Improved 2-D attenuation analysis for Northern Italy using a merged dataset from selected regional seismic networks

A merged, high-quality waveform dataset from different seismic networks has been used to improve our understanding of lateral seismic attenuation for Northern Italy. In a previous study on the same region, Morasca et al. (Bull Seismol Soc Am 98:1936–1946, 2008) were able to resolve only a small area due to limited data coverage. For this reason, the interpretation of the attenuation anomalies was difficult given the complexity of the region and the poor resolution of the available data. In order to better understand the lateral changes in the crustal structure and thickness of this region, we selected 770 earthquakes recorded by 54 stations for a total of almost 16,000 waveforms derived from seismic networks operating totally or partially in Northern Italy. Direct S-wave and coda attenuation images were obtained using an amplitude ratio technique that eliminates source terms from the formulation. Both direct and early-coda amplitudes are used as input for the inversions, and the results are compared. Results were obtained for various frequency bands ranging between 0.3 and 25.0 Hz and in all cases show significant improvement with respect to the previous study since the resolved area has been extended and more crossing paths have been used to image smaller scale anomalies. Quality-factor estimates are consistent with the regional tectonic structure exhibiting a general trend of low attenuation under the Po Plain basin and higher values for the Western Alps and Northern Apennines. The interpretation of the results for the Eastern Alps is not simple, possibly because our resolution for this area is still not adequate to resolve small-scale structures.     

Microlevelling procedures applied to regional aeromagnetic data: an example from the Transantarctic Mountains (Antarctica)

The extensive application of digital enhancement and filtering as a powerful tool for aeromagnetic interpretation, not only of high resolution but also of regional data, requires an improved levelling. Two microlevelling techniques were thus compared in order to find an effective but relatively simple procedure to remove, or at least to reduce, residual magnetic errors remaining after standard levelling processes. This study was carried out on regional aeromagnetic data recently acquired at high magnetic latitudes along the Transantarctic Mountains in Antarctica, where it is particularly critical to remove time-dependent magnetic variations. Two-dimensional FFT filters applied to the gridded data, namely the Butterworth and a directional cosine filter, proved to be more effective than previously proposed one-dimensional space-domain filters in the reduction of the 'residual corrugation' not removed by statistical levelling. Tectonic interpretation of trends detected in the total field magnetic anomaly map and in the 3D analytic signal improved after application of frequency-domain microlevelling. However, we also show that when interpreting microlevelled data, two factors must be considered: (i) the possible presence of real geological trends aligned along the flight lines; (ii) modifications in the results yielded by depth estimates of magnetic sources due to the FFT filters applied during the microlevelling procedure. Such changes were seen both in the well-established 2D FFT method, based on the slope of the energy spectrum, and in the more recent 3D Euler deconvolution technique. Overall our results indicate that microlevelling could profitably be applied to older gridded aeromagnetic data sets in Antarctica, thus improving the accuracy and geological significance of future regional magnetic compilations, as already seen in other continents.     

PCBs in Central Vietnam coastal lagoons: levels and trends in dynamic environments

PCBs were analysed in surficial sediments and selected sediment cores collected between 2002 and 2008 in Central Vietnam coastal lagoons. The aim was to determine contamination levels and trends, and to evaluate the effects of anthropogenic pressures and natural events. Samples were mostly fine-grained with low total PCB concentrations (0.367-44.7 μg kg⁻¹). Atmospheric transport and post depositional processes modify to some degree the fingerprint of PCB inputs to the environment favouring the predominance of 3, 4 and 5 chlorinated congeners. The similarity of congener distributions in contemporary surficial samples also suggests the presence of a unique source over the entire study area, probably connected to mobilisation and long range transports from land-based stocks. The removal of consistent sediment layers is hypothesised based on repeated samplings of the same area. Natural meteorological events (such as typhoons) are suspected to be responsible for these sediment losses.     

