Deep structure of the Central Alps in the light of recent seismic data

The deep seismic reflection traverses across the Central Alps (NFP 20, ECORS-CROP) contain a new set of data on the lower crust which has been interpreted in different ways. One currently fashionable model depicts the European lower crust (ELC) as gently dipping below the Adriatic crust. However, this model requires that an observed sharp termination of the ELC under the internal border of the External Massifs is due to the non-transmission of organized seismic energy through the complex upper crust. This explanation is questioned as other reflections in this and similarly complex areas are recorded, and as the same sharp termination of the ELC under the internal border of the External Massifs is observed on all seismic lines for a length of 300 km. A tectonic — metamorphic cause appears to more satisfactorily explain the obeservations, and therefore an alternative model combining surface and deep geophysical data is proposed. It consists of three mutually largely decoupled tectonic levels. (1) The shallow obducted part or lid, bounded at its base by the combined Late Miocene Jura and Lombardic basal thrusts. Estimates of shortening based on balanced sections are at least about 100 km. (2) The intermediate level between the brittle-ductile transition and the top of the subducted mantle. It contains a stack of lower crust imbrications (with a minor admixture of upper mantle) accommodated by (inducted into) the ductile middle crust. Estimates of shortening based on area balancing are again of the order of slightly more than 100 km. (3) The subducted upper mantle, for which there are no reflection data.In the Central Alps the Late Miocene phase was dextrally transpressive, producing flower structures at the shallow level (External Massifs); the stacks of lower crust imbrications at the intermediate level may be the equivalent of the External Massifs at that level. Inverted flower structures of the subducted mantle are possible, but no detailed data are available.     

Inner part observation of theβ pictoris disk

The inner regions of the circumstellar disk around Pictoris might be dust-free due to a possible planet which may have cleared up dust particles. We present a new observational technique based on the use of an anti-blooming CCD in order to directly image this zone. The structure of the disk is revealed down to 2 arcsec from the star (30 AU). We show that the Pic disk brightness is neutral inV, R, andI _C , but drops down when going inward inB, possibly related to a change in the dust composition. Also, a slight disk asymmetry is present but inverted from the outer to the inner zones.Paper presented at the Conference onPlanetary Systems: Formation, Evolution, and Detection held 7–10 December, 1992 at CalTech, Pasadena, California, U.S.A.     

Long,accurate time series measurements of radial velocities of solar-type stars

We have been measuring changes in the radial velocities (RV's) of solar-type stars to search for gravitational perturbations by planets. We transmit violet starlight through a Fabry-Perot etalon interferometer and sense changes in Doppler shift from changes in the fluxes of light on the slopes of stellar absorption lines. Our data now span 6 years. Our observations of the Sun showed earlier that both our technique and the profiles of solar photospheric violet absorption lines can be stable enough to reveal planetary perturbations. We now carry this validation to the spectra of other near-solar-type stars. Annual averages of our RV's of Draconis and Virginis are stable to ±6 m s^–1. The slope of our five-year series of RV's of Bootis A is consistent with the star's well-determined visual astrometric orbit about Bootis B. The Fabry-Perot technique of Doppler shift measurement is fully capable of detecting perturbations due to planets with masses and orbits similar to those of Jupiter.Paper presented at the Conference onPlanetary Systems: Formation, Evolution, and Detection held 7–10 December, 1992 at CalTech, Pasadena, California, U.S.A.     

A coronal loop model for the production of X-ray and radio flares in the RS CVn binary HR 1099

The RS CVn binary stellar system HR 1099 is a source of both X-ray and radio flares. We present here a model of the system in which the two types of flare are produced by the same population of mildly-relativistic ( 10) electrons, injected into a coronal loop. After reviewing possible radiation mechanisms we conclude that, given the probable conditions in the flaring region, the radio emission is gyrosynchrotron radiation and the X-ray emission is thermal bremsstrahlung. The thermal X-ray source must lie in the stellar chromosphere, but the apparent absence of plasma absorption at radio frequencies indicates that the radio source is located high in the coronal loop. Using the relationships given by Dulk and Marsh (1982) for the radio emission from a power-law electron energy spectrum,N() ( - 1)^–, we conclude that 3 7, with 30% of the electron population trapped in the radio source. Some implications of these results for one particular version of the model are discussed.     

