A case study on fuel oil contamination in a mangrove swamp in Hong Kong

Mangroves commonly found along tropical and subtropical coastlines are susceptible to oil pollution. In December 2000, around 500 1 m tall Kandelia candel saplings at the age of 3–5 years old located at the foreshore region of Sheung Pak Nai swamp, Hong Kong SAR, were found to be damaged by oil pollution. More than 80% of the saplings were either dead or washed away and leaving less than 5% healthy saplings with dense green leaves. Elevated concentrations of light n-alkanes (ranging from n-C₁₄ to n-C₂₀), pristane and phytane were recorded in surface sediments collected in December 2000. The ratio between light and total n-alkanes was 0.4. The total petroleum hydrocarbons (60–80 μg g⁻¹ TPH) and unresolved complex mixtures (60–70 μg g⁻¹ UCM) were higher than the background values of other mangrove sediments in Hong Kong, which were 40 and 20 μg g⁻¹, respectively. In certain root zone sediments, TPH concentrations were above 1000 μg g⁻¹. These results suggest that surface sediments in Sheung Pak Nai were contaminated by petroleum oil, most likely by illegal discharge of fuel oil which occurred between 1998 and 2002. One year later, in December 2001, unhealthy saplings had recovered and re-grown. The concentrations of TPH and UCM in sediments declined to around 40 μg g⁻¹, pristane and phytane dropped by 80%, and the ratio of light to total n-alkanes was 0.15, suggesting that residual oil in sediments was weathered leading to a remarkable recovery of the unhealthy saplings.     

Drying of salt-contaminated masonry: MRI laboratory monitoring

Drying of masonry specimens was monitored by means of a two-dimensional (2D) magnetic resonance imaging (MRI) technique. The external surfaces stayed wet for longer if NaCl was present instead of pure water only. This corroborates many practical observations that salts aggravate dampness in masonry. A slower evaporation process and not hygroscopicity was the cause. That suggests that salt-induced dampness may, in general, arise simply from changes in the drying process of masonry materials. That also implies that the height and depth at which crystallization occurs in walls may depend on the relative equilibrium humidity (RHeq) and other properties of salts that influence drying of porous materials. Evaporation rates of free surfaces of pure water and saturated NaCl solution were measured by a gravimetric technique. The results indicate that slow drying of salt-contaminated materials is not due only to the lower RHeq of salt solutions. The effective surface of evaporation is likely to be reduced perhaps due to blocking of pores by salt crystals. Final salt-distribution maps of the specimens show that: (a) salts may affect the inner materials of the masonry, even in evaporation-induced processes that lead crystallization to occur predominantly on the external surface; (b) distinct internal distribution patterns occur if masonry composition varies. Electronic supplementary material Supplementary material is available in the online version of this article at and is accessible for authorized users.     

Geochronology of a composite granitoid pluton: a high-precision ID-TIMS U–Pb zircon study of the Variscan Karkonosze Granite (SW Poland)

Resolving time differences between successive magmatic pulses in composite granitoid plutons is often a difficult task. High-precision CA-ID-TIMS zircon ages obtained from such a pluton, the Variscan Karkonosze Granite (NE part of the Bohemian Massif), provide evidence that the crystallization of the two main granite facies, porphyritic and equigranular, happened between 312.5 ± 0.3 and 312.2 ± 0.3 Ma, thus unresolvable at the 0.08–0.1 % precision level of a single ²⁰⁶Pb/²³⁸U age. This finding is at odds with most other previous dating attempts and asks for a re-evaluation of the previous scattered geochronological data. The main reasons for the scatter of the earlier dates obtained by various techniques can include analytical causes, the presence of older inheritance and disturbance of the U–Pb isotopic system, due to zircon metamictization (enhanced by high-U content in zircon) or late- and post-magmatic alteration.     

Asbestos and other fibrous minerals contained in the serpentinites of the Gimigliano-Mount Reventino Unit (Calabria,S-Italy)

Serpentinites are metamorphic rocks with good technological properties and valuable ornamental characteristics, which have been exploited since ancient times. Actually, their use is limited and monitored in several countries worldwide because they can contain fibrous asbestos minerals that may be carcinogenic. Furthermore, certain types of fibrous minerals can be confused with asbestos, and must therefore be carefully investigated. We have investigated the possible presence of the asbestos and non-asbestos fibrous phases contained in serpentinitic rocks in a meta-ophiolitic sequence from the Gimigliano-Mount Reventino Unit (Southern Italy), which had not been previously assessed. The detection and quantification of asbestos and the correct distinction of the fibrous non-asbestos minerals are very important not only from a scientific point of view, but also from a legislative one. This is especially the case for the administrative agencies that have to take decisions with regards to the implementation of public and occupational health protection measures (e.g., in road yards and quarry excavations). As a consequence of this, serpentinitic rock samples have been characterized in detail through X-ray powder diffraction, scanning and transmission electron microscopy combined with energy-dispersive spectrometry, analytical electron microscopy (SEM–EDS and TEM–AEM), differential scanning calorimetry, thermogravimetry and micro-Raman spectroscopy. Two kinds of asbestos and four kinds of non-asbestos fibrous silicates have been detected in the examined samples. In order of decreasing abundance these are polygonal serpentine, chrysotile, fibrous antigorite, tremolite, gedrite and magnesiohornblende. The size, morphology, crystallinity and chemical composition of the fibres were also discussed, in the light of the possible role these properties could play in the carcinogenic effect on human health.     

