Noise reduction and detection of weak, coherent signals through phase-weighted stacks

We present a new tool for efficient incoherent noise reduction for array data employing complex trace analysis. An amplitude-unbiased coherency measure is designed based on the instantaneous phase, which is used to weight the samples of an ordinary, linear stack. The result is called the phase-weighted stack (PWS) and is cleaned from incoherent noise. PWS thus permits detection of weak but coherent arrivals. The method presented can easily be extended to phase-weighted cross-correlations or be applied in the τ p domain. We illustrate and discuss the advantages and disadvantages of PWS in comparison with other coherency measures and present examples. We further show that our non-linear stacking technique enables us to detect a weak lower-mantle P -to- S conversion from a depth of approximately 840 km on array data. Hints of an 840 km discontinuity have been reported; however, such a discontinuity is not yet established due to the lack of further evidence.     

Late Pleistocene–Holocene rise and collapse of Lake Suguta,northern Kenya Rift

The Late Pleistocene to Middle Holocene African Humid Period (AHP) was characterized by dramatic hydrologic fluctuations in the tropics. A better knowledge of the timing, spatial extent, and magnitude of these hydrological fluctuations is essential to decipher the climate-forcing mechanisms that controlled them. The Suguta Valley (2°N, northern Kenya Rift) has recorded extreme environmental changes during the AHP. Extensive outcrops of lacustrine sediments, ubiquitous wave-cut notches, shorelines, and broad terrace treads along the valley margins are the vestiges of Lake Suguta, which once filled an 80 km long and 20 km wide volcano–tectonic depression. Lake Suguta was deep between 16.5 and 8.5 cal ka BP. During its maximum highstand, it attained a water depth of ca 300 m, a surface area of ca 2150 km², and a volume of ca 390 km³. The spatial distribution of lake sediments, the elevation of palaeo-shorelines, and other geomorphic evidences suggest that palaeo-Lake Suguta had an overflow towards the Turkana basin to the north. After 8.5 cal ka BP, Lake Suguta abruptly disappeared. A comparison of the Lake Suguta water-level curve with other reconstructed water levels from the northern part of the East African Rift System shows that local insolation, which is dominated by precessional cycles, may have controlled the timing of lake highstands in this region. Our data show that changes of lake levels close to the Equator seem to be driven by fluctuations of spring insolation, while fluctuations north of the Equator are apparently related to variations in summer insolation. However, since these inferred timings of lake-level changes are mostly based on the radiocarbon dating of carbonate shells, which may have been affected by a local age reservoir, alternative dating methods are needed to support this regional synthesis. Between 12.7 and 11.8 cal ka BP, approximately during the Northern Hemisphere high-latitude Younger Dryas, the water level of Lake Suguta fell by ca 50 m, suggesting that remote influences also affected local hydrology.     

Using Diurnal Temperature Signals to Infer Vertical Groundwater‐Surface Water Exchange

Heat is a powerful tracer to quantify fluid exchange between surface water and groundwater. Temperature time series can be used to estimate pore water fluid flux, and techniques can be employed to extend these estimates to produce detailed plan‐view flux maps. Key advantages of heat tracing include cost‐effective sensors and ease of data collection and interpretation, without the need for expensive and time‐consuming laboratory analyses or induced tracers. While the collection of temperature data in saturated sediments is relatively straightforward, several factors influence the reliability of flux estimates that are based on time series analysis (diurnal signals) of recorded temperatures. Sensor resolution and deployment are particularly important in obtaining robust flux estimates in upwelling conditions. Also, processing temperature time series data involves a sequence of complex steps, including filtering temperature signals, selection of appropriate thermal parameters, and selection of the optimal analytical solution for modeling. This review provides a synthesis of heat tracing using diurnal temperature oscillations, including details on optimal sensor selection and deployment, data processing, model parameterization, and an overview of computing tools available. Recent advances in diurnal temperature methods also provide the opportunity to determine local saturated thermal diffusivity, which can improve the accuracy of fluid flux modeling and sensor spacing, which is related to streambed scour and deposition. These parameters can also be used to determine the reliability of flux estimates from the use of heat as a tracer.     

