The Roche Limit

The role of tides in deforming and possibly disrupting a secondary body orbiting about a primary body has been known for a considerable time. This was first inspired by the observations of ocean tides on Earth and then seen as playing an important role in the formation and evolution of the Earth–Moon system. Finally, in the beginning of the 20th century it was generally thought to have a significant role in the formation of the solar system through the tidal disruption of the Sun. Here, an overview of the historical developments of the ideas concerned with tidal disruption of a secondary body that can lead to mass loss is given. Some discussion of possible extensions to consider more realistic situations where the secondary body may not be moving on a circular orbit and may not rotate so as to maintain the phase-on configuration to the primary body is also given.     

Microtextures and crystal chemistry in P21/c pigeonites

Summary ?A single-crystal X-ray investigation was performed on crystals of P2₁/c natural pigeonite with varying Ca and Fe^* ( = Fe²⁺ + Mn²⁺) contents, in order to verify the effect of microtextural disorder on structure refinements and to constrain the crystal chemistry of pigeonite. Antiphase domains and exsolution lamellae affect differently the refinement results. In a crystal free of exsolution the structure obtained after refinement with all reflections is an average of that of the antiphase domains and of their boundaries, whereas in an exsolved crystal it represents only the structure of the prevailing pigeonite lamellae. The refinement using only h + k odd reflections seems to give the structure of the Ca-free pigeonite characteristic of the antiphase domains rather than that of Ca-rich domain walls. The ratio of the scale factors in refinements with all reflections and with only h + k odd reflections allows the ratios of the exsolved augite and pigeonite phases to be estimated. The crystal chemistry of the investigated samples follows the trends outlined by data on Ca-free and Fe-free synthetic samples. In particular, it is shown that Ca and Fe^* substitution for Mg induce similar changes in the average structure, i.e. both induce an expansion in the M1 polyhedron and decrease the difference between the M2–O3 distances. Received October 18, 2001; revised version accepted February 15, 2002     

Size and shape evolution of pores in a viscoplastic matrix under compression

The frequent use of soils and earth materials for hydraulic capping and for geo‐environmental waste containment motivated our interest in detailed modelling of changes in size and shape of macro‐pores to establish links between soil mechanical behaviour and concurrent changes in hydraulic and transport properties. The objective of this study was to use finite element analysis (FEA) to test and extend previous analytical solutions proposed by the authors describing deformation of a single macro‐pore embedded in linear viscoplastic soil material subjected to anisotropic remote stress. The FEA enables to consider more complex pore geometries and provides a detailed picture of matrix yield behaviour to explain shortcomings of approximate analytical solutions. Finite element and analytical calculations agreed very well for linear viscous as well as for viscoplastic materials, only limited for the case of isotropic remote stress due to the simplifications of the analytical model related to patterns and onset of matrix‐yielding behaviour. FEA calculations were compared with experimental data obtained from a compaction experiment in which pore deformation within a uniform modelling clay sample was monitored using CAT scanning. FEA predictions based on independently measured material properties and initial pore geometry provided an excellent match with experimentally determined evolution of pore size and shape hence lending credence to the potential use of FEA for more complex pore geometries and eventually connect macro‐pore deformation with hydraulic properties. Copyright © 2006 John Wiley & Sons, Ltd.     

Structural development along the Billefjorden Fault Zone in the area between Kjellströmdalen and Adventdalen/Sassendalen, central Spitsbergen

The Billefjorden Fault Zone represents a major lineament on Spitsbergen with a history of tectonic activity going back into the Devonian and possibly earlier. Recent structural, sedimcntological and stratigraphical investigations indicate that most of the stratigraphic thickness variations within the Mesozoic strata along the Billefjorden Fault Zone south of Isfjordcn are due to Tertiary compressional tectonics related to the transpressive Eocene West-Spitsbergen Orogeny. No convincing evidence of distinct Mesozoic extensional events, as suggested by previous workers, has been recognized. Tertiary compressional tectonics are characterized by a combined thin-skinned/thick-skinned structural style. Decollement zones arc recognized in the Triassic Sassendalen Group (tower Décollement Zone) and in the Jurassic/Cretaceous Janusfjellet Subgroup (Upper Décollement Zone). East-vergent folding and reverse faulting associated with these decollement' zones have resulted in the development of compressional structures, of which the major arc the Skolten and Tronfjellct Anticlines and the Advcntelva Duplex. Movements on one or more high angle east-dipping reverse faults in the pre-Mesozoic basement have resulted in the development of the Juvdalskampcn Monocline, and are responsible for out-of-sequence thrusting and thinning of the Mesozoic sequence across the Billefjorden Fault Zone. Preliminary shortening calculations indicate an eastward displacement of minimum 3-4 km, possibly as much as 10 km for the Lower Cretaceous and younger rocks across the Billefjorden Fault Zone.     

