Investigation of waste disposal areas using electrical methods: a case study from Chania,Crete, Greece

A geophysical investigation of a landfill area was conducted as inextricable phase of a preliminary geotechnical, geological and hydrogeological study of the area under investigation. Electrical resistivity tomography (ERT), one of the most promising prospecting techniques mainly concerning its effective contribution to resolve several environmental problems, was applied for the geophysical modeling. ERT is a robust imaging method the theory and implementation of which are well documented in geophysical research literature. The survey site is located in Akrotirion Peninsula, about 7 km east of Chania city in Crete I. The geological setting comprises Trypalion limestones, marly limestones and a clayed weathered layer. Cavities are also identified at various scales which are recent tectono-karstic voids. Due to the above-mentioned geological singularity and in the light of the requirement for an environmentally safe construction of the landfill, an ERT survey was carried out. Specifically, seven geoelectrical tomographies were conducted reaching the prospecting depth of 36 m. The resulted images conduced, to overcome geotechnical problems since the spatial distribution of karstic voids was determined, to plan the future sites for waste disposal as the geological conditions were studied in detail and to reliably estimate the thickness of the already deposited wastes. The resulted images were confirmed using available borehole logs and ambient noise measurements.     

Conditional Probability Approach of the Assessment of Tsunami Potential: Application in Three Tsunamigenic Regions of the Pacific Ocean

We develop stochastic approaches to determine the potential for tsunami generation from earthquakes by combining two interrelated time series, one for the earthquake events, and another for the tsunami events. Conditional probabilities for the occurrence of tsunamis as a function of time are calculated by assuming that the inter-arrival times of the past events are lognormally distributed and by taking into account the time of occurrence of the last event in the time series. An alternative approach is based on the total probabilitiy theorem. Then, the probability for the tsunami occurrence equals the product of the ratio, r (= tsunami generating earthquakes/total number of earthquakes) by the conditional probability for the occurrence of the next earthquake in the zone. The probabilities obtained by the total probability theorem are bounded upwards by the ratio r and, therefore, they are not comparable with the conditional probabilities. The two methods were successfully tested in three characteristic seismic zones of the Pacific Ocean: South America, Kuril-Kamchatka and Japan. For time intervals of about 20 years and over the probabilities exceed 0.50 in the three zones. It has been found that the results depend on the approach applied. In fact, the conditional probabilities of tsunami occurrence in Japan are slightly higher than in the South America region and in Kuril-Kamchatka they are clearly lower than in South America. Probabilities calculated by the total probability theorem are systematically higher in South America than in Japan while in Kuril-Kamchatka they are significantly lower than in Japan. The stochastic techniques tested in this paper are promising for the tsunami potential assessment in other tsunamigenic regions of the world.     

The Poseidon Operational Tool for the Prediction of Floating Pollutant Transport

In this work the development and the application of an operational management tool for the Greek Seas is described. This tool consists of a three-dimensional floating pollutant prediction model coupled with a weather, a hydrodynamic and a wave model in order to track the movements and the spreading of the pollutants and indicate those coastal areas which might be affected. The tool is part of the Poseidon system which has been designed to provide real time data and forecasts for marine environmental conditions in the Greek Seas. In this paper, we present four case studies based on realistic scenarios that show the value of the application for long-term strategic planning and short-term decision making in oil spill accidents.     

An investigation of earthquake induced pounding between adjacent buildings

The response of adjacent buildings in city blocks to several strong earthquakes is analysed, taking into account the mutual collisions, or pounding, resulting from insufficient or non-existing separation distances. The buildings are idealized as lumped-mass, shear beam type, multi-degree-of-freedom (MDOF) systems with bilinear force-deformation characteristics and with bases supported on translational and rocking spring-dashpots. Collisions between adjacent masses can occur at any level and are simulated by means of viscoelastic impact elements. Using five real earthquake motions the effects of the following factors are investigated: building configuration and relative size, seismic separation distance and impact element properties. It is found that pounding can cause high overstresses, mainly when the colliding buildings have significantly different heights, periods or masses. This suggests a possibility for introducing a set of conditions into the codes, combined with some special measures, as an alternative to the seismic separation requirement.     

