AbstractCompared with traditional methods, the three-dimensional laser-scanning (3D-LS) technique can efficiently acquire many high-quality geometric properties of rock discontinuities. In practice, engineers usually prefer to simplify the processing by using single-station point data and roughly orienting owing to the complexity of registration/georeferencing multi-station point data. However, prior published studies have paid little attention to the accuracy and reliability when determining discontinuity orientations using 3D-LS. We propose a reliable and accurate method with robust on-site applicability. As part of an ongoing effort, we are evaluating the precision of the commonly used coarse registration method and the fine registration method, and promoted the optimized coarse- and fine-registration methods and evaluated their precision. It is found that: (1) the common and the optimized registration method can meet our project’s engineering requirements, and the optimized registration method improved accuracy in the dip direction by approximately 1°; (2) fine registration using an iterative closest point (ICP) algorithm can correct both dip direction and dip angle; and (3) the orientation is of high precision with commonly used coarse and fine registration, whereas the optimization effect to correct the orientation is slightly limited. 相似文献
AbstractUnder seismic loading, the soil layer is subjected to multidirectional cyclic shear stress with different amplitudes and frequencies because of the coupling of multiple shear waves and the soil element within a slope or behind a retaining wall is subjected to initial static shear stress before subjected to cyclic loading. Due to the complexity of seismic loading propagation, a phase difference exists between the initial static shear stress and cyclic shear stress. To investigate the influence of the phase difference and initial static shear stress on cyclic shear strain, cyclic modulus, and cyclic strength, a series of laboratory tests are performed on Wenzhou marine soft clay by multi-directional simple shear system, which can simulate the actual state better by controlling the horizontal cyclic stress in the x and y directions simultaneously. As the phase difference varies from 0° to 90°, the dynamic shear modulus increases and cyclic strain accumulation decreases with an increasing number of cycles. The shear strain increases with the initial shear stress. 相似文献
The transfer and evolution of stress among rock blocks directly change the void ratios of crushed rock masses and affect the flow of methane in coal mine gobs. In this study, a Lagrange framework and a discrete element method, along with the soft-sphere model and EDEM numerical software, were used. The compaction processes of rock blocks with diameters of 0.6, 0.8, and 1.0 m were simulated with the degrees of compression set at 0%, 5%, 10%, 15%, 20%, and 25%. This study examines the influence of stress on void ratios of compacted crushed rock masses in coal mine gobs. The results showed that stress was mainly transmitted downward through strong force chains. As the degree of compression increased, the strong force chains extended downward, which resulted in the stress at the upper rock mass to become significantly higher than that at the lower rock mass. It was determined that under different degrees of compression, the rock mass of coal mine gobs could be divided, from the bottom to the top, into a lower insufficient compression zone (ICZ) and an upper sufficient compression zone (SCZ). From bottom to top, the void ratios in the ICZ sharply decreased and those in the SCZ slowly decreased. Void ratios in the ICZ were 1.2–1.7 times higher than those in the SCZ.
Natural Resources Research - Alkali–surfactant–polymer (ASP)-produced effluent contains polymer, alkali and surfactant, and it has higher content of suspended oil droplets and suspended... 相似文献