A mass ratio limit for primordial black holes

We augment our scenario for the formation of astronomical objects from macroscopic superstrings by the assumption that the central matter keeps its identity in the fragmentation. From the condition that the angular momentum per mass squared of this matter should be less than the Kerr limit G/c, we obtain upper limits for the ratio of the mass of central black holes M(BH) to the mass M of the host object. This limit is M(BH)/M ≈ 0.001, and, expressed in observed quantities, approximately M(BH)/M ≈ σ²/(v · c) where σ is the r.m.s. velocity, v the rotational velocity and c the velocity of light. The valuesM(BH) agree with the observed behaviour both in order of magnitude and in the variation with velocity dispersion. (© 2003 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Dissolved Carbohydrate Concentration,Composition, and Bioavailability to Microbial Heterotrophs in Stream Water

Dissolved total carbohydrates (DTCH), dissolved free monosaccharides (DFMS), dissolved organic carbon (DOC), biodegradable DOC (BDOC), and humic substances (HS) were measured in White Clay Creek (WCC), a stream in southeastern Pennsylvania Piedmont, USA. Samples were collected over different seasons and under baseflow and stormflow conditions. DOC concentrations ranged from 1.0 to 12.8 mg/L C with the highest concentrations associated with stormflows. Carbohydrates ranged from 0.42 to 12.4 μM and accounted for 2.9 to 12.7% of the DOC. Humic substances represented the major DOC fraction, accounting for 55 to 72% of the DOC pool under all flow conditions. The humic fraction had a lower carbohydrate content (4.4%) than the non-humic fraction of DOC (7.2%). Stormflow DOC was enriched in carbohydrates relative to baseflow DOC, but the percentage of humic-C changed little. Carbohydrates were primarily present as dissolved polysaccharides (55%), but a significant fraction was bound to humic substances (40%), while a small proportion was present as monosaccharides (5%). The major monosaccharides in stream water, listed in order of decreasing concentration, included glucose, galactose, rhamnose, xylose, arabinose, mannose, and fucose. On average (30.6 ± 7.4)% (n = 44) of the stream water DOC was biodegradable, and carbohydrates accounted for 9.9 to 17.7% of the BDOC.     

Narrow-line Seyfert 1 galaxies

This paper summarizes the soft X-ray properties of narrow-line Seyfert 1 galaxies (NLS1). NLS1 have generally steeper soft X-ray continuum slopes than Seyfert 1s with broader lines, and there exists an anticorrelation between 0.1–2.4 keV continuum slope and the FWHM of the Hβ line. Objects with steep 0.1–2.4 keV continuum slopes and Hβ FWHM > 3000 km s⁻¹ are clearly discriminated against by nature. When simple power-law models are fit to the data, photon indices reach values up to about 5, much higher than is usually seen in Seyfert 1s. Models with smaller mass black holes and/or higher Eddington fractions show some promise to explain the relation between the FWHM of the Hβ line and the X-ray continuum slope. We further report evidence for persistent gaint and rapid variability in the ultrasoft narrow-line Seyfert 1 galaxy IRAS 13224–3809. We have examined possible explanations for the gaint variability. Unusually strong relativistic effects provide a plausible explanation of the X-ray data. Relativistic boosting effects may be relevant to understanding the strong X-ray variability of some steep spectrum Seyferts more generally.     

Occurrence and Distribution of Organic Contaminants in the Aquatic System in Berlin. Part III: Determination of Synthetic Musks in Berlin Surface Water Applying Solid-phase Microextraction (SPME) and Gas Chromatography-Mass Spectrometry (GC-MS)

Polycyclic musks and nitro musks were found as environmental pollutants in screening analyses of 30 representative surface water samples collected from rivers, lakes, and canals in Berlin. These synthetic musks, which are used as fragrances in cosmetics, detergents, and other products, are discharged by the municipal sewage treatment plants into Berlinπs surface waters. In particular, the polycyclic musks 1,3,4,6,7,8-hexahydro-4,6,6,7,8,8-hexamethylcyclopenta-(g)-2-benzopyrane (HHCB; Galaxolide®, Abbalide®) and 7-acetyl-1,1,3,4,4,6-hexamethyltetraline (AHTN; Tonalide®, Fixolide®) were found in the receiving surface waters at considerable concentrations up to the μg/L-level. In the Wuhle, a small brook almost totally consisting of sewage effluents, maximum concentrations were 12.5 μg/L for HHCB and 6.8 μg/L for AHTN. Additionally, the polycyclic musk 4-acetyl-1,1-dimethyl-6-tert-butylindane (ADBI; Celestolide®, Crysolide®) and 1-tert-butyl-3,5-dimethyl-2,6-dinitro-4-acetylbenzene (musk ketone) were detected at low concentrations in most of the samples. Two other nitro musks, namely 1,1,3,3,5-pentamethyl-4,6-dinitroindene (musk moskene) and 1-tert-butyl-3,5-dimethyl-2,4,6-trinitrobenzene (musk xylene), were only detected in a single surface water sample. Solid-phase microextraction (SPME) with detection by gas chromatography-mass spectrometry (GC-MS) has proven to be a rapid and reliable tool for the screening of synthetic musks in surface and sewage water samples. Internal calibration with a suitable internal standard enables reproducible quantitation of the analytes down to the low ng/L-level.     