Alteration kinetics of natural stones due to sodium sulfate crystallization: can reality match experimental simulations?

Salt decay is a very destructive mechanism that affects frequently the porous building materials of our architectural heritage. Sodium sulfate is one of the salts found in this context. It usually demonstrates high destructive power in salt crystallization tests because it can crystallize not only during evaporative processes but also when the temperature drops or when the salt solution comes into contact with pre-existing crystals. However, the use of extreme temperatures or successive wet/dry cycles also makes these tests unrepresentative of reality. To verify whether sodium sulfate can also be so destructive in field conditions, we have performed crystallization tests consisting of a single isothermal drying event. Three natural stones, relevant for the architectural heritage, were used for the purpose: Bentheimer sandstone, Ançã limestone, and a current Portuguese limestone of low porosity. The stones gave rise to distinct salt decay patterns: efflorescence, multilayer delamination and unilayer delamination, respectively. These morphological alterations were characterized at the micrometer scale by a new method based on what we have called the alteration kinetics curve. Such curve is calculated from topographic profiles obtained by a non-contact optical technique. The multilayer and unilayer delamination decay were also monitored by time-lapse photography. The work led us to conclude that sodium sulfate can indeed be also very destructive in field-representative conditions. Moreover, it showed that the optical method can be a valuable aid in the development of more realistic salt crystallization tests.     

Can industrial pollution cause intersexuality in the amphipod, Echinogammarus marinus?

Following recent studies, in which intersex and/or reproductive abnormalities have been observed in a number of crustaceans in association with pollution, the prevalence of intersexuality in the amphipod, Echinogammarus marinus was monitored at sites receiving industrial discharges for one year in 2002/2003. Based upon reports of intersexuality occurring in amphipods due to feminising microsporidian parasites, the occurrence, and role of microsporidian parasites in causing intersex was investigated through histological examination. Results demonstrate a significantly higher prevalence of intersex organisms was found at sites receiving industrial discharges throughout the year when compared to a reference site, with the phenotype of intersex (intersex male and intersex female) varying in its dominance between impacted sites. Intersex specimens were significantly more likely to be infected with microsporidian parasites at sites receiving discharges than reference sites, however relatively few specimens (normal or intersex) were infected at reference sites suggesting parasitism is not the only cause of intersex. The direct/indirect role of pollution in the observed intersexuality is discussed.     

Geomorphic indices and relative tectonic uplift in the Guerrero sector of the Mexican forearc

Tectonically active areas, such as forearc regions, commonly show contrasting relief, differential tectonic uplift, variations in erosion rates, in river incision, and in channel gradient produced by ongoing tectonic deformation. Thus, information on the tectonic activity of a defined area could be derived via landscape analysis. This study uses topography and geomorphic indices to extract signals of ongoing tectonic deformation along the Mexican subduction forearc within the Guerrero sector. For this purpose, we use field data, topographical data, knickpoints, the ratio of volume to area (R_VA), the stream-length gradient index (SL), and the normalized channel steepness index (k_sn).The results of the applied landscape analysis reveal considerable variations in relief, topography and geomorphic indices values along the Guerrero sector of the Mexican subduction zone. We argue that the reported differences are indicative of tectonic deformation and of variations in relative tectonic uplift along the studied forearc. A significant drop from central and eastern parts of the study area towards the west in values of R_VA (from ～500 to ～300), SL (from ～500 to ca. 400), maximum SL (from ～1500–2500 to ～1000) and k_sn (from ～150 to ～100) denotes a decrease in relative tectonic uplift in the same direction. We suggest that applied geomorphic indices values and forearc topography are independent of climate and lithology. Actual mechanisms responsible for the observed variations and inferred changes in relative forearc tectonic uplift call for further studies that explain the physical processes that control the forearc along strike uplift variations and that determine the rates of uplift. The proposed methodology and results obtained through this study could prove useful to scientists who study the geomorphology of forearc regions and active subduction zones.     