The Role of Fluvial and Glacial Erosion in Landscape Evolution: The Ben Ohau Range,New Zealand

A morphometric comparison of valleys has been made for the Ben Ohau Range in the central Southern Alps of New Zealand. The range is undergoing rapid tectonic transport and uplift. The humid north of the range is a glacial trough-and-arête landscape, with a temperate glacial climate. The dry south has rounded divides and plateau remnants dissected by fluvial valleys. Assuming that space–time substitution allows today's spatial valley-form transition to represent evolutionary stages in valley development, the tectonic history allows time constraints to be placed on the rate of transition to an alpine glacial landscape. Morphometric change has been quantified using hypsometric curves, and distance–elevation plots of cirque and valley-floor altitudes. Ancestral fluvial valleys have less concave long profiles but are stepped at altitude owing to the presence of high-level cirques and remnant plateau surfaces, and possess a low proportion of land area at low elevation. Increasing glacial influence is manifest as smoother, more deeply concave long profiles and U-shaped cross-profiles associated with a higher proportion of the land area at lower elevation. The full morphological transition has involved up to 2.4 km of vertical denudation over the 4 Ma lifetime of the mountain range, of which 80 per cent would have occurred by preglacial fluvial erosion. Combining the trajectory of tectonic transport with reconstructed glaciation limits and climatic history, it is indicated that about 200 ka of temperate glacial erosion produces recognizable trough-and areête topography. Mean and modal relief increase where glacial activity is confined to cirques, but decrease when trough incision by ice becomes established as a dominant process in the landscape. © 1997 by John Wiley & Sons, Ltd.     

Passive seismic control of cable-stayed bridges with damped resonant appendages

A study is conducted to investigate the effectiveness of attaching to cable-stayed bridges resonant appendages with a relatively small mass and a high damping ratio as a means to reduce their response to earthquake excitations. The study is based on a previously developed formulation that shows that the use of these appendages may increase the inherent damping of building structures and, as a result, may reduce their response to seismic disturbances. It includes numerical and experimental tests that are conducted to assess the validity of such a formulation for the case of cable-stayed bridges and the extent to which such appendages can reduce their seismic response. In the numerical study, an actual cable-stayed bridge is modelled with finite elements and analysed with and without the proposed appendages under different earthquake ground motions. Appendages with damping ratios of 10, 15, 20 and 30 per cent and masses that, respectively, represent 0.67, 1.5, 2.7 and 6.0 per cent of the total mass of the bridge are considered. In the experimental test, a 3.7 m long cable-stayed bridge and an appendage consisting of a small mass, a small spring and a small viscous damper are built and the bridge tested, without and with the appendage, on a pair of shaking tables which are set to reproduce ground acceleration records from past earthquakes. The damping ratio of the appendage in this test is 32 per cent and its mass represents about 8 per cent of the total mass of the bridge model. In the numerical test, it is found that the appendages reduce the longitudinal response of the bridge deck up to 88 per cent. Similarly, in the experimental test it is found that the appendage reduces the longitudinal bridge deck response by about 41 per cent. From these studies, it is concluded that the suggested appendages may indeed be effective in reducing the seismic response of cable-stayed bridges as they are for building structures.     

The passivation of calcite by acid mine water. Column experiments with ferric sulfate and ferric chloride solutions at pH 2

Column experiments, simulating the behavior of passive treatment systems for acid mine drainage, have been performed. Acid solutions (HCl or H₂SO₄, pH 2), with initial concentrations of Fe(III) ranging from 250 to 1500 mg L⁻¹, were injected into column reactors packed with calcite grains at a constant flow rate. The composition of the solutions was monitored during the experiments. At the end of the experiments (passivation of the columns), the composition and structure of the solids were measured. The dissolution of calcite in the columns caused an increase in pH and the release of Ca into the solution, leading to the precipitation of gypsum and Fe–oxyhydroxysulfates (Fe(III)–SO₄–H⁺ solutions) or Fe–oxyhydroxychlorides (Fe(III)–Cl–H⁺ solutions). The columns worked as an efficient barrier for some time, increasing the pH of the circulating solutions from 2 to 6–7 and removing its metal content. However, after some time (several weeks, depending on the conditions), the columns became chemically inert. The results showed that passivation time increased with decreasing anion and metal content of the solutions. Gypsum was the phase responsible for the passivation of calcite in the experiments with Fe(III)–SO₄–H⁺ solutions. Schwertmannite and goethite appeared as the Fe(III) secondary phases in those experiments. Akaganeite was the phase responsible for the passivation of the system in the experiments with Fe(III)–Cl–H⁺ solutions.     

The climate tourism potential of Alpine destinations using the example of Sonnblick, Rauris and Salzburg

The climate tourism potential of a region can be described by methods used in human biometeorology and applied climatology. Frequency analyses based on complex thermal bioclimatic indices (e.g. physiologically equivalent temperature) and diagrams of precipitation patterns based on thresholds offer new approaches of visualisation. An integral approach for tourism climatologic analyses is provided by the climate?Ctourism/transfer?Cinformation?Cscheme that also bases on frequency distributions of relevant factors and parameters which are important for a destination. The knowledge about the vertical variability of tourism climatologic factors is of high importance because of the several kinds of tourism activities affected by weather. The same holds for a quantification of extreme events like heat waves because of their possible effects on health and recreation over a year's course. The results show that the vertical gradient of bioclimatic and tourism-related parameters can be of value when developing strategies of adaption to climate change.     

