增强显示和伪彩色数字化红外云图在台风降水预报中的应用

本文应用增强显示红外云图资料,主要考虑台风增强云系温度等级、云系范围、螺旋结构、台风眼情况、台风西南方卷入云带等,结合台风所对应位置组成经验公式,作出华南台风的降水量级预报。在采用伪彩色数字化云图时,除了考虑上述台风云系数字化数值外,还结合台风移向移速,有无其他天气系统共同作用等,组成计算公式,所作出华南台风降水量预报与实况相近。关于强降水落区,则用物理量计算分布的极值区来决定。      

气旋爆发性发展过程的动力特征及能量学研究

本文对不同路径的爆发性气旋进行了动力特征及能量学研究。发现高空大值位涡空气的下伸是气旋爆发性发展的一个重要条件。初生气旋逐渐向强位涡区移近并形成上下位涡区相接的形势。使气旋迅速发展。高空急流与气旋发展有密切关系。发展中的气旋明显地向着急流左侧的辐散区移动。急流的突然加强及高空强风动量的不断下传，构成了下层的强风带及上下一致的急流结构。能量学研究指出在气旋发展前气旋内散度风动能向旋转风动能的转换突然增强。散度风动能在爆发气旋发展时有明显增长。     

正压准共振三波能量和拟能的传输

从准地转正压涡度方程出发，在ｋ１＋ｋ２＋ｋ３＝△ｋ、ｌ１＋ｌ２＋ｌ３＝０和ω１＋ω２＋ω３＝０的准共振条件下，分析了准共振三波能量和位涡拟能的传输。当△ｋ很小时，准共振三波组的总能量和总拟能近似守恒；三波之间能量和拟能的传输方向与共振情况基本相同，但中波向长波传输较多能量、向短波传输较多拟能和三波之间产生能量与拟能传输这三者的可能非线性准共振的面积与共振时相比均有较大的变化，而三者的面积比也有较明     

Climatic regime shift and decadal anomalous events in China

Climatic time series from historical documents and instrumental records from China showed temporal and regional patterns in the last two to three centuries, including two multidecadal oscillations at quasi-20-year and quasi-70-year timescales revealed by signal analysis from wavelet transform. Climatic anomalous events on the decadal timescale were identified based on the two oscillations when their positive (or negative) phases coincide with each other to amplify amplitude. The coldest event occurred in the decade of 1965–1975 in eastern China, while the periods of 1920–1930, 1940–1950, and 1988–2000 appeared to be warmer in most parts of China. For the precipitation series in northern China, the dry anomalous event was found in the late 1920s, while the wet anomalous event occurred in the 1950s. A severe drought in 1927–1929 in northern China coincided with the anomalous warm and dry decade, caused large-scale famine in nine provinces over northern China. Climatic anomalous events with a warm-dry or cold-wet association in the physical climate system would potentially cause severe negative impacts on natural ecosystem in the key vulnerable region over northern China. The spatial pattern of summer rainfall anomalies in the eastern China monsoon region showed an opposite variations in phase between the Yellow River Valley (North China) and the mid-low Yangtze River Valley as well as accompanied the shift of the northernmost monsoon boundary. Climatic regime shifts for different time points in the last 200 years were identified. In North China, transitions from dry to wet periods occurred around 1800, 1875, and 1940 while the transitions from wet to dry periods appeared around 1840, 1910, and the late 1970s. The reversal transition in these time points can also be found in the lower Yangtze River. Climatic regime shifts in China were linked to the interaction of mid- and low latitude atmospheric circulations (the westerly flow and the monsoon flow) when they cross the Tibetan Plateau in East Asia.     

Atmospheric chemistry of hydrogen fluoride

Although a large volume of monitoring and computer simulation data exist for global coverage of HF, study of HF in the troposphere is still limited to industry whose primary interest is the safety and risk assessment of HF release because it is a toxic gas. There is very limited information on atmospheric chemistry, emission sources, and the behavior of HF in the environment. We provide a comprehensive review on the atmospheric chemistry of HF, modeling the reactions and transport of HF in the atmosphere, the removal processes in the vertical layer immediately adjacent to the surface (up to approximately 500 m) and recommend research needed to improve our understanding of atmospheric chemistry of HF in the troposphere. The atmospheric chemistry, emissions, and surface boundary layer transport of hydrogen fluoride (HF) are summarized. Although HF is known to be chemically reactive and highly soluble, both factors affect transport and removal in the atmosphere, the chemistry can be ignored when the HF concentration is at a sufficiently low level (e.g., 10 ppmv). At a low concentration, the capability for HF to react in the atmosphere is diminished and therefore the species can be mathematically treated as inert during the transport. At a sufficiently high concentration of HF (e.g., kg/s release rate and thousands of ppm), however, HF can go through a series of rigorous chemical reactions including polymerization, depolymerization, and reaction with water to form molecular complex. As such, the HF species cannot be considered as inert because the reactions could intimately influence the plume’s thermodynamic properties affecting the changes in plume temperature and density. The atmospheric residence time of HF was found to be less than four (4) days, and deposition (i.e., atmosphere to surface transport) is the dominant mechanism that controls the removal of HF and its oligomers from the atmosphere. The literature data on HF dry deposition velocity was relatively high compared to many commonly found atmospheric species such as ozone, sulfur dioxide, nitrogen oxides, etc. The global average of wet deposition velocity of HF was found to be zero based on one literature source. Uptake of HF by rain drops is limited by the acidity of the rain drops, and atmospheric particulate matter contributes negligibly to HF uptake. Finally, given that the reactivity of HF at a high release rate and elevated mole concentration cannot be ignored, it is important to incorporate the reaction chemistry in the near-field dispersion close to the proximity of the release source, and to incorporate the deposition mechanism in the far-field dispersion away from the release source. In other words, a hybrid computational scheme may be needed to address transport and atmospheric chemistry of HF in a range of applications. The model uncertainty will be limited by the precision of boundary layer parameterization and ability to accurately model the atmospheric turbulence.     

