A time-varying parameter model of a body oscillating in pitch

Among the assumptions upon which linear time-invariant models of floating bodies are based is that the body motions are so small that any change in the body’s angular position can be disregarded. However, it is often a major design requirement of a wave energy conversion device that the response amplitude is large, thereby invalidating one of the assumptions of the linear model. In particular, the immersed geometry of a body undergoes considerable variation when it is moved in pitch. With regard to this we investigate the difference in performance between a quasi-linear model in which the change of immersed surface is modelled by time-varying parameters and a basic linear model in which the immersed surface is time-invariant. The time-varying parameter model is realized by interpolation between the appropriate parameter values of a set of linear time-invariant (LTI) models derived for the different immersed surfaces that occur at discrete body displacements. It is shown that the responses predicted using the time-varying parameter model are closer to those measured experimentally than those of a standard frequency-domain model. Particular improvement occurs when the responses are large, such as at or near the resonance frequency. A problem which may limit the general use of the model is also discussed.     

Tidal fluxes of nutrients and suspended sediments at the North Inlet–Winyah Bay National Estuarine Research Reserve

Beginning June of 1993 suites of 13 water samples have been collected at Oyster Landing, North Inlet (SC), every 20 days covering two consecutive tidal cycles at 2.07 h intervals. In order to ascertain whether this large (and still growing) water chemistry data set can be used to determine tidal fluxes of nutrients and sediments, we coupled measured concentrations to estimates of instantaneous tidal discharge based on a basin water storage curve and hindcast tides. The mean advective fluxes of all constituents, including salt, showed statistically significant exports. This result, however, is largely due to an ebb bias in the sampling protocol, which resulted in 52% of the samples being collected on ebb tide versus a theoretical percentage of 48%. When this bias was corrected by reducing the mean discharge (−610 l s⁻¹) to a value (−125 l s⁻¹) that produced a balance between the mean advective and dispersive salt fluxes, the advective fluxes of the other constituents were reduced to values that are not significantly different from zero. In addition to a statistically significant dispersive influx of salt, significant dispersive exports were found for DON, NH₄, DOP, PO₄ and DOC. All particulate constituents (PN, PP, ISS and OSS) yielded dispersive fluxes that were not significantly different from zero. Annual material budgets for the Oyster Landing basin based on the dispersive fluxes of all constituents (except salt) are generally similar in magnitude and direction to those measured by [Dame, R.F., Spurrier, J.D., Williams, T.M., Kjerfve, B., Zingmark, R.G., Wolaver, T.G., Chrzanowski, T.H., McKeller, H.N., Vernberg, F.J., 1991. Annual material processing by a salt marsh-estuarine basin in South Carolina, USA. Marine Ecology Progress Series 72, 153–166.] in the nearby and ecologically similar Bly Creek basin, indicating that the dispersive fluxes determined in this study are realistic. We offer suggestions for improving the reliability and usefulness of future Oyster Landing water quality data.     

Isotopic and Elemental Variations of Carbon and Nitrogen in a Mangrove Estuary

Variations in elemental and isotopic ratios of suspended particulate matter (SPM) were investigated in the Guayas River Estuary Ecosystem (GREE) that empties into the Gulf of Guayaquil, Ecuador. Detritus in the system was identified on the basis of extremely high carbon:chlorophyll aratios (>1000). This material had mean δ¹³C of −26·4±0·3, δ¹⁵N of +4·8±0·2, and (C:N)_atomicof 14·1±0·9. The isotopic data were comparable to measurements reported for fresh and degrading mangrove leaves, whereas the elemental ratio was comparatively enriched in nitrogen. Isotope measurements of SPM throughout the GREE were more similar to values for riverine material and detritus compared with that for the coastal end-member. Values indicative ofin situproduced algae, sewage and shrimp pond effluent were only found at selected sites. Bacterial bioassays, which were used to document potential sources of dissolved organic matter in the GREE, were isotopically similar to SPM. This correspondence coupled with the relatively low (C:N)_aof SPM could be explained by bacterial immobolization of nitrogen onto detritus. Finally, tidal variations of (C:N)_aand δ¹³C at a brackish mangrove site were similar in magnitude to spatial variations encountered throughout the GREE. Based on these results, the authors caution that care must be taken when samples are taken for food-web studies in these systems.     

