40Ar/39Ar and oxygen isotope studies of polymetamorphism from Tinos Island, Cycladic blueschist belt, Greece

Abstract Petrological, oxygen isotope and ⁴⁰Ar/³⁹Ar studies were used to constrain the Tertiary metamorphic evolution of the lower tectonic unit of the Cyclades on Tinos. Polyphase high-pressure metamorphism reached pressures in excess of 15 kbar, based on measurements of the Si content in potassic white mica. Temperatures of 450–500° C at the thermal peak of high-pressure metamorphism were estimated from critical metamorphic assemblages, the validity of which is confirmed by a quartz–magnetite oxygen isotope temperature of 470° C. Some ⁴⁰Ar/³⁹Ar spectra of white mica give plateau ages of 44–40 Ma that are considered to represent dynamic recrystallization under peak or slightly post-peak high-pressure metamorphic conditions. Early stages in the prograde high-pressure evolution may be documented by older apparent ages in the high-temperature steps of some spectra. Eclogite to epidote blueschist facies mineralogies were partially or totally replaced by retrograde greenschist facies assemblages during exhumation. Oxygen isotope thermometry of four quartz–magnetite pairs from greenschist samples gives temperatures of 440–470° C which cannot be distinguished from those deduced for the high-pressure event. The exhumation and overprint is documented by decreasing ages of 32–28 Ma in some greenschists and late-stage blueschist rocks, and ages of 30–20 Ma in the lower temperature steps of the Ar release patterns of blueschist micas. Almost flat parts of Ar–Ar release spectra of some greenschist micas gave ages of 23–21 Ma which are assumed to represent incomplete resetting caused by a renewed prograde phase of greenschist metamorphism. Oxygen isotope compositions of blueschist and greenschist facies minerals show no evidence for the infiltration of a δ¹⁸O-enriched fluid. Rather, the compositions indicate that fluid to rock ratios were very low, the isotopic compositions being primarily controlled by those of the protolith rocks. We assume that the fundamental control catalysing the transformation of blueschists into greenschists and the associated resetting of their isotopic systems was the selective infiltration of metamorphic fluid. A quartz–magnetite sample from a contact metamorphic skarn, taken near the Miocene monzogranite of Tinos, gave an oxygen isotope temperature of 555° C and calculated water composition of 9.1%. The value of δ¹⁸O obtained from this water is consistent with a primary magmatic fluid, but is lower than that of fluids associated with the greenschist overprint, which indicates that the latter event cannot be directly related to the monozogranite intrusion.     

Shakedown in layered pavements under moving surface loads

Elastic–plastic deformations in pavements consisting of layers of different frictional materials are investigated. The upper bound, kinematic shakedown theorem is used to obtain estimates of the critical shakedown loads. Fully general three-dimensional deformations are considered. The influence of the loading distribution, interactions between loads, and the effect of varying the thickness, stiffness and strength of the layers are explored. Consequences of this investigation for particular existing designs of flexible pavements are investigated. In particular, it is found that the strength of the subgrade has no effect on the magnitude of the critical shakedown load.     

Study of radiative energy losses in the moving envelopes of T Tau stars

Crimean Astrophysical Observatory. Translated from Astrofizika, Vol. 32, No. 1, pp. 69–83, January–February, 1990.     

Auroral zone effects on hydrogen geocorona structure and variability

The instantaneous structure of planetary exospheres is determined by the time history of energy dissipation, chemical, and transport processes operative during a prior time interval set by intrinsic atmospheric time scales. The complex combination of diurnal and magnetospheric activity modulations imposed on the Earth's upper atmosphere no doubt produce an equally complex response, especially in hydrogen, which escapes continuously at exospheric temperatures. Vidal-Madjar and Thomas (1978) have discussed some of the persistent large scale structure which is evident in satellite ultraviolet observations of hydrogen, noting in particular a depletion at high latitudes which is further discussed by Thomas and Vidal-Madjar (1978). The latter authors discussed various causes of the H density depletion, including local neutral temperature enhancements and enhanced escape rates due to polar wind H⁺ plasma flow or high latitude ion heating followed by charge exchange. We have reexamined the enhancement of neutral escape by plasma effects including the recently observed phenomenon of low altitude transverse ion acceleration. We find that, while significant fluxes of neutral H should be produced by this phenomenon in the auroral zone, this process is probably insufficient to account for the observed polar depletion. Instead, the recent exospheric temperature measurements from the Dynamics Explorer-2 spacecraft suggest that neutral heating in and near the high latitude cusp may be the major contributor to depleted atomic hydrogen densities at high latitudes.     