Nonthermal radio emission from hot star winds

Nonthermal radio emission has been observed from some of the most luminous hot star winds. It is understood to be synchrotron radiation of the relativistic electrons in the winds. To understand how the electrons are accelerated to such high energies and to correctly explain the observed radio flux and spectra require an exhaustive investigation of all the relevant physical processes involved and possibly point to a complex wind structure. In this paper we discuss the logical path toward a comprehensive model of the nonthermal radio emission from hot star winds. Based on the available observational data and fundamental theoretical considerations, we found that the only physically viable and self-consistent scenario is:the nonthermal radio emission is synchrotron radiation of relativistic electrons the electrons are accelerated by shocks via the first-order Fermi mechanism the acceleration has to be in situ in the radio emitting region the shocks formed at the base of the winds have to propagate to beyond the radio photosphere).     

Clouds, hazes, and the stratospheric methane abundance in Neptune

Analysis of high-spatial-resolution (approximately 0.8 arcsec) methane band and continuum imagery of Neptune's relatively homogeneous Equatorial Region yields significant constraints on (1) the stratospheric gaseous methane mixing ratio (fCH4,s), (2) the column abundances and optical properties of stratospheric and tropospheric hydrocarbon hazes, and (3) the wavelength-dependent single-scattering albedo of the 3-bar opaque cloud. From the center-to-limb behavior of the 7270-angstroms and 8900-angstrom sCH4 bands, the stratospheric methane mixing ratio is limited to fCH4,s < 1.7 x 10(-3), with a nominal value of fCH4,s = 3.5 x 10(-4), one to two orders of magnitude less than pre-Voyager estimates, but in agreement with a number of recent ultraviolet and thermal infrared measurements, and largely in agreement with the tropopause mixing ratio implied by Voyager temperature measurements. Upper limits to the stratospheric haze mass column abundance and 6190-angstroms and 8900-angstroms haze opacities are 0.61 microgram cm-2 and 0.075 and 0.042, respectively, with nominal values of 0.20 microgram cm-2 and 0.025 and 0.014 for the 0.2-micrometer radius particles preferred by the recent Voyager PPS analysis of Pryor et al. (1992, Icarus 99, 302-316). The tropospheric CH4 haze opacities are comparable to that found in the stratosphere, upper limits of 0.104 and 0.065 at 6190 angstroms and 8900 angstroms, respectively, with nominal values of 0.085 and 0.058. This indicates a column abundance less than 11.0 micrograms cm-2, corresponding to the methane gas content within a well-mixed 3% methane tropospheric layer only 0.1 cm thick near the 1.5-bar CH4 condensation level. Constraints on the single-scattering albedos of these hazes include (1) for the stratospheric component, 6190-angstroms and 8900-angstroms imaginary indices of refraction less than 0.047 and 0.099, respectively, with 0.000 (conservative scattering) being the nominal value at both wavelengths, and (2) CH4 haze single-scattering albedos greater than 0.85 and 0.50 at these two wavelengths, with conservative scattering again begin the preferred value. However, conservative scattering is ruled out for the opaque cloud near 3 bars marking the bottom of the visible atmosphere. Specifically, we find cloud single-scattering albedos of 0.915 +/- 0.006 at 6340 angstroms, 0.775 +/- 0.012 at 7490 angstroms, and 0.803 +/- 0.010 at 8260 angstrom. Global models utilizing a complete global spectrum confirm the red-absorbing character of the 3-bar cloud. The global-mean model has approximately 7.7 times greater stratospheric aerosol content then the Equatorial Region. An analysis of stratospheric haze precipitation rates indicates a steady-state haze production rate of 0.185-1.5 x 10(-14) g cm-2 sec-1, in agreement with recent theoretical photochemical estimates. Finally, reanalysis of the Voyager PPS 7500-angstroms phase angle data utilizing the fCH4,s value derived here confirms the Pryor et al. result of a tropospheric CH4 haze opacity of a few tenths in the 22-30 degrees S latitude region, several times that of the Equatorial Region or of the globe. The factor-of-10 reduction in fCH4,s below that assumed by Pryor et al. implies decreased gas absorption and consequently a decrease in the forward-scattering component of tropospheric aerosols.     

