The biogeochemical sulfur cycle in the marine boundary layer over the Northeast Pacific Ocean

The major components of the marine boundary layer biogeochemical sulfur cycle were measured simultaneously onshore and off the coast of Washington State, U.S.A. during May 1987. Seawater dimethylsulfide (DMS) concentrations on the continental shelf were strongly influenced by coastal upwelling. Concentration further offshore were typical of summer values (2.2 nmol/L) at this latitude. Although seawater DMS concentrations were high on the biologically productive continental shelf (2–12 nmol/L), this region had no measurable effect on atmospheric DMS concentrations. Atmospheric DMS concentrations (0.1–12 nmol/m³), however, were extremely dependent upon wind speed and boundary layer height. Although there appeared to be an appreciable input of non-sea-salt sulfate to the marine boundary layer from the free troposphere, the local flux of DMS from the ocean to the atmosphere was sufficient to balance the remainder of the sulfur budget.     

Intraplate deformation and 3D rheological structure of the Rhine Rift System and adjacent areas of the northern Alpine foreland

The lithosphere of the Northern Alpine foreland has undergone a polyphase evolution during which interacting stress-induced intraplate deformation and upper mantle thermal perturbations controlled folding of the thermally weakened lithosphere. In this paper we address relationships among deeper lithospheric processes, neotectonics and surface processes in the Northern Alpine foreland with special emphasis on tectonically induced topography. We focus on lithosphere memory and neotectonics, paying special attention to the thermo-mechanical structure of the Rhine Graben System and adjacent areas of the northern Alpine foreland lithosphere. We discuss implications for mechanisms of large-scale intraplate deformation and links with surface processes and topography evolution.     

TEM study of a special grain boundary in a synthetic K-feldspar bicrystal: Manebach Twin

 A monoclinic KAlSi₃O₈ feldspar Manebach twin boundary was synthesized by diffusion bonding and examined using high-resolution transmission electron microscopy. The sharp (001) twin boundary is straight and free of strain. The boundary width is smaller than d₀₀₁. There is no rigid body shift observed at the twin boundary, and the feldspar structure is arranged symmetrically across (001). The twin boundary structure consists of bridged tetrahedral crankshafts, which are characteristic of the feldspar lattice. The grain boundary structure is in good agreement with the geometrical model of Taylor et al. (1934). The grain boundary composition of K_1/2H_1/2AlSi₃O₈ differs from their model. Received: 13 February 2002 / Accepted: 24 December 2002 Acknowledgements We thank M. Rühle, S. Hutt, J. Mayer, A. Strecker and U. Salzberger at MPI, Stuttgart, for their support and valuable advice in preparing TEM sections of bicrystals.     

Inverse Analysis of Deep Excavation Using Differential Evolution Algorithm

This paper presents the applications of the differential evolution (DE) algorithm in back analysis of soil parameters for deep excavation problems. A computer code, named Python‐based DE, is developed and incorporated into the commercial finite element software ABAQUS, with a parallel computing technique to run an FE analysis for all trail vectors of one generation in DE in multiple cores of a cluster, which dramatically reduces the computational time. A synthetic case and a well‐instrumented real case, that is, the Taipei National Enterprise Center (TNEC) project, are used to demonstrate the capability of the proposed back‐analysis procedure. Results show that multiple soil parameters are well identified by back analysis using a DE optimization algorithm for highly nonlinear problems. For the synthetic excavation case, the back‐analyzed parameters are basically identical to the input parameters that are used to generate synthetic response of wall deflection. For the TNEC case with a total of nine parameters to be back analyzed, the relative errors of wall deflection for the last three stages are 2.2, 1.1, and 1.0%, respectively. Robustness of the back‐estimated parameters is further illustrated by a forward prediction. The wall deflection in the subsequent stages can be satisfactorily predicted using the back‐analyzed soil parameters at early stages. Copyright © 2014 John Wiley & Sons, Ltd.     

