段差别很大。以浊积岩发育作为俯冲阶段的标志,磨拉石建造出现作为闭合的标志,显生宙以来,大别造山带曾经历了两次俯冲和两次汇聚,俯冲时间分别是晚奥陶世—早志留世和早三叠世,汇聚的时间分别为中 晚泥盆世和中三叠世,早期的汇聚具有软碰撞特征,以上认知得到了北淮阳地区地层、古生物和沉积记录的支持,同时也与大别山造山带榴辉岩的同位素年龄数据基本吻合。高压 超高压变质岩在晚三叠世处于快速折返阶段,早侏罗世以前到达地表,其平均折返隆升速率为39～66mm/a。     

Caledonian Low-Temperature Granulite-Facies Metamorphism in the West Kunlun Orogenic Belt—SHRIMP Chronological Evidence from Zircon

The West Kunlun orogenic belt is located at the conjunction of the paleo-Asian tectonic system and the Tethys tectonic system. Petrological and mineralogical studies of the Early Cambrian metamorphic surface crust in this region have shown that in case the metamorphism reached low-temperature granulate facies, the typical mineral assemblage is biotite-garnet-silimanite-K feldspar-plagioclase-quartz. The peak metamorphic temperatures are within the range of 720–740°C and the pressure is 0.6 GPa ±. Three types of metamorphic zircon have been detected in the metamorphic rocks: the complex inclusion-bearing type ; the early relic zircon inclusion-bearing type; and the inclusion-free type. SHRIMP age determination of these three types of metamorphic zircon have revealed that these zircons were formed principally during 400–460 Ma, indicating that pre-Cambrian metamorphic surface crust rocks underwent low-temperature granulite facies metamorphism during the Caledonian. In combination with the geological characteristics of this region, it is considered that when the oceanic basin was closed, there occurred intense intracontinental subduction (type A), bringing part of the Early Cambrian metamorphic basement in this region downwards to the lower crust. Meanwhile, there were accompanied with tectonic deformation at deep levels and medium- to high-grade metamorphism. This study provided important chronological and mineralogical evidence for the exploration of the evolutionary mechanism and process of the West Kunlun Early Paleozoic. Part of the results from the research project “ Research on the West Kunlun pre-Cambrian tectonic events” under the program “ Research on the important geological problems of China’ s pre-Cambrian” (No. 200113900070) sponsored by the China National Geological Surveying Bureau.     

Effect of removing small (<150?μm) chironomids on inferring temperature in cold lakes

Sieving samples for chironomid analysis with a 150 μm mesh was shown to greatly reduce sample preparation time, and use of only larger specimens did not affect chironomid-inferred salinities in African lakes. Here, we tested if this method is suitable for temperature reconstruction in colder lakes at higher latitudes. Removal of specimens <150 μm in two training sets, one from Canada and one from Sweden, had little impact on the performance statistics of the calibration models. Chironomid abundance, however, decreased greatly because more than half of the head capsules in assemblages were <150 μm. This had major impacts on the temperature reconstructions. Inferences were on average 2°C warmer with the modified models (all specimens >150 μm) than those obtained with the full model (all specimens >100 μm). General patterns of temperature change were also altered. For Lake 7 on Southampton Island, Canada, a cooling trend was reconstructed with the full Canadian model while the modified Canadian model yielded a warming trend. When only specimens >150 μm were used, two to three times more wet sediment was needed to obtain a sufficient number of head capsules. These results indicate that, in cold lakes (mean July/August air temperature ≤11°C), large proportions of head capsules are <150 μm, and sieving the samples in a 150 μm mesh leads to altered temperature reconstructions.     

