Desert methane: Implications for life detection on Mars

Methane, a potential biosignature, has recently been detected in the martian atmosphere. This Note focuses on field investigations/operational simulations and laboratory studies which resulted in successful detection of methane within arid terrestrial soils, as distinct from the usual methanogen environment, but in at least partial analogy to martian conditions.     

Deep tow studies of the Tamayo transform fault

The Tamayo transform fault occurs at the north end of the East Pacific Rise where it enters the Gulf of California. The two deep-tow surveys reported here show that the transform fault zone changes significantly as a function of distance from the spreading center intersections. At site 1, near the intersection, one side of the fault is young and the fault zone is narrow and well-defined. Strike slip occurs in a zone approximately 1-km wide suggesting a correspondingly narrow zone of decoupling between the Pacific and North American plates. On the young side of the strike-slip zone, normal faults occur along shear zones which are 45°–50° oblique to the transform strike. They occur parallel to the short axis of the strain ellipse for transform fault strain here, i.e., perpendicular to the least compressive stress. The transform walls are formed by normal faulting as has been pointed out in previous detailed surveys. Here, however, the age contrast of 2.5 m.y. across the transform valley is apparent in the morphology of the normal fault scarps. While the scarps are steep and well-defined on the young side, the scarps on the older side have gradual 10°–30° slopes and appear to be primarily talus ramps. Apparently, the scarps have been tectonically eroded by continued strike slip activity after the initial stages of normal faulting. Thus, transform valleys should be quite asymmetric in cross-section where there is a significant age contrast and one side is less than approximately 0.5 m.y. old. Also, along older sections of the transform valley walls, normal faulting may not be at all obvious due to degradation of the scarps by tectonic erosion. This phenomenon makes the likelihood of transform faults providing windows into the oceanic crust most unlikely except in special cases.The picture of transform deformation is more complex at site 2 in the central portion of the fault where both sides of the fault are greater than 1 m.y. old. Here the transform valley is wider (25–30 km as opposed to 2–5 km). There is no clear simple zone of strike slip tectonics. In fact, the only clear evidence for deformation is the intrusion of magmatic or serpentinite diapirs through the sediments of the transform valley floor. The diapirs have deformed the turbidite layers flooring the valley and in one carefully studied case the turbidite sequence has been uplifted, perched atop the diapir. The pattern of deformation on this outcropping diapir shows radial and concentric fractures which can be modeled by a vertical intrusion circular in plan view. Magnetic studies limit the possible composition to basalt or serpentinite. A 60-km-long median ridge is also likely to be the product of intrusion along the transform fault. The survey at site 2 pointed out the importance of vertical tectonics in the transform valley floor and in particular the importance of diapiric intrusions of either basaltic or serpentinite composition.Based on initial boundary conditions and present tectonic elements in the Tamayo fault zone, a possible history of the mouth of the Gulf of California is outlined. The median ridge was emplaced starting approximately 0.8 m.y. ago by regional extension across the transform fault, the result of leaky transform faulting. The diapirs occur along a possible relay zone of extension midway along the fault which began approximately 0.15 m.y. ago. The extension in this case is parallel to the trend of the transform fault, is still occurring at present, and may evolve into a true spreading center.Contribution of the Scripps Institution of Oceanography, new series.     

