A fault model of the 1946 Nankaido earthquake derived from tsunami data

A fault model of the 1946 Nankaido earthquake (M = 8.2) is determined by the use of tsunami records of Uwajima, Shimotsu and Hososhima which were located within or near the area of major coseismic crustal deformation. Synthetic tsunamis computed for various fault models are matched with the observed tsunamis to determine the fault parameters. A low-angle thrust model slightly revised from a previous model by Ando is consistent with the observed tsunamis. The duration of faulting is constrained as less than 10 min based upon the tsunami. The fault is divided into an eastern and a western segment corresponding to areas associated with and without aftershocks, respectively. The fault area and dislocation for the western segment are 150 × 70 km² and 6 m, and those for the eastern segment are 150 × 70 km² and 3 m, respectively. The total seismic moment is 4.7 × 10²⁸ dyn·cm, significantly smaller than that obtained from a geodetic model by Fitch and Scholz, but still larger than that of the seismic model by Kanamori. The discrepancy in seismic moment between the seismic and the present models (RAN2) could be interpreted in terms of a slow dislocation on the fault, but this interpretation does not match the seismic intensity distribution and damage pattern, and the slow-slip model for the Nankaido earthquake is rejected. The discrepancy between the two seismic moments is considered insignificant within error involved in data and modeling assumptions. If the revised geodetic model (RAN2) is modified, the seismic moment required to explain the observed tsunamis would be reduced further by ～30%. If we consider the uncertainties involved in the fault model of Kanamori and the fault-finiteness effect affecting the amplitude of seismic waves, the seismic moment required to interpret the seismic-wave data could be increased, possibly being more than twice that of Kanamori. Thus, the two seismic moments from the different data sets could be close to each other within allowable tolerance. This implies that the rise time of the Nankaido earthquake was short enough to generate short-period seismic waves from both the western and the eastern fault segments.     

Mechanism of the olivine–ringwoodite transformation in the presence of aqueous fluid

The mechanism of the high pressure transformation of olivine in the presence of aqueous fluid was investigated by high pressure experiments conducted nominally at the wadsleyite + ringwoodite stability field at 14.5 GPa and 700 and 800°C. The microstructures of recovered samples were observed using an analytical transmission electron microscope (ATEM) for which foils were prepared using a focused ion beam technique. Glass films approximately 1 μm in width always occupied the interface between olivine and hydrous ringwoodite. ATEM measurements showed that the chemical compositions of the glass films had approximately the same Mg/Fe ratio as that of olivine, but a higher Si content. Micro-structural and -chemical observations suggest that these glass films formed as quenched glass from the aqueous fluid dissolving olivine and that hydrous ringwoodite was crystallized from the fluid. This indicates that the transformation of olivine to hydrous ringwoodite was prompted by the dissolution–reprecipitation process. The dissolution–reprecipitation process is considered an important mineral replacement mechanism in the Earth’s crust by which one mineral is replaced by a more stable phase or phases. However, this process has not previously been reported for deep mantle conditions.     

Delineation of an exhumed intermediate-depth crustal fault in a collisional setting: An example from the Himalaya

The regionally prominent main boundary thrust (MBT) of the Himalayan fold-thrust belt in northwest India is typically defined by the presence of Proterozoic rocks in the hanging wall and Cenozoic rocks in the footwall. The present study focuses on identifying the MBT contact across Gambar River section in Himachal Pradesh, India, using alternative methodologies, such as the meter-scale litho-structural mapping, followed by detrital zircon U–Pb geochronology to precisely identify the thrust contact and provide insights on the deformation history of the MBT zone. We have identified a sharp change in the age (from ~600 to ~61 Ma) of the sedimentary units along a narrow zone in the study area by detrital zircon U–Pb geochronology using LA-ICP-MS. The sharp change in the detrital zircon U–Pb age data thus delineate the MBT occurring in the area along a < ~1 m thickness. The lithological assemblage and the age data indicate the unified maximum depositional age from ~700 to ~600 Ma for the hanging wall rocks, which have been equated with the Krol Group of the Lesser Himalayan Sequence (LHS). In comparison, the footwall rocks exhibit the maximum depositional age of ~61 Ma and have been equated with the Cenozoic Subathu Formation of the Sub-Himalayan Sequence (SHS).     

Hydraulic tomography for detecting fracture zone connectivity

Fracture zones and their connectivity in geologic media are of great importance to ground water resources management as well as ground water contamination prevention and remediation. In this paper, we applied a recently developed hydraulic tomography (HT) technique and an analysis algorithm (sequential successive linear estimator) to synthetic fractured media. The application aims to explore the potential utility of the technique and the algorithm for characterizing fracture zone distribution and their connectivity. Results of this investigation showed that using HT with a limited number of wells, the fracture zone distribution and its connectivity (general pattern) can be mapped satisfactorily although estimated hydraulic property fields are smooth. As the number of wells and monitoring ports increases, the fracture zone distribution and connectivity become vivid and the estimated hydraulic properties approach true values. We hope that the success of this application may promote the development and application of the new generations of technology (i.e., hydraulic, tracer, pneumatic tomographic surveys) for mapping fractures and other features in geologic media.     

