Imaging the Mariánské Lázně Fault (Czech Republic) by 3-D ground-penetrating radar and electric resistivity tomography

Geodynamic activity in the area of West Bohemia is typified by the occurrence of earthquake swarms, Quaternary volcanism and high flux of mantle-derived CO₂. The highest swarm activity occurs beneath the eastern edge of the Cheb basin, which is delineated by the NW-SE trending morphologically pronounced Mariánské Lázn?? Fault (MLF) controlling the formation of the basin. The previous trenching survey across the MLF zone has identified several fault strands with possible Quaternary activity. In this paper we present the results of the geophysical survey focused to trace the faults signatures in geophysical sections and to build an image of near surface tectonics. The method of electric resistivity tomography (ERT) along two profiles parallel to the trench identified a strong resistivity contrast between the bodies of sandy gravels in the middle and conductive clayey sands to the west and weathered crystalline basement to the east. The 2-D ground penetration radar (GPR) sections show direct correlation of reflections with lithological boundaries identified in the trench. As expected, the GPR signal amplitudes increase with the resistivities found in the ERT sections. Two of the four faults identified in the trench are indicated in the resistivity and GPR sections. A 3-D GPR measurement has identified a spot of high amplitudes elongated parallel to the MLF trend, which coincides with the high resistivity body. To improve the signal-to-noise ratio of the time slices we stacked the GPR time slices within vertically homogeneous blocks. This provided a contrast image of the sand-gravel body including its boundaries in three dimensions. The detailed analysis of the 3-D GPR cube revealed additional fault that limits the highly reflective sands and appears to be offset by another younger fault. Our results suggest a complex fault pattern in the studied area, which deserves a further study.     

Distribution patterns of some heavy metals in the surface sediment fractions at northern Safaga Bay, Red Sea, Egypt

The distribution patterns, the index of geo-accumulations (MI_geo), and the enrichment ratios (ER _n ) of the contaminant metals: Fe, Mn, Zn, Cu, Pb, and Ni were studied in gravel, sand, mud, coarse, medium, and fine sediment fractions of the uppermost layer of the bottom sediments collected from 12 stations covering the northern part of Safaga Bay. The distribution levels of these metals were increasing with grain size decreasing toward the central axis of the bay that extends NE–SW and southward to Safaga Harbour indicating that these metals concentrated mainly in the fine, very fine, and particulate fractions of sediments and to many anthropogenic sources. The geo-accumulation factor of Zn was more significant (MI_geo?≈?0.62–4.23) relative to the other metals. The bay was classified as moderately to strongly polluted by Zn while it is unpolluted to moderately polluted with the other metals with accumulation sequence of: Zn>Ni>Cu>Mn≥Pb. Zn and Ni recorded the highest enrichment ratios (average ER_Zn?≈?3.07 to 8.89; average ER_Ni?≈?0.84 to 3.63) in the different sediment fractions relative the other metals. These enrichment ratios classified the bay as minimal enrichment, suggestive of no or minimal pollution, to significant enrichment, suggestive of a significant pollution signals with metals sequence of: Zn>Ni>Cu>Pb>Mn.     

Wildfire impacts on schools and hospitals following the 2018 California Camp Fire

Natural Hazards - Wildfire impacts on communities have become more pronounced in recent years as the intensity and frequency of wildfires have increased in densely populated areas of the...     

Spatial analysis of a historical phenomenon: using GIS to demonstrate the strategic placement of Umayyad desert palaces

The Umayyad qusour (desert palaces) are monumental structures built during the reign of the first caliphate of Islam. Usually dismissed as “pleasure palaces” or “hunting lodges,” some scholars are beginning to argue that these prominent structures were strategic interventions in the landscape. Until now, historians have relied mainly on textual, architectural and art-historical analyses of the qusour in order to understand Umayyad state architecture. This research proposes the use of spatial analysis through GIS to lend a new dimension to the discussion. The results of the analysis show that Umayyad qusour are carefully situated at routes of transhumance and water sources. The distribution pattern of the Umayyad qusour is clustered at the outlet of Wadi Sarhan, and there is actually line-of-sight communication between Azraq, Amra, Haranah, Muwaqqar, Umm al Walid, Mushatta, and Qastal. There is also a positive association between Umayyad qusour and their water sources. These results support the argument that the Umayyad qusour were built strategically at perennial water sources in order to monitor routes of transhumance amongst the socio-political centers of the period.     

Hydrogeochemical characterization and groundwater quality assessment in Al-Hasa,Saudi Arabia

Fifty groundwater samples were collected from Al-Hasa to analyze the pH, electrical conductivity (EC, dS m^?1), total dissolved solids (TDS), major anions (HCO₃^?, CO₃^2?, Cl^?, SO₄^2?, and NO₃^?), major cations (Ca²⁺, Mg²⁺, Na⁺, and K⁺), and total hardness. The analyzed data plotted in the Piper, Gibbs, and Durov diagrams, and water quality index (WQI) were calculated to evaluate the groundwater geochemistry and its water quality. The results reveal that most of the investigated samples are Ca²⁺, Mg²⁺, SO₄^2?, Cl^? and Na⁺, and HCO₃^? water types using the Piper diagram. Na⁺?>?Ca²⁺?>?Mg²⁺ are the dominant cations, while Cl^??>?HCO₃^??>?SO₄^2??>?CO₃^2? are the dominant anions. Sodium adsorption ratio (SAR) values varied from 0.79 to 10; however, the Kelly ratio (KR) ranged between 0.1 and 2.2. The permeability index (PI) showed that well water is suitable for irrigation purposes with 75% or more of maximum permeability. The US salinity diagram revealed that the water quality classes of studied waters were CIII-SI, CIII-SII, and CIV-SII, representing height hazards of salinity and medium- to low-sodium hazard. The water quality index (WQI) results indicated that total dissolved solids are out of the drinking water standard limits in Saudi Arabia. The WQI revealed that 38% of the studied wells were considered as poor water (class III), 52% are found as very poor water class (IV), and 10% are unsuitable water for drinking class (V).     

