The biogeochemical sulfur cycle in the marine boundary layer over the Northeast Pacific Ocean

The major components of the marine boundary layer biogeochemical sulfur cycle were measured simultaneously onshore and off the coast of Washington State, U.S.A. during May 1987. Seawater dimethylsulfide (DMS) concentrations on the continental shelf were strongly influenced by coastal upwelling. Concentration further offshore were typical of summer values (2.2 nmol/L) at this latitude. Although seawater DMS concentrations were high on the biologically productive continental shelf (2–12 nmol/L), this region had no measurable effect on atmospheric DMS concentrations. Atmospheric DMS concentrations (0.1–12 nmol/m³), however, were extremely dependent upon wind speed and boundary layer height. Although there appeared to be an appreciable input of non-sea-salt sulfate to the marine boundary layer from the free troposphere, the local flux of DMS from the ocean to the atmosphere was sufficient to balance the remainder of the sulfur budget.     

Slump debris flows in the Akovolwo Mountains area of Benue State,Nigeria

In September 1979, rain-induced complex landslides occurred in two separate localities along the slopes of the Akovolwo Mountains near Jato-Aka in the Kwande Local Government area of Benue State, Nigeria.The two movements developed on bedrock slopes covered by a veneer of colluvium and (or) residuum no more than 1.5 to 2m deep. Each started as a slump and graduated into a debris flow. The slump, extending downhill a short distance away from the head scarp, had been reconstituted into a debris flow as the initial movement (sliding movement) of the soil mass caused remoulding of the saturated moving mass into viscous debris-laden mud. The resulting mass moved partly along a pre-existing mountain stream channel and partly along a fresh channel it cleared in the savanna forest. At the break of slope, the mass of boulders was dumped and a trail of smaller fragments littered the channels towards the Katsina-Ala River.     

Intraplate deformation and 3D rheological structure of the Rhine Rift System and adjacent areas of the northern Alpine foreland

The lithosphere of the Northern Alpine foreland has undergone a polyphase evolution during which interacting stress-induced intraplate deformation and upper mantle thermal perturbations controlled folding of the thermally weakened lithosphere. In this paper we address relationships among deeper lithospheric processes, neotectonics and surface processes in the Northern Alpine foreland with special emphasis on tectonically induced topography. We focus on lithosphere memory and neotectonics, paying special attention to the thermo-mechanical structure of the Rhine Graben System and adjacent areas of the northern Alpine foreland lithosphere. We discuss implications for mechanisms of large-scale intraplate deformation and links with surface processes and topography evolution.     

Gamma-ray bursts: optical afterglows in the deep Newtonian phase

Gamma-ray burst remnants become trans-relativistic typically in days to tens of days, and they enter the deep Newtonian phase in tens of days to months, during which the majority of shock-accelerated electrons will no longer be highly relativistic. However, a small portion of electrons are still accelerated to ultra-relativistic speeds and are capable of emitting synchrotron radiation. The distribution function for electrons is re-derived here so that synchrotron emission from these relativistic electrons can be calculated. Based on the revised model, optical afterglows from both isotropic fireballs and highly collimated jets are studied numerically, and compared to analytical results. In the beamed cases, it is found that, in addition to the steepening due to the edge effect and the lateral expansion effect, the light curves are universally characterized by a flattening during the deep Newtonian phase.     

Mode Mixing by a Shallow Sunspot

Sunspots are strong absorbers of f and p modes. A possible absorption mechanism is direct conversion to slow magnetoacoustic waves. Calculations based on vertical magnetic field models show that this works well for f modes, but is inadequate for p modes. Using a very simple shallow spot model, in which the effects of the magnetic field are accounted for solely by a surface condition, we investigate the possibility that p modes first scatter into f modes inside the spot, which are then more susceptible to conversion to slow modes. We find that the coupling between an incident p mode and the internal f mode is unlikely to be strong enough to account for the observed absorption, but that the incident modes do couple strongly to the acoustic jacket in some cases, leading to a region immediately around the sunspot where a significant fraction of the surface velocity is due to the jacket modes.     

Karst groundwater protection in the Kupa River catchment area and sustainable development

One of the most significant water resources in the Republic of Croatia is the catchment area of the Kupa River, located in the region bordering the Republic of Slovenia. About 88% of the total amount of water in this catchment originates in Croatia and just 12% from Slovenia; therefore, the largest part of the catchment area (about 1000 km²) is on the Croatian side of the border. It is a typical karst area of the Dinarides with aquifers characterized by a relatively rapid water exchange, high groundwater flow velocities and aquifers open to human impact from the surface. Consequently, the aquifers are highly vulnerable and at risk. Due to the availability of large quantities of high-quality spring water (about 6 m³/s), the entire area has a strategic importance within the context of any future development strategy pertaining to the western part of Croatia. The catchment area on the Croatian side was investigated using a wide range of research methods that included a classical hydrogeological approach, the detailed hydrologic calculation of water balance to the hydrogeochemical analyses and modelling. The objective was to determine protection zones and protection measures for the whole area. The difficulties are increased due to the fact that the karst catchment area is crossed by major traffic corridors, oil pipelines and a railway and that many settlements and a highly developed wood industry are present. The combination of protecting water resources with adequate prevention measures and necessary remedial activities that should satisfy the very strict requirements necessary for the protection of the karst aquifers while still allowing for present and future human activities is difficult – but not impossible – to achieve. One good example is the present highway with a closed dewatering system and waste water treatment before the water passes into the karst underground system.     

A Late Pleistocene submarine slide on the Bear Island Trough Mouth Fan

A large submarine slide on the southern flank of the Bear Island Trough Mouth Fan, southwestern Barents Sea continental slope, has a run-out distance of about 400 km, a total volume of about 1100 km³, and is younger than 330 ka. Three seismic units, comprising mainly hemipelagic sediments has partly filled the slide scar. An increased sedimentation rate on the Bear Island Trough Mouth Fan from Late Pliocene time, probably in combination with abundant earthquakes, is the most likely cause of the slide. Based on these and previous studies, we suggest that large-scale slides were important sediment transport processes during Plio-Pleistocene.     

A constitutive model for mechanical and chemo‐mechanical compaction in sedimentary basins and finite element analysis

Compaction and associated fluid flow are fundamental processes in sedimentary basin deformation. Purely mechanical compaction originates mainly from pore fluid expulsion and rearrangement of solid particles during burial, while chemo‐mechanical compaction results from Intergranular Pressure‐Solution (IPS) and represents a major mechanism of deformation in sedimentary basins during diagenesis. The aim of the present contribution is to provide a comprehensive 3D framework for constitutive and numerical modeling of purely mechanical and chemo‐mechanical compaction in sedimentary basins. Extending the concepts that have been previously proposed for the modeling of purely mechanical compaction in finite poroplasticity, deformation by IPS is addressed herein by means of additional viscoplastic terms in the state equations of the porous material. The finite element model integrates the poroplastic and poroviscoplastic components of deformation at large strains. The corresponding implementation allows for numerical simulation of sediments accretion/erosion periods by progressive activation/deactivation of the gravity forces within a fictitious closed material system. Validation of the numerical approach is assessed by means of comparison with closed‐form solutions derived in the context of a simplified compaction model. The last part of the paper presents the results of numerical basin simulation performed in one dimensional setting, demonstrating the ability of the modeling to capture the main features in elastoplastic and viscoplastic compaction. Copyright © 2016 John Wiley & Sons, Ltd.