Occurrence and Distribution of Organic Contaminants in the Aquatic System in Berlin.Part II: Substituted Phenols in Berlin Surface Water

In a surface water screening, 30 representative surface water samples collected from rivers, canals, and lakes in Berlin were investigated for the presence of 22 substituted phenols. The phenols selected include the 11 phenols considered as “priority pollutants” by the US Environmental Protection Agency (US-EPA). Surface water samples were extracted applying solid-phase extraction with styrenedivinylbenzene adsorbent. The recoveries, determined in spiking experiments, were between 80 % and 103 %. After derivatization with N-(tert-butyldimethylsilyl)-N-methyl-trifluoroacetamide (MTBSTFA) the samples were analyzed by capillary gas chromatography-mass spectrometry (GC-MS). Phenol, cresols, 2-ethylphenol, 2-chlorophenol, 4-chloro-3-methylphenol, pentachlorophenol, 2-nitrophenol, and 4-nitrophenol were detected in the surface water samples at concentrations between 0.02 μg/L and 7.8 μg/L, respectively. The distribution of these residues in the Berlin surface waters showed that the phenolic residues, with the exception of pentachlorophenol and 2-ethylphenol, do not originate primarily from municipal sewage treatment plants discharges. Some of the phenols are formed naturally or occur as ubiquitous anthropogenic contaminants in the aquatic system.     

Modeling the Phase Transition Associated with Melting Snow in a 1D Kinematic Framework: Sensitivity to the Microphysics

A simple 1D kinematic cloud model coupled to a two-moment bulk microphysics scheme is used to perform quasi-idealized simulations of snow, with a prescribed upper boundary snow field based on observed radar reflectivity and temperature, falling into a low-level melting layer. The model realistically simulates the formation of a nearly isothermal layer below the melting level, the surface precipitation rate, and the phase transition from liquid to solid, consistent with observations for this case. A series of test runs is performed to examine the sensitivity of modeling the timing and duration of the phase transition period to details of specific parameterization aspects related to snow in the microphysics scheme. The sensitivity tests include varying the number of prognostic moments, the mass–diameter relation, the fall velocity–diameter relation, the treatment of aggregation, and the lower limit for the slope of the size distribution. It is shown that the simulated transition period, for such a case with the initial melting level being close to the surface, can be quite sensitive to model parameters specified within realistic ranges and/or ranges within our physical understanding.     

Cretaceous metamorphism in the Austroalpine Matsch Unit (Eastern Alps): The interrelation between deformation and chemical equilibration processes

In the polymetamorphic Austroalpine Matsch Unit (European Eastern Alps) Cretaceous upper greenschist facies metamorphism overprinted Variscan and Permian magmatic and metamorphic assemblages. Mineral compositional and (micro-)structural data of metapelites and metapegmatites document different mechanisms of interrelated deformation and (re-)equilibration during Cretaceous overprinting: i) Microfractures in relic garnet represented pathways for material transport, and thus established material exchange between intragranular domains and the matrix. Major element equilibration by fast diffusion along microfractures contrasts with limited volume diffusion in adjacent host garnet. ii) Syn-tectonic breakdown of staurolite initially to paragonite, then chloritoid allows correlating reaction progress with the formation of different fracture sets. iii) Syn-tectonic mineral growth with shape-preferred orientation in foliation domains contrasts with radial growth in microlithons and strain shadows of the mylonitic foliation. iv) Syn-tectonic unmixing of pre-existing oligoclase (an_14–16) produced fine-grained aggregates of two supposedly coexisting plagioclase-phases (an_3–6 and an_20–25) in strain shadows of the oligoclase-clasts. v) Pre-existing deformation-induced heterogeneities in the spatial distribution of phases and their preferred orientation influence the kinetics of phase equilibration. Understanding the mechanisms of the mutual interrelation between deformation and phase equilibration is a prerequisite for deducing PT-constraints from strained metamorphic rocks. New garnet—whole rock Sm-Nd data from metapegmatites indicate their emplacement at 263–280 Ma and provide an important age constraint on the interrelated deformation and re-equilibration processes.     

On-chip earthquake simulation model using potentials

A two-dimensional (2-D) Cellular Automata (CA) dynamic system constituted of cells-charges has been proposed for the simulation of the earthquake process. The CA model has been calibrated with the use of real data. The calibration incorporates major seismic characteristics of the area under test. The simulation results are found in good quantitative and qualitative agreement with the recorded Gutenberg–Richter (GR) scaling relations. The model is enriched with a powerful multi-parameter interface that enables the user to load real data from different regions. This paper examines the on-chip realisation of the model and its instrumentation. The CA model hardware implementation is based on Field Programmable Gate Array (FPGA) logic. It utilises an array of 32 × 32 cells. Parameters that construct the local CA rule constitute the input data. The initial seed, which to some extent corresponds to the seismic features of the area under test, is loaded in a semi-parallel way and the process is completed in a certain number of time steps. The automatic response of the processor provides the corresponding GR scaling law of the area under study. The hardware implementation of the CA-based earthquake simulation model is advantageous in terms of low-cost, high-speed, compactness and portability features. It can operate as a preliminary data-acquisition filter that accelerates the evaluation of recorded data as far as its origin time, spatial and magnitude completeness and quality are concerned. Software that performs reliable automatic phase picking, as well as data elaboration, can be assembled next to the earthquake recording instruments (the whole network) output to assure a quick and reliable iteration of the focal parameters of a recorded earthquake (epicentre coordinates, focal depth and magnitude). The dedicated processor can be accommodated right after this stage (before any manual elaboration) focusing on the near real-time development of a reliable qualitative dynamical seismic record and a mapping of the seismic characteristics of the area.