CUTLASS Finland radar observations of the ionospheric signatures of flux transfer events and the resulting plasma flows

The CUTLASS Finland radar has been run in a two-beam special scan mode, which offered excellent temporal and spatial information on the flows in the high-latitude ionosphere. A detailed study of one day of this data revealed a convection reversal boundary (CRB) in the CUTLASS field of view (f.o.v) on the dayside, the direction of plasma flow either side of the boundary being typical of a dawn-cell convection pattern. Poleward of the CRB a number of pulsed transients are observed, seemingly moving away from the radar. These transients are identified here as the ionospheric signature of flux transfer events (FTEs). Equatorward of the CRB continuous backscatter was observed, believed to be due to the return flow on closed field lines. The two-beam scan offered a new and innovative opportunity to determine the size and velocity of the ionospheric signatures associated with flux transfer events and the related plasma flow pattern. The transient signature was found to have an azimuthal extent of 1900 ± 900 km and an poleward extent of 250 km. The motion of the transient features was in a predominantly westward azimuthal direction, at a velocity of 7.5 ± 3 km.     

Boundary-layer depth and entrainment zone characterization with a boundary-layer profiler

A technique for determining the height of the convective atmospheric boundary layer (CBL) with a 915 MHz boundary-layer profiler is discussed. The results are compared with CBL heights determined from radiosonde measurements. The profiler provides continuous CBL height measurements with very good time resolution (30 minutes or less), allowing for detailed understanding of the growth and fluctuations of the CBL. In addition, the profiler provides information about the degree of definition of the CBL top and the thickness of the entrainment zone. The measurements discussed were taken during the Rural Oxidants in the Southern Environment II (ROSE II) experiment.     

Steady models for the hard X-ray loops in the solar corona

In some gradual hard X-ray bursts with high intensity, hard X-ray source (15–40 keV) is steadily located in the corona along with softer X-ray source (5–10 keV).Two stationary models, high density and high temperature models, are proposed to solve the difficult problem of confinement of hot (or nonthermal) plasma in the direction of the magnetic field along the loops in the corona. In both models, an essential point is that the effective X-ray source is composed of fine dense filamentary loops imbeded in a larger rarefied coronal loop, and the electron number density in the filaments is so high as 10¹¹–10¹² cm^-3. If the density is so high heat conduction can be as reasonably small as of the order of 10²⁷ erg s ^-1 for the given emission measures of observed X-rays, since the required cross-sectional area is small and also classical conduction is valid. Collisional confinement of thermal tail, and nonthermal electrons if any, up to 50–60 keV in the filaments is also possible, so that the hard X-ray images can be loop like structure instead of double source (foot points).High density model is applicable to the coronal filamentary loops with temperature T _m < 5 × 10⁷ K at the loop summit. The heat flow from the summit downwards is lost almost completely by the radiation from the loop during the conduction to the foot points. A continuous energy release is assumed near the summit to maintain the stationary temperature T _m, and pressure balance is maintained along the loop. In this model, the number density at the summit is given by n _m - 10⁶ T _m ² /s_m, where s _m is the length of the loop from the summit to the foot point, and the distribution of temperature and density along the loop are given by T = T _m(s/s_m)^1/3 and n = n _m(s/s_m)^-1/3, respectively.High temperature model is applicable to the filamentary loops with higher temperature up to about 10^8.5 K and comparatively lower number density as 10¹¹ cm^-3 for the requirement of magnetic confinement of the hot plasma in radial direction. The radiation from the loop is negligibly small in this model so that the heat flux is nearly conserved down to the foot points. In this case, temperature gradient is smaller than that of the high density model, depending on the tapering of the magnetic bottle.In both models, the differential emission measure is maximum at the highest temperature T _m and the brightness distribution along the loop shows a maximum around the summit of the loop if some magnetic tapering is taken into account.     

Experiments on steady buoyancy transfer through turbulent fluid layers separated by density interfaces

A laboratory experiment was performed to investigate mixing across a density interface which separates two turbulent fluid layers and coexists with a stabilizing buoyancy flux. It was found that the buoyancy flux (q₀) across the interface and through the turbulent layers (of depth D) becomes steady and constant in magnitude in the vertical direction, only when , where u is the horizontal r.m.s. velocity at the base of the mixed layers. The results suggest that mixing across the density interface is controlled by a dynamically important buoyancy gradient induced in the turbulent layers and that parameters such as the bulk Richardson number, , where Δb is the interfacial buoyancy jump, are of secondary importance. Measurements are used to infer the mixing mechanism at the interface, the mixing efficiency of stratified fluids and the entrainment law. Some geophysical applications of the results are also discussed.     

Influence of salinity on permeability characteristics of marine sediments

Abstract

Laboratory tests were conducted on compacted marine sediments to study the effect of salt concentration of permeating fluid on its permeability characteristics. Deep sea sediment samples were collected from water depths varying from 3700 to 4500 m off Mauritius coast. Liquid limit and plasticity index varied widely from 45 to 75 and 10 to 35, respectively. Permeability was found at different void ratios with distilled water and 0.2, 0.4, and 0.8 N NaCl solutions as permeating fluid. It was found that permeability increases with an increase in salt concentration for a given void ratio. This is explained by diffused double layer theory. Also, the rate of increase in permeability decreases with increase in salt concentration. The effect of salt concentration seemed to be less at higher void ratios.