Application of Convergence Confinement Analysis to the study of preceding displacement of a squeezing rock tunnel

Summary This paper deals with a study on the geomechanical behavior of the rock mass around the tunnel. The Convergence Confinement Analysis is one of the most appropriate way to estimate this behavior. Elasto-plastic models proposed by Hoek and Brown, Egger and Kastner were adopted in this study.Measurements of the preceding displacement were performed in a road tunnel in Japan, the geology of which is Neogene squeezing mudstone. The measured data was compared with the results of Convergence Confinement Analysis.The preceding displacement was about 40% against the upper bench face converged displacement and 17% against the final converged displacement. Meanwhile, it increased drastically in lower bench excavation step.Back analysis was also executed to calculate the extension of the plastic zone of the rock mass, which was half of that estimated by Convergence Confinement Analysis in upper bench excavation step. But, in lower bench excavation step, the results of the two analyses were very similar. The support pressure and support stiffness were also calculated.     

Evaluation of the Residual Mass Fractionation in High-Precision Cr Isotopic Analysis with TIMS

The Cr isotope ratios of terrestrial and extra-terrestrial materials are emerging as one of the most important tracers in geosciences. Previous studies on Cr isotopic measurements using TIMS have found that there is residual Cr isotopic fractionation between the mass-fractionation-corrected ⁵³Cr/⁵²Cr and ⁵⁴Cr/⁵²Cr ratios, which may cause an offset of obtained ratios from the reference values. The residual fractionation was thought to be caused by the evaporation of Cr-oxide species during thermal ionisation, but the mechanism by which this residual fractionation could be reduced remained unclear. Here we revisit the issue of residual fractionation and propose that this problem can be alleviated by utilising W filaments instead of conventionally used Re filaments for Cr ionisation. Using W filaments, the formation of CrO⁺ was suppressed during heating as the filament temperature was ~ 100 °C lower than when Re filaments were used. In repeated measurement of a carbonaceous chondrite, the intermediate precisions of ⁵³Cr/⁵²Cr and ⁵⁴Cr/⁵²Cr ratios in the W filament runs were two to three times better than those of the Re filament runs. Therefore, the new finding of this study will be of key importance for future studies of Cr isotopes for terrestrial and extra-terrestrial materials.     

Geology and geochronology of the Betara region in south-southeastern Brazil: Evidence for possible Statherian (1.80–1.75 Ga) and Calymmian (1.50–1.45 Ga) extension events

The results of geological mapping, chemical analysis and radiometric dating of metabasic rocks of Betara Formation, and mapping and dating of those present in the Betara basement nucleus together with mylonitic granodiorite and syenogranite are reported here. U–Pb analysis of bulk zircon fractions from the metabasic rocks of the basement nucleus yielded a Statherian age of 1790 ± 22 Ma, while the metabasic rocks from the upper part of the Betara Formation yielded a Calymmian age between 1500 and 1450 Ma. This age is a minimum for the deposition of the Betara Formation. The older metabasic rocks are associated with post-tectonic, possibly anorogenic syenogranite, while the younger ones are gabbro or very porphyritic ankaramite whose REE patterns are consistent with crystallization from an N-MORB parent magma. The observations and data point to the probable events associated with extensional processes of the end of Paleoproterozoic and early Mesoproterozoic. Similar registers of Statherian (1.80–1.75 Ga) and Calymmian (1.50–1.45 Ga) extensional events are recorded in other parts of the South American and African continents. The Neoproterozoic witnessed the formation and junction of the tectonic slices which formed the Apiaí domain during the assemblage of western Gondwana.     

