Successful sidetracking of a well onshore Germany by integration of 3D vertical seismic profiling technology – a case study

The exploration for and exploitation of deep Lower Rotliegend gasfields onshore in North Germany often suffers from poor surface seismic imaging. This is owing to the depth of the reservoirs and a thick and complex Zechstein salt overburden. RWE Dea conducted a 3D vertical seismic profile (VSP) survey in a low‐performing production well after the borehole was plugged near total depth. Our main objective was to improve the seismic image of the reservoir zone in the vicinity of the well to determine a new landing point for a planned sidetrack. Because acquisition was in a densely populated and also partially environmentally protected area, there were surface restrictions concerning source deployment. Additionally, due to the complex geological setting, we conducted two 2D VSP field tests and thorough pre‐survey modelling to achieve the best results in terms of seismic imaging, environmental impact and reasonable cost. Deformation bands in the drill core suggest that the initial well was drilled close to a major fault, which was regarded as the main reason for the disappointing production rate. Therefore, we put special emphasis on fault detection in our processing and interpretation. Our interpretation approach used an enhanced structural mapping workflow that helped to design a sidetrack. When the sidetrack was drilled two years later, it ended up being one of the most productive wells in the field.     

Continental ridges in the Arctic Ocean: Lorex constraints

Recent multidisciplinary geophysical measurements over the Lomonosov Ridge close to the North Pole support the widely held belief that it was formerly part of Eurasia. The known lithologies, ages, P-wave velocity structure and thickness of the crust along the outer Barents and Kara continental shelves are similar to permitted or measured values of these parameters newly acquired over the Lomonosov Ridge. Seismic, gravity and magnetic data in particular show that the ridge basement is most likely formed of early Mesozoic or older sedimentary or low-grade metasedimentary rocks over a crystalline core that is intermediate to basic in composition. Short-wavelength magnetic anomaly highs along the upper ridge flanks and crest may denote the presence of shallow igneous rocks. Because of the uncertain component of ice-rafted material, seafloor sediments recovered from the ridge by shallow sampling techniques cannot be clearly related to ridge basement lithology without further detailed analysis. The ridge is cut at the surface and at depth by normal faults that appear related to the development of the Makarov Basin. This and other data are consistent with the idea that the Makarov Basin was formed by continental stretching rather than simple seafloor spreading. Hence the flanking Alpha and Lomonosov ridges may originally have been part of the same continental block. It is suggested that in Late Cretaceous time this block was sheared from Eurasia along a trans-Arctic left-lateral offset that may have been associated with the opening of Baffin Bay. The continental block was later separated from Eurasia when the North Altantic rift extended into the Arctic region in the Early Tertiary. The data suggest that the Makarov Basin did not form before the onset of rifting in the Artic.     

Effects of climate change on the groundwater system in the Grote-Nete catchment,Belgium

The effects of climate change on the groundwater systems in the Grote-Nete catchment, Belgium, covering an area of 525 km², is modeled using wet (greenhouse), cold or NATCC (North Atlantic Thermohaline Circulation Change) and dry climate scenarios. Low, central and high estimates of temperature changes are adopted for wet scenarios. Seasonal and annual water balance components including groundwater recharge are simulated using the WetSpass model, while mean annual groundwater elevations and discharge are simulated with a steady-state MODFLOW groundwater model. WetSpass results for the wet scenarios show that wet winters and drier summers are expected relative to the present situation. MODFLOW results for wet high scenario show groundwater levels increase by as much as 79 cm, which could affect the distribution and species richness of meadows. Results obtained for cold scenarios depict drier winters and wetter summers relative to the present. The dry scenarios predict dry conditions for the whole year. There is no recharge during the summer, which is mainly attributed to high evapotranspiration rates by forests and low precipitation. Average annual groundwater levels drop by 0.5 m, with maximum of 3.1 m on the eastern part of the Campine Plateau. This could endanger aquatic ecosystem, shrubs, and crop production.     

Anthropogenic subsidence in the Mexicali Valley,Baja California,Mexico, and slip on the Saltillo fault

Deep fluid extraction in the Cerro Prieto geothermal field (CPGF) has caused subsidence and induced slip on tectonic faults in the Mexicali Valley (Baja California, Mexico). The Mexicali Valley is located in the southern part of the Salton Trough, at the boundary between the Pacific and North American plates. The Valley is characterized by being a zone of continuous tectonic deformation, geothermal activity, and seismicity. Within the Cerro Prieto pull-apart basin, seismicity is concentrated mainly in swarms, while strong earthquakes have occurred in the Imperial and Cerro Prieto transform faults, that are the eastern and western bound of the basin. Since 1973, fluid extraction at the CPGF has influenced deformation in the area, accelerating the subsidence and causing rupture (frequently as vertical slip or creep) on the surface traces of tectonic faults. Both subsidence and fault slip are causing damage to infrastructure like roads, railroad tracks, irrigation channels, and agricultural fields. Currently, accelerated extraction in the eastern part of CPGF has shifted eastwards the area of most pronounced subsidence rate; this accelerated subsidence can be observed at the Saltillo fault, a southern branch of the Imperial fault in the Mexicali Valley. Published leveling data, together with field data from geological surveys, geotechnical instruments, and new InSAR images were used to model the observed deformation in the area in terms of fluid extraction. Since the electricity production in the CPGF is an indispensable part of Baja California economy, extraction is sure to continue and may probably increase, so that the problem of damages caused by subsidence will likely increase in the future.     