The impact of wave loads and pore-water pressure generation on initiation of sediment transport

The build-up of pore-water pressure by waves can lead to sediment liquefaction and subsequent transport by traction currents. This process was investigated by measuring pore-water pressures both in a field experiment and laboratory wave tank tests. Liquefaction was observed in the wave tank tests. The results suggest that sand is less susceptible than silts to wave-induced liquefaction because of the tendency to partially dissipate pore-water pressures. However, previous studies have determined that pore-water pressures must approach liquefaction before current velocities necessary to initiate transport are reduced. Once liquefaction has occurred more sediment can be transported.     

Wavelet analysis of bathymetric sidescan sonar data for the classification of seafloor sediments in Hopvågen Bay - Norway

In this paper we examine the use of bathymetric sidescan sonar for automatic classification of seabed sediments. Bathymetric sidescan sonar, here implemented through a small receiver array, retains the advantage of sidescan in speed through illuminating large swaths, but also enables the data gathered to be located spatially. The spatial location allows the image intensity to be corrected for depth and insonification angle, thus improving the use of the sonar for identifying changes in seafloor sediment. In this paper we investigate automatic tools for seabed recognition, using wavelets to analyse the image of Hopvågen Bay in Norway. We use the back-propagation elimination algorithm to determine the most significant wavelet features for discrimination. We show that the features selected present good agreement with the grab sample results in the survey under study and can be used in a classifier to discriminate between different seabed sediments.     

A detailed geochemical and rock magnetic study of dredged basalt from the Sheba Ridge,Gulf of Aden

We report the results of petrological, geochemical and rock magnetic studies of basalt dredged from the eastern end of the west Sheba Ridge during cruise 11/1979 of R. R. S. Shackleton to the Western Gulf of Aden. The ridge is part of the Red Sea-Gulf of Aden spreading axis and the basalts are olivine tholeiites. The abundances of some elements are characteristic of normal MORB (mid-ocean ridge basalt) but other elemental abundances suggest affinites with transitional-type MORB.The observed magnetic properties are interpreted in terms of the composition, concentration and microstructure of the magnetic mineral fraction by recourse to the available data on synthetic analogues. The analysis has been carried out in greater detail than has been attempted in previous magneto-petrological studies. It appears that submarine weathering of the magnetic minerals (maghemitization) brings about not only the expected change in composition but also a fall in concentration of the magnetic fraction. This could result from the removal-of-iron oxidation mechanism operating in the submarine environment. It is also found that the fall in remanence with increasing degree of maghemitization is not explicable in terms of the change in composition and concentration of the magnetic minerals. A further influence—probably microstructural change—significantly reduces the remanence intensity.     

Behavioural Effects of Chemically Dispersed Oil and Subsequent Recovery in Diploria strigosa (Dana)

Abstract. Survival and behaviour of the hermatypic coral Diploria strigosa was studied during 6–24 h doses with water-accomodated fractions of chemically dispersed crude oil, and for a subsequent recovery period of 1 month. Experiments utilized a flow-through laboratory dosing procedure and incorporated petroleum hydrocarbon measurements in order to simulate a major but short-term oil spill in shallow subtidal benthic reef environments. Chemically dispersed oil treatments consisted of Arabian Light Crude oil with Corexit 9527 or BP1100WD at 1–20 ppm concentrations of oil.
In general, effects observed were sub-lethal, temporary, and associated with the highest concentrations tested. Responses to the presence of dispersed oil at 20ppm for 24 h included mesenterial filament extrusion, extreme tissue contraction, tentacle retraction and localized tissue rupture. The nature and severity of reactions during the dosing phase varied between colonies and treatments, but colonies typically resumed normal behaviour within 2 h to 4 d of the recovery period. It therefore seems unlikely that observed biological effects would impair long-term viability.     

