The self-thinning exponent in overcrowded stands of the mangrove, Kandelia obovata, on Okinawa Island, Japan

Weller??s allometric model assumes that the allometric relationships of mean area occupied by a tree $ \bar{s} $ , i.e., the reciprocal of population density $ \rho $ , $ \bar{s}\left( { = {1 \mathord{\left/ {\vphantom {1 {\rho = g_{\varphi } \cdot \bar{w}^{\varphi } }}} \right. \kern-0em} {\rho = g_{\varphi } \cdot \bar{w}^{\varphi } }}} \right) $ , mean tree height $ \bar{H}\left( { = g_{\theta } \cdot \bar{w}^{\theta } } \right) $ , and mean aboveground mass density $ \bar{d}\left( { = g_{\delta } \cdot \bar{w}^{\delta } } \right) $ to mean aboveground mass $ \bar{w} $ hold. Using the model, the self-thinning line $ \left( {\bar{w} = K \cdot \rho^{ - \alpha } } \right) $ of overcrowded Kandelia obovata stands in Okinawa, Japan, was studied over 8?years. Mean tree height increased with increasing $ \bar{w} $ . The values of the allometric constant $ \theta $ and the multiplying factor $ g_{\theta } $ are 0.3857 and 2.157?m?kg^???, respectively. The allometric constant $ \delta $ and the multiplying factor $ g_{\delta } $ are ?0.01673 and 2.685?m^?3?kg^1???, respectively. The $ \delta $ value was not significantly different from zero, showing that $ \bar{d} $ remains constant regardless of any increase in $ \bar{w} $ . The average of $ \bar{d} $ , i.e., biomass density $ \left( {{{\bar{w} \cdot \rho } \mathord{\left/ {\vphantom {{\bar{w} \cdot \rho } {\bar{H}}}} \right. \kern-0em} {\bar{H}}}} \right) $ , was 2.641?±?0.022?kg?m^?3, which was considerably higher than 1.3?C1.5?kg?m^?3 of most terrestrial forests. The self-thinning exponent $ \alpha \left( { = {1 \mathord{\left/ {\vphantom {1 {\varphi = }}} \right. \kern-0em} {\varphi = }}{1 \mathord{\left/ {\vphantom {1 {\left\{ {1 - \left( {\theta + \delta } \right)} \right\}}}} \right. \kern-0em} {\left\{ {1 - \left( {\theta + \delta } \right)} \right\}}}} \right) $ and the multiplying factor $ K\left( { = \left( {g_{\theta } \cdot g_{\delta } } \right)^{\alpha } } \right) $ were estimated to be 1.585 and 16.18?kg?m^?2??, respectively. The estimators $ \theta $ and $ \delta $ are dependent on each other. Therefore, the observed value of $ \theta + \delta $ cannot be used for the test of the hypothesis that the expectation of the estimator $ \theta + \delta $ equals 1/3, i.e., $ \alpha = {3 \mathord{\left/ {\vphantom {3 2}} \right. \kern-0em} 2} $ , or 1/4, i.e., $ \alpha = {4 \mathord{\left/ {\vphantom {4 3}} \right. \kern-0em} 3} $ . The $ \varphi $ value was 0.6310, which is the same as the reciprocal of the self-thinning exponent of 1.585, and was not significantly different from 2/3 (t?=?1.860, df?=?191, p?=?0.06429), i.e., $ \alpha = {3 \mathord{\left/ {\vphantom {3 2}} \right. \kern-0em} 2} $ . Thus the self-thinning exponent is not significantly different from 3/2 based on the simple geometric model. On the other hand, the self-thinning exponent was significantly different from 3/4 (t?=?6.213, df?=?191, p?=?3.182?×?10^?9), i.e., $ \alpha = {4 \mathord{\left/ {\vphantom {4 3}} \right. \kern-0em} 3} $ . Therefore, the self-thinning exponent is significantly different from 4/3 based on the metabolic model.     