A Shear Model Accounting Scale Effect in Rock Joints Behavior

Understanding the scale effect on the mechanical behavior of a single rock joint is still very important in rock engineering. Rock joints can be classified into three different categories depending on their scale: the “micro scale” which is the scale of the asperities; the “meso scale” is the scale of the specimens tested in laboratory; and the “macro scale” which is the scale of the rock mass. The purpose of this paper is to propose an effective way to model rock joints at both the meso and macro scale. An original constitutive mechanical model, in which parameters are deduced from experimental results, has been developed. This model is then extended to simulate the discontinuities occurring at a larger size. At the macro scale, the constitutive modeling was carried out for both small and large relative displacements. Large displacements lead to substantial changes in dilation. For both cases, the peak shear stress vanishes for joints longer than 2 m.     

A GIS-index integration approach to groundwater suitability zoning for irrigation purposes

In recent decades, the high population growth has increased the demand for agricultural lands and products. Groundwater offers reliability and flexibility in access to water for irrigation purposes, especially in arid and semi-arid areas, such as Amol-Babol Plain, Iran. However, the quality and quantity of groundwater may not be suitable for irrigation purposes in all areas due to urbanizations, and intensive agricultural and industrial activities. Groundwater suitability zoning for irrigation purposes could be useful to improve water resources and land use planning, mostly in areas with water scarcity. Therefore, a GIS-based indices method is proposed to assess suitable zones for agricultural activities, integrating the irrigation water quality (IWQ) index and hydrogeological factors. IWQ index was utilized to assess groundwater quality based on salinity hazard, infiltration hazard, specific ions, and trace elements hazards, and miscellaneous effects such as pH, bicarbonate, and nitrate. The potential of the aquifer for irrigation water abstraction was investigated using hydrogeological surveys such as slope angle of the plain, hydraulic conductivity, and aquifer thickness. The groundwater suitability index classified most of the study area (more than 90 %) as “excellent” or “good” suitability zones for irrigation purposes. A limited area of around 5.6 % of the total area has moderate suitability for irrigation purposes due to the Caspian Seawater intrusion and the presence of fossil saline water. The proposed methodology provides useful information in order to allow irrigation management to prevent water and soil deterioration.     

The relationship between carbonate facies, volcanic rocks and plant remains in a late Palaeozoic lacustrine system (San Ignacio Fm, Frontal Cordillera, San Juan province, Argentina)

The San Ignacio Fm, a late Palaeozoic foreland basin succession that crops out in the Frontal Cordillera (Argentinean Andes), contains lacustrine microbial carbonates and volcanic rocks. Modification by extensive pedogenic processes contributed to the massive aspect of the calcareous beds. Most of the volcanic deposits in the San Ignacio Fm consist of pyroclastic rocks and resedimented volcaniclastic deposits. Less frequent lava flows produced during effusive eruptions led to the generation of tabular layers of fine-grained, greenish or grey andesites, trachytes and dacites. Pyroclastic flow deposits correspond mainly to welded ignimbrites made up of former glassy pyroclasts devitrified to microcrystalline groundmass, scarce crystals of euhedral plagioclase, quartz and K-feldspar, opaque minerals, aggregates of fine-grained phyllosilicates and fiammes defining a bedding-parallel foliation generated by welding or diagenetic compaction. Widespread silicified and silica-permineralized plant remains and carbonate mud clasts are found, usually embedded within the ignimbrites. The carbonate sequences are underlain and overlain by volcanic rocks. The carbonate sequence bottoms are mostly gradational, while their tops are usually sharp. The lower part of the carbonate sequences is made up of mud which appear progressively, filling interstices in the top of the underlying volcanic rocks. They gradually become more abundant until they form the whole of the rock fabric. Carbonate on volcanic sandstones and pyroclastic deposits occur, with the nucleation of micritic carbonate and associated production of pyrite. Cyanobacteria, which formed the locus of mineral precipitation, were related with this nucleation. The growth of some of the algal mounds was halted by the progressive accumulation of volcanic ash particles, but in most cases the upper boundary is sharp and suddenly truncated by pyroclastic flows or volcanic avalanches. These pyroclastic flows partially destroyed the carbonate beds and palaeosols. Microbial carbonate clasts, silicified and silica-permineralized tree trunks, log stumps and other plant remains such as small branches and small roots inside pieces of wood (interpreted as fragments of nurse logs) are commonly found embedded within the ignimbrites. The study of the carbonate and volcanic rocks of the San Ignacio Fm allows the authors to propose a facies model that increases our understanding of lacustrine environments that developed in volcanic settings.     

Geochemistry and Nd,Sr isotopes of the Pohrenk fluorites (Kırsehir-Turkey)

The Pohrenk fluorite mineralisation which makes up Central Anatolia’s most extensive fluorite region is Lutetian aged, and hosted in carbonate rocks that have undergone occasional karstification and silicification along a N–S fault trend. Fluid inclusion values and the position of fluorites in the Tb/La–Tb/Ca diagram show that mineralisation occurred in a hydrothermal environment with homogenisation temperatures ranging from 78.1–363°C. The presence of fluorite as a space filler in carbonate rocks and its association with silicification indicates that the solutions contained considerable amounts of Si alongside F (fluorine). The Pohrenk fluorite samples have ¹⁴³Nd/¹⁴⁴Nd values of between 0.512349 and 0.512497, whilst ⁸⁷Sr/⁸⁶Sr values vary between 0.708161 and 0.708772. These values indicate a mantle origin where continental contamination could occur. When the Nd–Sr values are compared to magmatic and young volcanics, the Pohrenk fluorites are seen to be enriched and exhibit similar isotopic signatures to Upper Cretaceous aged magmatics, Early-Middle Miocene volcanics and Mio-Quaternary volcanics.