Depositional ages and characteristics of Middle–Upper Jurassic and Lower Cretaceous lacustrine deposits in southeastern Mongolia

Lower Cretaceous lacustrine oil shales are widely distributed in southeastern Mongolia. Due to the high organic carbon content of oil shale, many geochemical studies and petroleum exploration have been conducted. Although most of the oil shales are considered to be Early Cretaceous in age, a recent study reveals that some were deposited in the Middle Jurassic. The present study aims at establishing depositional ages and characteristics of the Jurassic and Cretaceous lacustrine deposits in Mongolia. The Lower Cretaceous Shinekhudag Formation is about 250 m thick and composed of alternating beds of shale and dolomite. The Middle Jurassic Eedemt Formation is about 150 m thick and composed of alternating beds of shale, dolomitic marl, and siltstone. The alternations of shale and dolomite in both formations were formed by lake level changes, reflecting precipitation changes. Shales were deposited in the center of a deep lake during highstand, while dolomites were formed by primary precipitation during lowstand. Based on the radiometric age dating, the Shinekhudag Formation was deposited between 123.8 ±2.0 Ma and 118.5 ±0.9 Ma of the early Aptian. The Eedemt Formation was deposited at around 165–158 Ma of Callovian–Oxfordian. The calculated sedimentation rate of the Shinekhudag Formation is between 4.7 ±2.6 cm/ky and 10.0 ±7.6 cm/ky. Shales in the Shinekhudag Formation show micrometer‐scale lamination, consisting of algal organic matter and detrital clay mineral couplets. Given the average thickness of micro‐laminae and calculated sedimentation rate, the micro‐lamination is most likely of varve origin. Both Middle–Upper Jurassic and Lower Cretaceous lacustrine oil shales were deposited in intracontinental basins in the paleo‐Asian continent. Tectonic processes and basin evolution basically controlled the deposition of these oil shales. In addition, enhanced precipitation under humid climate during the early Aptian and the Callovian–Oxfordian was another key factor inducing the widespread oil shale deposition in Mongolia.     

Toward institutions for community-based management of inshore marine resources in the Western Indian Ocean

This paper examines the frameworks being developed to co-manage coral reefs in Kenya and Madagascar. The historical and social context, flexibility of rule-making, monitoring and enforcement, and how community-based organizations are nested within other organizations is described. A comparison of the degree to which these two frameworks contain 10 key design principles thought to be important for successful commons institutions is presented. Finally, recommendations are made for improving co-management in these countries. A principal finding is that both co-management frameworks were developed for other systems (terrestrial and lakes), which creates misfits for how marine systems can be managed.     

Post‐Eocene intensification of deep‐water circulation in the central South Pacific: Micropalaeontological clues from dredged sites along the eastern Manihiki Plateau margin

Reconstruction of early Cenozoic deep‐water circulation is one of the keys to modelling Earth's greenhouse‐to‐icehouse surface evolution, but it has long been hampered by the paucity of information from the central South Pacific. To help overcome this knowledge gap, we present new micropalaeontological data from dredged carbonates (R/V Sonne Expedition SO193) at several eastern volcanic salients of the Manihiki Plateau. Interestingly, despite appreciable longitudinal separations among the dredged sites, ages indicated by the foraminiferal assemblages are consistently around the Middle Eocene (including mixed Turonian [Late Cretaceous]/Eocene at a single site), suggesting widespread post‐Eocene cessation of the pelagic sedimentation. By integrating with independent seismic and chronostratigraphic data (Deep Sea Drilling Project Leg 33) for large‐scale erosion of top‐Eocene–Oligocene sedimentary units on the eastern Manihiki Plateau, our results can be viewed as novel physical evidence for the intensification of central South Pacific deep‐water circulation since the Eocene/Oligocene climatic transition.     

Advanced mosasaurs from the Upper Cretaceous Nakaminato Group in Japan

Plotosaurus is a highly aquatically adapted mosasaur, which is supposed to inhabit the deep ocean basin. The geographic occurrence of this genus has been limited only to the west coast of North America. In this study, two Plotosaurus-type mosasaur caudal vertebrae derived from the Upper Cretaceous Nakaminato Group in Ibaraki Prefecture, Japan, are described with discussion on the paleobiogeographic significance of the Late Cretaceous mosasaur fauna in the Northwestern Pacific region. The two specimens are an intermediate caudal vertebra found in a beach cobble, which presumably originated from the Hiraiso Formation (upper Campanian), and a terminal caudal vertebra found in situ in the lower Isoai Formation (lower Maastrichtian). Because their relative centrum lengths (ratio of centrum length/centrum height, ~0.7) are very close to that of Plotosaurus, the specimens are referred to cf. Plotosaurus sp. The two specimens provide the first evidence that highly specialized Plotosaurus-type mosasaurs inhabited the Northwestern Pacific Ocean, suggesting that such forms had a wider distribution than previously recognized and might have existed since the late Campanian in the Northwestern Pacific Ocean.     

Gamma-ray burst neutrino background and star formation history in the universe

We estimate the flux of the gamma-ray burst (GRB) neutrino background and compute the event rate at SK and TITAND in the collapsar model, assuming that GRB formation rate is proportional to the star formation rate. We find that the predicted background neutrino flux is highly sensitive to unknown model parameters, mainly to the mass–accretion rate, to the fraction of disk energy emitted in thermal neutrinos (as opposed to emission through electromagnetic processes), and to the fraction of collapsar events leading to GRBs. The predicted neutrino flux varies over many orders of magnitude as the values of unknown model parameters are varied. We investigate the detection possibility of thermal neutrinos from collapsars which lead to GRBs by TITAND. We find that the GRB neutrino background might be detected by TITAND within 10 yrs only for the optimistic cases in which the average mass–accretion rate is high ( a few M s⁻¹), and the probability that one collapsar generates a GRB is high (f=0.5–1.0).