Seasonal variations of alkenones and U37 in the Chesapeake Bay water column

Alkenone unsaturation indices (U^K₃₇ and U^K′₃₇) have long been used as proxies for surface water temperature in the open ocean. Recent studies have suggested that in other marine environments, variables other than temperature may affect both the production of alkenones and the values of the indices. Here, we present the results of a reconnaissance field study in which alkenones were extracted from particulate matter filtered from the water column in Chesapeake Bay during 2000 and 2001. A multivariate analysis shows a strong positive correlation between U^K₃₇ (and U^K′₃₇) values and temperature, and a significant negative correlation between U^K₃₇ (and U^K′₃₇) values and nitrate concentrations. However, temperature and nitrate concentrations also co-vary significantly. The temperature vs. U^K₃₇ relationships (U^K₃₇=0.018 (T)−0.162, R²=0.84, U^K′₃₇=0.013 (T)−0.04, R²=0.80) have lower slopes than the open-ocean equations of Prahl et al. [1988. Further evaluation of long-chain alkenones as indicators of paleoceanographic conditions. Geochimica et Cosmochimica Acta 52, 2303–2310] and Müller et al. [1998. Calibration of the alkenone paleotemperature index U^K′₃₇ based on core-tops from the eastern South Atlantic and the global ocean (60°N–60°S). Geochimica et Cosmochimica Acta 62, 1757–1772], but are similar to the relationships found in controlled studies with elevated nutrient levels and higher nitrate:phosphate (N:P) ratios. This implies that high nutrient levels in Chesapeake Bay have either lowered the U^K₃₇ vs. temperature slope, or nutrient levels are the main controller of the U^K₃₇ index. In addition, particularly high abundances (>5% of total C₃₇ alkenones) of the tetra-unsaturated ketone, C_37:4, were found when water temperatures reached 25 °C or higher, thus posing further questions about the controls on alkenone production as well as the biochemical roles of alkenones.     

The sea-surface microlayer of puget sound: Part I. Toxic effects on fish eggs and larvae

The sea surface is an important habitat for the developmental stages (eggs and larvae) of many fish and invertebrates; it is also a concentration point for anthropogenic contaminants entering the sea. Studies were conducted to determine the extent to which the sea surface of Puget Sound was toxic to the early life history stages of fish. Three urban bays with suspected contamination, a rural reference bay, and a Central Sound site were compared. Surface-dwelling eggs and organisms (zooneuston) were collected with a surface-skimming neuston net and their densities enumerated. Sand sole (Psettichthys melanostictus) embryos were exposed in the field and laboratory to the sea-surface microlayer. To develop a useful year-round approach to monitoring sea-surface toxicity, larval development of anchovies, kelp bass, and sea urchins was also evaluated as an indication of sea-surface microlayer toxicity.During the spawning season (February and March), urban boys in Puget Sound had lower concentrations of sand sole eggs and neustonic organisms on the sea surface than did the rural bayor Central Sound reference sites. Compared to the reference sites, laboratory exposure to surface microlayer samples collected from urban bay sites generally resulted in more chromsomal aberrations in developing sole embryos, reduced hatching success of sole larvae, and reduced growth in trout cell cultures. In situ hatching success of sole eggs was reduced by half or more in urban bays compared to reference sites.Toxicity was associated with visible surface slicks and, in urban bays, increased with increasing surface pressure (dynes cm⁻¹). Results to be reported separately (Part II) indicate that toxicity is strongly correlated with the presence of high concentrations of polycyclic aromatic hydrocarbons and metals in the sea-surface microlayer. The toxicity of SMIC samples was similar when evaluated by sole, anchovy, kelp bass, or sea urchin tests. A sea-surface monitoring program could use sea urchin embryos to evaluate site-specific sea-surface toxicity throughout the year.     

The rise of coastal and marine tourism

Marine tourism has surfaced as a pressing topic in the field of ocean and coastal management. Neither necessarily good, nor bad, this tourism is inherently controversial. Today, demand for travel exhibits greater variation and magnitude than ever in history. In response, the tourism industry has become the largest business on earth. This, coupled with the respect people profess for marine environments and local peoples, creates feelings of ambivalence for the tourist. Sociologically, the activity of tourism may be studied as a symbolic interaction fostering social solidarity. Ecotourism, a recent phenomenon attuned to the ideal of sustainable development, is suggested to emerge through the social construction processes of restoration and enhancement. The papers in this theme volume add fuel to the proposition that the resolution of tourism problems in the coastal zone will require the scientific study of environmental and social conditions, policy analyses, planning, and public education.     