Investigation of Small‐Scale Preferential Flow with a Forced‐Gradient Tracer Test

A new tracer experiment (referred to as MADE‐5) was conducted at the well‐known Macrodispersion Experiment (MADE) site to investigate the influence of small‐scale mass‐transfer and dispersion processes on well‐to‐well transport. The test was performed under dipole forced‐gradient flow conditions and concentrations were monitored in an extraction well and in two multilevel sampler (MLS) wells located at 6, 1.5, and 3.75 m from the source, respectively. The shape of the breakthrough curve (BTC) measured at the extraction well is strongly asymmetric showing a rapidly arriving peak and an extensive late‐time tail. The BTCs measured at seven different depths in the two MLSs are radically different from one another in terms of shape, arrival times, and magnitude of the concentration peaks. All of these characteristics indicate the presence of a complex network of preferential flow pathways controlling solute transport at the test site. Field‐experimental data were also used to evaluate two transport models: a stochastic advection‐dispersion model (ADM) based on conditional multivariate Gaussian realizations of the hydraulic conductivity field and a dual‐domain single‐rate (DDSR) mass‐transfer model based on a deterministic reconstruction of the aquifer heterogeneity. Unlike the stochastic ADM realizations, the DDSR accurately predicted the magnitude of the concentration peak and its arrival time (within a 1.5% error). For the multilevel BTCs between the injection and extraction wells, neither model reproduced the observed values, indicating that a high‐resolution characterization of the aquifer heterogeneity at the subdecimeter scale would be needed to fully capture 3D transport details.     

Multiplatform observation of the surface circulation in the Gulf of Naples (Southern Tyrrhenian Sea)

The Gulf of Naples (Southern Tyrrhenian Sea) is a highly urbanised area, where human activities and natural factors (e.g. river runoff, exchanges with adjacent basins) can strongly affect the water quality. In this work we show how surface transport can influence the distribution of passively drifting surface matter, and more in general if and how the circulation in the basin can promote the renovation of the surface layer. To this aim, we carried out a multiplatform analysis by putting together HF radar current fields, satellite images and modelling tools. Surface current fields and satellite images of turbidity patterns were used to initialise and run model simulations of particle transport and diffusion. Model results were then examined in relation to the corresponding satellite distributions. This integrated approach permits to investigate the concurrent effects of surface dynamics and wind forcing in determining the distribution of passive tracers over the basin of interest, identifying key mechanisms supporting or preventing the renewal of surface waters as well as possible areas of aggregation and retention.     

Volatile-rich magma injection into the feeding system during the 2001 eruption of Mt. Etna (Italy): its role on explosive activity and change in rheology of lavas

The explosive behavior and the rheology of lavas in basaltic volcanoes, usually driven by differentiation, can also be significantly affected by the kinetics of magma degassing in the upper portion of the feeding system. The complex eruption of 2001 at Mt. Etna, Italy, was marked by two crucial phenomena that occurred at the Laghetto vent on the southern flank of the volcano: 1) intense explosive activity and 2) at the end of the eruption, emission of a lava flow with higher viscosity than flows previously emitted from the same vent. Here, we investigate the hypothesis that these events were driven by the injection of volatile-rich magma into the feeding system. The input and mixing of this magma into a reservoir containing more evolved magma had the twofold effect of increasing 1) the overall concentration of volatiles and 2) their exsolution with consequent efficient vesiculation and degassing. This led to an explosive stage of the eruption, which produced a ~75-m-high cinder cone. Efficient volatile loss and the consequent increase of the liquidus temperature brought about the nucleation of Fe-oxides and other anhydrous crystalline phases, which significantly increased the magma viscosity in the upper part of the conduit, leading to the emission of a high viscosity lava flow that ended the eruption. The 2001 eruption has offered the opportunity to investigate the important role that input of volatile-rich magma may exert in controlling not only the geochemical features of erupted lavas but also the eruption dynamics. These results present a new idea for interpreting similar eruptions in other basaltic volcanoes and explaining eruptions with uncommonly high explosivity when only basic magmas are involved.     

