Saturn's electrostatic discharges: Could lightning be the cause?

It is proposed that Saturn's electrostatic discharges (SED) might be generated in the planet's equatorial atmosphere, perhaps as lightning from a storm system. The 10^h10^m periodicity of the signal envelope duplicates that of Saturn's equatorial jet. The rings shield the atmosphere from solar EUV photons, and thereby substantially reduce the local ionospheric cutoff frequency to allow low-frequency SED to leak out. Many of the unusual properties of SED could be explained in terms of changes in the storm system, the relative spacecraft position in the beaming pattern of the source, local refraction of the signal by the highly disturbed ionosphere, and the influence of the ring particles on the highest frequency component of SED. A comparison of SED with planetary lightning on other planets shows that the two are similar in general character and some time behavior; the power output of SED may be higher than most planetary lightnings but that is unclear because of uncertainties in the measurements and variations in the signal's spectrum. Our simple discussion suggests that lightning could be a viable source for SED and that exotic ring mechanisms are not necessarily required.     

On the warming of intermediate and deep waters in the equatorial North Atlantic

In July 2000, a transatlantic hydrographic section was made on board the Russian R/V Akademik Ioffe in the northern equatorial region at ～6.5° N on the WOCE (World Ocean Circulation Experiment) A06 line. A significant warming in the layers of intermediate and deep waters in the interior eastern basin is determined from comparison of the section temperature data and those obtained on the WOCE A06 line in 1993. This result, together with the results of the previous studies, indicates a substantial warming of intermediate and upper deep waters above 2800–3000 m in the eastern equatorial North Atlantic during the second half of the 20th century. In the 1000–2000 m layer, temperature has increased by 0.13–0.14°C since 1957.     

Biosorption of Rare-Earth Elements and Yttrium by Heterotrophic Bacteria in an Aqueous Environment

This paper reports the results of the experimental determination of the coefficient of sorption of rare-earth elements and yttrium (REY) under conditions of acidic pH using several strains of heterotrophic bacteria (Microbacterium sp., Curtobacterium sp., Bacillus subtilis, Pseudomonas putida, and Bacillus pumilis) that are widespread in natural and technogenic waters of the Far East (Russia). Insignificant fractionation between heavy and light rare-earth elements, negative cerium and dysprosium anomalies, and a positive europium anomaly were revealed. The selectivity of REY biosorption by gram-positive and gram-negative bacteria, as well as inertia of the biosorption process under more acidic conditions of the medium, were shown.     

PGE distribution in deformed lherzolites of the Udachnaya kimberlite pipe (Yakutia)

The results of the first study of the PGE distribution in deformed lherzolites of the Udachnaya kimberlite pipe (Yakutia) are presented here. The complex character of evolution of the PGE composition in the Deformed lherzolites is assumed to be the result of silicate metasomatism. At the first stage, growth in the amount of clinopyroxene and garnet in the rock is accompanied by a decrease in the concentration of the compatible PGE (Os, Ir). During the final stage, the rock is enriched with incompatible PGE (Pt, Pd) and Re possible due to precipitation of submicron-sized particles of sulfides in the interstitial space of these mantle rocks.     

Guided wave propagation in laterally varying media - II. Lg-waves in north-western Europe

Summary. Lg -wave observations at NORSAR from a sequence of explosions straddling the Central Graben in the North Sea, show that the phase is almost extinguished by passing through this structure. For models of the graben structure, based on seismic refraction experiments, with crustal thinning beneath a zone of thickened sediments, numerical modelling of Lg propagation shows very poor transmission. The inclusion of attenuation simulating the effects of scattering from faults and other complex structures further diminishes the transmittivity. The theoretical effect of a crustal pinch is to redistribute S energy over a wide range of groups velocities, a pattern that fits well with the observations.
Three components recordings at NORSAR of explosive charges fired in water covering a wide range of azimuths, show significant transverse components to the seismograms. The transverse energy builds up with travel time and for Lg is of the same order as the vertical component. These results are consistent with the theoretical prediction of progressive net transfer of energy from Rayleigh to Love modes as the wavetrain propagates through a three-dimensionally heterogeneous medium.     