Multi-Source Emission Determination Using an Inverse-Dispersion Technique

Inverse-dispersion calculations can be used to infer atmospheric emission rates through a combination of downwind gas concentrations and dispersion model predictions. With multiple concentration sensors downwind of a compound source (whose component positions are known) it is possible to calculate the component emissions. With this in mind, a field experiment was conducted to examine the feasibility of such multi-source inferences, using four synthetic area sources and eight concentration sensors arranged in different configurations. Multi-source problems tend to be mathematically ill-conditioned, as expressed by the condition number κ. In our most successful configuration (average κ = 4.2) the total emissions from all sources were deduced to within 10% on average, while component emissions were deduced to within 50%. In our least successful configuration (average κ = 91) the total emissions were calculated to within only 50%, and component calculations were highly inaccurate. Our study indicates that the most accurate multi-source inferences will occur if each sensor is influenced by only a single source. A “progressive” layout is the next best: one sensor is positioned to “see” only one source, the next sensor is placed to see the first source and another, a third sensor is placed to see the previous two plus a third, and so on. When it is not possible to isolate any sources κ is large and the accuracy of a multi-source inference is doubtful.     

Statistical estimation of high-resolution surface air temperature from MODIS over the Yangtze River Delta,China

High-resolution surface air temperature data are critical to regional climate modeling in terms of energy balance, urban climate change, and so on. This study demonstrates the feasibility of using Moderate Resolution Imaging Spectroradiometer (MODIS) land surface temperature (LST) to estimate air temperature at a high resolution over the Yangtze River Delta region, China. It is found that daytime LST is highly correlated with maximum air temperature, and the linear regression coefficients vary with the type of land surface. The air temperature at a resolution of 1 km is estimated from the MODIS LST with linear regression models. The estimated air temperature shows a clear spatial structure of urban heat islands. Spatial patterns of LST and air temperature differences are detected, indicating maximum differences over urban and forest regions during summer. Validations are performed with independent data samples, demonstrating that the mean absolute error of the estimated air temperature is approximately 2.5°C, and the uncertainty is about 3.1°C, if using all valid LST data. The error is reduced by 0.4°C (15%) if using best-quality LST with errors of less than 1 K. The estimated high-resolution air temperature data have great potential to be used in validating high-resolution climate models and other regional applications.     

Glauconites from the Late Palaeocene — Early Eocene Naredi Formation,western Kutch and their genetic implications

Glauconitic minerals are considered as one of the valuable input parameters in sequence stratigraphic analysis of a basin. In the present study glauconitic minerals are reported from subtidal green shale facies in the lower part of the Late Paleocene-Early Eocene Naredi Formation of western Kutch. On the basis of the foraminiferal assemblage the glauconite bearing beds are interpreted to have formed in a mid shelf depositional settings of an unstable marine conditions. XRD studies confirm the glauconite mineralogy of the green pellets and provide an estimation of glauconite maturity. Textural attributes of the glauconites confirm their derivation by different degrees of alteration of precursor feldspar grains. Because of the authigenic origin and autochthonous nature, these glauconites hold promise for understanding sequence stratigraphy of the Palaeogene succession of the western Kutch.     

Formation of the adakite-like granitoid complex and porphyry copper-gold deposit in Shaxi from southern Tancheng-Lujiang fault belt： A clue to the West Pacific plate subduction

On the basis of the geological and geochemical studies, including chemical analysis of bulk rocks, rare-earth and trace element studies, fluid inclusion, and S and O isotopic analyses, the authors described the geo-logical background of the deposit in detail and presented significant proofs for the conditions of formation of the Shaxi porphyry copper-gold deposit. Compared with other large and supper-large porphyry copper deposits in China and the adjacent Cu-Au mineralized areas, the ore-forming processes and conditions were analyzed; and the possibil-ity of forming large porphyry copper deposits in the Shaxi area was discussed. The present study indicated that the ore-forming fluid and material were mainly of magmatic origin, while meteoric water played a certain role in the ore-forming processes. Interactions between subducting and overriding plates provided a major driving force for the formation of igneous rocks and the deposition of metal elements in East China since Jurassic. Based on the geo-chemical data of the Shaxi intrusive, it is found that the copper (gold) mineralization is closely related to the genesis of adakite-like intrusive in the Shaxi area. This adakite-like intrusive was formed in the subduction environment as a result of the subduction of the West Pacific plate toward the East China continent, where there is a great potential-ity to form a large porphyry copper deposit.     

Raman spectroscopic study of K-lingunite at various pressures and temperatures

K-lingunite is a high-pressure modification of K-feldspar that possesses the tetragonal hollandite structure. Variations of the Raman spectra of K-lingunite were studied up to ~31.5 GPa at room temperature, and in the range 79–823 K at atmospheric pressure. The Raman frequencies of all bands were observed to increase with increasing pressure, and decrease with increasing temperature for K-lingunite. This behavior is in line with those observed for most of other materials. New sharp Raman bands appear at pressures greater than 13–15 GPa, suggesting a phase transition in K-lingunite with increasing pressure. The transition is reversible when pressure was released. The appearance of these new Raman bands may correspond to the phase transition revealed earlier at around 20 GPa by X-ray diffraction studies. Instead of transforming back to its stable minerals, such as orthoclase, microcline or sanidine, K-lingunite became amorphous in the temperature range 803–823 K at atmospheric pressure.