The effect of annealing on the luminescence decay-time of synthetic calcite:Mn

Calcite was synthesized by four methods, and the luminescence decay-time was measured for nine samples before and after heating hydrothermally in the temperature range 200–400°C. Decay-time data were collected between room temperature and approximately 15 K. The decay time at room temperature is approximately 50 ms, with little difference between a given calcite before and after hydrothermal treatment. The decay time at 15 K is always greater than at room temperature as the effect of thermal quenching diminishes. Differences in decay time before and after heating are more apparent at low temperature owing to this reduction in thermal quenching. The decay time decreased significantly in two samples, and an increase in decay time was observed in the remaining seven samples following heating. Among the latter group, the change in decay time was insignificant in three samples. The results are compared with previous data in which it was shown that the effect of heating is to increase the intensity of luminescence.     

Iron isotopic analyses of geological reference materials on MC-ICP-MS with instrumental mass bias corrected by three independent methods

Here we report iron (Fe) isotopic data of three pure Fe solution standards (IRMM-014, GSB Fe, and NIST 3126a) and five widely used geological reference materials (RMs) from the United States Geological Survey and Geological Survey of Japan obtained on a Neptune Plus multi-collector–inductively coupled plasma–mass spectrometer (MC-ICP-MS) in our laboratory over the past 3 years. The instrumental mass bias was corrected by three independent methods: sample-standard bracketing (SSB), Ni doping?+?SSB, and ⁵⁷Fe–⁵⁸Fe double spike?+?SSB. Measurements reveal that both the Ni doping and double spike methods helped calibrate short-term fluctuations in mass bias. Collectively, almost all measurements of RMs yielded δ⁵⁶Fe within?±?0.05 of recommended values, provided that each sample was measured four times on MC-ICP-MS. For the first time, new recommended values for NIST SRM3126a are reported (δ⁵⁶Fe?=?0.363?±?0.006, 2SE, 95% CI; and δ⁵⁷Fe?=?0.534?±?0.010, 2SE).     

Effects of natural attenuation processes on groundwater contamination caused by abandoned waste sites in Berlin

The aim of this research project is to identify, characterize and quantify natural attenuation (NA) processes in groundwater affected by emissions of abandoned waste disposal sites in Berlin-Kladow/Gatow, Germany. It is part of the funding priority called KORA established by the Federal Ministry for Education and Research (BMBF) to explore the extent to which NA can be used for remedial purposes for varied forms of soil and groundwater contamination. Information on the emission behaviour of individual parameters is generated on the basis of hydrogeochemical comparison of 20 years old and new data. Using groundwater-modelling and CFC-analysis, information on the transport and retention of pollutants in groundwater is compiled. The microbial colonization of contaminated aquifers is characterized by molecular biological methods [polymerase chain reaction (PCR) and denaturing gradient gel electrophoresis (DGGE)] to differentiate between contaminated and not contaminated zones.     

Chromium speciation in oxide-type compounds: application to minerals,gems, aqueous solutions and silicate glasses

Cr K-edge XANES spectra were obtained for a variety of Cr-bearing model compounds containing Cr(II), Cr(III), Cr(IV), Cr(V) and Cr(VI), in which the Cr-site symmetry is D4h, Oh and Td. The centroid position of the pre-edge feature is a better indicator of the Cr valence than the edge position. In Cr-rich oxides, higher-energy transitions must be excluded in order to refine a robust valence for Cr. The pre-edge for chromates is not unique and varies as a function of the CrO₄ ^2? moiety distortion, which is often related to Cr-polymerization (monochromate vs. dichromate). Both the analogy with the Mn K-pre-edge information and ab initio FEFF calculations of the pre-edge feature for Cr(III) and Cr(VI) confirm the experimental trends. This methodology is applied to the Cr K-edge pre-edge feature collected in gems (emerald, spinel and ruby), the layered minerals fuchsite and kämmererite, two Cr-bearing aqueous solutions and a set of sodo-calcic silicate glasses used for bottling sparkling white wine. In emerald and fuchsite, the Cr-site is differently distorted than its ruby or spinel counterpart. In a Cr(III)-bearing aqueous solution and sodo-calcic glass, no evidence for Cr(III) with Td and C3v symmetry is detected. However, minor amounts of chromate moieties (most likely monomeric) are detected in a glass synthesized in air. Preliminary spectra for the wine bottle glass suggest that only trace amounts of chromates might possibly be present in these glasses.     