沈阳城市应急避难场所的识别、空间格局与服务功能

以沈阳市为例,运用高分辨率遥感影像识别城市应急避难场所,采用空间插值、波段集统计等方法刻画应急避难场所空间分布及其与人口的空间匹配性,通过栅格成本分析和加权Voronoi图等方法测算空间可达性并划分其服务区范围。研究表明:(1)沈阳市应急避难场所分布呈现出"小集聚、大分散"的基本格局,与人口分布的空间匹配性差;(2)应急避难场所可达性表现出空间异质性,大型用地对整体格局起到主要塑造作用;(3)研究区域可划分为14个较为明确的应急避难场所服务区,不同服务范围在空间上存在大小、数量和构成上的差异。最后,从城市安全视角对沈阳市应急避难场所的空间布局提出优化建议,为政府部门决策提供科学依据与政策参考。     

Modeling the morphology of gully cross sections in the Yuanmou Dry-hot Valley

Abstract

Characterizing gully cross sections (GCs) is essential for calculating the volume and erosion rate of the gully. However, little research has focused on modeling the morphology of GCs. This study investigated 456 GCs with a laser distance meter located at the mouth, middle, and head of 152 gullies in the Yuanmou Dry-hot Valley of China; mapped them with AutoCAD software; fitted them with 2nd–6th degree polynomial functions, and discussed the correlation between the coefficients and the morphology of GCs. The results showed that: (1) using a 2nd-degree polynomial function (y = ax² + bx + c) to describe the morphology of GCs produced a better result than other polynomial functions; (2) the coefficient a of 2nd-degree polynomial function was correlated with depth (r = ?0.226, p < 0.01), gradient (r = 0.545, p < 0.01), and activities; and (3) the symmetry axis (?b/2a) of 2nd-degree polynomial function increased with gully change from left-deflection to right-skewed, and the absolute value showed the asymmetrical degree (r = 0.216, p < 0.01). This study will not only help to understand the morphology and evolution of gullies, but will also provide a scientific basis for prevention of gully erosion.     

Characterization of hydraulic suitability of Chinese sturgeon (Acipenser sinensis) spawning habitat in the Yangtze River

Hydrodynamic flow fields affect the ecological processes such as the water diversity and the distribution of organisms. Understanding the hydrodynamic and ecological processes is critical for the restoration and protection of especially fragile ecological habitats in river systems. This study uses turbulent flow to characterize the ecological behaviour of Chinese Sturgeon (Acipenser sinensis) in the Yangtze River. The Delft3D‐Flow model, which is first validated with field‐measured data, is used to simulate the flow field within spawning habitats of Chinese Sturgeon, downstream of Gezhouba Dam. The model‐simulated turbulent kinetic energy (TKE) and its distribution pattern are then used to characterize the hydraulic environment of the fish's spawning habitat. For the spawning habitat, downstream of Gezhouba Dam, the lower limit of TKE for the Chinese Sturgeon egg mass field is 0.025 m²/s², which occurs at a velocity less than 1.7 m/s. Chinese Sturgeon prefers habitats with TKE range of 0.010 ~ 0.015 m²/s² for resting. This suggests that discharge regimes provide the basis for ecological regulation of the Three Gorges Reservoir and the scientific reference for river management. Copyright © 2011 John Wiley & Sons, Ltd.     

Experimental research on the effect of slope morphology on bank collapse in mountain reservoir

Farmers along the Amazon River each year face multiple natural hazards that threaten crop production and limit the potential for agricultural development of the expansive floodplain and active channel. In this paper we report the findings of a study of natural hazard-related risk associated with rice production on silt bars in the active channel of the Amazon River near Iquitos, Peru. Data were gathered in four rice producing communities in 2014 using household surveys (n = 83 households), focus group discussions, surveying of land elevations along the Amazon River, and interpretation of remote sensing imagery. The probability, extent, and severity of rice crop shortfalls were estimated for recent production years and the economic losses to farming households were also assessed. Our findings point to a very high risk of crop shortfalls due to natural hazards, suggesting that a good year brings rice farmers bounty and a bad year, near penury. River stage reversals (repiquetes) and edaphic conditions were found to be more problematic than the often cited hazard of high and/or early floods. Also surprisingly, farmers’ perceptions of hazards and risk diverged markedly from actual shortfalls experienced during the production years studied. Our results provide the first quantitative estimates of risk due to the multiple natural hazards along the Amazon River and point to the need to assist lowland farmers with risk mitigation so as to unlock the considerable potential of Amazon floodlands for agricultural production.