Seismic evaluation of an existing complex RC building

The seismic evaluation of existing buildings is a more difficult task than the seismic design of new buildings. Non-linear methods are needed if realistic results are to be obtained. However, the application to real complex structures of various evaluation procedures, which have usually been tested on highly idealized structural models, is by no means straightforward. In the paper, a practice-oriented procedure for the seismic evaluation of building structures, based on the N2 method, is presented, together with the application of this method to an existing multi-storey reinforced concrete building. This building, which is asymmetric in plan and irregular in elevation, consists of structural walls and frames. It was designed in 1962 for gravity loads and a minimum horizontal loading (2% of the total weight). The main results presented in terms of the global and local seismic demands are compared with the results of non-linear dynamic response-history analyses. As expected, the structure would fail if subjected to the design seismic action according to Eurocode 8. The shear capacity of the structural walls is the most critical. If the shear capacity of these elements was adequate, the structure would be able to survive the design ground motion according to Eurocode 8, in spite of the very low level of design horizontal forces. The applied approach proved to be a feasible tool for the seismic evaluation of complex structures. However, due to the large randomness and uncertainty which are involved in the determination of both the seismic demand and the seismic capacity, only rough estimates of the seismic behaviour of such structures can be obtained.     

半潜平台浮子式系泊系统参数优化研究

通过在系泊缆中设置浮子可以改善系泊系统性能,降低平台运动响应。建立浮子式系泊系统的数值计算模型,验证浮子式系泊系统数值计算方法,详细分析浮子设计参数(设置位置和净浮力大小)变化对系泊缆张力特性与平台运动的影响规律,并根据得到的规律选择了优化的浮子系泊系统方案。最后对优化方案进行评估,表明优化方案可以显著降低系泊中的平台水平运动,尤其是低频运动,同时系泊缆张力变化不大,仍满足安全要求。研究结果可为今后浮子式系泊系统设计提供参考。     

Results from the Big Spring basin water quality monitoring and demonstration projects,Iowa, USA

Agricultural practices, hydrology, and water quality of the 267-km² Big Spring groundwater drainage basin in Clayton County, Iowa, have been monitored since 1981. Land use is agricultural; nitrate-nitrogen (-N) and herbicides are the resulting contaminants in groundwater and surface water. Ordovician Galena Group carbonate rocks comprise the main aquifer in the basin. Recharge to this karstic aquifer is by infiltration, augmented by sinkhole-captured runoff. Groundwater is discharged at Big Spring, where quantity and quality of the discharge are monitored. Monitoring has shown a threefold increase in groundwater nitrate-N concentrations from the 1960s to the early 1980s. The nitrate-N discharged from the basin typically is equivalent to over one-third of the nitrogen fertilizer applied, with larger losses during wetter years. Atrazine is present in groundwater all year; however, contaminant concentrations in the groundwater respond directly to recharge events, and unique chemical signatures of infiltration versus runoff recharge are detectable in the discharge from Big Spring. Education and demonstration efforts have reduced nitrogen fertilizer application rates by one-third since 1981. Relating declines in nitrate and pesticide concentrations to inputs of nitrogen fertilizer and pesticides at Big Spring is problematic. Annual recharge has varied five-fold during monitoring, overshadowing any water-quality improvements resulting from incrementally decreased inputs. Electronic Publication     

北京市房地产价格空间分布变化研究

针对北京市主城区房地产价格长区间的空间分布变化及其成因进行研究,为北京市房价的空间分布规律提供参考.采用空间相关性分析方法中的平均最近邻分析、全局Moran'sI指数、Moran散点图和LISA集聚图等分析工具结合空间自相关理论对北京市主城区房地产价格的空间分布变化进行分析,通过克里金插值分析方法验证房价的空间特征,分析空间分布的变化及其成因.得出北京市主城区房地产价格20152019年,空间集聚特征不变,正向空间自相关增强,价格中心由单中心变为中心—副中心的多中心形式,区位因素和交通可达性条件是影响房价空间分布变化的重要因素.     