Nucleation and crystallization of otavite, witherite, calcite, strontianite, hydrozincite, and hydrocerussite by CO2 membrane diffusion technique

Otavite, witherite, calcite, strontianite, hydrozincite and hydrocerussite nucleation was induced by CO₂ diffusion through a polyethylene membrane into a metal bearing solution. Nucleation and ongoing precipitation was followed at 25 ± 1 °C by the chemical evolution of the solution and the consumption of sodium hydroxide (pH-stat conditions). X-ray diffraction patterns as well as FT-infrared and Raman spectra confirmed the formation of well crystallized solids, except for less crystalline hydrozincite. In several experiments simonkolleite and laurionite precipitated concurrently with hydrozincite and hydrocerussite. The carbonate end-member minerals, smithsonite and cerussite, however were not formed. Carbonate minerals crystallized as spherical aggregates of thin layered otavite, spherical orientated witherite needles, rhombohedral calcite, pseudo-hexagonal strontianite laths, fibrous lumps of hydrozincite and planar hexagonal hydrocerussite crystals. Crystal and aggregate sizes range between 1 and 100 μm. Nucleation occurred at well defined reaction times and distinct critical supersaturation indices (SI_crit). The time for nucleation at constant pH decreased as the initial metal concentration increased for a given solid. The SI_crit values decreased in the order of hydrocerussite (3.2), otavite (2.5), strontianite (1.6), witherite (0.9) and calcite (0.7).     

Behaviour of radiogenic Pb in zircon during ultrahigh-temperature metamorphism: an ion imaging and ion tomography case study from the Kerala Khondalite Belt,southern India

Zircon crystals from a locally charnockitized Paleoproterozoic high-K metagranite from the Kerala Khondalite Belt (KKB) of southern India have been investigated by high-spatial resolution secondary ion mass spectrometry analysis of U–Th–Pb and rare earth elements (REE), together with scanning ion imaging and scanning ion tomography (depth-profiled ion imaging). The spot analyses constrain the magmatic crystallization age of the metagranite to ca. 1,850 Ma, with ultrahigh-temperature (UHT) metamorphism occurring at ca. 570 Ma and superimposed charnockite formation at ca. 520–510 Ma, while the ion imaging reveals a patchy distribution of radiogenic Pb throughout the zircon cores. Middle- to heavy-REE depletion in ca. 570 Ma zircon rims suggests that these grew in equilibrium with garnet and therefore date the UHT metamorphism in the KKB. The maximum apparent ²⁰⁷Pb/²⁰⁶Pb age obtained from the unsupported radiogenic Pb concentrations is also consistent with formation of the Pb patches during this event. The superimposed charnockitization event appears to have caused additional Pb-loss in the cores and recrystallization of the rims. The results of depth-profiling of the scanning ion tomography image stack show that the Pb-rich domains range in size from <5 nm to several 10 nm (diameter if assumed to be spherical). The occurrence of such patchy Pb has previously been documented only from UHT metamorphic zircon, where it likely results from annealing of radiation-damaged zircon. The formation of a discrete, heterogeneously distributed and subsequently immobile Pb phase effectively arrests the normal Pb-loss process seen at lower grades of metamorphism.     

Influence of the zone of weakness on dip angle and shear heating of subducted slabs

We study the importance of the zones of weakness and the pattern of downgoing flow in steady-state models of subducting lithosphere, which interacts mechanically and thermally with the ambient mantle. The non-linear system of governing equations consists of (i) the momentum equation in stream function formulation and (ii) the steady-state heat transfer equation including conduction and advection of heat and dissipation. A finite element method has been applied to this system. We consider the viscosity to be a non-linear function of both the temperature and the stream function. In steady-state two-dimensional (2D) flow, the stream function isolines follow material trajectories. They are used to follow the top of the subducting slab, which because of its possible increase in water content, is assumed to have a lower viscosity. The zone of weakness has been thus obtained in the self-consistent fashion since the stream function as well as the temperature are the output from our modeling and no a priori assumptions about the shape of the bending lithosphere are taken into account. It was shown that several orders decrease of viscosity in the zone of weakness is required to obtain the dip angle of about 45°. If the decrease of viscosity is not sufficient enough, the subducted slab either sinks almost vertically or does not exhibit a plate-like behavior. We have also demonstrated that shear heating can unrealistically increase at the zone of weakness for fast subductions if decrease of viscosity is underestimated.