Assessing the vulnerability of social–environmental system from the perspective of hazard,sensitivity, and resilience: a case study of Beijing,China

Despite a recent increase in the number of vulnerability analyses there has been relatively little discussion of vulnerability assessment of social–environment system, especially when they face multiple hazards. In this study, we developed an applicable and convenient method to assess vulnerability of social–environment system at a regional scale. Vulnerability is quantified by measuring three critical elements (i.e. hazards, sensitivity, and resilience) through some key variables. The results showed that vulnerability is high in Miaofeng Mountain in Mengtougou District, the hills of Pinggu County and the riparian zones of the lower courses of the Beiyun and Yongding Rivers; but low in the city of Beijing and the southwestern part of the Fangshan District. Areas of very high, high, medium, and low-vulnerability account for 6.19, 25.48, 33.06, and 35.27% of the total area, respectively. The degree of vulnerability decreases in a northwest direction in mountainous areas and declines from watercourses to riparian zones along a lateral direction in the plain. Some adaptive strategies are also proposed.     

Reconstruction of palaeosalinity using carbon isotopes and benthic associations: a comparison

Carbon and oxygen isotopes were determined on 40 recrystallized shells of Late Jurassic bivalves from the Lusitanian Basin of Portugal. In contrast with the oxygen isotopes, which exhibited considerable diagenetic distortion, the carbon isotopes are thought to preserve a record of the salinity of the Jurassic marginal marine seas in which these bivalves lived. The reconstructed palaeosalinities range from 35%o (euhaline) to 5% (oligohaline). Comparing these values with the palaeosalinity reconstructed from a palaeoecological analysis of 17 stratigraphic levels within the basin, the independently derived values agree in most cases. Strongly differing values are explained as being due to biotic factors and to diagenetic distortion of the isotopic signal; they are less likely to be due to smallscale time-averaging or insufficient microstratigraphic sampling. On the whole, the carbon isotope analyses are thought to produce reasonable palaeosalinity values, although data from infaunal, originally aragonitic bivalves appear to be less reliable than those from epifaunal bivalves with a predominantly or exclusively calcitic shell. As diagenetic alteration of the carbon isotope signal is, however, unpredictable and biotic effects on the isotopic composition are insufficiently known, palaeosalinity reconstructions based on stable isotope data should be supported by palaeoecological data.     

Bristen granite: a highly differentiated,fluorite-bearing A-type granite from the Aar massif,Central Alps,Switzerland

Bristen granite is a body of fine-grained leucogranite occurring in the Gotthard rail base tunnel in the Central Alps. During construction of the tunnel, Bristen granite (Brgr) has been drilled along a 600 m long section. The aplite-granite belongs to the suite of Variscan granitoid intrusions of the Aar massif and contains a variety of accessory minerals typical of highly differentiated granites. Rock forming fluorite, partly enriched in yttrium (Y) and rare earth elements (REE), is intergrown with the late Y- and REE-bearing carbonate mineral synchysite. The granite contains a variety of Ti- and Y-REE-niobates, thorite, and zircon. Compared with the calc-alkaline central Aar granite (cAgr), Bristen granite is strongly depleted in Ti, P, Mg, Sr, and Ba and shows a remarkable enrichment in incompatible elements such as Rb, Th, U, Nb, Y, HREE and F. Bristen granite is the most evolved granitoid rock of the Aar massif. The composition of Brgr is typical of post-collisional reduced (ferroan) A-type granites. The Brgr melt formed in the lower crust and crystallized from a highly differentiated melt at the cotectic point in the quartz-feldspar system close to 100 MPa and 700 °C. The Brgr intruded as a small isolated stock pre-Variscan gneisses with sharply discordant contacts. The primary igneous host of Nb, Ta, Y, U, Th and REE is biotite in addition to minor amounts of allanite, and zircon. The presence of Y-REE-fluorite, synchysite, parisite and Y- and Ti-niobates and other REE-minerals can be related to reaction of igneous biotite and primary fluorite with hydrothermal fluids. The reaction is associated with alpine metamorphism, because Y-bearing fluorite and synchysite have been reported from Alpine fissures. The transformation of primary biotite to chlorite and muscovite released the heavy metal oxides under lower greenschist facies conditions that formed the Alpine diagnostic mineral stilpnomelane at about 300 °C.     

Chemical composition of rock-forming minerals and crystallization physicochemical conditions of the Middle Eocene I-type Haji Abad pluton,SW Buin-Zahra,Iran

