Pop-up bottom seismic recorder (PUBS) of the Institute of Oceanographic Sciences,U.K.

A pop-up bottom seismic recorder designed for seismic refraction experiments was built by the Institute of Oceanographic Sciences in 1968. The device is housed within a 71 cm diameter sphere weighing 270 kg when launched. signals picked up by a hydrophone are recorded in analogue form on magnetic tape in the band 2–100 Hz. The total continuous recording period is 12 hr but the lifetime of the system can be effectively extended by cycling the tape-recorders to allow shooting to go on for up to 3 days. Ballast release is by acoustic command or by pre-set clock. The instruments have been used in water depths from 150 to 4820 m making a total of 63 deployments with a 95% recovery rate. A new version with three-component geophones is being built.     

Hydroacoustic Field of a Point Source in an Inhomogeneous Marine Medium Containing a Cylindrical Body Floating on the Surface

We study the problem of determination of the sound field of a point harmonic source in the coastal zone and the influence of a cylindrical body floating above the source on the sound field formed in the marine medium. A numerical-analytic method is proposed for the determination of the velocity potential. According to this method, the unknown coefficients in the general solution of the problem are determined from the corresponding infinite system of linear algebraic equations by the method of reduction. We present results of numerical calculations for a special case of a waveguide whose parameters are typical of the coastal part of the sea and perform the comparative analysis of the data obtained as a result of variation of the indicated parameters.     

Preliminary attempt to characterize the rotation of seafloor in the Pito Deep area of the Easter Microplate using a submersible magnetometer

Several mechanisms have been proposed to account for the rotation of the nearly north-south abyssal hill fabric formed on the East Pacific Rise north of the Easter Microplate to the nearly east-west trends in the northern microplate interior. Proposed mechanisms include rigid microplate rotation, transform fault – parallel shear, and bookshelf faulting during the transfer of lithosphere from the Nazca Plate to the microplate. We used a submersible magnetometer on a NAUTILE dive program to measure the magnetic vector rotation of a pillow basalt and dike spur near Pito Deep, the present location of the tip of the propagating rift system that created the microplate. Our results, although too limited to draw strong conclusions from, suggest clockwise rotations of the seafloor magnetic vectors inconsistent with the transform-parallel shear model, and larger than can be explained solely by rigid microplate rotation.     

Invertebrates in the trophic webs of the white sea near-shore ecosystem (using the example of Gryaznaya Inlet)

In the food clods of the mass species of macrobenthos of the Gryaznaya Inlet, nonstructured matter plays a great role. We identify this matter as derivates from plant tissues, which are the products of their external metabolism and degradation, with associated microorganisms. This way, the near-shore community considered is supported by a detrital trophic web. This feature distinguishes it from the similar community of the near-Atlantic waters that is based on a pasture web, at least as far as the bivalve mass species are concerned. The groups of the near-shore species of Gryaznaya Inlet separated by a cluster analysis are identified as consortia, combined by the biogeochemical conditions (edifice factor), which can hardly be analyzed at present.     

Mathematical modeling of turbulent jets of deep-water sewage discharge into coastal basins

The basic properties of the dynamic model of a turbulent jet formed by a deep-water sewage discharge into the stratified environment of coastal regions are considered. The model developed was used to estimate the parameters of a floating-up jet of deep wastewater discharge from Sand Island into the basin of Mamala Bay (Hawaii) depending on the season and discharge operation mode. The estimates of the float-up depths of the jet and the initial dilution of the jet were estimated on the basis of model calculations using experimental data on the vertical profiles of the water temperature and salinity under the actual conditions of stratification in the study region. It is shown that the further propagation of the wastewater jet depends on tidal events and internal waves generated by tides. The appearance of turbulent jets at the sea surface was recorded. The model estimates of the parameters of the wastewater discharge were compared with the results of experimental measurements. Good agreement was found, which indicates that the physical mechanisms of the propagation of turbulent jets in a stratified medium are adequately described by the model.     

Problems with biogenic silica measurement in marginal seas

Surface sediment samples from the Bohai, Yellow Sea, and the Pacific were used to assess biogenic silica (BSi) content and to study uncertainties in BSi measurements. The contents of BSi in the Bohai and Yellow Sea are all less than 1%. The dissolution of BSi in sediments from the Bohai and Yellow Sea is very important to maintain high levels of silicate in the water column. The non-biogenic silica from clay minerals has an obvious effect on BSi of sediment samples in the Bohai and Yellow Sea with low BSi and high clay minerals. The solid to solution ratio was found to have a great influence on BSi measurement, which can induce uncertainties up to 75%. The effect of loss by sorption and centrifugation is negligible. Interlaboratory comparison of techniques for BSi measurement by the wet alkaline extraction technique of Mortlock and Froelich [Deep-Sea Res. 36 (1989) 1415-1426] with clay correction was suggested to give no significant differences. However, differences in sediment compositions and reagent to sample ratio may limit the application of the wet alkaline extraction method.     

On the adequacy of second-order models to predict abnormal waves

The paper is intended to extend the investigations about the nature of abnormal waves that have been reported in the work of Guedes Soares et al. (Characteristics of abnormal waves in North Sea states. Applied Ocean Research 25, [337–344]). The same dataset gathered at the oil platform North Alwyn in the North Sea during the November storm in 1997 is used along with the time series from the Draupner platform, in which an abnormal wave occurred. The data are reanalyzed from the viewpoint of the applicability of second-order models to fit large waves. The observed results confirm that the second-order approximation is not adequate to describe highly asymmetric and abnormal waves.     

The impact of wave loads and pore-water pressure generation on initiation of sediment transport

The build-up of pore-water pressure by waves can lead to sediment liquefaction and subsequent transport by traction currents. This process was investigated by measuring pore-water pressures both in a field experiment and laboratory wave tank tests. Liquefaction was observed in the wave tank tests. The results suggest that sand is less susceptible than silts to wave-induced liquefaction because of the tendency to partially dissipate pore-water pressures. However, previous studies have determined that pore-water pressures must approach liquefaction before current velocities necessary to initiate transport are reduced. Once liquefaction has occurred more sediment can be transported.