Inertial and hydrodynamic inertial loads on floating units

The analysis of the dynamic behavior of floating units usually employs a coordinate system with origin in the unit's center of gravity, which significantly simplifies the global mass matrix. Hydrodynamic coefficients are then computed considering the same coordinate system. However, to analyze other conditions of mass distribution and maintain the simplicity of a global mass matrix, it is necessary to determine again the hydrodynamic coefficients, thereby reducing the efficiency of the entire process. Another important point is that the geometries frequently used in floating units are such that the cross-terms of an added mass are relatively unimportant when compared with the main terms, and it is, therefore, common to use only some of them to analyze the unit's dynamic behavior. Recently, however, in the search for production systems suitable for water depths greater than 3000 m, other geometries have been considered in technical and economic feasibility studies. It is possible that for these new geometries all terms of the added mass matrix must be included in the analysis. This paper presents the full development used to determine the complete global mass matrix, the inertial and hydrodynamic inertial loads that make use of the added mass matrices considering any coordinate system and the six degrees of freedom, including all cross-terms.     

Nutrient budgets and trophic state in a hypersaline coastal lagoon: Lagoa de Araruama, Brazil

Lagoa de Araruama in the state of Rio de Janeiro, Brazil, is a hypersaline lagoon with salinity varying spatially from 45 to 56. We collected water samples during monthly cruises throughout the lagoon, and along the streams feeding the system, from April 1991 to March 1992. Nutrients and other water quality parameters exhibited great spatial and temporal variations. Mass balance calculations indicate large amounts of anthropogenic nutrient inputs. The data indicate that the lagoon currently is oligotrophic but is in a state of transition to become a mesotrophic system. Molar dissolved inorganic nitrogen:dissolved inorganic phosphorus (DIN/DIP) varied between 2.2:1 and 659:1 with a volume-weighted average of 22:1. The high DIN/DIP ratio contrasts with that found in nearby lagoons, suggesting that phytoplankton primary production is limited by phosphorus in Lagoa de Araruama. The major loss of DIP is apparently driven by biological assimilation and diagenic reactions in the sediments. Calculations indicate that the lagoon is slightly net autotrophic at +0.9 mol C m⁻² yr⁻¹. This suggests that the biomass of the primary producers is restricted by phosphorus availability. Phosphorus retention in the sediment and the hypersaline state of the lagoon prevent changes in autotrophic communities and the formation of eutrophic conditions.     

Seismic studies of the Brasília fold belt at the western border of the São Francisco Craton, Central Brazil, using receiver function, surface-wave dispersion and teleseismic tomography

The Tocantins Province in Central Brazil is composed of a series of SSW–NNE trending terranes of mainly Proterozoic ages, which stabilized in the Neoproterozoic in the final collision between the Amazon and São Francisco cratons. No previous information on crustal seismic properties was available for this region. Several broadband stations were used to study the regional patterns of crustal and upper mantle structure, extending the results of a recent E–W seismic refraction profile. Receiver functions and surface wave dispersion showed a thin crust (33–37 km) in the Neoproterozoic Magmatic Arc terrane. High average crustal Vp/Vs ratios (1.74–1.76) were consistently observed in this unit. The foreland domain of the Brasília foldbelt, on the other hand, is characterized by thicker crust (42–43 km). Low Vp/Vs ratios (1.70–1.72) were observed in the low-grade foreland fold and thrust zone of the Brasília belt adjacent to the São Francisco craton. Teleseismic P-wave tomography shows that the lithospheric upper mantle has lower velocities beneath the Magmatic Arc and Goiás Massif compared with the foreland zone of the belt and São Francisco craton. The variations in crustal thickness and upper mantle velocities observed with the broadband stations correlate well with the measurements along the seismic refraction profile. The integration of all seismic observations and gravity data indicates a strong lithospheric contrast between the Goiás Massif and the foreland domain of the Brasília belt, whereas little variation was found across the foldbelt/craton surface boundary. These results support the hypothesis that the Brasília foreland domain and the São Francisco craton were part of a larger São Francisco-Congo continental plate in the final collision with the Amazon plate.     

Estimating Buoyancy Heat Flux Using the Surface Renewal Technique over Four Amazonian Forest Sites in Brazil

The surface renewal (SR) method was applied for the first time to measurements of air temperature over four Amazonian forest sites and different seasons in order to obtain estimates of buoyancy heat flux. The required calibration of this method against eddy covariance resulted in a value for a specific parameter that is close to the range reported in other studies, contributing to the generalization of the SR method to different kinds of canopies. The comparison with fluxes obtained using the eddy covariance technique revealed a good match between the two methods for different sites, heights and seasons. Sites with high levels of non-stationarity in the signals of temperature and wind speed presented higher scatter in the regression with fluxes from eddy covariance. For a particular site with previously reported influence of low-frequency motions, the regression was only satisfactory, i.e., slope parameter close to unity and small offset, when oscillations with periods longer than $\approx $ ≈ 13 min were filtered out. The SR method has a great potential due to the simplicity of the instrumentation required. However, care should be taken when measuring under the influence of mesoscale motions, which can lead to high levels of non-stationarity, compromising the fundamental concepts of the SR theory.     

