Grain boundary diffusion in enstatite

We have investigated grain boundary diffusion rates in enstatite by heating single crystals of quartz packed in powdered San Carlos olivine (Mg_0.90Fe_0.10)₂SiO₄ at controlled oxygen fugacities in the range 10^?5.7 to 10^?8.7?atm and temperatures from 1350° to 1450?°C for times from 5 to 100?h at 1?atm total pressure. Following the experiments, the thickness of the coherent polycrystalline reaction rim of pyroxene that had formed between the quartz and olivine was measured using backscatter scanning imaging in the electron microprobe. Quantitative microprobe analysis indicated that the composition of this reaction phase is (Mg_0.92Fe_0.08)₂Si₂O₆. The rate of growth of the pyroxene increases with increasing temperature, is independent of the oxygen fugacity, and is consistent with a parabolic rate law, indicating that the growth rate is controlled by ionic diffusion through the pyroxene rim. Microstructural observations and platinum marker experiments suggest that the reaction phase is formed at the olivine-pyroxene interface, and is therefore controlled by the diffusion of silicon and oxygen. The parabolic rate constants determined from the experiments were analyzed in terms of the oxide activity gradient across the rim to yield mean effective diffusivities for the rate-limiting ionic species, assuming bulk transport through the pyroxene layer. These effective diffusivities are faster than the lattice diffusivities for the slowest species (silicon) calculated from creep experiments, but slower than measured lattice diffusivities for oxygen in enstatite. Thus, silicon grain boundary diffusion is most likely to be the rate-limiting process in the growth of the pyroxene rims. Also, as oxygen transport through the pyroxene rims must be faster than silicon transport, diffusion of oxygen along the grain boundaries must be faster than through the lattice. The grain boundary diffusivity for silicon in orthopyroxenite is then given by D¯gbSiδ=(3.3±3.0)×10^?9f0.0O₂e^?400±65/RT?m³s^?1, where the activation energy for diffusion is in kJ/mol, and δ is the grain boundary width in m. Calculated growth rates for enstatite under these conditions are significantly slower than predicted by an extrapolation from similar experiments performed at 1000?°C under high pressure (hydrous) conditions by Yund and Tullis (1992), perhaps due to water-enhancement of diffusion in their experiments.     

An experimental study in forming a long synthetic aperture at sea

The testing of a synthetic aperture technique, the ETAM algorithm, is extended and its performance for CW pseudorandom signals and broadband ship noise is examined. The results show the limitations of the technique and are of special interest for operational systems development. In the CW experiments, the transmitted signal was generated with high temporal coherence, and loss of the spatial and temporal coherence of the received signal was introduced only by the medium and the stability of the towed array. In the experiments that included the pseudorandom signal and the ship noise, the temporal coherence of the transmitted signals was deliberately chosen to be poor in order to study the effects and the performance of this algorithm with broadband signals. The related experimental results show that for received signals, which have their segments over the synthesizing period highly cross-correlated, a synthetic aperture array gain was achieved that corresponds to the length of an equivalent fully populated array     

A techno-economic comparison of power systems for autonomousunderwater vehicles

This paper compares lead-acid batteries, sodium-sulfur batteries, solid polymer fuel cells and closed-cycle diesel engines for autonomous underwater vehicle (AUV) applications. The service is described in terms of a parametric mission and life cycle. A generic AUV is used as a basis for comparison. Power systems are evaluated by two criteria: (1) submerged endurance capability and (2) life cycle cost. This study determines categories of service for which each power system is preferred. The solid polymer fuel cell can provide greater submerged endurance than other power systems examined. For extremely long duration AUV missions, the fuel cell is the required system, indicating a possible market niche for today's fuel cell technology. Considering cost projections for each power system, the results also show that the SPFC can become cost-competitive with conventional technologies, particularly for services characterized by high levels of utilization     

Multiple-source localization using GPS technology and receivedarrival time structure analysis in an air-deployed system

An efficient and robust method has been developed to locate multiple impulsive sources in an ocean environment. Global position system (GPS) receivers were installed on sonobuoys to obtain their locations within a few meters of accuracy. A sonobuoy field was deployed in a ring-type pattern. Charges were then set off at arbitrary locations within the ring, High-resolution plots were used to obtain direct path and/or first bottom bounce arrivals on each buoy. A model grid of arrival times was constructed, corresponding to the dimensions of the buoy field. A ray model previously developed here at the Applied Research Laboratories at the University of Texas at Austin (ARL:UT) was used to obtain model travel times. The minimum value of the least-square-type error between the real arrival times and the modeled travel times resulted in an unambiguous location of the source, within the limits of the grid spacing chosen. This value was calculated by picking one receiver as the reference and then summing the timing errors of the remaining receivers relative to the reference. Successive iterations with finer grid spacings result in source localization within the accuracy of the buoy locations. The localization routine was extended by allowing permutations of the pulse arrivals on each buoy to account for multiple sources closely separated in time and/or space. An automated correlation technique is presented as an alternative to the leading edge-detection method used here for obtaining relative arrival times. Two proof-of-concept experiments were performed and some results of data obtained at Lake Travis and the Gulf of Mexico are presented     

