Problems with biogenic silica measurement in marginal seas

Surface sediment samples from the Bohai, Yellow Sea, and the Pacific were used to assess biogenic silica (BSi) content and to study uncertainties in BSi measurements. The contents of BSi in the Bohai and Yellow Sea are all less than 1%. The dissolution of BSi in sediments from the Bohai and Yellow Sea is very important to maintain high levels of silicate in the water column. The non-biogenic silica from clay minerals has an obvious effect on BSi of sediment samples in the Bohai and Yellow Sea with low BSi and high clay minerals. The solid to solution ratio was found to have a great influence on BSi measurement, which can induce uncertainties up to 75%. The effect of loss by sorption and centrifugation is negligible. Interlaboratory comparison of techniques for BSi measurement by the wet alkaline extraction technique of Mortlock and Froelich [Deep-Sea Res. 36 (1989) 1415-1426] with clay correction was suggested to give no significant differences. However, differences in sediment compositions and reagent to sample ratio may limit the application of the wet alkaline extraction method.     

Magnetic anomalies in the canary basin and the Mesozoic evolution of the central North Atlantic

The data from a recent magnetic compilation by Verhoefet al. (1991) off west Africa were used in combination with data in the western Atlantic to review the Mesozoic plate kinematic evolution of the central North Atlantic. The magnetic profile data were analyzed to identify the M-series sea floor spreading anomalies on the African plate. Oceanic fracture zones were identified from magnetic anomalies and seismic and gravity measurements. The identified sea floor spreading anomalies on the African plate were combined with those on the North American plate to calculate reconstruction poles for this part of the central Atlantic. The total separation poles derived in this paper describe a smooth curve, suggesting that the motion of the pole through time was continuous. Although the new sea floor spreading history differs only slightly from the one presented by Klitgord and Schouten (1986), it predicts smoother flowlines. On the other hand, the sea floor spreading history as depicted by the flowlines for the eastern central Atlantic deviates substantially from that of Sundvik and Larson (1988). A revised spreading history is also presented for the Cretaceous Magnetic Quiet Zone, where large changes in spreading direction occurred, that can not be resolved when fitting magnetic isochrons only, but which are evident from fracture zone traces and directions of sea floor spreading topography.Deceased 11 November 1991     

Relationship between the seismicity and geologic structure of the Blanco Transform Fault Zone

Morphologic studies of an oceanic transform, the Blanco Transform Fault Zone (BTFZ), have shown it to consist of a series of extensional basins that offset the major strike-slip faults. The largest of the extensional basins, the Cascadia Depression, effectively divides the transform into a northwest segment, composed of several relatively short strike-slip faults, and a southeast segment dominated by fewer, longer faults. The regional seismicity distribution (m _b 4.0) and frequency-magnitude relationships (b-values) of the BTFZ show that the largest magnitude events are located on the southeast segment. Furthermore, estimates of the cumulative seismic moment release and seismic moment release rate along the southeast segment are significantly greater than that of the northwest segment. These observations suggest that slip along the southeast segment is accommodated by a greater number of large magnitude earthquakes. Comparison of the seismic moment rate, derived from empirical estimates, with the seismic moment rate determined from plate motion constraints suggests a difference in the seismic coupling strength between the segments. This difference in coupling may partially explain the disparity in earthquake size distribution. However, the results appear to confirm the relation between earthquake size and fault length, observed along continental strike-slip faults, for this oceanic transform.     

Detection of buried targets using a synthetic aperture sonar

This paper presents observations of buried target detections made using a 20-kHz synthetic aperture sonar. At grazing angles below the critical angle, surprisingly high signal-to-noise detections were made of cylindrical targets buried at depths of 15 and 50 cm. During a separate set of measurements, buried spheres were clearly seen at steep grazing angles, but were generally not seen below the critical angle. Since scattering from wave-generated sand ripples may contribute to detections at grazing angles below critical angle, the information available on the ripple fields is discussed and used in acoustic backscatter simulations for the buried spheres. Lack of information on the ripple height precludes a definitive explanation for the absence of buried sphere detections at subcritical grazing angles.     

The autonomous underwater glider "Spray"

A small (50-kg, 2-m long) underwater vehicle with operating speeds of 20-30 cm/s and ranges up to 6000 km has been developed and field tested. The vehicle is essentially an autonomous profiling float that uses a buoyancy engine to cycle vertically and wings to glide horizontally while moving up and down. Operational control and data relay is provided by GPS navigation and two-way communication through ORBCOMM low-Earth-orbit satellites. Missions are envisioned with profile measurements repeated at a station or spaced along a transect. The initial instrument complement of temperature, conductivity, and pressure sensors was used to observe internal waves and tides in the Monterey underwater canyon     

Studies on the determination of inorganic iodine in seawater

Existing methods for the determination of the various forms of iodine present in seawater are laborious or unwieldy in use. This paper describes modified forms of the iodate and total iodine methods described by Barkley and Thompson (1960), a spectrophotometric procedure for iodate determination derived from Johannesson's (1958) work, and an automatic method for total iodine determination. Procedures for iodate and total-iodine determination which are suitable for use aboard ship, are recommended. Both procedures for iodate determination returned a standard deviation close to 0.5 μg/l when several replicate samples of a seawater containing approximately 30 μg/l of iodate-iodine were analysed. The automatic method for total iodine determination yielded a standard deviation of 0.8 μg/l by the repeated analysis of a seawater containing a total of approximately 50 μg/l of iodine. Suitable methods for the filtration and storage of seawater are also described.     

Uptake of plutonium from seawater and sediment by a marine polychaete worm

The results of the uptake of plutonium 239 from sediment by a marine polychaete wormNereis diversicolor is reported in the present paper. A comparison is made of the relative importance of two possible uptake pathways, sediment and seawater by which this worm may obtain its plutonium body-burden. Under the laboratory conditions used for the comparison of those two routes it would appear thatNereis obtains greater than 98% of its body activity from seawater.