Laboratory wave reflection analysis using co-located gages

Most coastal and ocean engineering laboratories employ techniques that use two or three spatially separated wave gages to estimate reflection of irregular waves in two-dimensional wave flumes. This paper presents a frequency domain method for separating incident and reflected wave spectra from co-located gages (gages located on the same vertical line). The technique is based on linear wave theory, and it can be applied to time series of sea surface elevation and horizontal water velocity collected in a vertical array, or it can be used with horizontal and vertical water velocity time series collected at the same point in the water column. Application of the method is limited to those frequencies showing good coherence between time series signals. Outside the range of good coherence, gross inaccuracies occur.The utility of the co-located gage method is illustrated using water velocity data collected in a wave flume with a laser Doppler velocimeter, and the method is validated for the case of complete reflection by a vertical wall. Side-by-side comparison to the spatially-separated wave gage method of Goda and Suzuki (1976) exhibited close agreement for a variety of irregular wave trains being weakly reflected by a mild sloping beach. The co-located gage method is useful in situations where there are spatial variations in the wavelength, such as on a mildly sloping bottom, or in the region close to highly reflective structures where errors arising from spatial variations in characteristic wave parameters would corrupt estimates made using the spatially-separated wave gage method.     

High-resolution seafloor mapping using the DSL-120 sonar system: Quantitative assessment of sidescan and phase-bathymetry data from the Lucky Strike segment of the Mid-Atlantic Ridge

High-resolution, side-looking sonar data collected near the seafloor (100 m altitude) provide important structural and topographic information for defining the geological history and current tectonic framework of seafloor terrains. DSL-120 kHz sonar data collected in the rift valley of the Lucky Strike segment of the Mid-Atlantic Ridge near 37° N provide the ability to quantitatively assess the effective resolution limits of both the sidescan imagery and the computed phase-bathymetry of this sonar system. While the theoretical, vertical and horizontal pixel resolutions of the DSL-120 system are <1 m, statistical analysis of DSL-120 sonar data collected from the Lucky Strike segment indicates that the effective spatial resolution of features is 1–2 m for sidescan imagery and 4 m for phase-bathymetry in the seafloor terrain of the Mid-Atlantic Ridge rift valley. Comparison of multibeam bathymetry data collected at the sea-surface with deep-tow DSL-120 bathymetry indicates that depth differences are on the order of the resolution of the multibeam system (10–30 m). Much of this residual can be accounted for by navigational mismatches and the higher resolving ability of the DSL-120 data, which has a bathymetric footprint on the seafloor that is 20 times smaller than that of hull-mounted multibeam at these seafloor depths (2000 m). Comparison of DSL-120 bathymetry with itself on crossing lines indicates that residual depth values are ±20 m, with much of that variation being accounted for by navigational errors. A DSL-120 survey conducted in 1998 on the Juan de Fuca Ridge with better navigation and less complex seafloor terrain had residual depth values half those of the Lucky Strike survey. The quality of the bathymetry data varies as a function of position within the swath, with poorer data directly beneath the tow vehicle and also towards the swath edges.Variations in sidescan amplitude observed across the rift valley and on Lucky Strike Seamount correlate well with changes in seafloor roughness caused by transitions from sedimented seafloor to bare rock outcrops. Distinct changes in sonar backscatter amplitude were also observed between areas covered with hydrothermal pavement that grade into lava flows and the collapsed surface of the lava lake in the summit depression of Lucky Strike Seamount. Small features on the seafloor, including volcanic constructional features (e.g., small cones, haystacks, fissures and collapse features) and hydrothermal vent chimneys or mounds taller than 2 m and greater than 9 m² in surface area, can easily be resolved and mapped using this system. These features at Lucky Strike have been confirmed visually using the submersible Alvin, the remotely operated vehicle Jason, and the towed optical/acoustic mapping system Argo II.