The Spačice eclogite: constraints on the P–T–t history of the Gföhl granulite terrane, Moldanubian Zone, Bohemian Massif

Summary In the Kutná Hora Complex, the Běstvina Formation, which is similar to Gf?hl granulite, contains eclogite that has escaped widespread retrograde recrystallization. The eclogite assemblage, garnet + omphacite + quartz + rutile ± plagioclase, yields an estimate for peak metamorphic conditions of 18–20 kbar and 835–935 °C, which is comparable to that determined from felsic granulite, 14–20 kbar and 900–1000 °C. Garnet in eclogite exhibits both prograde and retrograde compositional zoning, from which constraints on thermal history of the Gf?hl terrane can be derived by diffusion modelling. At 900 °C, a garnet grain of 800–1000 μm radius would homogenize in 7.5–11.7 million years, but the existence of compositional gradients on a length scale of 100–200 μm suggests that the duration of peak metamorphism may have been limited to ∼500,000 years. Diffusion modelling of retrograde zoning in garnet yields a cooling rate of 150–100 °C/m.y. for a radius of 800–1000 μm and initial temperature of 900 °C. The relatively brief duration of high-pressure/high-temperature metamorphism and rapid cooling and exhumation of the Gf?hl terrane may be a consequence of lithospheric delamination during Early Carboniferous collision of Bohemia (Teplá-Barrandia) and Moldanubia (Franke, 2000).     

Projecting land-use change processes in the Sierra Norte of Oaxaca, Mexico

The objective of study was to explore short-term trends of processes that determine land-use change in Sierra Norte of Oaxaca (SNO), Mexico. Land use and land cover changes (LULCC) were estimated in a complex mosaic of vegetation in the SNO from 1980 to 2000, and projected them to 2020 through a Markovian model. SNO is highly vulnerable to climatic change according to a 2050 GCM scenario. However, 3% annual rate of tropical and temperate forest deforestation from agriculture and livestock encroachment, suggest the threat from land-use change is higher than that from climatic change for this study site. Productive land-use strategies are needed to reduce such high deforestation rates for tropical regions. Controlling deforestation would also reduce short-term effects of CO₂ emissions to the atmosphere. Because of the necessity to evaluate anthropogenic ecosystem changes, it is imperative to separate short-term influences such as deforestation, from long-term influences such as climatic change.     

Seed germination of five Helianthemum species: Effect of temperature and presowing treatments

The germination behaviour of five Helianthemum species (H. almeriense, H. appeninum, H. cinereum, H. hirtum, H. squamatum) has been studied under controlled conditions. Constant 15, 20 or 25 °C and alternating 25/15 °C temperature regimes and 16/8 h light/dark photoperiod conditions were used. Presowing treatments applied were manual scarification, boiling water, hot water, dry heat and sulphuric acid. Germination values recorded were final germination percentage and germination rate expressed as days to reach 50% of the final germination percentage (T₅₀). Incubation temperature had no significant effect on final germination percentage for untreated seeds of the five Helianthemum species. However, variation due to temperature was significant for scarified seeds, with the lowest germination percentage attained at 25 °C. In all Helianthemum species studied, the highest germination percentages were obtained by manual scarification of seeds. Germination rate of scarified seeds decreased as germination temperature increased. The different presowing treatments investigated allowed some germination in some species, but none were any better than manual scarification. The high germination among most species studied, following mechanical rupture of the seed coat, shows that the mechanism of dormancy lies in the seed coat. The physical dormancy caused by impermeable seed-coat appears to be the main reason of poor germination of untreated seeds of Helianthemum species studied.     

Interpretation of subhorizontal crustal reflections by metamorphic and rheologic effects in the eastern part of the Pannonian Basin

The geologic origin of subhorizontal reflections, often observed in crustal seismic sections, was investigated by establishing metamorphic facies and strength of rocks in depth, and correlating these properties to seismic reflection sections from eastern Hungary. Estimation of the depths of metamorphic mineral stability zones utilized the principles developed by Fyfe et al. and known geothermal data of the area. The strength versus depth profile was derived by relating local seismic P -wave interval velocities to Meissner et al. 's activation energy. The results show that the series of subhorizontal reflections, observed in the Pannonian Basin, are a consequence of combined metamorphic and rheologic changes in depths. The synthesis of the integrated data set suggests that the retrograde alteration of the pre-Tertiary basement above the percolation threshold was made possible by the softening effect of shear zones and their water-conducting capacity. The subhorizontal reflections of highest energy, of the consolidated crust below the percolation threshold, originate in the depths of greenschist, amphibolite and granulite metamorphic mineral facies, which were formed in geothermal and pressure conditions similar to those existing today. These results imply the overprint of earlier (Variscan) metamorphic sequences of the crust by more recent retrograde metamorphic processes.     

Haul-out pattern of itinerant male Antarctic fur seals (Arctocephalus gazella) at Laurie Island, South Orkney Islands

The seasonal haul-out pattern of itinerant male Antarctic fur seals ( Arctocephalus gazella ) was determined by regular counts at Mossman Peninsula, Laurie Island, South Orkney Islands, from 1996 to 2005. Small numbers of animals began to arrive at the beach in late December/early January (mean date 28 December Ø 15 days, n= 10). Peak numbers of animals ashore changed considerably between seasons. In 1996, 1998 and 2001, peak numbers were registered in March (6/3, 18/3 and 6/3, respectively). Numbers peaked in 1997, 1999 and 2005 at the end of January/beginning of February (26/1,2/2 and 28/1, respectively). In 2000, 2002, 2003 and 2004 peaks were registered in the third week of February (15/2, 22/2, 14/2 and 20/2, respectively). Peaks in numbers of seals ashore also varied between years, being minimum during 2001 (2531 individuals) and maximum during 2006 (16 610 individuals). In March 1998 the coasts of Laurie Island were surveyed by navigating inflatable boats near the shoreline; 18 haul-out places were identified. The big differences in peak numbers, as well as in the dates of peak events among years, suggest that local conditions could have an effect on the numbers of animals hauled out in a given year. It may therefore be difficult to predict trends from summer censuses in non-breeding places.     

