WATER QUALITY STUDIES IN MALAYSIAN DISUSED MAN MADE LAKFS FOR SUITABILITY OF AN AQUACULTURE PROJECT

A study has been conducted on the status of water quality in two disused man made lakes, which have potential for cage aquaculture project. This study highlights the quality of water analyzed with reference to various physical - chemical parameters in two selected lakes and their suitability for fish farming. A number of parameters were measured including the amount of NH3 - N, NO3 - N, NO2 - N and total phosphorus while in - situ measurement including DO, pH, temperature, conductivity, TDS and Secchi disk visibility. Beside the physical -chemical of water, the location, morphometry and climate conditions were also investigated. The chemical data analyzed for six months indicated that Lake A and Lake B are characterized by relatively high DO, slightly neutral pH and low TSS. The concentration of NH3 -N and NO2 -N was very low （0. 058 mg/L and 0. 04 mg/L, respectively） and total phosphorus was usually in low concentration and sometimes would seem negligible. Besides, NO3 - N occurred in slightly higher concentration （1.75 mg/L）. Results obtained indicated that the study site has high potentiality for development of inland fisheries practices.     

Occurrence of jarosite within Quaternary coastal sabkha sediments in Kuwait,Arabian Gulf

X-ray diffractometer analysis and SEM investigation confirmed the occurrence of jarosite and alunogen minerals in the Quaternary siliciclastic sabkha sediments of northern Kuwait within the Bahrah oilfield area, Arabian Gulf. Jarosite is relatively abundant in a near-surface whitish sticky tidal muddy sand layer about 60 cm thick that overlies the ferruginous sandstone of the Oligo-Miocene Ghar Formation. Jarosite occurs as clusters of euhedral pseudo-cubes of about 1 μm in size and as agglomerated nanoglobules of 250 nm in size. A hypogenetic origin related to the reaction of sulfuric acid produced by the oxidation of H₂S associated with hydrocarbon gas seepages with K and Fe leachates is suggested. The restricted occurrence of jarosite within near-surface sabkha sediments may be attributed to limited tidal inundation and prevalence of arid climatic conditions.     

Electrical and electromagnetic surveys to locate possible causes of water seepage to ground surface at a quarry open pit near Helwan city,Egypt

Water seepage to ground surface at a limestone quarry located at Wadi Garawy about 20 km south-east of Helwan city in Egypt posed a real threat to the mining activity at the quarry. The quarry area is known to be very dry for decades and away from water utilities and infrastructures that may cause water leaks to the quarry. Geophysical investigation including 1D Vertical Electrical Sounding (VES), 2D Electrical Resistivity Tomography (ERT) and 1D Transient Electromagnetic (TEM) surveys were conducted to characterize the rock sequence and locate what could be a possible source of water seepage to the quarry. The resistivity profiles generated from the VES and TEM surveys mapped the rock units in the area down to depths exceeded 100 m. The ERT profiles acquired from the quarrying zone close to the water seepage spot have imaged the top of groundwater level at few meters below the ground surface at the quarry open pit. The spot of groundwater seepage seemed to occur at an area of limestone dissolution that were filled by finer sediments. The finer sediments acted as a hydrological conduit that allowed an upward seepage of groundwater to ground surface under the capillary action effect.     

Integrated geoelectrical resistivity and hydrogeochemical methods for delineating and mapping heavy metal zone in aquifer system

A novel study on using geoelectrical resistivity, soil property, and hydrogeochemical analysis methods for delineating and mapping of heavy metal in aquifer system is presented in this paper. A total of 47 surveys of geoelectrical resistivity with Wenner configuration were conducted to determine the subsurface and the groundwater characteristics. The groundwater sample from 53 existing wells and 2 new wells has been analyzed to derive their water chemical content. The chemical analysis was done on the soil sample obtained from new two wells and from selected locations. The water and soil chemical analysis results from the new two wells were used as calibration in resistivity interpretation. The occurrence of heavy metal in aquifer system was expected to detect using the geoelectrical resistivity survey for the whole study area. The result of groundwater analysis shows that the groundwater sample contains a relatively low concentration of Fe (<?0.3 mg/L) elongating from the south up to the middle region. While in the middle and the northwestern, Fe concentration is relatively high (around 12 mg/L). Chemical analysis of soil sample shows that in the lower resistivity zone (<?18 Ωm), Al and Fe concentrations are comparatively high with an average of 68,000 and 40,000 mg/kg, respectively. Starting from the middle to the northwestern zone, the resistivity value appears to be low. It is definitely caused by higher Al and Fe concentration within the soil, and it is supported also by lower total anion content in the groundwater. While the resistivity value of more than 40 Ωm in aquifers is obtained in the zone which Fe concentration is relatively lower in the soil but not present in the groundwater. Correlation Fe concentration in the soil and Fe concentration in the groundwater sample shows the trend of positively linear; however, the Al concentration in soil has no correlation with Al content in groundwater. Finally, the probability of high heavy metal zone in the aquifer system is easily delineated by the distribution of geoelectrical resistivity presented in depth slice shapes which extend from the Boundary Range Composite Batholith in the north to the northwest.     

Fluid flow equations governing primary oil migration as a separate phase

A mathematical model of primary oil migration as a separate phase out of compacting shales is presented. During burial and oil generation, source rock porosity decreases and oil saturation increases until residual oil saturation is reached. At this stage oil is expelled out by capillary and excess fluid pressure gradients. The model is a system of differential equations which relate changes in oil and water saturation in time to water and oil flow out of the source rock during burial. An additional set of equations for periods of erosion of overburden are also provided. The equations can be numerically solved by finite difference method. If oil and water flow is to be simulated during oil generation, then at each time step, changes by oil generation in oil and water saturations and porosity must be calculated. The solution procedure is briefly outlined.     

