电离层水平不均匀性对无线电掩星资料反演的影响

电离层水平不均匀结构是引起掩星资料反演的主要误差源.本文模拟不均匀结构对无线电掩星资料反演的影响.首先利用3-D全球射线追踪技术进行了模拟.结果指出:电离层电子密度20%的变化可能引起GPS的时延增加约12m.其次,将90%的掩星时延对应的路径长度,定义为电离层掩星测量的水平分辨率,其值为1200-2000 km.最后,计算了不同纬度电离层当地正午、子夜和日出时的电离层水平不对称指数.它表明:低纬夏季日出时,不对称指数达-78%,反演结果可能有较大误差.     

航磁异常轴向特征提取算法研究及其应用

通过分析航磁异常的空间分布特征，提出一种在平面等值线追踪基础上，根据封闭等值线之间的关系并应用离散卡洛变换，自动检测和绘制航磁异常轴向图的方法，将该方法用于新疆某地航磁异常分析，发现了断裂构造，有效地验证了算法的正确性。     

Production of selected cosmogenic radionuclides by muons: 2. Capture of negative muons

We have determined the production yields for radionuclides in Al₂O₃, SiO₂, S, Ar, K₂SO₄, CaCO₃, Fe, Ni and Cu targets, which were irradiated with slow negative muons at the Paul Scherrer Institute in Villigen (Switzerland). The fluences of the stopped negative muons were determined by measuring the muonic X-rays. The concentrations of the long-lived and short-lived radionuclides were measured with accelerator mass spectrometry (AMS) and γ-spectroscopy, respectively. Special emphasis was put on the radionuclides ¹⁰Be, ¹⁴C and ²⁶Al produced in quartz targets, ²⁶Al in Al₂O₃ and S targets, ³⁶Cl in K₂SO₄ and CaCO₃ targets, and ⁵³Mn in Fe₂O₃ targets. These targets were selected because they are also the naturally occurring target minerals for cosmic ray interactions in typical rocks. We also present results of calculations for depth-dependent production rates of radionuclides produced after cosmic ray μ⁻ capture, as well as cosmic ray-induced production rates of geologically relevant radionuclides produced by the nucleonic component, by μ⁻ capture, by fast muons and by neutron capture.     

Identification of Mining Blasts at Mid- to Far-regional Distances Using Low Frequency Seismic Signals

—?This paper reports results from two recent monitoring experiments in Wyoming. Broadband seismic recordings of kiloton class delay-fired cast blasts and instantaneous calibration shots in the Black Thunder coal mine were made at four azimuths at ranges from 1° to 2°. The primary focus of this experiment was to observe and to explain low-frequency signals that can be seen at all azimuths and should routinely propagate above noise to mid-regional distances where most events will be recorded by International Monitoring System (IMS) stations.¶The recordings clearly demonstrate that large millisecond delay-fired cast blasts routinely produce seismic signals that have significant spectral modulations below 10?Hz. These modulations are independent of time, the azimuth from the source and the orientation of the sensor. Low-frequency modulations below 5?Hz are seen beyond 9°. The modulations are not due to resonance as they are not produced by the calibration shots. Linear elastic modeling of the blasts that is guided by mine-blast reports fails to reproduce the fine detail of these modulations but clearly indicates that the enhanced “spectral roughness” is due to long interrow delays and source finiteness. The mismatch between the data and the synthetics is likely due to source processes, such as nonlinear interactions between shots, that are poorly understood and to other effects, such as variations of shot time and yield from planned values, that are known to be omnipresent but cannot be described accurately. A variant of the Automated Time-Frequency Discriminant (Hedlin, 1998b), which uses low-frequency spectral modulations, effectively separates these events from the calibration shots.¶The experiment also provided evidence that kiloton class cast blasts consistently yield energetic 2–10 second surface waves. The surface waves are strongly dependent on azimuth but are seen beyond 9°. Physical modeling of these events indicates that the surface waves are due mainly to the extended source duration and to a lesser extent to the slap-down of spalled material. The directionality is largely a path effect. A discriminant that is based on the partitioning of energy between surface and body waves routinely separates these events from the calibration shots.¶The Powder River Basin has essentially no natural seismic activity. How these mining events compare to earthquake observations remains to be determined.     

The Influence of 3-D Structure on the Propagation of Seismic Waves Away from Earthquakes

-- The seismic records from significant earthquakes are profoundly affected by 3-D variations in crustal structure both in the source zone itself and in propagation to some distance. Even in structurally complex zones such as Japan and Mexico relatively coherent arrivals are found associated with different classes of propagation paths. The presence of strong lateral variations can disrupt the arrivals, and impose significant variations in propagation characteristics for different directions from the source as illustrated by observations for the 1995 Kobe and 2000 Tottori-ken Seibu earthquakes in western Japan. Such effects can be modelled in 3 dimensions using a hybrid scheme with a pseudospectral representation for horizontal coordinates and finite differences in depth. This arrangement improves parallel implementation by minimising communication costs. For a realistic 3-D model for the structure in western Japan the 3-D simulations to frequencies close to 1 Hz provide a good representation of the observations from subduction zones events such as the 1946 Nankai earthquake and the 2000 Tottori-ken Seibu earthquake. The model can therefore be used to investigate the pattern of ground motion expected for future events e.g., in current seismic gaps.     