Upscaling of elastic properties for large scale geomechanical simulations

Large scale geomechanical simulations are being increasingly used to model the compaction of stress dependent reservoirs, predict the long term integrity of under‐ground radioactive waste disposals, and analyse the viability of hot‐dry rock geothermal sites. These large scale simulations require the definition of homogenous mechanical properties for each geomechanical cell whereas the rock properties are expected to vary at a smaller scale. Therefore, this paper proposes a new methodology that makes possible to define the equivalent mechanical properties of the geomechanical cells using the fine scale information given in the geological model. This methodology is implemented on a synthetic reservoir case and two upscaling procedures providing the effective elastic properties of the Hooke's law are tested. The first upscaling procedure is an analytical method for perfectly stratified rock mass, whereas the second procedure computes lower and upper bounds of the equivalent properties with no assumption on the small scale heterogeneity distribution. Both procedures are applied to one geomechanical cell extracted from the reservoir structure. The results show that the analytical and numerical upscaling procedures provide accurate estimations of the effective parameters. Furthermore, a large scale simulation using the homogenized properties of each geomechanical cell calculated with the analytical method demonstrates that the overall behaviour of the reservoir structure is well reproduced for two different loading cases. Copyright © 2004 John Wiley & Sons, Ltd.     

Geometry and kinematics of recent deformation in the Mondy–Tunka area (south-westernmost Baikal rift zone, Mongolia–Siberia)

We used satellite imagery and field data to investigate the south‐westernmost Baikal rift zone. We focus our study in the Mondy and Ikhe Ukhgun valleys, site of an Mw = 6.9 seismic event in 1950. Surface deformations are observed along the E–W‐trending Mondy strike‐slip fault and along the Ikhe Ukhgun thrust. The Mondy fault system is 80 km long and is composed of four segments 10–15 km long. These segments are characterized by subvertical planes with left‐lateral movements. The Ikhe Ukhgun thrust is 20 km long, dips 40° to the south and shows reverse movement with a left‐lateral component. These observations are consistent with the present‐day regional NNE–SSW compression and with the focal mechanism of the 1950 Mondy earthquake that was recently re‐evaluated. These features, like those observed in the Tunka basin, demonstrate a recent change of regional strain regime from transtension to transpression that we place before the Late Pleistocene.     

A shipborne- type wave-height meter for oceangoing vessels, using microwave Doppler radar

A wave-height meter using a simple microwave Doppler radar,simeq10mW in power and 10.525 GHz in frequency, is proposed so that we can measure oceanic waves effectively while the ship is steaming. It was first applied to the measurement of the variation of water level generated in a wave tank, which suggested that it is adequately applicable to the measurement of oceanic waves. A field test was carried out off the cape of Nojimazaki by installing the Doppler radar 5 m above the sea level at the bow of the ship. The result agreed reasonably well with that measured simultaneously by the ultrasonic wave-height meter installed at the same position. Another test is running successfully on a larger ship with the wave-height meter installed at 9 m above the sea level. The significant wave height measured by the present meter is being compared with that observed visually by the navigation officers.     

Preliminary organic petrography of Palaeozoic rocks from the Grand Banks,Newfoundland

Samples of lower Palaeozoic bedrock from the Grand Banks of Newfoundland were examined using reflected light microscopy and Rock-Eval pyrolysis. These samples contained organic material which included bitumen (structureless organic material), acritarchs, chitinozoa, scolecodonts and graptolites. The reflectance of the organic material increased from acritarchs towards graptolites with bitumen showing a wide range of reflectance. Multiple phases of oil migration through one sample were inferred by examination of the bitumens: the lowest reflecting being more recent than the highest reflecting bitumen. Combined reflectance and Rock-Eval analysis indicate that these samples are mature to overmature. The two oldest samples (Arenig-Llanvirn, Ordovician) are assessed as mature and as having potential for generation of liquid hydrocarbons, but must be considered as mainly gas prone.     

Readout Techniques for Drift and Low Frequency Noise Rejection in Infrared Arrays

Three different methods are presented to subtract thermal drifts and low-frequency noise from the signal of infrared array. The first is dead pixels with open Indium bumps, the second is reference output as implemented on the Hawaii2 multiplexer, and the third is dark pixels to emulate reference cells having a capacity connected to the gate of the unit cell field-effect transistor (FET). The third method is the most effective and yields a reduction in readout noise from15.4–9.4 erms. A novel method will be described to extend this readout technique to the Aladdin 1 K × 1 K InSb array. This revised version was published online in July 2006 with corrections to the Cover Date.