Spatial and temporal variations of solar coronal loops

Skylab EUV observations of an active region near the solar limb were analyzed. Both cool (T < 10⁶ K) and hot (T > 10⁶ K) loops were observed in this region. For the hot loops the observed intensity variations were small, typically a few percent over a period of 30 min. The cool loops exhibited stronger variations, sometimes appearing and disappearing in 5 to 10 min. Most of the cool material observed in the loops appeared to be caused by the downward flow of coronal rain and by the upward ejection of chromospheric material in surges. The frequent EUV brightenings observed near the loop footpoints appear to have been produced by both in situ transient energy releases (e.g. subflares) and the infall/impact of coronal rain. The physical conditions in the loops (temperatures, densities, radiative and conducting cooling rates, cooling times) were determined. The mean energy required to balance the radiative and conductive cooling of the hot loops is approximately 3 × 10^–3 erg cm^–3 s^–1. One coronal heating mechanism that can account for the observed behavior of the EUV emission from McMath region 12634 is heating by the dissipation of fast mode MHD waves.     

Kinetic studies of lead(II) uptake by the seagrass Zostera muelleri in water by radiotracing,atomic absorption spectrometry and electrochemical techniques

Evidence was found that uptake of lead from seawater in both model and natural systems by the leaves of the seagrass Zostera muelleri does occur for live, dead and scraped leaves at all the lead concentrations tested. Positive uptake of lead was measured using the three analytical techniques of radio-tracer, differential pulse anodic stripping voltammetry and atomic absorption spectrometry; similar uptake profiles were obtained for each technique. Profiles always showed an initial rapid uptake phase followed by a gradual transition to a plateau phase at which an approximate equilibrium between lead attached to seagrass and free ionic lead in seawater was reached. The presence of active lead uptake processes was indicated in experiments which attempted to remove lead from leaves by a chelating agent.     

Petrology and origin of amoeboid olivine aggregates in CR chondrites

Abstract— Amoeboid olivine aggregates (AOAs) are irregularly shaped, fine‐grained aggregates of olivine and Ca, Al‐rich minerals and are important primitive components of CR chondrites. The AOAs in CR chondrites contain FeNi metal, and some AOAs contain Mn‐rich forsterite with up to 0.7 MnO and Mn:Fe ratios greater than one. Additionally, AOAs in the CR chondrites do not contain secondary phases (nepheline and fayalitic olivine) that are found in AOAs in some CV chondrites. The AOAs in CR chondrites record a complex petrogenetic history that included nebular gas‐solid condensation, reaction of minerals with the nebular gas, small degrees of melting, and sintering of the assemblage. A condensation origin for the Mn‐rich forsterite is proposed. The Mn‐rich forsterite found in IDPs, unequilibrated ordinary chondrite matrix, and AOAs in CR chondrites may have had a similar origin. A type A calcium, aluminum‐rich inclusion (CAI) with an AOA attached to its Wark‐Lovering rim is also described. This discovery reveals a temporal relationship between AOAs and type A inclusions. Additionally, a thin layer of forsterite is present as part of the Wark‐Lovering rim, revealing the crystallization of olivine at the end stages of Wark‐Lovering rim formation. The Ca, Al‐rich nodules in the AOAs may be petrogenetically related to the Ca, Al‐rich minerals in Wark‐Lovering rims on type A CAIs. AOAs are chondrite components that condensed during the final stage of Wark‐Lovering rim formation but, in general, were temporally, spatially, or kinetically isolated from reacting with the nebula vapor during condensation of the lower temperature minerals that were commonly present as chondrule precursors.     

Massless scalar field in Robertson-Walker space-time

Recently, exact spatially-homogeneous solutions have been found for a conformally invariant massless scalar fieldS(t) coupled to a Robertson-Walker geometry. We investigate extending these solutions to inhomogeneous scalar fieldsS(t, x ^l ). For an isotropic scalar fieldS(t, r) we find a solution satisfying three of the five field equations. If we use REDUCE, we show that the remaining equations forceS=S(t).