On the Application of the Novel Thin Spray-on Liner (TSL): A Progress Report in Mining Operations

Stability is the main problem in underground excavations that can result in rock-related accidents or closure of mines. This is often controlled by the geological condition of the rockmass and the in situ stress field where excavation is being carried out. Over the years, conventional support systems such as bolts, shotcrete and mesh have been the standard support systems used in difficult ground conditions to maintain stability of underground openings. The novel Thin Spray Liner (TSL) is a technology with an improvement in terms of support capabilities for difficult geological conditions. This technology is predicted to replace conventional support systems, as it offers a significant yielding capacity that is better than that of the traditional techniques of controlling strata. The performance of the TSL lies between that of shotcrete and wire mesh. The TSL has numerous advantages regarding rock reinforcement such as rapid curing period, fast application, high tensile strength, high adhesion properties that prevent movement of rock keyblocks, improved cycle times, reduction in material-handling compared to shotcrete, and a significant ability to penetrate joints. These advantages increase the allowance for mechanisation and improvement of safety in excavations. Despite various benefits of TSLs, there are shortcomings which make end-users to be sceptical about the technology. This study provides a detailed review of the mechanism, properties, composition and types, as well as the general and mining applications of TSLs. It also describes the challenges faced by the mining industry and other end-users in accepting the technology as a solution for stability issues in underground openings. In addition, some insightful suggestions are made as recommendations for future work on the development of suitable, effective and efficient thin surface rock support technology within limitations/constraints.

     

Hydrochemical characterization of groundwater in Balad district,Salah Al-Din Governorate,Iraq

The assessment of hydrochemical quality of groundwater is very important to explore its nature and usefulness. In this paper, groundwater quality evaluation is carried out in the Balad district, Salah Al-Din Governorate, Iraq. A total of 28 groundwater samples are collected from shallow tube wells and analyzed for various physicochemical parameters. Groundwater suitability for drinking is evaluated based on the World Health Organization (WHO) and Iraqi standards, and suitability of groundwater for irrigation is assessed based on various hydrochemical parameters. The results reveal that the dominant types of groundwater based on piper diagram are mixed CaMgCl and CaCl. Gibbs ratio indicates that the groundwater in the studied area is affected by the evaporation process. The cation-anion exchange reaction in the studied area demonstrates that 54% of the groundwater samples indicate a direct base (cation-anion) exchange reaction, while 46% of the groundwater samples indicating the chloro-alkaline disequilibrium. Furthermore, generally all of the groundwater samples are unsuitable for drinking and irrigation. Cluster analysis reveals two different groups of similarities between the groundwater samples, reflecting different pollution levels in the studied area.     

Evaluating some factors that affect feasility of using ground penetrating radar for landmine detection

Ground penetrating radar （GPR） is one of the promising technologies that can be used to detect landmines. Many factors may affect the ability of GPR to detect landmines. Among those factors are： 1） the type of landmine material （metallic or plastic）, 2） conditions of the host soil （soil texture and soil moisture）, and 3） the radar frequency utilized. The impact of these factors on the ability of GPR to detect landmines is investigated by studying their effect on the dielectric permittivity contrast between the landmine and the host soil, as well as on the attenuation of the radar waves. The impact of each factor was theoretically reviewed and modeled using the Matlab and Mathcad software packages. Results of the computer modeling were correlated with GPR data acquired for metallic and plastic landmine types. It was found that the ability of GPR to detect landmines depends to a great extent on the landmine type, water content of the host soil, utilized radar frequency, and soil texture. The landmines are much easier to detect than plastic landmines for any soil conditions and any radar frequency. Increasing the soil＇s moisture content, regardless of soil texture, eases the detection of the plastic landmine and worsens the detection of the metallic mines. Increasing the percentage of clay in the soil causes the same effect as the moisture content. However, higher radar frequency delivers better results for landmine detection as long as the percentage of clay and the moisture content in the soil remains low. The results of this study are expected to help in selecting optimum radar antennae and data acquisition parameters depending on the landmine type and environmental conditions.     

Physical,radiative, and dynamical processes within a nighttime marine stratus cloud

Observations taken by aircraft and conventional platforms are used to investigate dynamical, physical, and radiative processes within a marine stratus cloud during the Canadian Atlantic Storms Program (CASP) II field project which took place over the east coast of Canada. Stratus which formed over the ocean on February 6, 1992 during the nighttime, is studied to analyze cloud top and base processes. The cloud was supercooled during the study period. Fluctuations and fluxes are calculated along constant flight altitude legs approximately 100 km long in space. The scales of structures larger than 5 km are removed from the analysis using a running average technique. Droplet spectra obtained by a forward scattering spectrometer probe (FSSP) were used in a 1-D radiative transfer model to calculate infrared (IR) fluxes and radiative heating rates. A heat conservation equation was used to estimate vertical air velocity (w _a ) within the cloud. The results showed that, because of a warmer ocean surface, significant moisture and heat were transferred from the ocean surface to the boundary layer. The cloud base was at about 400 m height and the top was at about 1.4 km.w _a at the cloud base was estimated about 5 cm s^–1. Strong IR cooling rate at the cloud top was calculated to be 75°C day^–1 for a 100 m thick layer. Negative skewness inw _a , suggesting narrow downdrafts, was likely due to radiative cooling at the cloud top. The entrainment velocity was found to be about 1.5 cm s^–1 at cloud top. Mean moisture and heat fluxes within the cloud were estimated to be comparable to those from the ocean surface. Vertical air velocity at the cloud top due to radiative cooling was found to be about –40 cm s^–1.