Results of TV imaging of Phobos (Experiment VSK-Fregat)

From February to March 1989 the Phobos 2 spacecraft took 37 TV images of Phobos at a distance of 190-1100 km. These images complement Mariner-9 and Viking data by providing higher-resolution coverage of a large region West of the crater Stickney (40-160 degrees W) and by providing disk-resolved measurements of surface brightness at a greater range of wavelengths and additional phase angles. These images have supported updated mapping and characterization of large craters and grooves, and have provided additional observations of craters' and grooves' bright rims. Variations in surface visible/near-infrared color ratio of almost a factor of 2 have been recognized; these variations appear to be associated with the ejecta of specific large impact craters. Updated determinations of satellite mass and volume allow calculation of a more accurate value of bulk density, 1.90 +/- 0.1 g cm-3. This is significantly lower than the density of meteoritic analogs to Phobos' surface, suggesting a porous interior perhaps containing interstitial ice.     

Continuous injection model for hard X-ray correlated microwave bursts

Asymmetric magnetic field configurations in solar active regions hinder mildly relativistic electrons with magnetic moments suitable to produce microwave radiation from being trapped. Therefore the duration of stay of electrons in the microwave source region is much shorter (<0.2 s) than in the usually assumed trapping models. On this basis we construct a consistent model of hard X-ray correlated microwave bursts due to continuous injection of electrons into a pole field of an asymmetric magnetic loop (Figures 1 and 2). This resolves the discrepancy of the numbers of electrons needed to produce X-ray and radio emission.We compute gyrosynchrotron spectra with the assumption of conservation of the magnetic moment M in the microwave source. The consequence is an anticorrelation between the low frequency power index a of the microwave spectrum and the power index of the hard X-ray spectrum. In fact during the flare of May 18, 1972 increases with time while a is decreasing, so that +a= constant. Furthermore, it is shown that electrons with energies below 100 keV contribute significantly to the microwave radiation; they determine the low frequency spectrum completely.The model is able to explain the most often observed type C-spectra (Guidice and Castelli, 1975), but also flat spectra over one frequency decade.On leave from University of Berne, Institute of Applied Physics.     

Une approche innovante pour modéliser la biodégradation des composés organochlorés volatils en aquifères poreux

The goal of this study was to develop an innovative chloroethene biodegradation module based on biological, thermodynamical and mechanistic concepts. The biodegradation scheme was based on the postulate that in each part of an aquifer only one degradation mechanism is dominant: the one involving the most energetic electron acceptor. Thus, the selection of the active degradation mechanism was a function of the concentration of different electron acceptors. Modified Monod-type kinetics was used in order to take into account the possible influence of some compounds on the biodegradation of a given organic compound. The numerical model developed was applied to a simple test case, whose results are presented here. To cite this article: F. Nex et al., C. R. Geoscience 338 (2006).     

Assessing the Vibrational Frequencies of the Cathedral of Cologne (Germany) by Means of Ambient Seismic Noise Analysis

Ambient seismic noise measurements were conducted inside the Cathedral of Cologne (Germany) for assessing its frequencies of vibration and for checking whether these occur in the range where soil amplification is expected. If this is the case, damages may increase in case of an earthquake due to an increased structural response of the building. Analysis of the ratio between the horizontal and vertical components of the spectra recorded at stations located inside the building as well as the ratio between the corresponding components of the spectra recorded simultaneously inside the building and at a reference station placed in the basement of the cathedral indicated several modes of vibration. Facilitated by these results an assessment of the seismic vulnerability was attempted for a 2D ground motion scenario using the finite element method.     

Weathering characteristics of arctic islands in northern Norway

The arctic islands of the Lofoten-Vesterålen archipelago in northern Norway have a wide distribution of weathered land surfaces commonly located above 250 m with several apparent similarities. In order to investigate the characteristics of (deep) weathering in this region, northern Langøya and Hadseløya were chosen for in-depth analyses. Eight weathering profiles were excavated from various surfaces, and the stratigraphies were logged in detail. Material was collected throughout the weathering horizons, and all samples were subsequently analysed for clay mineralogy (< 63 μm fraction) and grain size distribution. The sampling strategy was complemented by samples from additional saprolites and other landforms such as moraines and rock glaciers. The XRD results indicate that the presence of secondary minerals, such as gibbsite (Al(OH)₃) and kaolinite (Al₂Si₂O₅(OH)₄), are very common throughout the profiles. Gibbsite is an extreme end product of silicate weathering and usually associated with a warmer and more humid climate, as found in Scandinavia during the Tertiary. The grain size analyses (< 63 μm) show that the finer silt fractions (< 8 μm) tend to be high in the profiles (20–40%), with significant amounts of clay (5–15%) demonstrating that the regolith itself is susceptible to frost sorting mechanisms.¹⁰Be exposure dates from in situ quartz knobs on tors and boulders of local origin suggest > 40,000 years of subaerial conditions. Considering the steady surface erosion, this figure should be viewed as an absolute minimum age estimate. Mapping of the superficial sediments and geomorphological features of the study areas has revealed several common morphological features, which indicate dominance of glacial and periglacial processes in the areas lying below the lower boundary of blockfields (c. 250 m). The weathering mantles are not a periglacial end product, but rather a relict tertiary landform that were modulated by permafrost processes as well as biological processes at later stages. The regolith cover constrain the vertical extension of warm-based Quaternary ice sheets challenging the notion of a parabolic ice mass consuming every mountain top of Lofoten and Vesterålen.     

