Near surface geophysical surveys with a high frequency mutual impedance measuring system

Relationships for the mutual impedance of horizontal coplanar, vertical coplanar, perpendicular and vertical coaxial loop antenna arrays operating at a high frequency, located over a layered conducting medium, have been derived. The relationships take into account the occurrence of displacement currents in both the free space and the conducting medium. The relations can be used for calculating the earth parameters in geophysical prospecting. The use of high frequency antenna array makes it possible to determine distributions of apparent resistivity as well as apparent electrical permittivity. The potential application of the measurements of mutual impedance of loop antennas operating at a high frequency to the geophysical examinations is presented. The measuring system developed for this purpose is described. A simple method of interpreting the mutual impedance measurements to obtain the traces of apparent resistivity and apparent permittivity of the investigated earth is given.     

A study of the interaction among mining-induced seismic events in the Legnica-Głogów Copper District,Poland

We applied the Coulomb stress transfer technique to investigate interactions among seismic events induced by mining works in the Rudna mine in the Legnica-Glogów Copper District in Poland. We considered events with energy greater than 10⁵ J from the period 1993–1999. We examined the influence of the cumulative static stress changes (ΔCFF) due to previous events on the generation of subsequent ones. The results indicate that in many cases strong mining tremors produce changes in the state of stress of a sufficient magnitude to influence subsequent events. The location of over 60% of events is consistent with stress-enhanced areas where the values of ΔCFF were above 0.01 MPa. For most of the events located inside areas of a calculated negative ΔCFF, their modelled rupture zone was partially located inside stress enhanced area, providing thus additional evidence for possible triggering at the nucleation point.     

Microseismicity induced during fluid-injection: A case study from the geothermal site at Groß Schönebeck,North German Basin

The technical feasibility of geothermal power production in a low enthalpy environment will be investigated in the geothermal site at Groß Schönebeck, North German Basin, where a borehole doublet was completed in 2007. In order to complete the Enhanced Geothermal System, three massive hydraulic stimulations were performed. A seismic network was deployed including a single 3-component downhole seismic sensor at only 500 m distance to the injection point. Injection rates reached up to 9 m³/min and the maximum injection well-head pressure was as high as ～60 MPa. A total of 80 very small (?1.8 < M _W < ?1.0) induced seismic events were detected. The hypocenters were determined for 29 events. The events show a strong spatial and temporal clustering and a maximum seismicity rate of 22 events per day. Spectral parameters were estimated from the downhole seismometer and related to those from other types of induced seismicity. The majority of events occurred towards the end of stimulation phases indicating a similar behavior as observed at similar treatments in crystalline environments but in our case at a smaller level of seismic activity and at lower magnitudes.     

Sediment lithology and stable isotope composition of organic matter in a core from a cirque in the Krkonoše Mountains,Czech Republic

This study presents detailed lithostratigraphy and stable carbon and nitrogen isotopic variations in a 520-cm-long sediment core from a cirque basin in the Labsky důl Valley, Krkonoše Mountains, Czech Republic. Detailed study of the core reveals five major periods of sedimentation during the last 7600 years: silt and sand deposition during ~7.6–5.1 ka cal BP, Sphagnum peat accumulation during ~5.1–4.0 ka cal BP, sandy silt and sand during ~4.0–2.8 ka cal BP, raised peat bog during ~2.8–2.0 ka cal BP (Sphagnum peat), and sedimentation of sandy silt since ~2.0 ka cal BP. The δ¹³C values of the organic matter in the core vary in the range typical for C3 plants, from −24.35 to −27.68‰, whereas the δ¹⁵N values vary from −2.65 to +4.35‰. Core sections having ash contents ≥70% have δ¹⁵N > 1‰ and δ¹³C < −26‰, whereas those having ≤70% ash content have δ¹⁵N < 1‰ and δ¹³C > −26‰. Strong linear correlations are observed between δ¹³C and δ¹⁵N values as well as between C:N ratios and δ¹⁵N values in the horizons with ash content >10%, primarily for sand and silt horizons. On the other hand, poor correlations between δ¹³C and C:N ratio, as well as δ¹⁵N and C:N ratio, were observed in Sphagnum peat layers (45–125 and 185–265 cm). We conclude that the primary stable isotope variations are not preserved in the layers where significant correlation between δ¹⁵N and C:N ratio is observed. The relatively small δ¹³C variation in the uppermost Sphagnum peat layer suggests stable temperature during ~2.8–2.0 ka cal BP.     