A Monte Carlo simulation of the intergalactic absorption and the detectability of the Lyman continuum from distant galaxies

We have made a Monte Carlo simulation of the intergalactic absorption in order to model the Lyman continuum absorption, which is required to estimate the escape fraction of the Lyman continuum from distant galaxies. To input into the simulation, we derive an empirical distribution function of the intergalactic absorbers which reproduces recent observational statistics of the Lyman α forest, Lyman limit systems (LLSs) and damped Lyman α systems (DLAs) simultaneously. In particular, we assume a common functional form of the number evolution along the redshift for all types of absorbers. The Lyman series transmissions in our simulation reproduce the observed redshift evolution of the transmissions excellently, and the Lyman continuum transmission also agrees with an observed estimation which is still quite rare in the literature. The probability distribution of the Lyman α opacity in our simulation is lognormal with a tail towards a large opacity. This tail is produced by DLAs. The probability distribution of the Lyman continuum opacity in our simulation also shows a broad tail towards a large opacity. This tail is produced by LLSs. Because of the rarity of LLSs, we have a chance to have a clean line of sight in the Lyman continuum even for   z ∼ 4  with a probability of about 20 per cent. Our simulation expects a good correlation between the Lyman continuum opacity and the Lyman α opacity, which may be useful to estimate the former from the latter for an individual line of sight.     

Dust ring formation due to sublimation of dust grains drifting radially inward by the Poynting-Robertson drag: An analytical model

Dust particles exposed to the stellar radiation and wind drift radially inward by the Poynting-Robertson (P-R) drag and pile up at the zone where they begin to sublime substantially. The reason they pile up or form a ring is that their inward drifts due to the P-R drag are suppressed by stellar radiation pressure when the ratio of radiation pressure to stellar gravity on them increases during their sublimation phases. We present analytic solutions to the orbital and mass evolution of such subliming dust particles, and find their drift velocities at the pileup zone are almost independent of their initial semimajor axes and masses. We derive analytically an enhancement factor of the number density of the particles at the outer edge of the sublimation zone from the solutions. We show that the formula of the enhancement factor reproduces well numerical simulations in the previous studies. The enhancement factor for spherical dust particles of silicate and carbon extends from 3 to more than 20 at stellar luminosities L_?=0.8-500L_⊙, where L_⊙ is solar luminosity. Although the enhancement factor for fluffy dust particles is smaller than that for spherical particles, sublimating particles inevitably form a dust ring as long as their masses decrease faster than their surface areas during sublimation. The formulation is applicable to dust ring formation for arbitrary shape and material of dust in dust-debris disks as well as in the Solar System.     

Evidence for energy injection and a fine-tuned central engine at optical wavelengths in GRB 070419A

We present a comprehensive multiwavelength temporal and spectral analysis of the 'fast rise exponential decay' GRB 070419A. The early-time emission in the γ-ray and X-ray bands can be explained by a central engine active for at least 250 s, while at late times the X-ray light curve displays a simple power-law decay. In contrast, the observed behaviour in the optical band is complex (from 10² up to 10⁶ s). We investigate the light-curve behaviour in the context of the standard forward/reverse shock model; associating the peak in the optical light curve at ∼450 s with the fireball deceleration time results in a Lorenz factor  Γ≈ 350  at this time. In contrast, the shallow optical decay between 450 and 1500 s remains problematic, requiring a reverse shock component whose typical frequency is above the optical band at the optical peak time for it to be explained within the standard model. This predicts an increasing flux density for the forward shock component until   t ∼ 4 × 10⁶ s  , inconsistent with the observed decay of the optical emission from   t ∼ 10⁴ s  . A highly magnetized fireball is also ruled out due to unrealistic microphysic parameters and predicted light-curve behaviour that is not observed. We conclude that a long-lived central engine with a finely tuned energy injection rate and a sudden cessation of the injection is required to create the observed light curves, consistent with the same conditions that are invoked to explain the plateau phase of canonical X-ray light curves of γ-ray bursts.     

Dietary analysis of harbour seals (Phoca vitulina) from faecal samples and overlap with fisheries in Erimo,Japan