一种用于海底类型聚类的新方法

By using sonar imaging, this paper presents a new algorithm for the clustering of seabed types based on the self-organizing feature maps （SOFM） neural network. The theory as well as data processing is studied in detail. Some valuable conclusions and suggestions are given     

A Directed-Line-Segment-Based Photogrammetry Method to Survey the Tunneling Working Surface of Mine Roadway

Absolute orientation is a basic technical work in digital image geologic logging of underground coal mine. Traditional control-point-based absolute orientation method requires setting object space control points of the known three-dimensional coordinates, which may lead to low efficiency. Therefore, this paper proposed a point-free close-range photogrammetry absolute orientation algorithm, which utilized direction line segments including plumb line segments and line segments with known directions and lengths to identify the dimensional orientation of a stereoscopic model. Experiment results show that the precision of the orientation results is favorable. σ _X and σ _Y are as high as 0.5 mm, and σ _Z is 0.3 mm. Finally, this paper introduced the application of the proposed algorithm in rapid geological logging of coal mine roadway, which was fast and reliable, convenient and feasible.     

地电化学法寻找隐伏金矿的应用研究

通过对金的地电化学成晕机制的研究,利用地电化学法在东北大兴安岭森林覆盖区虎拉林金矿和澳大利亚第四纪厚层覆盖区Challenger金矿进行可行性找矿试验研究。试验结果在上述已知矿区的剖面上均测出了清晰的地电化学异常,表明利用地电化学法在上述地区寻找的隐伏金矿是有效的。在此基础上对两矿区外围及深部进行了找矿预测,发现4个有利的成矿靶区,经工程验证发现2个金矿体,取得了良好的经济和社会经济效益。     

Real-time envelope cross-correlation detector: application to induced seismicity in the Insheim and Landau deep geothermal reservoirs

We develop and test a real-time envelope cross-correlation detector for use in seismic response plans to mitigate hazard of induced seismicity. The incoming seismological data are cross-correlated in real-time with a set of previously recorded master events. For robustness against small changes in the earthquake source locations or in the focal mechanisms we cross-correlate the envelopes of the seismograms rather than the seismograms themselves. Two sequenced detection conditions are implemented: After passing a single trace cross-correlation condition, a network cross-correlation is calculated taking amplitude ratios between stations into account. Besides detecting the earthquake and assigning it to the respective reservoir, real-time magnitudes are important for seismic response plans. We estimate the magnitudes of induced microseismicity using the relative amplitudes between master event and detected event. The real-time detector is implemented as a SeisComP3 module. We carry out offline and online performance tests using seismic monitoring data of the Insheim and Landau geothermal power plants (Upper Rhine Graben, Germany), also including blasts from a nearby quarry. The comparison of the automatic real-time catalogue with a manually processed catalogue shows, that with the implemented parameters events are always correctly assigned to the respective reservoir (4 km distance between reservoirs) or the quarry (8 km and 10 km distance, respectively, from the reservoirs). The real-time catalogue achieves a magnitude of completeness around 0.0. Four per cent of the events assigned to the Insheim reservoir and zero per cent of the Landau events are misdetections. All wrong detections are local tectonic events, whereas none are caused by seismic noise.     

Allowed Quantity of Explosive Charge Depending on the Distance from the Blast

This paper analyses results of trial, construction and quarry blasting, carried out in sediment rock deposits, mainly limestone and dolomite. Based on results of seismic measurements and engineering geological observations in sedimentary formation, an empirical relationship was established between ground vibration and geological strength index (GSI). The charge weight of explosive that may be detonated per delay for any given distance of nearby structures from the blast is approximately determined by using the concept of the scaled distance (SD) along with the DIN 4150 standard.     

Characteristics of secondary circulations over an inhomogeneous surface simulated with large-eddy simulation

Large-eddy simulation is used to study secondary circulations in the convective boundary layer modulated as a result of horizontally varying surface properties and surface heat fluxes over flat terrain. The presence of heat flux heterogeneity and its alignment with respect to geostrophic wind influences the formation, strength and orientation of organized thermals. Results show boundary-attached roll formation along heat flux maxima in the streamwise direction. The streamwise organization of the updrafts and downdrafts formed downwind of heterogeneities leads to counter-rotating secondary circulations in the crosswind plane. The distribution of resolved-scale pressure deviations shows large pressure gradients in the crosswind plane. Spanwise and vertical velocity variances and heat flux profiles depict considerable spatial variability compared to a homogeneous forest simulation. Secondary circulations are observed for various ambient wind scenarios parallel and perpendicular to heterogeneities. In the presence of increased wind speed, thermals emerging from the heat flux heterogeneity are elongated, and organize along and downwind of large-scale heterogeneity in the streamwise direction. Simulation with a reduced heat flux shows a shallower circulation with a lower aspect ratio. Point measurements of heat flux inside the roll circulation could be overestimated by up to 15–25% compared to a homogeneous case.