Energetic protons from the solar flare of March 24, 1966

Ten to 100 meV protons from the solar flare of March 24, 1966 were observed on the University of California scintillation counter on OGO-I. The short rise and decay times observed in the count rates of the 32 channels of pulse-height analysis show that scattering of the protons by the interplanetary field was much less important in this event than in previously observed proton flares. A diffusion theory in which D = M _r is found to be inadequate to account for the time behavior of the count rates of this event. Small fluctuations of the otherwise smooth decay phase may be due to flare protons reflected from the back of a shock front, which passed the earth on March 23.     

A glancing incidence solar telescope for the soft x-ray region

This paper describes the instrumentation of an Aerobee rocket (NASA 4.95 GS) which was launched from White Sands Missile Range on May 20th 1966, to observe the Sun in the soft X-ray region. The experiment package, which was pointed at the sun by a control system stabilized about all three axes, carried two Wolter type I glancing incidence telescopes to photograph the sun in wavelength regions (determined by bandpass filters) between 3 and 75 Å, and two proportional counters to obtain flux data and rough spectral shapes in the regions 2–11 Å and 8–20 Å. The spatial resolution obtained was about 20 arc seconds. Limb brightening and polar darkening are very pronounced at the longer wavelengths. A tuft of emission was observed at the North Pole in addition to an arch-like structure on the NW limb. Several of the photographs are presented, and some preliminary results are discussed.     

Sea-level rise and flooding in coastal riverine flood plains

Abstract

This work presents a method for calculating the contributions of sea-level rise and urban growth to flood risk in coastal flood plains. The method consists of hydraulic/hydrological, urban growth and flood-damage quantification modules. The hydraulic/hydrological module estimates peak annual flows to generate flood stages impacted by sea-level rise within flood plains. A model for urban growth predicts patterns of urbanization within flood plains over the period 2010–2050. The flood-damage quantification module merges flood maps and urbanization predictions to calculate the expected annual flood damage (EAFD) for given scenarios of sea-level rise. The method is illustrated with an application to the Tijuana River of southern California, USA, and northwestern Mexico, where the EAFD is predicted to increase by over US$100 million because of sea-level rise of 0.25–1.0 m and urban growth by the year 2050. It is shown that urbanization plays a principal role in increasing the EAFD in the study area for the range of sea-level rise considered.

Editor Z.W. Kundzewicz

Citation Garcia, E.S. and Loáiciga, H.A., 2013. Sea-level rise and flooding in coastal riverine flood plains. Hydrological Sciences Journal, 59 (1), 204–220.     

Dissolved oxygen variations in alpine glacial meltwaters

Recent models of chemical weathering in alpine glacial meltwaters suggest that sulphide oxidation is a major source of solute in the distributed component of the subglacial hydrological system. This reaction requires O₂, and may lower dissolved oxygen levels to below saturation with respect to the atmosphere. This should result in an inverse association between SO₇^2- and dissolved oxygen saturation. However, measurements of O₂ saturation in bulk meltwaters draining the Haut Glacier d'Arolla, Switzerland, show that there is a positive association between SO₄^2- and O₂ saturation. The O₂ content of glacial meltwaters depends on the initial content of snow and icemelt, which may be controlled by the rate of melting, and the kinetic balance between O₂ losses (e.g. sulphide oxidation, microbial respiration) and gains (e.g. diffusion of O₂ into solution).     

Tropospheric Ozone in a Global-Scale Three-Dimensional Lagrangian Model and Its Response to NOX Emission Controls

A three-dimensional Lagrangian tropospheric chemistry modelis used toinvestigate the impact of human activities on the tropospheric distributionofozone and hydroxyl radicals. The model describes the behaviour of 50 speciesincluding methane, carbon monoxide, oxides of nitrogen, sulphur dioxide andnineorganic compounds emitted from human activities and a range of other sources.Thechemical mechanism involves about 100 chemical reactions of which 16 arephotochemical reactions whose diurnal dependence is treated in full. The modelutilises a five minute chemistry time step and a three hour advection timestepfor the 50,000 air parcels. Meteorological data for the winds, temperatures,clouds and so on are taken from the UK Meteorological Office global model for1994 onwards. The impacts of a 50% reduction in European NO_Xemissions onglobal ozone concentrations are assessed. Surface ozoneconcentrations decrease in summertime and rise in wintertime, but to differentextents.