New aromatic biomarkers and possible maturity indicators found in New Albany Shale extracts

Aromatic hydrocarbons from benzene extracts of New Albany Shale were characterized. A biomarker that has a molecular weight of 546 and a structural configuration consistent with that of an alkyl-aromatic hydrocarbon (C₄₀H₆₆) was tentatively identified. It was found that the relative concentrations of the biomarker are indicative of differing levels of thermal maturity of the shale organic matter. A 40-carbon bicyclic carotenoid (C₄₀H₄₈) is proposed as the geochemical precursor of this biomarker. Thermal maturity of the shale organic matter can also be differentiated by observing differences in “fingerprints” as obtained by field-ionization mass spectrometry on the aromatic hydrocarbon fraction. Using this technique, we found that the more mature shale samples from southeastern Illinois contain more low molecular weight extractable aromatic hydrocarbons and the less mature shale samples from northwestern Illinois contain more high molecular weight extractable aromatic hydrocarbons. It was demonstrated that field-ionization and tandem mass spectrometric techniques through fingerprint and individual compound identification, are useful for shale aromatic hydrocarbon fraction characterization and for thermal maturation interpretation.     

Decolorisation of exhausted reactive dye bath using ozonator for reuse

Exhausted Reactive dye bath samples of Turquoise Blue, Olive Green and Navy Blue shades were collected from cotton knit wear dyeing units in Tirupur. Ozonation was conducted in a column reactor system fed with ozone at the rate of 0.16 g/min to assess its efficiency in reducing the color, chemical oxygen demand and total organic carbon. Complete decolorization of the effluent was achieved in 10 min contact time and ozone consumption of 153 mg/ L for Turquoise Blue, 128 for Olive Green and 143 for Navy Blue shades effluents respectively. The corresponding COD removal was 43%, 44% and 43% for the three shades while TOC removal efficiency was 45%, 45% and 40% respectively. The results from the reusability studies indicate that the dyeing quality was not affected by the reuse of decolorized dye bath for two successive cycles. It is concluded that ozonation is efficient in decolorization of exhausted dye bath effluents containing conventional reactive dyes. However, the corresponding removal of COD from the textile effluent was not significant.     

A Mesocyclone over the Northern Sea of Japan in February 2013

Oceanology - The article considers a particular event in the influence of a mesoscale cyclone (MC) on the northern Sea of Japan on February 10–11, 2013. The passage of the MC was accompanied...     

The Structure of the Bazhenov Horizon in the Northeast Part of West Siberia

A new variant of the structural-facies zonation of the Bazhenov horizon (Tithonian–Lower Berriasian) in the northeastern part of West Siberia was considered using lithofacies and structural analysis. The low content of terrigenous sedimentary material in the high-carbon facies of the Bazhenov Formation is explained by the capturing of the material by the relatively deep Pur–Taz Paleobasin, where the fan of the Yenisei–Khatanga strait was formed. The Pur–Taz Paleobasin was filled by the sediments of the Yanovstanov Formation. In the northeast the basin borders the vast and relatively shallow Ob Paleobasin, where the black shales of the oil-source Bazhenov Formation were accumulated.     

Dating of mine waste in lacustrine sediments using cesium-137

For over a century Medicine Lake in northern Idaho has received heavy-metal-laden tailings from the Coeur d'Alene mining district. Establishing the depositional chronology of the lake bottom sediments provides information on the source and rate of deposition of the tailings. Cesium-137, an isotope produced in the atmosphere by nuclear bomb tests, was virtually absent in the environment prior to 1951, but reached its apex in 1964. Our analysis of cesium-137 in the sediments of Medicine Lake revealed that 14 cm of fine-grained tailings were deposited in the lake from 1951 to 1964 and tailing deposition downstream was greatly reduced by the installation of tailings dams in the district in 1968. Cesium-137 analysis is accomplished by a fairly simple gamma-ray counting technique and should be a valuable tool for analyzing sedimentation in any lacustrine environment that was active during the 1950s and 1960s.     

Micromammals and paleoenvironmental interpretation in southern Africa

Micromammalian remains from archaeological sites in southern Africa provide paleoenvironmental evidence at a number of levels of precision. At the lowest level, broad vegetation categories can be identified. At the second level, proportional representation of vegetation categories and general climatic conditions are indicated. the possible overlying effects of agriculture and sea-level changes can also be identified. At the third level, there is clear but as yet largely unrealized potential for quantifying climatic variation and specifying environmental factors. In order to improve potential for interpretation, greater rigor is necessary in sample collection and in the establishment of the widest possible comparative data base, with the latter being in particular need of attention. Detailed paleoenvironmental information can also provide an independent data base for assessment of ecological approaches to archaeology.     

The effects of heating on low-temperature susceptibility and hysteresis properties of basalts

The variation of the low-field susceptibility of basalts down to liquid-nitrogen temperature always falls into one of three types that depend on the composition and grain size of the titanomagnetite grains present. Group 1 basalts contain predominantly unoxidised, multidomain homogeneous titanomagnetites having x 0.3. Group 2 basalts contain predominantly titanomagnetite grains with many exsolved ilmenite lamallae that subdivide the grains so that they act similarly to single domains. Group 3 basalts contain predominantly multidomain magnetite or magnetite-rich titanomagnetite having x 0.15. After repeated heating to 615°C, the group 1 basalts gradually oxidise above 300°C to produce the characteristics of group 2 basalts, owing to the exsolution of ilmenite. On the other hand, both group 2 and 3 basalts are stable to oxidation until at least 500°C. They are therefore the most useful material for palaeointensity studies.     