新疆伽师强震群的震源破裂特征

利用国内外短周期P波初动符号及全球数字地震台网 (GDSN)的宽频带数字记录资料 ,研究了 1997年 1月 2 3日至 1997年 11月 4日伽师强震群的震源机制解和伽师强震群中的 5个强震、后续地震及其周边地震的震源破裂过程。从震源机制解来看 ,伽师强震群主要有走滑和正倾两种破裂类型 ,主压应力轴方向主要为NNE向和近垂直 ,而主张应力轴为NW向并近水平 ,与区域构造应力场方向存在差异 ,具有明显的局部特征。从破裂过程看 ,伽师强震群的破裂过程相对简单 ,破裂面积不大 ,上升时间较短 ,是由一点向四周快速扩散的脆性破裂 ,无明显的伸展方向 ,与阿图什地震完全不同。研究结果表明 ,伽师强震群与震源附近的地壳结构在垂向和横向上的非均匀变化有着密切关系 ,而阿图什地震与塔里木盆地的现今构造运动关系密切。伽师强震群是在震源区附近地壳上部垂向和水平向力共同作用下发生的多次沿NNE向的快速脆性破裂 ,从而形成了以张性破裂和左旋走滑为主的震源特征     

结构动力反应分析的三阶显式方法

本通过对传统动力反应分析方法的总结，阐明了建立隐式和显式方法的一般思路及数学本质，提出了使用系统位移反向向量三阶导数的隐工和实用显式积分方法－3阶显式方法，分析了该显式方法的精度和稳定性，并对建立更高阶隐式和显式方法以及方法的精度和稳定性作了初步讨论。最后，通过算例对本方法、献[1]方法和经典的常平均加速度法（隐式方法、视为精确解）的精度和稳定性进行了比较分析。结果表明，本方法具有明显的优点。     

云南丽江地区断裂构造岩岩组动力学研究

丽江地区构造岩岩组动力学研究表明，研究区内中更新世末构造主压应力保持在北西至北西西方向变化；晚更新世中期之后构造主压应力方向则以北北东至北东方向为主变化，并有逐渐向近南北向转化的特点。因此玉龙雪山东麓断裂在中更新世末曾有过左旋压扭活动为主的历史，兼有左旋、右旋的活动过程，1996年2月3日丽江M7．0地震的破裂过程继承了晚更新世后期断裂的活动特点。     

Moment Tensor Inversion of Regional Phases: Application to a Mine Collapse

—?The aim of our study consists of analyzing potentially non-double-couple seismic events recorded at regional distances. In order to define the nature of the seismic source, a moment tensor inversion is carried out as this method is general enough not to initially constrain the source mechanism. In this paper we present an application to a seismic event induced by a mine collapse which occurred near the town of Halle in Germany. Because of its induced nature, many parameters such as the location and geometry of this seismic source are known. This information allows us to test the influence of inadequate propagation modeling on the moment tensor obtained from the inversion. Green's functions have been computed with the reflectivity method in a flat layered medium, using the European model EurID (Du et? al., 1998; Dufumier et al., 1997). From the inversion of P-wave seismograms recorded by the German Regional Seismic Network will, we obtained a source time function which can be decomposed into two subevents. The first one has a large isotropic part and a deviatoric mechanism with near vertical nodal planes. No volume change is observed for the second subevent, but a deviatoric component opposite of the first one. The addition of S-waves does not change the results of the inversion which are stable. Surface waves were not used because of their poor dispersion curves. Based on the moment tensor obtained from these inversions, the physical process at the source is compatible with a large cavity collapse.     

Focal Fault of the 1999 Datong Ms5.6 Earthquake in Shanxi Province

Several earthquakes with Ms≥5.0 occurred in the Datong seismic region in 1989,1991 and 1999,The precise focus location of the earthquake sequence was made by the records of the remote sensing seismic station network in Datong.Using that data together with macro-intensity distribution and focal mechanism solutions,we analyze the difference among three subsequences.The results show that the focal fault of the 1999 Ms 5.6 earthquake was a NWW-trending left-lateral strike-slip fault.It is 16km long and 12km wide.It developed at the depth of 5km and is nearly vertical in dip.The two previous earthquake subsequences,however,were generated by activity along NNE-trending right-lateral strike-slip fault.It can be found that the rupture directioin of the 1999 earthquake has changed.It is generally found that a rupture zone has more than two directions and has different strength along these two directions.The complicate degree of focal circumstance is related to the type of earthquake sequences.There is the NE-trending Dawangcun fault and the NW-trending Tuanbu fault in the seismic region,but no proof indicates a connection between focal faults and these two tectonic faults.The feature that focal faults of three subsequences are strike-slip is different from that of the two tectonic faults.It is suggested that the 1999 earthquake subsequence was possibly generated by a new rupture.