http://www.sciencedirect.com/science/article/pii/S1674987114000917

Important ecological changes of the Earth(oxidization of the atmosphere and the ocean) increase in nutrient supply due to the break-up of the super continent(Rodinia) and the appearance of multi-cellular organisms(macroscopic algae and metazoan) took place in the Ediacaran period,priming the Cambrian explosion.The strong perturbations in carbon cycles in the ocean are recorded as excursions in carbonate and organic carbon isotope ratio(δ~(13)C_(carb) and δ~(13)C_(org)) from the Ediacaran through early Cambrian periods.The Ediacaran-early Cambrian sediment records of δ~(13)C_(carb) and δ~(13)C_(org),obtained from the drill-core samples in Three Gorges in South China,are compared with the results of numerical simulation of a simple one-zone model of the carbon cycle of the ocean,which has two reservoirs(i.e.,dissolved organic carbon(DOC) and dissolved inorganic carbon(DIC).The fluxes from the reservoirs are assumed to be proportional to the mass of the carbon reservoirs.We constructed a model,referred to here as the Best Fit Model(BFM),which reproduce δ~(13)C_(carb) and δ~(13)C_(org) records in the Ediacaran-early Cambrian period noted above.BFM reveals that the Shuram excursion is related to three major changes in the carbon cycle or the global ecological system of the Earth:(1) an increase in the coefficient of remineralization by a factor of ca.100,possibly corresponding to a change in the dominant metabolism from anaerobic respiration to aerobic respiration,(2) an increase of carbon fractionation index from 25‰ to 33‰,possibly corresponding to the change in the primary producer from rock-living cyanobacteria to free-living macro algae,and(3) an increase in the coefficient of the organic carbon burial by a factor of ca.100,possibly corresponding to the onset of a biological pump driven by the flourishing metazoan and zooplankton.The former two changes took place at the start of the Shuram excursion,while the third occurred at the end of the Shuram excursion.The other two excursions are explained by the tentative decrease in primary production due to cold periods,which correspond to the Gaskiers(ca.580 Ma) and Bikonor(ca.542 Ma) glaciations.     

Microfacies and diagenesis of older Pleistocene (pre‐last glacial maximum) reef deposits,Great Barrier Reef,Australia (IODP Expedition 325): A quantitative approach

During Integrated Ocean Drilling Program Expedition 325, 34 holes were drilled along five transects in front of the Great Barrier Reef of Australia, penetrating some 700 m of late Pleistocene reef deposits (post‐glacial; largely 20 to 10 kyr bp ) in water depths of 42 to 127 m. In seven holes, drilled in water depths of 42 to 92 m on three transects, older Pleistocene (older than last glacial maximum, >20 kyr bp ) reef deposits were recovered from lower core sections. In this study, facies, diagenetic features, mineralogy and stable isotope geochemistry of 100 samples from six of the latter holes were investigated and quantified. Lithologies are dominated by grain‐supported textures, and were to a large part deposited in high‐energy, reef or reef slope environments. Quantitative analyses allow 11 microfacies to be defined, including mixed skeletal packstone and grainstone, mudstone‐wackestone, coral packstone, coral grainstone, coralline algal grainstone, coral‐algal packstone, coralline algal packstone, Halimeda grainstone, microbialite and caliche. Microbialites, that are common in cavities of younger, post‐glacial deposits, are rare in pre‐last glacial maximum core sections, possibly due to a lack of open framework suitable for colonization by microbes. In pre‐last glacial maximum deposits of holes M0032A and M0033A (>20 kyr bp ), marine diagenetic features are dominant; samples consist largely of aragonite and high‐magnesium calcite. Holes M0042A and M0057A, which contain the oldest rocks (>169 kyr bp ), are characterized by meteoric diagenesis and samples mostly consist of low‐magnesium calcite. Holes M0042A, M0055A and M0056A (>30 kyr bp ), and a horizon in the upper part of hole M0057A, contain both marine and meteoric diagenetic features. However, only one change from marine to meteoric pore water is recorded in contrast with the changes in diagenetic environment that might be inferred from the sea‐level history. Values of stable isotopes of oxygen and carbon are consistent with these findings. Samples from holes M0032A and M0033A reflect largely positive values (δ¹⁸O: ?1 to +1‰ and δ¹³C: +1 to +4‰), whereas those from holes M0042A and M0057A are negative (δ¹⁸O: ?4 to +2‰ and δ¹³C: ?8 to +2‰). Holes M0055A and M0056A provide intermediate values, with slightly positive δ¹³C, and negative δ¹⁸O values. The type and intensity of meteroric diagenesis appears to have been controlled both by age and depth, i.e. the time available for diagenetic alteration, and reflects the relation between reef deposition and sea‐level change.     

