Mars surface properties observed by earth-based radar at 70-, 12.5-, and 3.8-cm wavelengths

A review of Mars radar data obtained through the 1973 opposition confirms that the surface of the planet has many diverse characteristics. Analysis of the quasi-specular echo component shows changes in apparent reflectivity of at least 5 to 1. If attributed entirely to variations in surface material, these correspond to dielectric constants between 1.6 and 4.0. Values of rms surface slope on 1- to 100-m scales range from as low as 0.5° in tablelands near Vlles Marineris to more than 3.0° (the upper limit for which these analysis techniques are appropriate) in certain other areas such as inside Coprates Chasma itself. There is weak correlation between the small-scale surface characteristics inferred from radar and those inferred from Mariner 9 images, geologic maps derived from those images, and other remote sensing data sets. Topography, a large-scale surface characteristic for which good correlation exists between radar and other data sets, was not considered in this study. A search for guidelines which would allow extrapolation of radar properties to new areas on the basis of those studied has been singularly unsuccessful. Data obtained during the 1973 opposition at Arecibo, Goldstone, and Haystack Observatories indicate that the scattering behavior of Mars varies little over the 70- to 3.8-cm wavelength range. Comparison of 1971 and 1973 Goldstone results shows no detectable variation with time.     

Updated Expressions for Determining Temperatures and Emission Measures from Goes Soft X-Ray Measurements

{We investigate the conversion of the 0.5–4 and 1–8 Å soft X-ray flux measurements made by detectors on the Geostationary Operational Environmental Satellites (GOES) into temperature and emission measures of coronal plasma using modern spectral models and modern understanding of coronal abundances. In particular, the original analysis by Thomas, Starr and Crannell (1985) is updated to take into account the realization that coronal abundances may be quite different from photospheric abundances. An important result of this analysis is that the derived temperatures and emission measures depend strongly on the assumed abundances even at high temperatures where continuum rather than spectral lines dominates the Sun’s X-ray spectrum. This occurs because the higher coronal abundances mean that most of the continuum is due to free–bound emission processes, not free–free emission, and thus is abundance-dependent. We find significant differences between modern calculations of the temperature response of the flux measurements and the versions currently in use: for a typical flare, emission measures may be up to a factor of 4 smaller than the current software suggests. Derived temperatures are similar for both photospheric and coronal abundances for cool flares (e.g., 15 MK), but for hot flares (e.g., 35 MK) coronal abundances can lead to significantly (~25%) lower temperatures being derived.     

Self-similar shocked accretion of collisional gas with radiative cooling

We describe similarity solutions that characterize the collapse of collisional gas on to scale-free perturbations in an Einstein–de Sitter universe. We consider the effects of radiative cooling and derive self-similar solutions under the assumption that the cooling function is a power law of density and temperature, Λ( T , ρ )∝ ρ ^3/2 T . We use these results to test the ability of smooth particle hydrodynamics (SPH) techniques to follow the collapse and accretion of shocked, rapidly cooling gas in a cosmological context. Our SPH code reproduces the analytical results very well in cases that include or exclude radiative cooling. No substantial deviations from the predicted central mass accretion rates or from the temperature, density and velocity profiles are observed in well-resolved regions inside the shock radius. This test problem lends support to the reliability of SPH techniques to model the complex process of galaxy formation.     

The depletion of carbon by extra mixing in metal-poor giants

There is an apparent dichotomy between the metal-poor  ([Fe/H]≤−2)  yet carbon-normal giants and their carbon-rich counterparts. The former undergo significant depletion of carbon on the red giant branch after they have undergone first dredge-up, whereas the latter do not appear to experience significant depletion. We investigate this in the context that the extra mixing occurs via the thermohaline instability that arises due to the burning of  ³He  . We present the evolution of [C/Fe], [N/Fe] and  ¹²C/¹³C  for three models: a carbon-normal metal-poor star, and two stars that have accreted material from a  1.5 M_⊙  AGB companion, one having received  0.01 M_⊙  of material and the other having received  0.1 M_⊙  . We find the behaviour of the carbon-normal metal-poor stars is well reproduced by this mechanism. In addition, our models also show that the efficiency of carbon-depletion is significantly reduced in carbon-rich stars. This extra-mixing mechanism is able to reproduce the observed properties of both carbon-normal and carbon-rich stars.     

