Environmental hydrogeology of the southern sector of the Samborombon Bay wetland,Argentina

The Samborombon Bay wetland is located on the west margin of the Rio de la Plata estuary, in the Province of Buenos Aires, Argentina. This paper analyses the geological, geomorphologic, soil and vegetation characteristics of the southernmost sector of this wetland and their influence on surface water and groundwater. The study area presents three hydrologic units: coastal dunes, sand sheets and coastal plain. Coastal dunes and sand sheets are recharge zones of high permeability with well-drained, non-saline soils, and a few surface water flows. Changes in the water table are related to rainfall. Groundwater in coastal dunes is Ca–Mg–HCO₃ to Na–HCO₃, and of low salinity (590 mg/l). Groundwater in sand sheets is mainly Na–HCO₃ with a salinity of about 1,020 mg/l. The coastal plain exhibits medium to low permeability sediments, with submerged saline soils poorly drained. Groundwater is Na–Cl with a mean salinity of 16,502 mg/l. A surface hydrological network develops in the coastal plain. Surface water levels near the shoreline are affected by tidal fluctuations; far from the shoreline water accumulates because of poor drainage. Both sectors have Na–Cl water, but the former is more saline. Human intervention and sea level rise may affect the wetland severely.     

Interference of Multiple Strip Footings on Sand Using Small Scale Model Tests

By using small scale model tests, the interference effect on the vertical load-deformation behavior of a number of equally spaced strip footings, placed on the surface of dry sand, was investigated. At any stage, all the footings were assumed to (i) carry exactly equal magnitude of load, and (ii) settle to the same extent. No tilt of the footing was permitted. The effect of clear spacing (s) among footings on the results was explored. A new experimental setup was proposed in which only one footing needs to be employed rather than a number of footings. The bearing capacity increases continuously with decrease in spacing among the footings. The interference effect becomes further prominent with increase in soil friction angle. In contrast to an increase in the bearing capacity, with decrease in spacing of footings, an increase in the footing settlement associated with the ultimate state of shear failure was observed. The present experimental observations were similar to those predicted by the available theory, based on the method of characteristics. As compared to the theory, the present experimental data, however, indicates much greater effect of interference especially for larger spacing among footings.     

Analysis of the 2003 Varunawat Landslide,Uttarkashi, India using Earth Observation data

Mass movements such as landslides in mountainous terrains are natural degradation processes and one of the most important landscape-building factors. Varunawat Parbat overlooking Uttarkashi town witnessed a series of landslides on 23 September 2003 and the debris slides and rock falls continued for 2 weeks. This landslide complex was triggered due to the incessant rainfall prior to the event, and its occurrence led to the blockage of the pilgrim route to Gangotri (source of the Ganges river) and evacuation of thousands of people to safer places. Though there was no loss of lives due to timely evacuation, heavy losses to the property were reported. High-resolution stereoscopic earth observation data were acquired after the incidence to study the landslide in detail with emphasis on the cause of the landslide and mode of failure. Areas along the road and below the Varunawat foothill region are mapped for landslide risk. It was found that the foothill region of the Varunawat Parbat was highly disturbed by man-made activities and houses are dangerously located below steep slopes. The potential zones for landslides along with the existing active and old landslides are mapped. These areas are critical and their treatment with priority is required in order to minimise further landslide occurrences.     

Finite Element Modeling of Swelling Soil Pressures Using Joint/Interface Elements

There could be some discontinuities in a soil media such as layers, earth structures, cracks, and fissures so that estimation of stresses and deformations in these types of soil masses are somewhat different from continuous masses. The discontinuities in a soil mass could be considered as a special link between two blocks. Transmitted swelling pressures affected by the soil properties of the backfill especially at the interface between the backfill and retaining wall. In order to estimate the transmitted swelling pressure distribution behind a retaining wall, using with interface element, a new finite element model and a code (SWELPRES) have been developed. To evaluate the effect of backfill characteristics and interface element from the transmitted lateral swelling pressures, four cases of thickness of backfills with or without interface elements are investigated.     

Monitoring Large-Scale Tests for Nuclear Waste Disposal

Two large-scale “in situ” demonstration experiments and their instrumentation are described. The first test (FEBEX Experiment) involves the hydration of a compacted bentonite barrier under the combined effect of an inner source of heat and an outer water flow from the confining saturated granite rock. In the second case, the progressive de-saturation of Opalinus clay induced by maintained ventilation of an unlined tunnel is analyzed. The paper shows the performance of different sensors (capacitive cells, psychrometers, TDR’s) and a comparison of fill behaviour with modelling results. The long term performance of some instruments could also be evaluated specially in the case of FEBEX test. Capacitive sensors provide relative humidity data during long transient periods characterised by very large variations of suction within the bentonite.     