A photochemical model of the martian atmosphere

The factors governing the amounts of CO, O2, and O3 in the martian atmosphere are investigated using a minimally constrained, one-dimensional photochemical model. We find that the incorporation of temperature-dependent CO2 absorption cross sections leads to an enhancement in the water photolysis rate, increasing the abundance of OH radicals to the point where the model CO abundance is smaller than observed. Good agreement between models and observations of CO, O2, O3, and the escape flux of atomic hydrogen can be achieved, using only gas-phase chemistry, by varying the recommended rate constants for the reactions CO + OH and OH + HO2 within their specified uncertainties. Similar revisions have been suggested to resolve discrepancies between models and observations of the terrestrial mesosphere. The oxygen escape flux plays a key role in the oxygen budget on Mars; as inferred from the observed atomic hydrogen escape, it is much larger than recent calculations of the exospheric escape rate for oxygen. Weathering of the surface may account for the imbalance. Quantification of the escape rates of oxygen and hydrogen from Mars is a worthwhile objective for an upcoming martian upper atmospheric mission. We also consider the possibility that HOx radicals may be catalytically destroyed on dust grains suspended in the atmosphere. Good agreement with the observed CO mixing ratio can be achieved via this mechanism, but the resulting ozone column is much higher than the observed quantity. We feel that there is no need at this time to invoke heterogeneous processes to reconcile models and observations.     

Rate constants for the reactions of the NO3 radical with HCOOH/HCOO− and CH3COOH/CH3COO− in aqueous solution between 278 and 328 K

The kinetics of the aqueous phase reactions of NO₃ radicals with HCOOH/HCOO^– and CH₃COOH/CH₃COO^– have been investigated using a laser photolysis/long-path laser absorption technique. NO₃ was produced via excimer laser photolysis of peroxodisulfate anions (S₂O ₈ ^2– ) at 351 nm followed by the reactions of sulfate radicals (SO ₄ ^– ) with excess nitrate. The time-resolved detection of NO₃ was achieved by long-path laser absorption at 632.8 nm. For the reactions of NO₃ with formic acid (1) and formate (2) rate coefficients ofk ₁=(3.3±1.0)×10⁵ l mol^–1 s^–1 andk ₂=(5.0±0.4)×10⁷ l mol^–1 s^–1 were found atT=298 K andI=0.19 mol/l. The following Arrhenius expressions were derived:k ₁(T)=(3.4±0.3)×10¹⁰ exp[–(3400±600)/T] l mol^–1 s^–1 andk ₂(T)=(8.2±0.8)×10¹⁰ exp[–(2200±700)/T] l mol^–1 s^–1. The rate coefficients for the reactions of NO₃ with acetic acid (3) and acetate (4) atT=298 K andI=0.19 mol/l were determined as:k ₃=(1.3±0.3)×10⁴ l mol^–1 s^–1 andk ₄=(2.3±0.4)×10⁶ l mol^–1 s^–1. The temperature dependences for these reactions are described by:k ₃(T)=(4.9±0.5)×10⁹ exp[–(3800±700)/T] l mol^–1 s^–1 andk ₄(T)=(1.0±0.2)×10¹² exp[–(3800±1200)/T] l mol^–1 s^–1. The differences in reactivity of the anions HCOO^– and CH₃COO^– compared to their corresponding acids HCOOH and CH₃COOH are explained by the higher reactivity of NO₃ in charge transfer processes compared to H atom abstraction. From a comparison of NO₃ reactions with various droplets constituents it is concluded that the reaction of NO₃ with HCOO^– may present a dominant loss reaction of NO₃ in atmospheric droplets.     

Rice paddies as a methane source

Rice fields are considered to be among the highest sources of atmospheric methane, an important source of global warming. In order to meet the projected rice needs of the increasing world population, it is estimated that the annual world's rough rice production must increase to 760 million tons (a 65% increase) in the next 30 years. This will increase methane emissions from ricefields if current technologies are kept. Methane emissions from ricefields are affected by climate, water regime, soil properties, and various cultural practices like irrigation and drainage, organic amendments, fertilization, and rice cultivars. Irrigated rice comprises 50% of the world-harvested rice area and contributes 70% to total rice production. Because of assured flooding during the growing period it is the primary source of methane. Rainfed rice emits less methane due to periods of droughts. Upland rice, being never flooded for a significant period of time, is not a significant source of methane. There is great potential to develop no regret mitigation options that are in accordance with increasing rice production.     

Palomar prime-focus infrared camera (PFIRCAM)

In a joint effort between engineers and scientists at the Jet Propulsion Laboratory and the California Institute of Technology, a near-infrared (0.8–2.6 m) direct imaging system has been developed and integrated into the Caltech Palomar Observatory detector series. The camera system has been tested and operated in a science mode at the prime-focus (f/3.3) of the Hale 5-m Telescope. This paper outlines the system components and performance, including discussion of the detector linearity.