The effect of thermal treatment on the 57Fe Mössbauer spectrum of beryl

Mössbauer spectra (MS) of blue, green and yellow beryl (ideally Be₃Al₂Si₆O₁₈) containing approximately 1% of iron were obtained at 295 and 500 K. Room temperature (RT) spectra of both blue and green samples showed the presence of an asymmetric Fe²⁺ doublet (ΔE _Q~2.7 mm/s, δ~1.1 mm/s), with a very broad low-velocity peak. There is no clear evidence for the presence of a ferric component. The MS of the yellow sample at RT consists of an intense central absorption with parameters typical for Fe³⁺ (ΔE _Q~0.4 mm/s, δ~0.29 mm/s), plus an apparently symmetrical Fe²⁺ doublet. This sample acquires a light-blue shade upon heating in air at about 620 K. Thermal treatments at high temperatures caused no significant changes in the MS, but the green and yellow beryl acquire a blue colour. All these results are interpreted in relation to the existence of channel water and the distribution of iron among the available crystallographic sites.     

The Alcamayo and Cedrobamba catastrophic debris flow (January, March and April 2004) in Machupicchu area—Peru

A debris flow originating from the Alcamayo River on 10th April 2004 destroyed a part of the town of Aguas Calientes, resulting in 11 victims, and with serious affects to the tourist flow to the Machupicchu inka citadel. On the same day, as well as in January and March 2004, other similar phenomena occurred on the Cedrobamba and Leonchayoq Rivers, affecting the railway and an electrical tower, and disrupting the train service.     

Avalanche Risk During Backcountry Skiing – An Analysis of Risk Factors

Skier-triggered avalanches are the main cause of avalanche accidents in backcountry skiing. The risk of accidents during backcountry skiing was analysed statistically and related to factors such as elevation level, aspect, stability rating and the time of the year. The analysis is based on a database about terrain usage and avalanche accidents from a large heli-skiing operator in Canada, which makes it possible to study the conditional probability of accidents given the recorded pattern of terrain usage. This study shows that the historical risk of accidentally triggering an avalanche greater than size 1 depends highly on the stability rating, with the highest risk occurring during “poor” stability. The risk is greater at high elevations, and it is lower during the late season than earlier on. Skier risk does not depend as much on aspect as may be indicated from avalanche data alone. However, it is relatively high in the N–NE–E sector. These factors are not independent of each other and therefore analyses of combined factors were also performed. Questionnaires and interviews were used to gain knowledge about the terrain selection of professional mountain guides. These results indicate that when selecting terrain, guides first look at the overall shape and size of the terrain, but avalanche history of terrain and inclination are also important factors. Finally, remarks in avalanche reports were analysed, and common human factors identified.     

Effect of sampling and linkage on fault length and length–displacement relationship

The power-law exponent (n) in the equation: D=cL ⁿ , with D = maximum displacement and L = fault length, would be affected by deviations of fault trace length. (1) Assuming n=1, numerical simulations on the effect of sampling and linkage on fault length and length–displacement relationship are done in this paper. The results show that: (a) uniform relative deviations, which means all faults within a dataset have the same relative deviation, do not affect the value of n; (b) deviations of the fault length due to unresolved fault tip decrease the values of n and the deviations of n increase with the increasing length deviations; (c) fault linkage and observed dimensions either increase or decrease the value of n depending on the distribution of deviations within a dataset; (d) mixed deviations of the fault lengths are either negative or positive and cause the values of n to either decrease or increase; (e) a dataset combined from two or more datasets with different values of c and orders of magnitude also cause the values of n to deviate. (2) Data including 19 datasets and spanning more than eight orders of fault length magnitudes (10⁻²–10⁵ m) collected from the published literature indicate that the values of n range from 0.55 to 1.5, the average value being 1.0813, and the peak value of n _d (double regression) is 1.0–1.1. Based on above results from the simulations and published data, we propose that the relationship between the maximum displacement and fault length in a single tectonic environment with uniform mechanical properties is linear, and the value of n deviated from 1 is mainly caused by the sampling and linkage effects.     

Geometry and accuracy of reflecting points in bistatic satellite altimetry

The analysis of the time and space distribution of specular (reflecting) points in bistatic altimetry between GPS and CHAMP satellites or SAC-C (taken as examples) is extended from Wagner and Klokočník (2003 J. Geod 77: 128–138). We demonstrate a significantly higher number and density of reflecting points in bistatic altimetry in comparison with traditional monostatic altimetry. After an outline of our older accuracy assessment for the vertical position of the reflecting point, we add a new independent derivation and compare both approaches. We account for orbit errors of both the transmitters (GPS) and receiver (CHAMP) satellites, and the measurement (delay) error. We found that the accuracy of the vertical position of the reflecting point decreases only slowly with increasing off-nadir angle and that the orbit errors must be accounted for if decimeter and better accuracy is required. In this paper, we do not study errors such as state of the ocean, technical parameters of the receiving system, and atmospheric corrections.