Magnetic properties of surface sediments as proxies of recent anthropogenic pollution in the Anllóns riverbed (NW Spain)

A study of surface sediments from the Anllóns riverbed (northwestern Spain) was conducted to assess the use of their magnetic properties as proxies of recent trace element contamination (i.e., As, Zn, Pb, Cr, Ni and Cu). Thermomagnetic curves, hysteresis parameters, specific magnetic susceptibility χ, frequency-dependent magnetic susceptibility κ _FD%, magnetic remanence and saturation isothermal remanent magnetization ratios (i.e., S and SIRM/χ) reveal the presence of mostly fine-grained magnetite and maghemite in these samples. The Tomlinson Pollution Load Index (PLI), as well as the magnetic parameters χ, κ _FD%, SIRM/χ and S-ratios, vary more or less in agreement to each other when they are sequentially arranged throughout a 30-km-long transect that goes from the town of Carballo to the river mouth in Ponteceso. From that profile, it is possible to identify an anomaly of χ that lies between two small peaks of the PLI and seems to define a contaminated area probably linked to a diffuse low-impact source of pollution. There is also a conspicuous peak of the PLI that is likely associated to a nearby gold mine. The variations of the κ _FD%’s along the transect are the ones that best reflect the changes in the PLI values, regardless of the level of contamination. This result suggests that adsorption is the main mechanism of trace elements removal by Fe oxides in these samples. Direct signal analyses, used to decompose the isothermal remanent magnetization curves, reveal the presence of four magnetic fractions, with varying relative concentrations all over the profile, namely single-domain magnetite, close to the superparamagnetic threshold (SD/SP) and/or maghemite (\(\log B_{1/2}\) ca 1.2), single-domain magnetite (\(\log B_{1/2}\) ca 2), hematite (\(\log B_{1/2}\) ca 2.5) and goethite (\(\log B_{1/2}\) ca 3.5). Integrating all the available information, it was sketched out a likely sequence of events that included magnetic minerals neoformation in parent soils, their subsequent chemical transformations and the contamination episodes that affected the region.     

Debris flow hazard assessment by means of numerical simulations: implications for the Rotolon creek valley (Northern Italy)

On 4^th November 2010, a debris flow detached from a large debris cover accumulated above the lowermost portion of the Rotolon landslide (Vicentine Pre-Alps, NE Italy) and channelized in the valley below within the Rotolon Creek riverbed. Such event evolved into a highly mobile and sudden debris flow, damaging some hydraulic works and putting at high risk four villages located along the creek banks. A monitoring campaign was carried out by means of a ground based radar interferometer (GB-InSAR) to evaluate any residual displacement risk in the affected area and in the undisturbed neighbouring materials. Moreover, starting from the current slope condition, a landslide runout numerical modelling was performed by means of DAN-3D code to assess the impacted areas, flow velocity, and deposit distribution of the simulated events. The rheological parameters necessary for an accurate modelling were obtained through the back analysis of the 2010 debris flow event. Back analysis was calibrated with all of the available terrain data coming from field surveys and ancillary documents, such as topographic, geomorphological and geological maps, with pre- and post-event LiDAR derived DTMs, and with orthophotos. Finally, to identify new possible future debris flow source areas as input data for the new modelling, all the obtained terrain data were reanalysed and integrated with the GB-InSAR displacement maps; consequently, new simulations were made to forecast future events. The results show that the integration of the selected modelling technique with ancillary data and radar displacement maps can be a very useful tool for managing problems related to debris flow events in the examined area.     

New Reference Materials,Analytical Procedures and Data Reduction Strategies for Sr Isotope Measurements in Geological Materials by LA-MC-ICP-MS

Laser ablation multi-collector mass spectrometry (LA-MC-ICP-MS) has emerged as the technique of choice for in situ measurements of Sr isotopes in geological minerals. However, the method poses analytical challenges and there is no widely adopted standardised approach to collecting these data or correcting the numerous potential isobaric inferences. Here, we outline practical analytical procedures and data reduction strategies to help establish a consistent framework for collecting and correcting Sr isotope measurements in geological materials by LA-MC-ICP-MS. We characterise a new set of plagioclase reference materials, which are available for distribution to the community, and present a new data reduction scheme for the Iolite software package to correct isobaric interferences for different materials and analytical conditions. Our tests show that a combination of Kr-baseline subtraction, Rb-peak-stripping using βRb derived from a bracketing glass reference material, and a CaCa or CaAr correction for plagioclase and CaCa or CaAr + REE²⁺ correction for rock glasses, yields the most accurate and precise ⁸⁷Sr/⁸⁶Sr measurements for these materials. Using the analytical and correction procedures outlined herein, spot analyses using a beam diameter of 100 μm or rastering with a 50–65 μm diameter beam can readily achieve < 100 ppm 2SE repeatability ("internal") precision for ⁸⁷Sr/⁸⁶Sr measurements for materials with < 1000 μg g^-1 Sr.