The Pindos Fold-and-thrust belt (Greece): inversion kinematics of a passive continental margin

Continuous exposure in the Pindos mountain chain (Greece) and the detailed stratigraphic measurements in the area enable us to construct eight balanced cross sections across the Pindos Fold-and-thrust belt (PFTB) and to approach quantitatively some parameters which controlled foreland evolution. The 160-km-wide passive continental margin of the Apulian continent in Greece was progressively shortened from east to west at rates of 6 mm/year between the Early Oligocene and Late Eocene. From the rear to the frontal part of the wedge, fault-bend folds, duplexes and imbricates were formed, while strain was partitioned into faulting (~34%), layer parallel shortening (~23%) and buckling (~9%). Foreland subsidence and internal deformation of the orogenic wedge are strongly affected by two parameters of equal importance: the thrust load of the overthrusted microcontinents and the rigidity of the underthrusted Apulian passive margin. Changes in the thickness of the pre-orogenic sediments and reactivated transform faults induced salients. During the Lower Miocene, the orogenic wedge in the Peloponnese suffered additional uplift and westward gravitational gliding induced by the intracontinental subduction of the Palaeozoic rift zone of the Phyllite-Quartzite Series, which was reactivated and returned to the earths surface during the Hellenic orogeny.     

Did the 7/9/1999 M5.9 Athens Earthquake Come with a Warning?

Prior to the 7/9/1999 M_S = 5.9 Athens earthquake, regional seismicity has exhibited a power-law increase, of the form = K+A(t_c - t)ⁿ, where is estimated using an expression log = cM + d and t_c is the time of the culminating event. Such changes appeared after the 17/8/1999 M7.4 Izmit event. We quantified the performance of the power law vs. the null hypothesis of constant seismic release rates, by defining the curvature C as the ratio of the power law fit RMS/linear fit RMS, so that the smaller C is, the better the power law behaviour. By mapping C, we have established a critical radius of 110 km and observed that the region of correlated accelerating seismic release extended from the N. Aegean, through Euboea and Attica to the SW Peloponnese. A few days prior to the Athens event, min(C) was centred at the epicentral area and numerical simulation yielded t_c = 1999.676 and predicted M_S = 5.77. Seismicity rates returned to normal (quasi-constant) after the Athens event. We interpret this effect as critical point behaviour, following remote excitation of a broad area by stress redistribution due to the Izmit event which, at Athens, has triggered `premature' failure of a fault nearing its load bearing capacity. If this is correct, we have documented a case of remote earthquake triggering by another earthquake, as well as insight into the mechanisms producing it. As a corollary, we note that a large event may beget another large event in its broader region of interaction, which may be preceded by characteristic precursory seismicity changes.     

Tsunami hazard in the Eastern Mediterranean: strong earthquakes and tsunamis in Cyprus and the Levantine Sea

A modern tsunami catalogue has been compiled for the region of Cyprus-Levantine Sea in which 24 certain or possible local tsunamis are listed from antiquity up to the present time, while six regional tsunamis, generated in the Hellenic arc, are documented which affected the region. Another set of 13 doubtful events not included in the catalogue are discussed. Tsunami intensities k and K were re-evaluated using the classic 6-grade and the new 12-grade intensity scales, respectively. The strongest tsunamis reported in the region of interest are those of 551 AD, 749, 1068, 1201, 1222, 1546 and 1759, all occurring along the Levantine coast from Gaza northward, with the exception of the 1222 wave which occurred in the Cyprean arc. The causative earthquakes, however, occur on land and are associated with the left-lateral strike-slip Levantine rift and, as such, remain unexplained. In this paper we speculate on the mechanism of these events. A second tsunami zone follows the Cyprean arc, where the situation of subaqueous seismogenic sources favours the generation of tsunamis by co-seismic fault displacements. Submarine or coastal earth slumping, however, may be an additional tsunamigenic component. Based on historical data, the average tsunami recurrence in the Cyprus-Levantine Sea region is roughly estimated to be around 30 years, 120 years and 375 years for moderate (k/K ≥ 2/3), strong (k/K ≥ 3/5) and very strong (k/K ≥ 5/8) events, respectively. The rate of tsunami occurrence equals 0.033, 8.3 × 10⁻³ and 2.7 × 10⁻³ events/year for intensity k/K ≥ 2/3, 3/5 and 5/8, respectively. For a Poissonian (random) process the probabilities of observing at least one moderate, strong or very strong tsunami are 0.28, 0.01 and 3 × 10⁻³ within 1 year, 0.81, 0.34 and 0.13 within 50 years and 0.96, 0.56 and 0.24 within 100 years, respectively. The tsunami potential in the Cyprus-Levantine Sea area is low relative to other Mediterranean tsunamigenic regions. However, the destructiveness of some historical events indicates the need to evaluate tsunami hazard by all available means. In addition, remote tsunamigenic sources, such as those of 1303 and 1481 in the eastern Hellenic arc, are able to threaten the coasts of the Cyprus-Levantine region and, therefore, such regional tsunamis should be taken into account in the evaluation of the tsunami risk of the region.     