Transient processes in Stromboli’s shallow basaltic system inferred from dolerite and magmatic breccia blocks erupted during the 5 April 2003 paroxysm

We describe the mineralogy, geochemistry, and mesomicrostructure of fresh subvolcanic blocks erupted during the 5 April 2003 paroxysm of Stromboli (Aeolian Islands, Italy). These blocks represent ∼50 vol.% of the total erupted ejecta and consist of fine- to medium-grained basaltic lithotypes ranging from relatively homogeneous dolerites to strongly or poorly welded magmatic breccias. The breccia components are represented by angular fragments of dolerites entrapped in a matrix of vesiculated (lava-like to scoriae) crystal-rich (CR) basalt. All of the studied blocks are cognates with the CR basalt of the normal Strombolian activity or lavas and they are often coated by a few-centimeter thick layer of crystal-poor (CP) basaltic pumice erupted during the paroxysm. We suggest that they result from the rapid increase of pressure and related subvolcanic rock failure that occurred shortly before the 5 April 2003 explosion, when the uppermost portion of the edifice inflated and suffered brecciation as the result of the sudden rise of the gas-rich CP basalt that triggered the eruption. Dolerites and magmatic matrix of the breccias show major and trace element compositions that match those of the CR basalts erupted during normal Strombolian activity and effusive events at Stromboli volcano. Dolerites consist of (a) phenocrysts normally found in the CR basalts and (b) late-stage magmatic minerals such as sanidine, An_60-28 plagioclase, Fe–Mn-rich olivines (Fo_68-48), phlogopite, apatite, and opaque mineral pairs (magnetite and ilmenite), most of which are never found both in lava flows and scoriae erupted during the persistent explosive activity that characterizes typical Strombolian behavior. Subvolcanic crystallization of the Stromboli CR magma, leading to slowly cooled equivalents of basalts, could result from transient drainage of the magma from the summit craters to lower levels. Fingering and engulfing of the material that collapsed from the summit crater floor into the shallow basaltic system during the late evening of 28 December 2002 coupled with the short break in the summit persistent explosions between December 2002 and March 2003 permitted the CR magma pockets to solidify as dolerites, which were confined to the uppermost portion of the system and thus not involved in the ongoing flank effusive activity. Crystal size distribution of the basaltic blocks and crystallization of the finer-grained (<0.1 mm) mafic minerals of the dolerites over a time interval of ∼100 days closely agrees with the above interpretation. Vesicle filling (miarolitic cavities) locally found in some dolerites, with minerals deposited as vapor-phase crystallization is a result of continuous gas percolation through the rocks of the uppermost portion of the volcanic system. Poorly welded magmatic breccias formed during syn-eruptive processes of 5 April 2003, when the paroxysm strongly shattered the shallow subvolcanic system and many dolerite fragments were entrapped in the CR magma. In contrast, the high degree of welding between the dolerite clasts and the CR basaltic matrix in the strongly welded magmatic breccias provides a snapshot of subvolcanic intrusions of the CR basalt into the dolerite when, after a 2-month break in activity, CR magmas started to rise again to the summit craters. Blocks similar to these subvolcanic ejecta of 5 April 2003 were also erupted during previous paroxysms (e.g., 1930) suggesting that changes in the usual Strombolian activity (e.g., short breaks in the persistent mild explosions and/or flank effusive activity) lead to transient crystallization of dolerites in the shallow plumbing system.     

Structural features of Panarea volcano in the frame of the Aeolian Arc (Italy): Implications for the 2002–2003 unrest

Panarea, characterized by gas unrest in 2002–2003, is the volcanic island with the least constrained structure in the eastern-central Aeolian Arc (Italy). Based on structural measurements, we define here its deformation pattern relative to the Arc. The main deformations are subvertical extension fractures (63% of data), normal faults (25%) and dikes (12%). The mean orientation of the extension fractures and faults is N38°E, with a mean opening direction of N135° ± 8°, implying extension with a moderate component of dextral shear. These data, matched with those available for Stromboli volcano (pure opening) and Vulcano, Lipari and Salina volcanoes (predominant dextral motions) along the eastern-central Arc, suggest a progressive westward rotation of the extension direction and an increase in the dextral shear. The dextral shear turns into compression in the western arc. The recent unrest at Panarea, coeval to that of nearby Stromboli, may also be explained by the structural context, as both volcanoes lie along the portion of the Arc subject to extension.