A Comparison of Sediment Varves (1950–2003 AD) in Two Adjacent Lakes in Northern Sweden

Koltjärnen and Nylandssjön are two closely situated lakes (<2 km apart) in northern Sweden. During the past century, distinct varved sediments have formed in these lakes. Nylandssjön has two varved, deep basins. Since lake and catchment characteristics superficially appear very similar for the two lakes and they are exposed to the same climate, one would expect the sediment varves to be similar. This investigation compares the varves in the two deep basins of Nylandssjön, and in the two lakes. The comparison of basins of Nylandssjön shows that varve thickness, water content and annual accumulation rates of organic matter and nitrogen are correlated for the period (1970–2003). The grey-scale curves are only clearly similar in about 50% of the varves. In the between-lake comparison varve thickness, water content and annual accumulation rates of organic matter and nitrogen are correlated for the period (1950–1996). However, the annual accumulation rates of dry mass, minerogenic matter and biogenic silica differ between the lakes, as well as within-varve successions in grey-scale. A general explanation to the differences is that the prerequisites for varve formation are not totally similar because of differences in catchment size, catchment- to-lake material fluxes, lake productivity and land-use influence. This study illustrates the complex relationships that exist between a lake, its catchment, in-lake productivity and formation of sediment varves. As a consequence, we must not apply a too simplistic view of the potential of varves as past climatic indicators, especially if the lakes are affected by land-use.     

Tackling social exclusion in European neighbourhoods: experiences and lessons from the NEHOM project

Disadvantaged urban neighbourhoods with their complex social, economic and physical situations have increasingly become the focus of governmental policies in the EU. The emphasis has shifted from improving physical qualities to building opportunities for social groups in these areas. While physical upgrade is easier to achieve, at least in the short run, initiatives often fail in outcomes on communities and local participation. This paper aims to improve understanding on how to tackle area-based social exclusion and create socially coherent communities. Building on the results of the NEHOM project, the focus is on examining how various interventions have impacted local communities and their opportunities for better inclusion. A comparison between neighbourhoods shows that mixing social groups to a certain degree is likely to be a necessary step towards opening long-term opportunities for a disadvantaged neighbourhood. The planned initiatives should at the same time directly benefit local communities, and the involvement of local groups in the planning and implementation process helps to guarantee that the overall changes are accepted by the local community. However, the proposed guidelines do not provide a universal recipe for a successful renewal suiting each neighbourhood—the contextual matters should always be a starting point when planning an initiative.     

Formation of iron-containing colloids by the weathering of phyllite

The formation of colloids during the weathering of phyllite was investigated by exposing ground phyllite to Milli-Q water. Secondary mineral colloids of 10¹–10² nm were detected in significant concentrations. At pH of about 8.5, the solution concentration of these colloids reached up to 10 mg/L (however, acidification to pH 4.0 prevented the formation of the colloids). The mineralogical composition of the secondary mineral colloids is assumed to be a mixture of ferrihydrite, manganese oxyhydroxides, aluminosilicates, amorphous Al(OH)₃ and gibbsite with possible additions of iron silicates and␣iron-alumino silicates. The colloids were stable over longer periods of time (at least several weeks), even in the presence of suspended ground rock. Direct formation of iron-containing secondary mineral colloids at the rock–water interface by the weathering of rock material is an alternative to the well-known mechanism of iron colloid formation in the bulk of water bodies by mixing of different waters or by aeration of anoxic waters. This direct mechanism is of relevance for colloid production during the weathering of freshly crushed rock in the unsaturated zone as for instance crushed rock in mine waste rock piles. Colloids produced by this mechanism, too, can influence the transport of contaminants such as actinides because these colloids have a large specific surface area and a high sorption affinity.