Geology of the Continental Margin of Enderby and Mac. Robertson Lands, East Antarctica: Insights from a Regional Data Set

In 2001 and 2002, Australia acquired an integrated geophysical data set over the deep-water continental margin of East Antarctica from west of Enderby Land to offshore from Prydz Bay. The data include approximately 7700 km of high-quality, deep-seismic data with coincident gravity, magnetic and bathymetry data, and 37 non-reversed refraction stations using expendable sonobuoys. Integration of these data with similar quality data recorded by Japan in 1999 allows a new regional interpretation of this sector of the Antarctic margin. This part of the Antarctic continental margin formed during the breakup of the eastern margin of India and East Antarctica, which culminated with the onset of seafloor spreading in the Valanginian. The geology of the Antarctic margin and the adjacent oceanic crust can be divided into distinct east and west sectors by an interpreted crustal boundary at approximately 58° E. Across this boundary, the continent–ocean boundary (COB), defined as the inboard edge of unequivocal oceanic crust, steps outboard from west to east by about 100 km. Structure in the sector west of 58° E is largely controlled by the mixed rift-transform setting. The edge of the onshore Archaean–Proterozoic Napier Complex is downfaulted oceanwards near the shelf edge by at least 6 km and these rocks are interpreted to underlie a rift basin beneath the continental slope. The thickness of rift and pre-rift rocks cannot be accurately determined with the available data, but they appear to be relatively thin. The margin is overlain by a blanket of post-rift sedimentary rocks that are up to 6 km thick beneath the lower continental slope. The COB in this sector is interpreted from the seismic reflection data and potential field modelling to coincide with the base of a basement depression at 8.0–8.5 s two-way time, approximately 170 km oceanwards of the shelf-edge bounding fault system. Oceanic crust in this sector is highly variable in character, from rugged with a relief of more than 1 km over distances of 10–20 km, to rugose with low-amplitude relief set on a long-wavelength undulating basement. The crustal velocity profile appears unusual, with velocities of 7.6–7.95 km s⁻¹ being recorded at several stations at a depth that gives a thickness of crust of only 4 km. If these velocities are from mantle, then the thin crust may be due to the presence of fracture zones. Alternatively, the velocities may be coming from a lower crust that has been heavily altered by the intrusion of mantle rocks. The sector east of 58° E has formed in a normal rifted margin setting, with complexities in the east from the underlying structure of the N–S trending Palaeozoic Lambert Graben. The Napier Complex is downfaulted to depths of 8–10 km beneath the upper continental slope, and the margin rift basin is more than 300 km wide. As in the western sector, the rift-stage rocks are probably relatively thin. This part of the margin is blanketed by post-rift sediments that are up to about 8 km thick. The interpreted COB in the eastern sector is the most prominent boundary in deep water, and typically coincides with a prominent oceanwards step-up in the basement level of up to 1 km. As in the west, the interpretation of this boundary is supported by potential field modelling. The oceanic crust adjacent to the COB in this sector has a highly distinctive character, commonly with (1) a smooth upper surface underlain by short, seaward-dipping flows; (2) a transparent upper crustal layer; (3) a lower crust dominated by dipping high-amplitude reflections that probably reflect intruded or altered shears; (4) a strong reflection Moho, confirmed by seismic refraction modelling; and (5) prominent landward-dipping upper mantle reflections on several adjacent lines. A similar style of oceanic crust is also found in contemporaneous ocean basins that developed between Greater India and Australia–Antarctica west of Bruce Rise on the Antarctic margin, and along the Cuvier margin of northwest Australia.     

Evidence for methane and hydrogen sulfide venting imprinted on a Quaternary eolianite from southern Israel

Two different and physically separated chemosynthetic communities of bacteria are responsible for the formation of the Beeri native sulfur deposit hosted in a Late Quaternary sandstone on the southern coastal plain of Israel. The enriched concentrations are distributed over an area of about 1 km², within a zone 2–3 m thick at 1–13 m below surface. Two hundred fifty meters below the sulfur deposit, sulfur-reducing bacteria, thriving on methane generated in Neogene marls, reduced the Messinian gypsum to generate hydrogen sulfide, which subaqueously vented together with methane into the siliciclastic Quaternary sequence. Another, different chemosynthetic community ofBeggiatoa-like and unidentified bacteria oxidized the hydrogen sulfide into native sulfur and secondary gypsum, alunite, and iron sulfates. The coupled chemical and bacterial processes attributed to the formation of the sulfur deposit at Beeri are strikingly similar to the processes occurring today in the context of submarine hydrocarbon vents associated with the salt diapirs in the Gulf of Mexico.