Fluids in the lithosphere, 2. Experimental constraints on CO2 transport in dunite and quartzite at elevated P-T conditions with implications for mantle and crustal decarbonation processes

In a series of experiments at 0.5–1.3 GPa and 1050–1200°C we have monitored the transport, via crack propagation, of CO₂ into well-annealed olivine and quartz aggregates. The objectives were to determine (1) the extent and rate of fluid penetration; (2) the effect of varying both P-T conditions and microstructure; and (3) the fluid penetration pathways. Experiments on CO₂ penetration into dunite annealed in the absence of MgO indicate rapid and pervasive fluid transport on a grain-dimension scale, but a limited penetration distance ( 1 mm). Additional experiments on dunite annealed in the presence of MgO (either dispersed or present at both ends), however, resulted in CO₂ penetration that was both pervasive on the scale of individual grains and almost always completely through the 5 mm long samples. The abundance of fine (10 μm) grains in the MgO-free dunite, in contrast to the much larger grain sizes of the samples annealed with MgO present, suggests the difference in fluid penetration behavior may arise because the strength variation in dunite scales with the grain size. Effects arising from changes in olivine point defect chemistry, however, are an additional possibility. The response of synthetic quartzite to CO₂ overpressure is distinct from that of dunite: Quartzite experiences rapid and complete penetration of CO₂, via a macroscopically visible system of transgranular fractures, over the range of P-T conditions investigated.The small amount of porosity ( 2–3%) present in most rock samples fabricated for this study, lacks three-dimensional connectivity, thus precluding any enhanced fluid penetration via porous flow. Pores could possibly enhance fluid penetration as the result of a small reduction in resistance to fracture, but the probable abundance of strength-controlling flaws in natural rocks is likely to produce similar behavior.The results of our experiments on olivine and olivine + MgO suggest that the transport of pressurized CO₂ in very olivine-rich mantle environments will be pervasive on the scale of individual grains and its extent may be dependent on rock microstructure and/or crystal chemical effects. Such pervasive fluid transport, perhaps associated with magma decarbonation, may have interesting implications for both magma transport and local LREE enrichment of adjacent mantle wall-rock. The ease with which quartzite is penetrated by CO₂ at the conditions of our experiments underscores the possible role of decarbonation reactions in crustal permeability-enhancement processes.     

An investigation of the controls on Irish precipitation δ18O values on monthly and event timescales

This two-year study investigates the relative influence of meteorological variables (precipitation amount and temperature), atmospheric circulation, air mass history, and moisture source region on Irish precipitation oxygen isotopes (δ¹⁸O_p) on event and monthly timescales. Single predictor correlations reveal that on the event scale, 20% of δ¹⁸O_p variability is attributable to the amount effect and 7% to the temperature effect while on the monthly timescale the North Atlantic Oscillation accounts for up to 20% of δ¹⁸O_p variability and the amount and temperature effects are not significant. In comparison, multivariate linear regression reveals that the interaction of temperature and precipitation amount explains up to 40% of δ¹⁸O_p variance at event and monthly timescales. Five-day kinematic back trajectories suggest that the amount-weighted mean δ¹⁸O_p value of southerly- and northerly-derived events are lower by 2‰ relative to events derived from the west. Because air mass history and atmospheric circulation appear to influence δ¹⁸O_p in Ireland, Irish paleo-δ¹⁸O_p proxy records are best interpreted as reflecting a combination of parameters, not just paleotemperature or paleorainfall.     

Field observations of waves generated by passing ships: A note

This short contribution reports the results of a field study on the nearshore characteristics of waves generated by both conventional and high speed passenger ferries. The field observations took place in the late summer of 2005, at a beach close to the port of Mytilene (Island of Lesbos, Greece), and involved the visual observation of ship waves, using digital video recordings and image processing techniques. The results showed that passage of the fast ferry was associated with a longer, more complex and energetic nearshore event; this event not only did include higher nearshore waves (up to 0.74 m) and was organised in different wave packets, but it was also an order of magnitude longer (∼ 680 s) than the conventional ferry event. Regarding the effects on beach sediment dynamics, the fast ferry waves were estimated to be very efficient in mobilising the nearshore sediments in contrast to those of the conventional ferry. The fast ferry service appears to generate daily prolonged nearshore events, which contain waves with higher energy than those expected from the normal summer wind wave regime of the area; these events also include some high and very steep waves, which can be particularly erosive. Therefore, fast ferry wakes may have considerable impacts on the seasonal beach sediment dynamics/morphodynamics and the nearshore benthic ecology, as well as they may pose significant risks to bathers, affecting the recreational use of the beaches exposed to fast ferry traffic. Finally, the study has shown that satisfactory field observations of the nearshore characteristics of ship-generated (and wind) waves can be obtained using inshore deployments of calibrated poles, digital video cameras and appropriate image processing algorithms.