Anomalous change in atmospheric radon concentration sourced from broad crustal deformation: A case study of the 1995 Kobe earthquake

Before the Kobe earthquake, an anomalous increase in atmospheric Rn concentration was observed. By separating the measured concentration of atmospheric Rn into three components according to the distance from the monitoring station, the variation of Rn exhalation rate can be estimated for the respective area using the daily minimum and maximum concentrations. The mean rate of Rn exhalation gradually increased in an area of 20 km around the monitoring station, becoming five times higher than normal in the period between October 1994 and the date of the earthquake. This area had a large co-seismic displacement of up to 30 cm, which roughly corresponds to the crustal strain of 10⁻⁶-order, and it is considered the main source for the atmospheric Rn prior to the Kobe earthquake. Analyses revealed that the pre-seismic change in the atmospheric Rn concentration exhibited an anomalous pattern which would yield information on the spatial distribution of the mechanical response of the ground.     

Sedimentary Crust and Metallogeny of Granitoid Affinity: Implications from the Geotectonic Histories of the Circum‐Japan Sea Region,Central Andes and Southeastern Australia

Metallogeny of granitoid affinity was reviewed from the aspect of geotectonic history of the continental crust, particularly of the genesis of sedimentary crust involved in magmatism. The redox state of granitoids and related mineralization shows a remarkable contrast between the east and west sides of the Pacific Rim, but if examined closely, the reduced‐type and oxidized‐type granitoid provinces are juxtaposed in three regions: the circum‐Japan Sea region, the central Andes, and the Lachlan Fold Belt in southeastern Australia. Comparative study of these regions revealed that the reduced‐type magmatism associated with Sn mineralization generated in thick sedimentary crust which formed in three geotectonic environments: (i) accretionary terrane along a subduction zone (e.g. Jurassic East Asia), (ii) continental rift (e.g. Early Paleozoic Andes), and (iii) mega‐fan (e.g. Early Paleozoic southeastern Australia). A collisional orogen can provide large amounts of clastic sediment to these environments. The age gap between the magmatism and sedimentation varies depending on the tectonic evolution of individual regions. Thin sedimentary crust may not play an essential role for the reduced‐type magmatism. The oxidized‐type magmatism associated with porphyry Cu and other mineralization generated in the crust which was initially carbon‐free igneous crust or modified from sedimentary crust by magmatism. Subduction‐related basaltic magmas are relatively oxidized, and may enhance fO₂ conditions of granitoid activity. Repeated magmatism in a monotonous convergent margin may be favorable for porphyry Cu mineralization as exemplified in the eastern Pacific Rim.     

GPS-measured land subsidence in Ojiya City, Niigata Prefecture, Japan

Land subsidence caused by compression of clay layers in Ojiya City, Japan was measured by global positioning system (GPS) between 1 April 1996 and 31 December 1998.

Three baselines were selected in and around the city, and height difference on a WGS-84 ellipsoid was measured by GPS on each baseline. The ground at the GPS station in the city subsides and rebounds 7 cm every winter and spring, respectively. Measurement accuracy was 9.5 mm standard deviation. Ground water level was observed at a well near the GPS station. Regression analysis between total strain, calculated as ratio of the height difference displacement to the total thickness of the clay layers, and the layers' effective stress change with ground water level change gave good correlation. The slope of regression line 7.0×10⁻¹¹ m²/N was obtained as an average apparent coefficient of volume compressibility of the layers.     

A computational procedure for joining separate map sheets

Map sheets have been often used as a basic spatial unit for managing spatial data produced from paper maps. This often results in incompatibility between adjacent map sheets, because spatial objects do not cross the boundaries smoothly and even the boundaries themselves do not match their neighbors exactly. To solve the problem this paper proposes a computational procedure for joining separate map sheets to obtain seamless spatial data. Line objects digitized separately in different map sheets are considered, which are frequently used to represent road networks, gas pipelines, and boundaries of polygon objects. The procedure consists of three steps: (1) extraction of end nodes, (2) detection of matching nodes, and (3) transformation of the map sheet. Each step goes interactively so that unexpected errors can be avoided by human observation. To test the validity of the procedure, map sheets are combined containing the road network data of Tokyo 23-ku area, Japan. This revised version was published online in July 2006 with corrections to the Cover Date.