Spectral properties and composition of potentially hazardous Asteroid (99942) Apophis

The known close approach of Asteroid (99942) Apophis in April 2029 provides the opportunity for the case study of a potentially hazardous asteroid in advance of its encounter. The visible to near-infrared (0.55 to 2.45 μm) reflectance spectrum of Apophis is compared and modeled with respect to the spectral and mineralogical characteristics of likely meteorite analogs. Apophis is found to be an Sq-class asteroid that most closely resembles LL ordinary chondrite meteorites in terms of spectral characteristics and interpreted olivine and pyroxene abundances, although we cannot rule out some degree of partial melting. A meteorite analog allows some estimates and conjectures of Apophis' possible range of physical properties such as the grain density and micro-porosity of its constituent material. Composition and size similarities of Apophis with (25143) Itokawa suggest a total porosity of 40% as a “current best guess” for Apophis. Applying these parameters to Apophis yields a mass estimate of 2×¹⁰¹⁰ kg with a corresponding energy estimate of 375 Mt for its potential hazard. Substantial unknowns, most notably the total porosity, allow uncertainties in these mass and energy estimates to be as large as factors of two or three.     

The Puerto Lápice eucrite

Abstract— Puerto Lápice is a new eucrite fall (Castilla‐La Mancha, Spain, 10 May 2007). In this paper, we report its detailed petrography, magnetic characterization, mineral and bulk chemistry, oxygen and noble gas isotope systematics, and radionuclide data. Study of four thin sections from two different specimens reveal that the meteorite is brecciated in nature, and it contains basaltic and granulitic clasts, as well as recrystallized impact melt and breccia fragments. Shock veins are ubiquitous and show evidence of at least three different shock events. Bulk chemical analyses suggest that Puerto Lápice belongs to the main group of basaltic eucrites, although it has a significantly higher Cr content. Oxygen isotopes also confirm that the meteorite is a normal member of the HED suite. Noble gas abundances show typical patterns, with dominant cosmogenic and radiogenic contributions, and indicate an average exposure age of 19 ± 2 Ma, and a Pu‐fission Xe age well within typical eucrite values. Cosmogenic radionuclides suggest a preatmospheric size of about 20–30 cm in diameter.     

A reanalysis of the Apollo light scattering observations, and implications for lunar exospheric dust

Conspicuous excess brightness, exceeding that expected from coronal and zodiacal light (CZL), was observed above the lunar horizon in the Apollo 15 coronal photographic sequence acquired immediately after orbital sunset (surface sunrise). This excess brightness systematically faded as the Command Module moved farther into shadow, eventually becoming indistinguishable from the CZL background. These observations have previously been attributed to scattering by ultrafine dust grains (radius ∼0.1 microns) in the lunar exosphere, and used to obtain coarse estimates of dust concentration at several altitudes and an order-of-magnitude estimate of ∼10⁻⁹ g cm⁻² for the column mass of dust near the terminator, collectively referred to as model “0”.We have reanalyzed the Apollo 15 orbital sunset sequence by incorporating the known sightline geometries in a Mie-scattering simulation code, and then inverting the measured intensities to retrieve exospheric dust concentration as a function of altitude and distance from the terminator. Results are presented in terms of monodisperse (single grain size) dust distributions. For a grain radius of 0.10 microns, our retrieved dust concentration near the terminator (∼0.010 cm⁻³) is in agreement with model “0” at z=10 km, as is the dust column mass (∼3–6×10⁻¹⁰ g cm⁻²), but the present results indicate generally larger dust scale heights, and much lower concentrations near 1 km (<0.08 cm⁻³ vs. a few times 0.1 cm⁻³ for model “0"). The concentration of dust at high altitudes (z>50 km) is virtually unconstrained by the measurements. The dust exosphere extends into shadow a distance somewhere between 100 and 200 km from the terminator, depending on the uncertain contribution of CZL to the total brightness. These refined estimates of the distribution and concentration of exospheric dust above the lunar sunrise terminator should place new and more rigorous constraints on exospheric dust transport models, as well as provide valuable support for upcoming missions such as the Lunar Atmosphere and Dust Environment Explorer (LADEE).