南汽试车跑道精密施工测量

介绍采用微型短边线形三角控制网、强制归心技术、独立前方交会成功的、高质量、高精度、高效益完成南汽试车跑道精密施工测量，希望能为类似工程测量提供一定的参考。(摘要修改)     

某大厦深基坑开挖与施工安全监测实践与体会

从深基坑安全监测实例出发,介绍了一种简便、易行、稳定、可靠的射线形水平位移基准网,同时适用用小角法高精度位移监测.另外就温度的变化对水平位移值的影响,降水施工对地面沉降,深层土体位移的影响及测斜管埋设的重要性提出了自己的观点、认识与体会,希望对类似工程有一定参考价值.     

人造热带气旋垂直结构问题初探

在人造热带气旋中引入了倾斜垂直结构，并将其用于西折后9806号热带气旋登陆路径的数值模拟。结果表明：应用该方案所得到的模拟结果优于应用正压结构的人造热带气旋方案的模拟结果要准确。因此，此类热带气旋的预报中，其初始涡旋可采用倾斜垂直结构，从而提出改进热带气旋初始涡旋的一种新思路。若对其作进一步研究、推广，则具有广阔的业务应用前景。     

An algorithm for determination of aerosol opticalthickness from AVHRR imagery over oceans

Summary The uncertainty in aerosol size distributions is a main source of errors in aerosol optical thickness determined from satellite measurements. To reduce the errors resulting from the uncertainty in aerosol size distributions, we have performed sensitivity analyses. It is found the errors resulting from the uncertainty in aerosol size distribution can be considerably reduced by using the Junge power law to approximate the aerosol size distribution in an actual atmosphere, if the exponent value is determined at the same time. An iterative algorithm is then developed for the simultaneous determination of aerosol optical thickness and the exponent of the Junge power law over ocean areas from the upwelling radiances measured in AVHRR visible and near infrared channels. A number of numerical experiments are carried out to investigate the validity of the Junge power law approximation by assuming the aerosol size distributions in an actual atmosphere are bimodal with different mode parameters, and by using the actual aerosol size distributions determined at several places by Kaufman et al. (1994). The results show that the errors in determined aerosol optical thickness resulting from the Junge power law approach are significantly reduced. The iterative algorithm is investigated further by comparing the aerosol optical thickness deduced from satellite measurement with that observed by a sun photometer. Received October 10, 2001 Revised December 28, 2001     

江西银山多金属矿床伊利石的形成与流体成矿作用的初步研究

江西银山多金属矿床的热液蚀变粘土矿物主要由伊利石组成,伊利石主要由流体作用过程中长石的伊利石化形成,其结晶度与成矿流体作用密切相关.银山第1期铅锌银成矿作用,水/岩比相对较低,成矿流体以孔隙渗透为主,溶质迁移慢,形成含有少量膨胀层的伊利石;第2期铜金成矿作用,水/岩比相对较高,流体的运移方式以通道式或裂隙式为主,溶质迁移的速度快,形成不含膨胀层的伊利石.研究表明成矿作用过程中的伊利石化主要与铅锌银矿化有关,而绿泥石化与铜金矿化有关.     

DGSC—203型液动射流冲击器在地热井的试验

介绍了新研制的DGSC－203石油钻井液动射液冲击器的性能参数及结构设计上的创新点，测试所获得的排量与压降之间的关系曲线可指导冲击器的使用。生产性试验证明该冲击器工作稳定，可大幅度提高硬地层钻井效率，克服钻柱振动，延长钻柱的使用寿命，具有良好应用前景。     

古炭屑与古森林火?

森林火普遍发生在地质历史时期中，它对自然植被系统的演替起着重要作用。不同强度和频率的森林火培育出不同类型的植被：频繁的森林火导致草甸的形成，而热带雨林形成的原因之一是森林火的缺乏。古炭屑作为古森林火的遗迹，具有分布广泛、细胞结构保存完好以及原地埋藏等特点，为研究古森林火发生的强度和频率提供了宝贵的材料。古炭屑的出现与当时的气候因素、植被类型和地理状况有密切关系：干旱、少雨的气候常常伴随高频率森林火的发生，表现出古炭屑的数量增多；易燃物种组成的植被易发生森林火，古炭屑的出现也会增多，而耐火树种会降低森林火的强度，古炭屑则出现少。因此，从古炭屑的数量和种类的变化，可探讨古森林火的发生规律，进而推断长期地质历史时期的气候、植被、地理状况的演变。     

论卡以头组的时代

中国科学院南京地质古生物研究所的有关人员 (1980 )曾做过大量地层古生物工作 ,证实卡以头砂页岩层或卡以头组的时代为三叠纪最早期 ,是飞仙关组底部地层的相变。“论卡以头组”一文认为该组下部的时代为二叠纪 ,上部则属三叠纪。对该文提供的地层古生物资料进行分析后 ,本文作者认为该论点缺乏证据 ,不能成立 ;将陆相的威宁哲觉剖面代替标准地点宣威羊场的过渡相剖面作为卡以头组的标准剖面 ,也是不合适的     

沐川太平砂岩型铼钼（饿）矿点的地质特征和矿化时代

四川沐川县民主-太平-带含钼砂岩为一新矿化类型——沉积砂岩型铼钼（锇）矿点。X-射线粉晶衍射分析结果表明其中微-细晶鳞片状含钼矿物为晶质辉钼矿；高精度质谱分析发现辉钼矿中分散元素Re和铂族元素Os含量很高，具有重要的综合利用价值；高精度Re-Os同位素测年证明辉钼矿形成年龄与含矿的中生代红物学和矿床学均具有重要的理论意义和应用价值。     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.