Neutron capture measurements on radioactive93Zr

Neutron capture measurements made on a sample of fission-product zirconium containing 20%⁹³Zr(t _1/2=1.5×10⁶a) at the Oak Ridge Electron Linear Accelerator time-of-flight facility resulted in the identification of 138 resonance peaks for the⁹³Zr isotope at neutron energies up to 21.5 keV. Average capture cross sections from 20 to 300 keV were derived by subtracting neutron capture yields of the stable zirconium isotopes^{90, 91, 92, 94, 96}Zr and additional backgrounds. The average cross sections found were significantly less than those of JENDL-1. While generally 30% higher than those of ENDF/B —V below 60 keV, the binned data overlapped the smooth ENDF/B —V curve. The average for a Maxwellian neutron spectrum withkT=30 keV is (95±10) mb and the resonance contribution to the capture resonance integral is (15.0±0.5)b.Research sponsored by the U.S. Department of Energy, Office of Basic Energy Sciences, under contract DE-AC05-840R21400 with the Martin Marietta Energy Systems, Inc.     

A sapphirine–phlogopite–cordierite paragenesis in a low-P amphibolite facies terrain, Arunta Inlier, Australia

Summary Silica-undersaturated phlogopite schists from the Cackleberry Metamorphics, Arunta Inlier, central Australia, preserve relatively low-temperature sapphirine-bearing parageneses that developed during low-pressure upper amphibolite facies metamorphism. Peak metamorphic phlogopite–cordierite–sapphirine assemblages are interpreted to have formed during the same event recorded in nearby metapelites, at c.3 kbar and 650–700 °C. Initial cooling of the terrain resulted in the breakdown of sapphirine to corundum–chlorite–phlogopite and corundum–spinel–chlorite assemblages. Further retrogression at greenschist facies conditions resulted in the replacement of sapphirine by diaspore–chlorite intergrowths. The reaction textures are consistent with a near-isobaric heating-cooling path at low-pressure, and provide evidence for the stability of sapphirine at c.700 °C at low pressures in rocks of an appropriate Mg- and Fe³⁺-rich bulk composition. Received August 15, 2001 accepted December 27, 2001     

Comparison of results from several AOGCMs for global and regional sea-level change 1900–2100

 Sea-level rise is an important aspect of climate change because of its impact on society and ecosystems. Here we present an intercomparison of results from ten coupled atmosphere-ocean general circulation models (AOGCMs) for sea-level changes simulated for the twentieth century and projected to occur during the twenty first century in experiments following scenario IS92a for greenhouse gases and sulphate aerosols. The model results suggest that the rate of sea-level rise due to thermal expansion of sea water has increased during the twentieth century, but the small set of tide gauges with long records might not be adequate to detect this acceleration. The rate of sea-level rise due to thermal expansion continues to increase throughout the twenty first century, and the projected total is consequently larger than in the twentieth century; for 1990–2090 it amounts to 0.20–0.37 m. This wide range results from systematic uncertainty in modelling of climate change and of heat uptake by the ocean. The AOGCMs agree that sea-level rise is expected to be geographically non-uniform, with some regions experiencing as much as twice the global average, and others practically zero, but they do not agree about the geographical pattern. The lack of agreement indicates that we cannot currently have confidence in projections of local sea-level changes, and reveals a need for detailed analysis and intercomparison in order to understand and reduce the disagreements. Received: 1 September 2000 / Accepted: 20 April 2001     

Multiple-source localization using GPS technology and receivedarrival time structure analysis in an air-deployed system

An efficient and robust method has been developed to locate multiple impulsive sources in an ocean environment. Global position system (GPS) receivers were installed on sonobuoys to obtain their locations within a few meters of accuracy. A sonobuoy field was deployed in a ring-type pattern. Charges were then set off at arbitrary locations within the ring, High-resolution plots were used to obtain direct path and/or first bottom bounce arrivals on each buoy. A model grid of arrival times was constructed, corresponding to the dimensions of the buoy field. A ray model previously developed here at the Applied Research Laboratories at the University of Texas at Austin (ARL:UT) was used to obtain model travel times. The minimum value of the least-square-type error between the real arrival times and the modeled travel times resulted in an unambiguous location of the source, within the limits of the grid spacing chosen. This value was calculated by picking one receiver as the reference and then summing the timing errors of the remaining receivers relative to the reference. Successive iterations with finer grid spacings result in source localization within the accuracy of the buoy locations. The localization routine was extended by allowing permutations of the pulse arrivals on each buoy to account for multiple sources closely separated in time and/or space. An automated correlation technique is presented as an alternative to the leading edge-detection method used here for obtaining relative arrival times. Two proof-of-concept experiments were performed and some results of data obtained at Lake Travis and the Gulf of Mexico are presented