Stratigraphy, depositional environments and level reconstruction of the last interglacial Lake Samra in the Dead Sea basin

In this paper we describe the stratigraphy and sediments deposited in Lake Samra that occupied the Dead Sea basin between ∼ 135 and 75 ka. This information is combined with U/Th dating of primary aragonites in order to estimate a relative lake-level curve that serves as a regional paleohydrological monitor. The lake stood at an elevation of ∼ 340 m below mean sea level (MSL) during most of the last interglacial. This level is relatively higher than the average Holocene Dead Sea (∼ 400 ± 30 m below MSL). At ∼ 120 and ∼ 85 ka, Lake Samra rose to ∼ 320 m below MSL while it dropped to levels lower than ∼ 380 m below MSL at ∼ 135 and ∼ 75 ka, reflecting arid conditions in the drainage area. Lowstands are correlated with warm intervals in the Northern Hemisphere, while minor lake rises are probably related to cold episodes during MIS 5b and MIS 5d. Similar climate relationships are documented for the last glacial highstand Lake Lisan and the lowstand Holocene Dead Sea. Yet, the dominance of detrital calcites and precipitation of travertines in the Dead Sea basin during the last interglacial interval suggest intense pluvial conditions and possible contribution of southern sources of wetness to the region.     

Ejecta from impacts at 0.2-2.3 m/s in low gravity

Collisions between planetary ring particles and in some protoplanetary disk environments occur at speeds below 10 m/s. The particles involved in these low-velocity collisions have negligible gravity and may be made of or coated with smaller dust grains and aggregates. We undertook microgravity impact experiments to better understand the dissipation of energy and production of ejecta in these collisions. Here we report the results of impact experiments of solid projectiles into beds of granular material at impact velocities from 0.2 to 2.3 m/s performed under near-weightless conditions on the NASA KC-135 Weightless Wonder V. Impactors of various densities and radii of 1 and 2 cm were launched into targets of quartz sand, JSC-1 lunar regolith simulant, and JSC-Mars-1 martian regolith simulant. Most impacts were at normal or near-normal incidence angles, though some impacts were at oblique angles. Oblique impacts led to much higher ejection velocities and ejecta masses than normal impacts. For normal incidence impacts, characteristic ejecta velocities increase with impactor kinetic energy, KE, as approximately KE^0.5. Ejecta masses could not be measured accurately due to the nature of the experiment, but qualitatively also increased with impactor kinetic energy. Some experiments were near the threshold velocity of 0.2 m/s identified in previous microgravity impact experiments as the minimum velocity needed to produce ejecta [Colwell, J.E., 2003. Icarus 164, 188-196], and the experimental scatter is large at these low speeds in the airplane experiment. A more precise exploration of the transition from low-ejecta-mass impacts to high-ejecta-mass impacts requires a longer and smoother period of reduced gravity. Coefficient of restitution measurements are not possible due to the varying acceleration of the airplane throughout the experiment.     

Do CRISTA Experiment/Campaign Data Represent a Typical Situation or Not?

Data from four A3 radio wave circuits in central Europe are used to analyse the representativeness of the ionization and gravity wave activity pattern in the lower ionosphere (85 – 100 km) in the CRISTA experiment interval (3 – 12 November 1994) for the given conditions. It has been found that the CRISTA experiment interval was run under conditions, which are highly representative both of October – November 1994 and autumn, low-moderate solar activity, the descending phase of solar cycle conditions, i.e. CRISTA measurements may be considered to provide values identical with, or close to climatological values (at least for central Europe, h = 85 – 100 km).     

Die frühmagmatische Bildung der Olivinausscheidungen vom Finkenberg (Siebengebirge) und Dreiser Weiher (Eifel)

Ohne Zusammenfassung     

Late Quaternary growth and decay of the Svalbard/Barents Sea ice sheet and paleoceanographic evolution in the adjacent Arctic Ocean

 The paleoceanography in the Nordic seas was characterized by apparently repeated switching on and off of Atlantic water advection. In contrast, a continous influx of Atlantic waters probably occurred along the northern Barents Sea margin during the last 150 ka. Temporary ice-free conditions enhanced by subsurface Atlantic water advection and coastal polynyas accelerated the final ice sheet build-up during glacial times. The virtually complete dissolution of biogenic calcite during interglacial intervals was controlled mainly by CO₂-rich bottom waters and oxidation of higher levels of marine organic carbon and indicates intensive Atlantic water inflow and a stable ice margin. Received: 25 February 1997 / Revision received: 4 March 1998     

Anisotropies of in-phase,out-of-phase,and frequency-dependent susceptibilities in three loess/palaeosol profiles in the Czech Republic; methodological implications