Effect of vapor pressure of grains in formation of planetesimals through the accretion disc

The role of grains in evolution of accretion disc is an important issue in astrophysics. In this paper, we study the effect of vapor pressure of grains in the dead zones of protoplanetary discs. Our study is limited to some particular observed cases in which evaporation of grains would be important and their vapor gas are constrained to an approximately isolated case. Here, we use the Einstein model to investigate the thermodynamics of vapor pressure. The results show that there is a critical temperature as a function of oscillation frequency and binding energy of particles. For temperatures greater than this critical value, the system goes into unstable mode. We show that the dead zone of the disc may reach to enough conditions to condense via instability caused by vapor pressure of grains. This mechanism may play an important role in the formation of planetesimals through protoplanetary disc.     

A GIS-based multi-criteria analysis model for earthquake vulnerability assessment using Choquet integral and game theory

Developing an accurate model for discharge estimation techniques of the ungauged river basin is a crucial challenge in water resource management especially in under-development regions. This article is a thorough review of the historical improvement stages of this topic to understand previous challenges that faced researchers, the shortfalls of methods and techniques, how researchers prevailed and what deficiencies still require solutions. This revision focuses on data-driven approaches and GIS-based methods that have improved the accuracy of estimation of hydrological variables, considering their advantages and disadvantages. Past studies used artificial intelligence and geo-statistical methods to forecast the runoff at ungauged river basins, and mapping the spatial distribution has been considered in this study. A recommendation for future research on the potential of a hybrid model utilizing both approaches is proposed and described.     

The Shear Behavior of Bedding Planes of Weakness Between Two Different Rock Types with High Strength Difference

In this article, the shear behavior of discontinuities caused by bedding planes of weakness between two different rock types with high strength difference is investigated. The effect of roughness and compressive strength of joint wall in such discontinuities are studied. The designed profiles consist of two regular and three irregular artificial joints molded by three types of plaster mortars with different uniaxial compressive strengths. Firstly, it is demonstrated that the shear behavior of discontinuities with different joint wall compressive strengths (JCS) is different from rock joints with identical wall compressive strengths by showing that Barton’s empirical criterion is not appropriate for the former discontinuities. After that, some correlation equations are proposed between the joint roughness coefficient (JRC) parameter and some surface statistical/fractal parameters, and the normal stress range of Barton’s strength criterion is also modified to be used for such discontinuities. Then, a new empirical criterion is proposed for these discontinuities in such a way that a rational function is used instead of JRC log₁₀(JCS/σ _n) as i ₀(σ _c/σ _n)^a/[b + (σ _c/σ _n) ^a ] by satisfying the peak dilation angle boundary conditions under zero and very high normal stress (physical infinite normal stress causing zero peak dilation angle). The proposed criterion has three surface parameters: i ₀, a, and b. The reason for separation of i ₀ from JRC is indicated and the method of its calculation is mentioned based on the literature. The two remaining coefficients (a and b) are discussed in detail and it is shown that a shows a power-law relationship with b, introducing the coefficient c through b = c ^a . Then, it is expressed that a is directly related to discontinuity surface topography. Finally, it is shown that the coefficient c has higher values in irregular profiles in comparison with regular profiles and is dominated by intensity of peak dilation angle reduction (majorly related to the surface irregularity and minorly related to roughness). The coefficient c is to be determined by performing regression analysis on experimental data.     

Improved Pile Geometry to Reduce Negative Skin Friction on Single Driven Pile and Pile Groups Subjected to Lateral Loads

Geotechnical and Geological Engineering - Negative skin friction on piles represents a severe problem when piles were installed in soft clay due to consolidation process. It reduces the bearing...     

Synoptic patterns leading to hailstorm in Chaharmahal and Bakhtiari province,Iran

The purpose of this study was to extract the synoptic patterns of 500 mb geopotential height and the sea level pressure leading to form hail in Chaharmahal and Bakhtiari province, Iran. To this end, at first, we explored hail occurrence in different areas of the province under investigation. Then, using sea level pressure and 500 mb geopotential height data, the patterns of hail occurrence were investigated through hierarchical clustering and Ward’s method. The level of 500 mb patterns resulting in hail formation in the area include: (1) settlement of a cut-off low pressure blocking in Turkey and Iran’s position in downstream of trough and injection of humidity coming from the Red Sea; (2) settlement of low ridge in northern Europe and Iran lying in downstream of the trough and injection of humidity of the Mediterranean Sea; (3) settlement of a cut-off low pressure in east of Europe and Iran lying in downstream of the trough; and (4) settlement of a deep trough in the Mediterranean Sea, formation of an omega-shaped blocking in Northern Europe and Iran lying in downstream of the trough. At sea level, the following patterns have caused hail formation in Chaharmahal and Bakhtiari province: (1) settlement of low pressure in Iran and Russia accompanying high pressure in Taklimakan Desert and east of Europe; (2) settlement of low pressure in Iran and high pressure in Egypt, northern Europe, and Taklimakan Desert; and (3) settlement of low pressure in Iran, Saudi Arabia and south of Italy and high pressure in Egypt and Siberia.