The Haji Abad intrusion is a well-exposed Middle Eocene I-type granodioritc pluton in the Urumieh–Dokhtar magmatic assemblage (UDMA). The major constituents of the investigated rocks are K-feldspar, quartz, plagioclase, pyroxene, and minor Fe–Ti oxide and hornblende. The plagioclase compositions fall in the labradorite, andesine, and oligoclase fields. The amphiboles range in composition from magnesio-hornblende to tremolite–hornblende of the calcic-amphibole group. Most pyroxenes principally plot in the field of diopside. The calculated average pressure of emplacement is 1.9 kbar for the granodioritic rocks, crystallizing at depths of about 6.7 km. The highest pressure estimated from clinopyroxene geobarometry (5 kbar) reflects initial pyroxene crystallization pressure, indicating initial crystallization depth (17.5 km) in the Haji Abad granodiorite. The estimated temperatures using two-feldspar thermometry give an average 724 °C. The calculated average temperature for clinopyroxene crystallization is 1090 °C. The pyroxene temperatures are higher than the estimated temperature by feldspar thermometry, indicating that the pyroxene and feldspar temperatures represent the first and late stages of magmatic crystallization of Haji Abad granodiorite, respectively. Most pyroxenes plot above the line of Fe³⁺?=?0, indicating they crystallized under relatively high oxygen fugacity or oxidized conditions. Furthermore, the results show that the Middle Eocene granitoids crystallized from magmas with H₂O content about 3.2 wt%. The relatively high water content is consistent with the generation environment of HAG rocks in an active continental margin and has allowed the magma to reach shallower crustal levels. The MMEs with ellipsoidal and spherical shapes show igneous microgranular textures and chilled margins, probably indicating the presence of magma mixing. Besides, core to rim compositional oscillations (An and FeO) for the plagioclase crystals serve as robust evidence to support magma mixing. The studied amphiboles and pyroxenes are grouped in the subalkaline fields that are consistent with crystallization from I-type calc-alkaine magma in the subduction environment related to active continental margin. Mineral chemistry data indicate that Haji Abad granodiorites were generated in an orogenic belt related to the volcanic arc setting consistent with the subduction of Neo-Tethyan oceanic crust beneath the central Iranian microcontinent.     

Absorption properties of urban/suburban aerosols in China

The broadband diffuse radiation method is improved to retrieve the aerosol refractive index imaginary part （AIP） and broadband （400-1000 nm mean） single scattering albedo （SSA）. In this method, four sets of SSA selection criteria are proposed for quality control. The method is used to retrieve AIP, SSA and absorptive optical thickness （AbOT） from routine hourly-exposed pyrheliometer and paranometer measurements over 11 sites （meteorological observatories） in China during 1998-2003. Apart from one suburban site （Ejin Qi）, the other urban sites are all located around big or medium cities. As shown in the retrieval results, annual mean SSA during 1998-2003 changes from 0.941 （Wuhan） to 0.849 （Lanzhou）, and AIP from 0.0054 to 0.0203. The 11-site average annual mean SSA and AIP are 0.898 and 0.0119, respectively. SSA during winter is smaller for most sites. There is an evidently positive correlation between SSA and aerosol optical thickness （AOT） for all sites. There is also a positive correlation between SSA and relative humidity for most sites, but a negative correlation for a few sites, such as Kashi and ǚrǚmqi in Northwest China.     

How effective is the new generation of GPM satellite precipitation in characterizing the rainfall variability over Malaysia?

We investigated the potential of the new generation of satellite precipitation product from the Global Precipitation Mission (GPM) to characterize the rainfall in Malaysia. Most satellite precipitation products have limited ability to precisely characterize the high dynamic rainfall variation that occurred at both time and scale in this humid tropical region due to the coarse grid size to meet the physical condition of the smaller land size, sub-continent and islands. Prior to the status quo, an improved satellite precipitation was required to accurately measure the rainfall and its distribution. Subsequently, the newly released of GPM precipitation product at half-hourly and 0.1° resolution served an opportunity to anticipate the aforementioned conflict. Nevertheless, related evidence was not found and therefore, this study made an initiative to fill the gap. A total of 843 rain gauges over east (Borneo) and west Malaysia (Peninsular) were used to evaluate the rainfall the GPM rainfall data. The assessment covered all critical rainy seasons which associated with Asian Monsoon including northeast (Nov. - Feb.), southwest (May - Aug.) and their subsequent inter-monsoon period (Mar. - Apr. & Sep. - Oct.). The ability of GPM to provide quantitative rainfall estimates and qualitative spatial rainfall patterns were analysed. Our results showed that the GPM had good capacity to depict the spatial rainfall patterns in less heterogeneous rainfall patterns (Spearman’s correlation, 0.591 to 0.891) compared to the clustered one (r = 0.368 to 0.721). Rainfall intensity and spatial heterogeneity that is largely driven by seasonal monsoon has significant influence on GPM ability to resolve local rainfall patterns. In quantitative rainfall estimation, large errors can be primarily associated with the rainfall intensity increment. 77% of the error variation can be explained through rainfall intensity particularly the high intensity (> 35 mm d^-1). A strong relationship between GPM rainfall and error was found from heavy (~35 mm d^-1) to violent rain (160 mm d^-1). The output of this study provides reference regarding the performance of GPM data for respective hydrology studies in this region.