DMS and SO2 at Baring Head, New Zealand: Implications for the Yield of SO2 from DMS

Atmospheric dimethyl sulfide (DMS) and sulfur dioxide (SO₂) concentrations were measured at Baring Head, New Zealandduring February and March 2000. Anti-correlated DMS and SO₂ diurnalcycles, consistent with the photochemical production of SO₂ from DMS, were observed in clean southerly air off the ocean. The data is used to infer a yield of SO₂ from DMS oxidation. The estimated yields are highly dependent on assumptions about the DMS oxidation rate. Fitting the measured data in a photochemical box model using model-generated OH levels and the Hynes et al. (1986) DMS + OH rate constant suggests that theSO₂ yield is 50–100%, similar to current estimates for the tropical Pacific.However, the observed amplitude of the DMS diurnal cycle suggests that the oxidation rate is higher than that used by the model, and therefore, that theSO₂ yield is lower in the range of 20–40%.     

Wind erosion from military training lands in the Mojave Desert, California, U.S.A.

Military training activities reduce vegetation cover, disturb crusts, and degrade soil aggregates, making the land more vulnerable to wind erosion. The objective of this study was to quantify wind erosion rates for typical conditions at the Marine Corps Air Ground Combat Center, Twentynine Palms, CA, U.S.A. Five Big Spring Number Eight (BSNE) sampler stations were installed at each of five sites. Each BSNE station consisted of five BSNE samplers with the lowest sampler at 0·05 m and the highest sampler at 1·0 m above the soil surface. Once a month, sediment was collected from the samplers for analysis. Occurrence of saltating soil aggregates was recorded every hour using Sensits, one at each site. The site with the most erosion had a sediment discharge of 311 kg m⁻¹ over a period of 17 months. Other sites eroded much less because of significant rock cover or the presence of a crust. Hourly sediment discharge was estimated combining hourly Sensit count and monthly sediment discharge measured using BSNE samplers. More simultaneously measured data are needed to better characterize the relationship between these two and reconstruct a detailed time-series of wind erosion. This measured time-series can then be used for comparison with simulation results from process-based wind erosion models such as the Wind Erosion Prediction System (WEPS), once it has been adapted to the unique aspects of military lands.     

Metal island growth and dynamics on molybdenite surfaces

In order to understand the adsorption mechanism of metal atoms to semiconducting surfaces, we have studied, as a model system, the vapor phase adsorption of Ag, Au, and Cu on the (001) surface of molybdenite (MoS₂) and the subsequent surface diffusion of these adsorbates. Our scanning tunneling microscopy (STM) images show that, depending on the type of metal atom that is adsorbed, islands of a characteristic size (2 nm for Ag, 8 to 10 nm for Cu, two distinct sizes of 2 nm and 8 to 10 nm for Au), shape (well rounded in the lateral extension) and thickness (one monolayer for Ag, 1 to 1.5 nm for Cu) are formed during the initial stages of deposition. Whole islands are observed to surface diffuse without loss of size or shape. Despite the relatively large size of the copper islands on molybdenite, these islands surface diffuse extensively, suggesting that the Cu-S interaction is weak. Surface diffusion is only hindered once individual islands start to coalesce. As copper islands accumulate, the size and shape of the original islands can still be recognized, supporting the conclusion that these characteristics are constant and that monolayer growth occurs by the aggregation of islands across the surface.The strength and the nature of the Ag-S(MoS₂) bond were further investigated by using molecular orbital calculations, ultraviolet photoelectron spectroscopy (UPS) and scanning tunneling spectroscopy (STS). By applying quantum mechanical approaches using a two-dimensional periodic molybdenite slab and hexagonal MoS₂ clusters of different sizes with metal atoms adsorbed to them, it is possible to calculate the electron transfer between the mineral surface and the metal atom as well as the adsorption energy as a function of surface coverage. In addition, we used the results from the quantum mechanical runs to derive empirical potentials that model the characteristics of the forces within the crystal, within the adsorbed islands, and the metal and mineral surface. The combination of quantum mechanical calculations and empirical force field calculations explain the electronic structure and the highest stability of Ag islands that have seven atoms in diameter, which exactly agrees with the size of experimentally observed islands. UPS results also suggest that a specific new state is formed (approximately 4.5 eV into the valence band) which may describe the Ag-S bond because it does not occur in pure silver or molybdenite.This study shows how the combination of microscopic (STM), spectroscopic (STS, UPS), compositional (X-ray photoelectron spectroscopy, XPS) and molecular modeling (quantum mechanical and empirical) techniques is a useful approach to understand the nature of the metal to sulfide bond. Further insights may be gained concerning the natural association of certain metals with sulfides.     

The Effects of Climate Change on Water Resources in the West: Introduction and Overview

The results of an experimental `end to end' assessment of the effects of climate change on water resources in the western United States are described. The assessment focuses on the potential effects of climate change over the first half of the 21st century on the Columbia, Sacramento/San Joaquin, and Colorado river basins. The paper describes the methodology used for the assessment, and it summarizes the principal findings of the study. The strengths and weaknesses of this study are discussed, and suggestions are made for improving future climate change assessments.     

