Decision support for infrastructure planning: a comprehensive location–allocation model for fire station in complex urban system

Natural Hazards - Infrastructures are the most important aspect of any urban system. Properly planned infrastructures are critical for ensuring services and protecting an urban system from...     

The Ganges and Brahmaputra rivers in Bangladesh: basin denudation and sedimentation

Every year the Ganges and Brahmaputra rivers in Bangladesh transport 316 and 721 million tonnes of sediment, respectively. These high loads of suspended sediment reflect the very high rate of denudation in their drainage basins. The average mechanical denudation rate for the Ganges and Brahmaputra basins together is 365 mm 10³ yr⁻¹. However, the rate is higher in the Brahmaputra Basin than that in the Ganges Basin. Several factors, including mean trunk channel gradient, relief ratio, runoff, basin lithology and recurring earthquakes are responsible for these high denudation rates. Of the total suspended sediment load (i.e. 1037 million tonnes) transported by these rivers, only 525 million tonnes (c. 51% of the total load) are delivered to the coastal area of Bangladesh and the remaining 512 million tonnes are deposited within the lower basin, offsetting the subsidence. Of the deposited load, about 289 million tonnes (about 28% of the total load) are deposited on the floodplains of these rivers. The remaining 223 million tonnes (about 21% of the total load) are deposited within the river channels, resulting in aggradation of the channel bed at an average rate of about 3·9 cm yr⁻¹. Although the Brahmaputra transports a higher sediment load than the Ganges, the channel bed aggradation rate is much higher for the Ganges. This study also documents a wide range of interannual, seasonal and daily variation in suspended sediment transport and water discharge. Interannual variation in sediment deposition within the basin is also suggested. Copyright © 1999 John Wiley & Sons, Ltd.     

Optimization of dissolved urea measurements in coastal waters with the combination of a single reagent and high temperature

Urea is an unstable and intermediate organic nitrogenous compound present in coastal environments and is derived from the excretion of some aquatic organisms and wastewater discharges. Urea plays an important role in the nitrogen cycle, where it is utilized by algae, including diatoms. However, there are very limited relevant data on the production, consumption, and degradation of urea because of the lack of appropriate measurement techniques. The conventional method is based on the formation of a colored product when urea reacts with diacetyl monoxime in a sulfuric acid solution. We examined the optimal conditions for the formation of the colored product; specifically, we evaluated different temperatures (22–80 °C), reaction times, mixing ratios of color reagents, and sample storage times. Application of the single mixed color-developing reagent (COLDER) at 70 °C resulted in the optimal formation of the colored product within a short reaction time of 60 min. This method was then used to measure dissolved urea in different coastal environments. The concentrations detected were as follows: 0.65–0.72, 0.49–0.58, and 1.09–2.28 µM urea-N at coral reef, seagrass, and mangrove sites, respectively. Our results showed high precision (SD = 0.02, CV = 1.2%), a low detection limit (0.03 µM urea-N), and a high recovery rate (94–99%). In summary, this high-temperature procedure for urea measurements should be valuable for obtaining high-precision data that can further the understanding of urea dynamics and its role in coastal ecosystems.     

Toxicity of organophosphorus pesticide sumithion on larval stages of stinging catfish <Emphasis Type="Italic">Heteropneustes fossilis</Emphasis>

Sumithion is widely used to control brittle in paddy fields and tiger bug in fish larval rearing ponds. The objective of this study was to elucidate the toxic effects of sumithion on larval stages of stinging catfish Heteropneustes fossilis. Larvae were exposed to two concentrations (150 and 250 μg/L) of sumithion with one control in three replicates of each. Larvae samples were collected at 20- and 24-h intervals followed by observation under a digital microscope. Exposures of stinging catfish larvae to sumithion produced deformities including irregular head shape, lordosis, yolk sac edema, body arcuation, tissue ulceration, etc. The mortality rates of larvae were significantly increased in response to increase in sumithion concentrations. Furthermore, around 30% of the total adult stinging catfish reared in sumithiontreated aquaculture ponds were found to be deformed permanently. These findings highlight that exposure of stinging catfish to sumithion at the critical and sensitive stages in their life cycle may significantly reduce the number of returning adults. Therefore, the use of sumithion for crop protection needs to be considered carefully and alternatives to sumithion should to be developed for controlling aquatic insects in aqua-ponds during larval rearing.     