Contamination of tsunami sediments in a coastal zone inundated by the 26 December 2004 tsunami in Thailand

Tsunami sediments deposited in a coastal zone of Thailand by the 26 December 2004 tsunami wave were sampled within 50 days after the event. All surface and ground waters in tsunami- inundated zone revealed significant salinity at that time. The tsunami sediments, composed mainly of fine to medium sand, contain significantly elevated contents of salts (Na⁺, K⁺, Ca⁺², Mg⁺², Cl and SO ₄ ⁻² ) in water-soluble fraction, and of Cd, Cu, Zn, Pb in the bioavailable fraction and As in the exchangeable fraction in relation to the reference sample. The origin of contaminants is marine, as well as litho- and anthropogenic. The salts and Pb, Zn and Cu reveal high correlation to each other and to the mean grain size (pore size and porosity). Serious environmental hazard exists in that region because, due to gentle morphology, there is a risk of migration of the contaminants into ground waters and food chain.     

Estimation of tail dependence coefficient in rainfall accumulation fields

Extreme rainfall events are of particular importance due to their severe impacts on the economy, the environment and the society. Characterization and quantification of extremes and their spatial dependence structure may lead to a better understanding of extreme events. An important concept in statistical modeling is the tail dependence coefficient (TDC) that describes the degree of association between concurrent rainfall extremes at different locations. Accurate knowledge of the spatial characteristics of the TDC can help improve on the existing models of the occurrence probability of extreme storms. In this study, efficient estimation of the TDC in rainfall is investigated using a dense network of rain gauges located in south Louisiana, USA. The inter-gauge distances in this network range from about 1 km to 9 km. Four different nonparametric TDC estimators are implemented on samples of the rain gauge data and their advantages and disadvantages are discussed. Three averaging time-scales are considered: 1 h, 2 h and 3 h. The results indicate that a significant tail dependency may exist that cannot be ignored for realistic modeling of multivariate rainfall fields. Presence of a strong dependence among extremes contradicts with the assumption of joint normality, commonly used in hydrologic applications.     

Peat-forming environments of Westphalian A coal seams from the Lower Silesian Coal Basin of SW Poland based on petrographic and palynologic data

The petrographic and palynologic compositions of coal seams of the acler formation (Upper Carboniferous, Westphalian A) from northwestern and southeastern part of the Lower Silesian Coal Basin (LSCB) were examined. Coals studied are highly volatile bituminous coal, where R_o ranges from 0.91% to 1.09%. Seam 430 from the northwestern part of the basin contains high vitrinite percentage with rather low inertinite and liptinite contents, while percentage of mineral matter is variable. This petrographic composition is associated either with a predominance of Lycospora in miospore assemblage, or with a miospore assemblage of mixed character. The abundance of Lycospora reflects vegetation composed of the arborescent lycopsids while the mixed miospore assemblage is connected with diverse palaeoplant communities, namely, arborescent lycopsids, calamites and ferns. Seams 409 and 412/413 from the southeastern part of the LSCB are rich in inertinite and liptinite, while the vitrinite content is moderate. Their characteristic feature is the occurrence of a diagnostic crassisporinite (densosporinite). Amount of the mineral components in these coals is very low. Densosporites and related crassicingulate genera are main components of these miospore assemblages and were produced by herbaceous and/or sub-arborescent lycopsids. These petrographic and palynologic features were the basis for distinguishing three maceral–miospore associations: an arborescent lycopsid and mixed associations, occurring in the seam 430 and a herbaceous and/or sub-arborescent lycopsid association which was recorded in seams 409 and 412/413. The first two assemblages are interpreted as having been deposited in a planar rheotrophic mire, whereas the herbaceous and/or sub-arborescent lycopsid association is thought to have developed in an ombrotrophic, domed mire.