A preliminary investigation into the use of ochre as a remedial amendment in arsenic-contaminated soils

Ochre is an unwanted waste product that accumulates in wetlands and streams draining abandoned coal and metal mines. A potential commercial use for ochre is to remediate As contaminated soil. Arsenic contaminated soil (605 mg kg⁻¹) was mixed with different ochres (A, B and C) in a mass ratio of 1:1 and shaken in 20 mL of deionised water. After 72 h As concentration in solution was ca. 500 μg kg⁻¹ in the control and 1–2.5 μg kg⁻¹ in the ochre treated experiments. In a second experiment soil:ochre mixtures of 0.05–1:1 were shaken in 20 mL of deionised water for 24 h. For Ochres A and C, as solution concentration was reduced to ca. 1 μg kg⁻¹ by 0.2–1:1 ochre:soil mixtures. For Ochre B, as concentration only reached ca. 1 μg kg⁻¹ in the 1:1 ochre:soil mix. Sorption of As was best modelled by a Freundlich isotherm using As sorption per mass of goethite in the ochre (log K = 1.64, n = 0.79, R² = 0.76, p 0.001). Efficiency of ochre in removing As from solution increased with increasing total Fe, goethite, citrate dithionite extractable Fe and surface area.     

Using monazite and zircon petrochronology to constrain the P–T–t evolution of the middle crust in the Bhutan Himalaya

The growth and dissolution behaviour of accessory phases (and especially those of geochronological interest) in metamorphosed pelites depends on, among others, the bulk composition, the prograde metamorphic evolution and the cooling path. Monazite and zircon are arguably the most commonly used geochronometers for dating felsic metamorphic rocks, yet crystal growth mechanisms as a function of rock composition, pressure and temperature are still incompletely understood. Ages of different growth zones in zircon and monazite in a garnet‐bearing anatectic metapelite from the Greater Himalayan Sequence in NW Bhutan were investigated via a combination of thermodynamic modelling, microtextural data and interpretation of trace‐element chemical ‘fingerprint’ indicators in order to link them to the metamorphic stage at which they crystallized. Differences in the trace‐element composition (HREE, Y, Eu_N/Eu*_N) of different phases were used to track the growth/dissolution of major (e.g. plagioclase, garnet) and accessory phases (e.g. monazite, zircon, xenotime, allanite). Taken together, these data constrain multiple pressure–temperature–time (P–T–t) points from low temperature (<550 °C) to upper amphibolite facies (partial melting, >700 °C) conditions. The results suggest that the metapelite experienced a cryptic early metamorphic stage at c. 38 Ma at <550 °C, ≥0.85 GPa during which plagioclase was probably absent. This was followed by a prolonged high‐T, medium‐pressure (~600 °C, 0.55 GPa) evolution at 35–29 Ma during which the garnet grew, and subsequent partial melting at >690 °C and >18 Ma. Our data confirm that both geochronometers can crystallize independently at different times along the same P–T path and that neither monazite nor zircon necessarily provides timing constraints on ‘peak’ metamorphism. Therefore, collecting monazite and zircon ages as well as major and trace‐element data from major and accessory phases in the same sample is essential for reconstructing the most coherent metamorphic P–T–t evolution and thus for robustly constraining the rates and timescales of metamorphic cycles.     

Taxonomic Studies on a New Marine Ciliate, Apocoleps magnus gen. nov., spec. nov. （Ciliophora, Colepidae）, Isolated from Qingdao, China

The morphology and infraciliature of a new marine colepid ciliate, Apocoleps magnus gen. nov., spec. nov., are described based on living observations and silver impregnations. The new genus Apocoleps is characterized by having 8 (vs. 6 in most other related genera) armour tiers, spines at both ends of the cell, 3 adoral organelles and plates with 4 reniform uni-windows. Apocoleps magnus spec. nov. is defined by the following features: body elongated and slightly curved, about 100–120μm× 35–45 μm in vivo; an...     

Representation of Uncertainty and Integration of PGIS-based Grazing Intensity Maps Using Evidential Belief Functions

In a project to classify livestock grazing intensity using participatory geographic information systems (PGIS), we encountered the problem of how to synthesize PGIS-based maps of livestock grazing intensity that were prepared separately by local experts. We investigated the utility of evidential belief functions (EBFs) and Dempster's rule of combination to represent classification uncertainty and integrate the PGIS-based grazing intensity maps. These maps were used as individual sets of evidence in the application of EBFs to evaluate the proposition that " This area or pixel belongs to the high, medium, or low grazing intensity class because the local expert(s) says (say) so ". The class-area-weighted averages of EBFs based on each of the PGIS-based maps show that the lowest degree of classification uncertainty is associated with maps in which "vegetation species" was used as the mapping criterion. This criterion, together with local landscape attributes of livestock use may be considered as an appropriate standard measure for grazing intensity. The maps of integrated EBFs of grazing intensity show that classification uncertainty is high when the local experts apply at least two mapping criteria together. This study demonstrates the usefulness of EBFs to represent classification uncertainty and the possibility to use the EBF values in identifying and using criteria for PGIS-based mapping of livestock grazing intensity.