VELOCITY DISPERSION OF SEISMIC WAVES*

In well velocity surveys made to calibrate Sonic (CV) Logs the calibration survey uses frequencies around 50 Hz whereas the Sonic Logging tool uses frequencies around 20 kHz. There thus exists the possibility of making a direct measure of velocity dispersion. In any one survey the disturbing factors, both instrumental and operational, will often mask any dispersive effect that might exist. Consequently this paper reports on a statistical analysis of the velocity differences resulting from calibration surveys and Sonic logs. Only Borehole Compensated Sonic Logs were used. Four areas were investigated: the North Sea, Abu Dhabi, Libya and Alaska. After rejecting logs and calibration records which were obviously in error there remained 424000 feet (about 130 km) of usable log distributed throughout 66 wells. The four areas were analysed separately and in no case was the estimated dispersion significantly different from zero. However, the mean values did correlate with lithology from (? 0.17 ± 0.18)% for the essentially carbonate section in Abu Dhabi to (+ 0.45 ± 0.25)% for the sand-shale section in Alaska, a positive sign meaning that the higher frequencies travelled faster. Except for Alaska the calibration surveys were made with a wall-clamp geophone, and for these areas amplitude measurements were made. After suitable corrections estimates of the absorption parameter Q were obtained. These varied from 20 to 200 with mean values of 63 for Libya, 70 for Abu Dhabi and 88 for the North Sea (excluding the Tertiary). If, as is usually assumed, the absorption mechanism is linear and is described by a Q which is independent of frequency, then these values would necessarily imply dispersion of several percent. As instanced above no such dispersion was observed. It is possible that the expected dispersion was compensated for by invasion of the mud filtrate into the borehole walls, but it is more likely that the absorption mechanism was substantially non-linear.     

Volcanogenic massive sulfide deposits of ophiolite associations

Volcanogenic massive sulfide deposits in ophiolite complexes are usually attributed to the Cyprus type. They associate with basaltic volcanics that are formed in mid-ocean or back-arc spreading centers and much less frequently in intra-plate settings. The deposits are characterized by copper or copper-zinc ores that are enriched in Ni, Co, and in places Mn and As, but are very poor in Pb and demonstrate a low to moderate content of Ag and Au. Typically, the deposits are low to very low in ore and metal reserves. Cyprus-type deposits were irregularly distributed during geological history. The most ancient of them were formed in the Neoproterozoic, while the bulk of the deposits are Ordovician or Cretaceous in age. Their possible Paleoproterozoic analogues can be found in the Svecofennian belt (Outokumpu ore district), while modern ones are confined to the Explorer and Endeavour Ridges and southern segment of the Juan de Fuca Ridge.     

Hydroextrusion as a possible mechanism for the ascent of diapirs,domes, and mantle plumes

A possible mechanism of the ascent of material within the Earth’s crust and mantle is the mechanism of hydroextrusion, i.e., the effect of squeezing of material under excess pressure. The major factors that predetermine the high plasticity of the material and its ability to produce hydroextrusions are high lithostatic pressures and temperatures. The phenomenon of hydroextrusion can be most clearly illustrated by the example of the origin of salt diapirs. The driving force of hydroextrusions of material in the crust and mantle is excess pressure, which can result from lateral differences between the densities of rocks (as is the case during the development of salt diapirs) and phase transitions associated with a volume increase. When the material of the upper mantle undergoes partial melting with the derivation of basaltic melts at depths of 60–100 km, excess pressures reach 80 MPa, whereas the plasticity limit of 20% melted rocks is no higher than 5 MPa. As a result, the partially molten material is forced from the melting region toward zones with lower lithostatic pressures. A local temperature increase in the transitional zones in the Earth’s mantle at positive dP/dT values of the phase transitions also gives rise to excess pressures, whose values can range from 100 to 800 MPa at a 0.5–3.0% volume change and which can be the driving force during the origin of mantle plumes. Original Russian Text ? V.N. Anfilogov, Yu.V. Khachai, 2006, published in Geokhimiya, 2006, No. 8, pp. 873–878.