Concentration profiles of particles settling in the neutral and stratified atmospheric boundary layer

An expression for the vertical equilibrium concentration profile of heavy particles, including the effects of canopy on the eddy diffusivity as well as corrections for atmospheric stability, is proposed. This expression is validated against measurements of vertical concentration profiles of corn pollen above a corn field. The fitted theoretical profiles show that particle settling is correctly accounted for. The sensitivity to variations in the turbulent Schmidt number, settling velocity and stability corrections are explicitly characterized. The importance of independent measurements of the surface flux of pollen in future experiments is noted.     

Evaluation of methods of spatial interpolation for monthly rainfall data over the state of Rio de Janeiro,Brazil

Five deterministic methods of spatial interpolation of monthly rainfall were compared over the state of Rio de Janeiro, southeast Brazil. The methods were the inverse distance weight (IDW), nearest neighbor (NRN), triangulation with linear interpolation (TLI), natural neighbor (NN), and spline tension (SPT). A set of 110 weather stations was used to test the methods. The selection of stations had two criteria: time series longer than 20 years and period of data from 1960 to 2009. The methods were evaluated using cross-validation, linear regression between values observed and interpolated, root mean square error (RMSE), coefficient of determination (r ²), coefficient of variation (CV, %), and the Willmott index of agreement (d). The results from different methods are influenced by the meteorological systems and their seasonality, as well as by the interaction with the topography. The methods presented higher precision (r ²) and accuracy (d, RMSE) during the summer and transition to autumn, in comparison with the winter or spring months. The SPT had the highest precision and accuracy in relation to other methods, in addition to having a good representation of the spatial patterns expected for rainfall over the complex terrain of the state and its high spatial variability.     

Simulated precipitation response to SST forcing and potential predictability in the region of the South Atlantic convergence zone

The sensitivity of the precipitation response in the South Atlantic convergence zone (SACZ) to sea surface temperature (SST) anomaly is investigated by an inter-model comparison study of ensembles of multidecadal integrations of two atmospheric general circulation models (AGCMs)—version 1 of the NASA Seasonal-to-Interannual Prediction Project (NSIPP-1) model, and the NCAR community climate model (CCM3) version 3.6.6. Despite the different physical parameterizations, the two models consistently show an SST-forced signal located mainly over the oceanic portion of the SACZ. The signal has interannual-to-decadal timescales, and consists of a shift and strengthening of the SACZ toward anomalous warm waters. A potential predictability analysis reveals that the maximum predictable variance is about 50% of the total SACZ variance over the ocean, but the signal attenuates rapidly toward the South American continent. This result implies that the land portion of the SACZ is primarily dominated by the internal variability, thereby having a limited potential predictability at seasonal timescales.     

An orthotropic interface damage model for simulating drying processes in soils

The study of drying process in soils has received an increased attention in the last few years. This is very complex phenomenon that generally leads to the formation and propagation of desiccation cracks in the soil mass. In recent engineering applications, high aspect ratio elements have proved to be well suited to tackle this type of problem using finite elements. However, the modeling of interfaces between materials with orthotropic properties that generally exist in this type of problem using standard (isotropic) constitutive model is very complex and challenging in terms of the mesh generation, leading to very fine meshes that are intensive CPU demanding. A novel orthotropic interface mechanical model based on damage mechanics and capable of dealing with interfaces between materials in which the strength depends on the direction of analysis is proposed in this paper. The complete mathematical formulation is presented together with the algorithm suggested for its numerical implementation. Some simple yet challenging synthetic benchmarks are analyzed to explore the model capabilities. Laboratory tests using different textures at the contact surface between materials were conducted to evaluate the strengths of the interface in different directions. These experiments were then used to validate the proposed model. Finally, the approach is applied to simulate an actual desiccation test involving an orthotropic contact surface. In all the application cases the performance of the model was very satisfactory.     

Environmental limitations on recruitment from seed in invasive Spartina densiflora on a southern European salt marsh

The South American cordgrass, Spartina densiflora, has invaded a range of different habitats that can support different native species assemblages on salt marshes in the Gulf of Cadiz, Spain. Little is known about the mechanisms of invasion. We examined the potential for seed germination and recruitment in a field transplant experiment, representing a wide range of environments, on elevational gradients across marshes with muddy and sandy sediments. The biotic resistance of native, perennial vegetation (where present) to recruitment of the alien was also investigated. Spartina densiflora seeds were able to germinate over a greater than 2-m range of elevation in the tidal frame. Germination success on unvegetated muddy sediments was related to sediment redox potential, with poor germination at strongly negative redox potentials on the lower sites. On sandy, well-drained sediments, germination was apparently constrained by water availability at the highest elevations. Comparison of vegetated and cleared plots on the upper marsh showed that there was a negative relationship between the presence of Atriplex portulacoides and germination on the muddy sediments. Recruitment (survival of seedlings for 12 weeks) was seen only on unvegetated muddy sediments at the highest elevation. Hence the invasive success and wide elevational tolerance of S. densiflora on the marshes of the Gulf of Cadiz are not reflected in its short-term ability to become established from its prolific seed production. Colonization of sub-optimal habitats may be largely by vegetative propagules and clonal growth.