Assessment of the reliability of 2D inversion of apparent resistivity data

The reliability of inversion of apparent resistivity pseudosection data to determine accurately the true resistivity distribution over 2D structures has been investigated, using a common inversion scheme based on a smoothness‐constrained non‐linear least‐squares optimization, for the Wenner array. This involved calculation of synthetic apparent resistivity pseudosection data, which were then inverted and the model estimated from the inversion was compared with the original 2D model. The models examined include (i) horizontal layering, (ii) a vertical fault, (iii) a low‐resistivity fill within a high‐resistivity basement, and (iv) an upfaulted basement block beneath a conductive overburden. Over vertical structures, the resistivity models obtained from inversion are usually much sharper than the measured data. However, the inverted resistivities can be smaller than the lowest, or greater than the highest, true model resistivity. The substantial reduction generally recorded in the data misfit during the least‐squares inversion of 2D apparent resistivity data is not always accompanied by any noticeable reduction in the model misfit. Conversely, the model misfit may, for all practical purposes, remain invariant for successive iterations. It can also increase with the iteration number, especially where the resistivity contrast at the bedrock interface exceeds a factor of about 10; in such instances, the optimum model estimated from inversion is attained at a very low iteration number. The largest model misfit is encountered in the zone adjacent to a contact where there is a large change in the resistivity contrast. It is concluded that smooth inversion can provide only an approximate guide to the true geometry and true formation resistivity.     

Numerical analysis of seismoelectric wave propagation in spatially confined geological units

Using numerical modelling, we investigate the evolution of seismoelectric effects induced by seismic excitation in spatially confined lithological units. Typical geometries represent clay lenses embedded in an aquifer or petroleum deposits in a host rock. In fluid‐saturated rocks, seismic waves can generate electromagnetic fields due to electrokinetic coupling mechanisms associated with such processes in the vicinity of the fluid‐mineral interface. Two seismoelectric phenomena are investigated: (1) the co‐seismic field associated with the seismic displacement at each point in a subsurface and (2) the interface response generated at layer boundaries. Our modelling uses a simplified time‐domain formulation of the coupled problem and an efficient 2D finite‐element implementation. To gain insight into the morphogenetic field behaviour of the seismoelectric effects, several numerical simulations for various target geometries were treated. Accordingly, we varied both the thickness of the confined units and the value of the electrical bulk conductivity in porous media. Analysis of these effects shows differences between interface responses for electrically conductive versus resistive units. So the pertinent contrast in electrical bulk conductivity controls the shape and structure of these seismoelectric conversion patterns. Moreover, the seismoelectric interface response captures both the petrophysical and geometrical characteristics of the geological unit. These models demonstrate the value of using seismoelectric interface response for reservoir characterization in either hydrogeological or hydrocarbon exploration studies.     

Shadow of Kerr-Taub-NUT black hole

The shadow of a rotating black hole with nonvanishing gravitomagnetic charge has been studied. It was shown that in addition to the angular momentum of black hole the gravitomagnetic charge term deforms the shape of the black hole shadow. From the numerical results we have obtained that for a given value of the rotation parameter, the presence of a gravitomagnetic charge enlarges the shadow and reduces its deformation with respect to the spacetime without gravitomagnetic charge. Finally we have studied the capture cross section for massive particles by black hole with the nonvanishing gravitomagnetic charge.     

Improvements in Inversion of Magnetic Resonance Exploration-Water Content, Decay Time, and Resistivity

In this review article, we present recent developments and Improvements in magnetic resonance sounding (MRS), a newly established geophysical exploration method that provides unique information about hydrogeophysical properties due to its direct sensitivity to hydrogen protons and proton dynamics. Starting with the most sophisticated and complete MRS formulation, we give a detailed view on how to solve the equation, i.e., inverting exactly for all model parameters: water content, decay time, and resistivity. Giving a short review of general inversion schemes used in geophysics, the special properties of MRS inversion are evaluated and the development of MRS inversion over recent years is shown. We present the extension of MRS to magnetic resonance tomography (MRT), i.e., the extension to two-dimensional investigations and appropriate inversions. Finally, we address restrictions, limitations, and inconsistencies as well as future developments.     

Influence of shape characteristics of talc mineral on the column flotation behavior

Column flotation, which is a very effective process in mineral processing especially for easily floatable minerals, is one of the most important new developments to emerge in mineral processing technology in the last years. In this study, the flotation behavior of talc products having different particle shapes produced by different grinding mills (ball and rod mill) was determined by using column flotation process. Shape characteristics of the particles were investigated by the two dimensional measuring technique based on the particle projections obtained from the SEM microphotographs using a COREL Draw 10.0 program. The results showed that particles possessing higher elongation and flatness properties were recovered better during column flotation, whilst roundness and relative width had a negative effect on the flotation behavior of the talc mineral studied. Consequently, as the shape of the particles produced by the mill deviated from the ideal sphere, their floatability was increased.     