Combined use of spot samples and continuous integrated sampling in a study of storm runoff from a lowland catchment in the south of England

We have used two different sampling techniques to study the geochemical response of a small lowland rural catchment to episodic storm runoff. The first method involves traditional daily spot sampling and has been used to develop a standard end‐member mixing analysis (EMMA) of the relative contributions of ground water flow and surface runoff to the total stream flow. The second method utilizes a continuous sampling device, powered by an osmotic pump, to produce an integrated 24‐h sample of the stream flow. When combined with the EMMA results from the spot samples, analyses of the integrated samples reveal the presence of a third component that makes a significant contribution to the dissolved NO₃, Ca and K export from the catchment during the rising limb of the hydrographic profile of a storm event following a prolonged dry period. The storm occurred in the middle of the night, so that the response of the stream chemistry was not captured by the daily samples. We hypothesize that this third component is derived from the flushing of stored soil water that contains the geochemical signature of decaying vegetation. Copyright © 2011 John Wiley & Sons, Ltd.     

Platinum-Group Mineral Characterization in Concentrates from High-Grade PGE Al-rich Chromitites of Korydallos Area in the Pindos Ophiolite Complex (NW Greece)

The Pindos ophiolite complex, located in the north-western part of continental Greece, hosts various podiform chromite deposits generally characterized by low platinum-group element (PGE) grades. However, a few locally enriched in PPGE + Au (up to 29.3 ppm) chromitites of refractory type are also present, mainly in the area of Korydallos (south-eastern Pindos). The present data reveal that this enrichment is strongly dependant on chromian spinel chemistry and base metal sulfide and/or base metal alloy (BMS and BMA, respectively) content in chromitites. Consequently, we used super-panning to recover PGM from the Al-rich chromitites of the Korydallos area. The concentrate of the composite chromitite sample contained 159 PGM grains, including, in decreasing order of abundance, the following major PGM phases: Pd-Cu alloys (commonly non-stoichiometric, although a few Pd-Cu alloys respond to the chemical formula PdCu₄), Pd-bearing tetra-auricupride [(Au,Pd)Cu], nielsenite (PdCu₃), sperrylite (PtAs₂), skaergaardite (PdCu), Pd-bearing auricupride [(Au,Pd)Cu₃], Pt and Pd oxides, Pt-Fe-Ni alloys, hollingworthite (RhAsS) and Pt-Cu alloys. Isomertieite (Pd₁₁Sb₂As₂), zvyagintsevite (Pd₃Pb), native Au, keithconnite (Pd₂₀Te₇), naldrettite (Pd₂Sb) and Rh-bearing bismuthotelluride (RhBiTe, probably the Rh analogue of michenerite) constitute minor phases. The bulk of PGE-mineralization is dominated by PGM grains that range in size from 5 to 10 µm. The vast majority of the recovered PPGM are associated with secondary BMS and BMA, thus confirming that a sulphur-bearing melt played a very important role in scavenging the PGE + Au content of the silicate magma from which chromian spinel had already started to crystallize. The implemented technique has led to the recovery of more, as well as noble, PGM grains than the in situ mineralogical examination of single chromitite samples. Although, the majority of the PGM occur as free particles and in situ textural information is lost, single grain textural evidence is observed. In summary, this research provides information on the particles, grain size and associations of PGM, which are critical with respect to the petrogenesis and mineral processing.