The number of harbour seals in Japan has been rebounding since protection began in the mid‐1980s. With the increase in seal numbers, increased conflict with fisheries has occurred through depredation and the belief that seals compete with fisheries for prey. However, competition can only be determined if the prey species and quantities seals consume over time are known. We studied the diet of harbour seals in Erimo, site of the largest population of harbour seals in Japan, from 2011 to 2012 and assessed the degree of prey overlap with local fisheries. We used both hard parts and DNA techniques to identify prey items in seal scats, and compared these results to local fisheries data. A total of 46 prey occurrences was detected by both methods, of which 17 matched between techniques at least to the family level. Hard parts methods identified five incidences of prey undetected by DNA methods in five scats (one incidence per scat). DNA methods identified 24 additional prey occurrences in 13 scats, for which no hard part evidence for that prey had been found. This more than doubled the total number of prey occurrences across the 15 scats compared. Overall, the most frequently occurring harbour seal prey were walleye pollock (Theragra chalcogramma), sculpins and snailfishes. In contrast, the top three groups targeted by fisheries were codfishes, salmon and invertebrates. Many species common in the harbour seal's diet such as snailfishes and blennies were not targeted by fisheries. Fishes such as greenlings, sculpins, rockfishes and Japanese anchovy (Engraulis japonicus) were common in the diet of harbour seals, but made up a very small proportion of fisheries catches in Erimo. The importance of other prey species varied between seasons. Sculpins, greenlings and forage fishes were the top three prey groups for harbour seals in spring by percent modified frequency of occurrence, whereas the most important target groups by percentage mass caught by fisheries were codfishes, cephalopods and other invertebrates. Sculpins and rockfishes remained as important prey items for harbour seals in summer and autumn, in addition to codfishes, snailfishes and blennies. In contrast, the main groups caught by fisheries in summer were other fishes, particularly Japanese amberjack (Seriola quinqueradiata) and various species of sharks and eels, and invertebrates. By autumn, Erimo fisheries had focussed on catching salmon. Salmon were taken by harbour seals as well during this period, but at a relatively lower frequency compared to other prey groups. The results of our study show that although harbour seals consumed several of the prey species targeted by fisheries, the relative importance of these species to seals and fisheries and the seasons in which they were targeted were different.     

A multiple-code simulation study of the long-term EDZ evolution of geological nuclear waste repositories

This simulation study shows how widely different model approaches can be adapted to model the evolution of the excavation disturbed zone (EDZ) around a heated nuclear waste emplacement drift in fractured rock. The study includes modeling of coupled thermal-hydrological-mechanical (THM) processes, with simplified consideration of chemical coupling in terms of time-dependent strength degradation or subcritical crack growth. The different model approaches applied in this study include boundary element, finite element, finite difference, particle mechanics, and elasto-plastic cellular automata methods. The simulation results indicate that thermally induced differential stresses near the top of the emplacement drift may cause progressive failure and permeability changes during the first 100 years (i.e., after emplacement and drift closure). Moreover, the results indicate that time-dependent mechanical changes may play only a small role during the first 100 years of increasing temperature and thermal stress, whereas such time-dependency is insignificant after peak temperature, because of decreasing thermal stress.     

Distribution of fault rocks in the fracture zone of the Nojima Fault at a depth of 1140 m: Observations from the Hirabayashi NIED drill core

Abstract Characteristics of deformation and alteration of the 1140 m deep fracture zone of the Nojima Fault are described based on mesoscopic (to the naked eye) and microscopic (by both optical and scanning electron microscopes) observations of the Hirabayashi National Research Institute for Earth Science and Disaster Prevention (NIED) drill core. Three types of fault rocks; that is, fault breccia, fault gouge and cataclasite, appear in the central part of the fault zone and two types of weakly deformed and/or altered rocks; that is, weakly deformed and altered granodiorite and altered granodiorite, are located in the outside of the central part of the fault zone (damaged zone). Cataclasite appears occasionally in the damaged zone. Six distinct, thin foliated fault gouge zones, which dip to the south-east, appear clearly in the very central part of the fracture zone. Slickenlines plunging to the north-east are observed on the surface of the newest gouge. Based on the observations of XZ thin sections, these slickenlines and the newest gouge have the same kinematics as the 1995 Hyogo-ken Nanbu earthquake (Kobe earthquake), which was dextral-reverse slip. Scanning electron microscopy observations of the freeze-dried fault gouge show that a large amount of void space is maintained locally, which might play an important role as a path for fluid migration and the existence of either heterogeneity of pore fluid pressure or strain localization.     

Thermal diffusivity of stishovite

The thermal diffusivity of synthetic polycrystalline stishovite was determined by the Ångstrom method in the temperature range 300–550 K at 1 atm. The calculated thermal conductivity of stishovite at 300 K is 0.086 W cm^?1 K^?1 which is comparable to that for TiO₂-rutile but much lower than for GeO₂ and SnO₂. The observed thermal conductivities of rutile-structure oxides increase systematically with increasing density, in contrast with the expected behavior for isostructural compounds.