Inversion of resistivity in Magnetic Resonance Sounding

Magnetic Resonance Sounding (MRS, or Surface Nuclear Magnetic Resonance - SNMR) is used for groundwater exploration and aquifer characterization. Since this is an electromagnetic method, the excitation magnetic field depends on the resistivity of the subsurface. Therefore, the resistivity has to be taken into account in the inversion: either as a priori information or as an inversion parameter during the inversion process, as introduced in the presented paper. Studies with synthetic data show that water content and resistivity can be resolved for a low resistive aquifer even using only the amplitude of the MRS signal. However, the inversion result can be significantly improved using amplitude and phase of the MRS signal. The successful implementation of the inversion for field data shows that the resistivities derived from MRS are comparable to those from conventional geoelectric methods such as DC resistivity and transient electromagnetic. By having information about both the resistivity and the water content, MRS inversions give information about the quality of the water in the aquifer. This is of utmost interest in hydrogeological studies as this specific information cannot be determined solely by geoelectric measurements, due to the nonunique dependence of resistivity on water content and salinity.     

Surface NMR within a geophysical study of an aquifer at Haldensleben (Germany)

The surface nuclear magnetic resonance (SNMR) method has been tested at a site in Haldensleben, northern Germany, to assess the suitability of this new method for groundwater exploration and environmental investigations. More information is obtained by SNMR, particularly with respect to aquifer parameters, than with other geophysical techniques. SNMR measurements were carried out at three borehole locations, together with 2D and 1D direct current geoelectrics, as well as ground-penetrating radar, and well logging (induction log, gamma-ray log and pulsed neutron-gamma log). Permeabilities were calculated from the grain-size distributions of core material determined in the laboratory. It is demonstrated that the SNMR method is able to detect groundwater and the results are in good agreement with other geophysical and hydrogeological data. Using the SNMR method, the water content of the unsaturated and saturated zones (i.e. porosity of an aquifer) can be reliably determined. This information and resistivity data permit in situ determination of other aquifer parameters. Comparison of the SNMR results with borehole data clearly shows that the water content determined by SNMR is the free or mobile water in the pores. The permeabilities estimated from the SNMR decay times are similar to those derived from sieve analysis of core material. Thus, the combination of SNMR with geoelectric methods promises to be a powerful tool for studying aquifer properties.     

Lg Wave Attenuation in the Isparta Angle and Anatolian Plateau (Turkey)

We estimate Lg wave attenuation using local and regional seismic phases in the Isparta Angle and the Anatolian Plateau (Turkey). The Isparta Angle (IA) is a tectonically active zone forming the boundary between the African Plate and the Anatolian Plateau, and is currently undergoing N–S extensional deformation. The Anatolian Plateau contains many intra-continental faults including the North Anatolian Fault Zone and the East Anatolian Fault Zone as well as the Menderes Massif. A large waveform data set was compiled from a variety of local and regional seismic networks including 121 digital seismic stations (broad-band and short period) between 1999 and 2008 spanning the IA, the Anatolian Plateau and Azerbaijan. The data set was used to determine the nature of Lg wave propagation and characterize the nature of seismic attenuation within the crust of these regions. Lg waveforms were used to calculate the frequency-dependent Lg-Q _o and Lg- $ \eta $ . A wide range of Lg-Q _o values was obtained between ~52 ± 6 and 524 ± 227. Low Lg-Q _o values (~90–155) are calculated towards the north of IA, Iskenderun Gulf and its vicinity, Bingöl-Karl?ova, Izmit and its vicinity. Lg-Q _o values are especially low (<90) along the Menderes Massif and the Aksehir-Simav Fault Zones. This may be due to intrinsic attenuation of Lg associated with the partially molten crust and young volcanism. The high Lg-Q _o values (~350) are probably caused by the crust not being subject to large amounts of extensional deformation like the Antalya Gulf and apparently being thick enough to support Lg propagation. Relatively higher values along the border of this subduction zone and plate boundary might be related to the Taurus Mountain belts and Bitlis-Zagros Suture Zone. The lateral frequency dependency Lg- $ \eta $ is also consistent with high tectonic activity in this region.     

Crustal velocity and Vp/Vs structures beneath central Anatolia from local seismic tomography

We applied a seismic tomography technique to arrival time data generated by local crustal earthquakes in central Anatolia in order to study the three-dimensional velocity and Vp/Vs structures and their relation with the complex tectonic processes and seismic activity occurring in the study region. The relatively equal and large number of both P- and S-wave arrival times comprising a total of 51,650 arrivals and the relatively uniform distribution of the recording stations imply that the obtained velocity anomalies are reliable features down to a depth of 40 km. This is also evident from the results of the checkerboard resolution test, hit count, and the ray-path coverage. The inversion results indicate the existence of strong lateral heterogeneities in the crust and uppermost mantle beneath central Anatolia. Prominent low-velocity anomalies are clearly imaged at all layers especially beneath existing volcanoes and the active fault segments. Higher-than-average Vp/Vs ratios are widely distributed, indicating the possible existence of over-pressurized fluids that may be responsible for the triggering of the large crustal earthquakes along the north and east Anatolian fault zones. We noticed that the seismic activity occurs mainly at the low-velocity areas and to a lesser extent in some high-velocity zones, perhaps because of the complex tectonics and geological structures. These observations imply that all the zones with velocity anomalies—either low or high—are potential sites for strain energy accumulation and subsequent release. The obtained velocity and Vp/Vs models are consistent with previous geophysical measurements conducted beneath central Anatolia and give much deeper understanding of the current seismotectonic processes occurring in the region.