The relationship between the anisotropy of frequency-dependent magnetic susceptibility (fdAMS) and the anisotropy of out-of-phase magnetic susceptibility (opAMS) was investigated theoretically and also empirically at three loess/palaoesol profiles in Prague and in Southern Moravia. The data treatment was made in terms of mean susceptibility, degree of AMS, and orientations of principal susceptibilities. It has shown that the fdAMS and opAMS can serve as indicators of the preferred orientations of ultrafine magnetic particles that are on transition between superparamagnetic and stable single domain states in rocks, soils and environmental materials. In loess/palaeosol sequences, the fdAMS and opAMS correlate reasonably, because they are due to magnetic particles of similar grain sizes. The fdAMS and opAMS can be both coaxial with standard AMS (i.e. anisotropy of in-phase susceptibility - ipAMS) or non-coaxial indicating slightly different orientations of viscous magnetic particles.     

Chemical Procedures for Rhenium Extraction from Geological Samples: Optimising the Anion Resin Bead Clean‐up Step

Rhenium–osmium geochronometry for samples with low Re and complex matrices requires improved Re extraction methods. Here, we investigate plausible controls on efficiency and efficacy of Re extraction during our anion resin bead purification. Four different protocols are compared, each isolating a single variable to test. Rhenium concentrations for solutions at each step of each protocol document differences in chemical recovery/yield. The negative‐thermal ionisation mass spectrometry (N‐TIMS) signal intensity serves as a proxy for Re yield and purity. These data document correlations between the N‐TIMS signal intensity and (a) the duration of anion resin bead conditioning prior to loading with Re‐bearing solution, and (b) both duration and strength of nitric acid used during rinsing of the Re‐loaded anion resin bead. The optimal protocol improved Re signal intensity around fourteen times compared with our current Re extraction protocol, an aggregate of 2.4 times improvement in chemical recovery (yield) and 5.8 times improvement in emission efficiency (purity). Repeated N‐TIMS isotopic measurements on our in‐house Re standard solution (1407) verify that our optimal protocol‐3 does not fractionate Re isotopes. The improved anion resin bead method considerably lowers the Re detection limit and allows Re‐Os isotopic analysis of picogram‐level Re hosted in geological samples with complex matrices.     

Event-based classification for global study of river flood generating processes

Better understanding of which processes generate floods in a catchment can improve flood frequency analysis and potentially climate change impacts assessment. However, current flood classification methods are either not transferable across locations or do not provide event-based information. We therefore developed a location-independent, event-based flood classification methodology that is applicable in different climates and returns a classification of all flood events, including extreme ones. We use precipitation time series and very simply modelled soil moisture and snowmelt as inputs for a decision tree. A total of 113,635 events in 4155 catchments worldwide were classified into one of five hydro-climatological flood generating processes: short rain, long rain, excess rainfall, snowmelt and a combination of rain and snow. The new classification was tested for its robustness and evaluated with available information; these two tests are often lacking in current flood classification approaches. According to the evaluation, the classification is mostly successful and indicates excess rainfall as the most common dominant process. However, the dominant process is not very informative in most catchments, as there is a high at-site variability in flood generating processes. This is particularly relevant for the estimation of extreme floods which diverge from their usual flood generation pattern, especially in the United Kingdom, Northern France, Southeastern United States, and India.     

Evaluation of bank filtration as a pretreatment method for the provision of hygienically safe drinking water in Norway: results from monitoring at two full-scale sites

Two case studies were carried out in central Norway in order to assess the performance of bank filtration systems in cold-climate fluvial aquifers relying on recharge from humic-rich surface waters with moderate microbial contamination. Three municipal wells and two surface-water sources at operative bank filtration systems were monitored for naturally occurring bacteriophages, fecal indicators, natural organic matter (NOM) and physico-chemical water quality parameters during a 4-month period. Aquifer passage effectively reduced the microorganism and NOM concentrations at both study sites. Bacteriophages were detected in 13 of 16 (81%) surface-water samples and in 4 of 24 (17%) well-water samples, and underwent 3 ± 0.3 log₁₀ reduction after 50–80-m filtration and 20–30 days of subsurface passage. NOM reductions (color: 74–97%; dissolved organic carbon: 54–80%; very hydrophobic acids: 70%) were similar to those achieved by conventional water-treatment processes and no further treatment was needed. Both groundwater dilution and sediment filtration contributed to the hygienic water quality improvements, but sediment filtration appeared to be the most important process with regard to microbial and NOM reductions. A strengths-weaknesses-opportunities-threats analysis showed that bank filtration technology has a high potential as a pretreatment method for the provision of hygienically safe drinking water in Norway.