Application of advanced technology to build a vibrant environment on planet mars

In order to make Mars a better planet, in this paper, photo-dissociation technology, mathematical modeling, and a series of chemical reaction methodology have been proposed to create a vibrant ecosystem and balance the atmosphere on Mars. Since CO₂ is a stable compound, breaking it down into C and O₂ always is challenging, but exciting thought. Interestingly, my recent research revealed that photo-dissociation by utilizing UVV (laser) could be an exciting technology to split CO₂ into C + O₂ since the theoretical reaction suggested that the production of C + O₂ channel from CO₂ photo-exciting technology releases the energetic level threshold of C(³P₂) + O₂(X³∑ _g ^? ) that can be detected by ultraviolet laser pump-probe spectroscopy. Subsequently, a mathematical model for creating of ocean on Mars by breaking its substantial polar ice has been performed considering algorithms for surface and coordinate between the barotropic momentum and continuity equations, and interestingly the calculation suggested that it is very much possible to flow ocean on Mars surface to meet its water demand. Subsequently, proposed series of chemical reaction technology suggested that implementation of carbonator looping and plasma reaction paths can convert photo-dissociated carbon (C) into N₂ and NH₃ to enrich Mars’ soil in order to grow vegetation as well as to create a balance ecosystem in Mars eventually. Finally, sustainable green technology has been proposed for the development of Mars to be a complete balanced planet to deliver all basic and modern needs to run daily life smoothly. Thus, implication of chemical reaction technologies along with sustainable development plans can indeed make the Mars a vibrant environment to live there in clean and green.     

Characterizing site response in the Attock Basin,Pakistan, using microtremor measurement analysis

The Attock Basin is situated close to the northwest of Pakistan. Recent seismic event of October 2015 (7.5M_w) near the Pakistan Afghanistan border has proved that the area of interest is seismically active and triggered a series of aftershocks of magnitude even greater than 6.5M_w. This seismic activity has posed danger to the future of the people and infrastructure especially to the northwestern part of the country. Therefore, site response analysis is essential for estimating local site conditions in response to seismic events. Ambient noise recordings were made at 50 sites within urban and semi-urban settlements in the Attock Basin to analyze the site response of the small but densely populated basin. At each of these sites, the fundamental frequency of the soft sediments (f ₀), the amplitude (A ₀) of corresponding H/V spectral ratios, the thickness of soft sediment (H) lying over competent lithology, and the soil vulnerability index (K _g) were studied. Results were correlated with sparsely available borehole data to enhance the credibility of the study conducted for microzonation and predicting the site response to earthquake seismicity in the Attock Basin. The soil vulnerability index was found to range from moderate to high. Results clearly showed that the study area exhibits low to moderate fundamental frequency with greater soft sediment thicknesses distributed throughout the study area. Moreover, higher impedance contrasts were found at most of the sites within the central part of the Attock Basin, thus reflecting a moderate to high susceptibility of damage in those regions in response to seismic events.     

A multi-isotope approach (O,H, C,S, B and Sr) to understand the source of water and solutes in some the thermal springs from West Coast geothermal area,India

The West Coast belt, consisting of nearly 60 thermal springs, is one of the most diversified geothermal fields in India. The present work describes the multi-isotopic (O, H, C, S, B and Sr) characterization of thermal waters carried out in the Tural-Rajwadi geothermal field, situated in southern sector of the west coast geothermal area. The aim of this study is to delineate the origin of thermal water as well as to ascertain the sources of carbon, sulphur, boron and strontium dissolved in those thermal springs. The stable isotopes (δ²H and δ¹⁸O) and tritium data indicate that these thermal springs are not recently recharged rain water rather, it contains very old component of water. Oxygen-18 shift is observed due to rock-water interaction over a long period of time. Carbon isotopic composition of DIC points out to the silicate weathering with soil CO₂ coming from C₃ type of plants whereas δ³⁴S of dissolved sulphate confirms the marine origin of sulphate. This marine signature is basically derived from paleo-seawater possibly entrapped within the flows. Boron isotopic data reveals that both the seawater and rock dissolution are the sources of boron in the thermal waters whereas high ⁸⁷Sr/⁸⁶Sr ratios (0.7220–0.7512) of the thermal waters conclusively establishes that archean granitic basement is the predominant rock source of strontium, not the Deccan flood basalts. In addition, like strontium, concentrations of lithium, rubidium and caesium are also governed by the rock-water interaction. Thus, the combined use of this multi-isotope technique coupled with trace element concentrations proves to be an effective tool to establish the sources of solutes in the thermal water.     

Temporal change of glaciers area and geomorphometric parameters in Parbati valley,Himachal Pradesh,India

Temporal change in the glacier coverage is analyzed for the period between 1962 and 2003 in Parbati valley, Himachal Pradesh. It is observed that the total glacier cover has been decreased by 17% ranging between 8 and 100% for individual glacier. The pattern of de-glaciation shows a high degree of shrinkage in outer zone of Parbati valley, while least shrinkage is observed in the inner valley. The present study is conducted to establish relationship between glacio-geomorphic parameters and glaciers shrinkage pattern to predict the future glacier cover in warming scenario. A systematic change is observed for glacio-geomorphic parameters associated with temporal change in glacier cover. It is observed that mean and minimum elevation, slope, relief and duration of insolation have changed substantially. Maximum elevation, plan/profile curvatures and aspect have shown less change from 1962 to 2003. A correlation matrix between glacio-geomorphic parameters for glaciers between 1962 and 2003 shows that the recent glaciers are much more controlled by terrain characteristics than that in the recent past.     

Occurrences of damaging earthquakes between the Himachal and Darjeeling Himalayas: Tectonic implications

Detailed analysis of intensity for ten damaging historical earthquakes in the central arcuate belt between the Himachal and Darjeeling Himalayas was carried out in the backdrop of isoseismal eccentricity, source depth and Indian plate obliquity. Results indicate that the elongated axes of the isoseismals and strike of ruptures for shallow earthquakes are almost parallel with strike of the Himalayan arc, and clearly conformable with the obliquity. An empirical power law relationship between eccentricity and focal depth established under the present study illustrates that the deeper events are more influenced by the bending of the penetrating Indian lithosphere, whereas the shallower events are principally controlled by the obliquity. A positive correlation between eccentricities and obliquity obviously supports this inference. The present study further reveals that the constant decrease in Indian plate obliquity from Himachal to Nepal-Bihar Himalaya is well compatible with the graben structures and horizontal shearing along this arcuate segment.     

Optimization of slope angle and its seismic stability: A case study for the proposed open pit coalmine in Phulbari, NW Bangladesh

The present study reflects upon the results of substantial program of two-dimensional Finite Element Method （FEM） numerical analyses of the open pit that links to slope angle optimization associated with the safety factor of the pit slope of a coal mine in Bangladesh. In the present analyses, two types of models have been presented. The first model estimates safety factor without seismic effect on the overall pit slope of the model; the second model incorporates safety factor with seismic stability of the model. The calculated optimum slope angle of the first model is 31% with a rational safety factor of 1.51, prior to the seismic effect. However, the value is reduced to 0.93, 0.82, and 0.72, after we applies the seismic effect in the second model with M6, M6.5, and M7, respectively. Finally, our modeling results emphasize that for the case of the proposed Phulbari coalmine, there is extremely high prospect for causing massive slope failure along the optimum pit slope angle with 31% if the mine area felt seismic shaking, like the Sikkim （in northern India） earthquake with M6.9 on September 18, 2011.