Sur la présence de nickel dans un gisement de bauxite près de Mégare

Résumé L'exploitation récente d'un gisement de bauxite près de Mégare (Grèce) a fait apparaître sur les calcaires de base une concentration verte d'oxyde de nickel relativement élevée. La présence dans le gisement d'argiles rouges, renfermant de fortes proportions d'oxyde de fer avec des teneurs relativement faibles en alumine et des traces d'oxyde de nickel, induit à penser qu'il s'agit d'un produit latéritique dérivé d'une roche ultrabasique et transporté ultérieurement sur la région calcaire karstifiée avec ses remplissages bauxitiques. L'étude se termine par une hypothèse sur la genèse de ce gîte singulier.

---

The recent mining of a bauxite deposit near Megara (Greece) has shown on the footwall limestone a relatively high concentration of a green nickel oxide. The occurrence in the same deposit of red clays with a rather high percentage of iron oxide and a low content of alumina, together with some traces of nickel, induces to think that this material is composed of a lateritic soil derived from an ultrabasic rock and subsequently transported on karstified limestone with its bauxitic fillings. — The study ends with an hypothesis on the genesis of this unusual deposit.

     

Longitudinal strength of a high-speed ferry

The longitudinal strength of the high-speed ferry was investigated by subjecting the ship's hull girder to long-term loads obtained from a frequency-domain panel code. Prior to the statistical analysis, linearly computed transfer functions were corrected for nonlinear effects, yielding two sets of transfer functions valid for different wave amplitudes. One set corresponded to the hogging condition; the other set, to the sagging condition. Two regular equivalent design waves were specified that resulted in loads representing the most severe global design load conditions. The still-water loading condition, yielding a still-water vertical bending moment in hogging, was superimposed on the wave-induced loads to obtain the total (design) loads in hogging. For the sagging condition only, additional impact-related loads were superimposed to obtain the total (design) loads in sagging. A finite element model of the ship's structure was subjected to pressure distributions according to the two regular design waves. For comparison with classification society rule values, a simple beam theory strength analysis of the ship's midship section was performed first, and then another finite element analysis was carried out, whereby the imposed loads were tuned to the rule values of vertical bending moments. Rule-based magnitudes of nominal maximum longitudinal stress deviated significantly (25–39%) from comparable stresses obtained by the panel code based finite element analysis. However, stresses obtained from the rule-based finite element analysis agreed more favorably, especially in hogging. In the uppermost deck, for example, the panel code based compressive stress was only 9% larger than the comparable stress from the rule-based finite element analysis.     

Constraining the origin and evolution of confined turbidite systems: southern Cretan margin,Eastern Mediterranean Sea (34°30–36°N)

Bathymetric, 9.5-kHz long-range sidescan sonar (OKEAN), seismic reflection and sediment-core data are used in the analysis of two tectonic troughs south of Crete, Eastern Mediterranean Sea. Here, up to 1.2 s two-way travel time (TWTT) of strata have accumulated since the Middle Miocene in association with extension in the South Aegean region. The study area comprises >100-km- long by >25-km-wide basins filled by sediments subdivided into two seismic units: (1) an upper Unit 1 deposited in sub-basins which follow the present-day configuration of the southern Cretan margin; (2) a basal Unit 2, more than 500 ms (TWTT) thick, accumulated in deeper half-graben/grabens distinct from the present-day depocentres. Both units overlap a locally stratified Unit 3 comprising the pre-Neogene core complex of Crete and Gavdos. In this work, the interpreted seismic units are correlated with the onshore stratigraphy, demonstrating that denudation processes occurring on Crete and Gavdos in response to major tectonic events have been responsible for high sedimentation rates along the proximal southern Cretan margin. Consequently, topographically confined sedimentary units have been deposited south of Crete in the last 12 Ma, including turbidites and other mass-flow deposits fed by evolving transverse and axial channel systems. Surface processes controlling facies distribution include the direct inflow of sediment from alluvial-fan systems and incising mountain rivers onto the Cretan slope, where significant sediment instability processes occur at present. In this setting, seismic profiles reveal eight different types of stratigraphic contacts on basin-margin highs, and basinal areas show evidence of halokinesis and/or fluid escape. The acquired data also show that significant changes to the margin’s configuration occurred in association with the post-Alpine tectonic and eustatic episodes affecting the Eastern Mediterranean.     

Community and Population Responses of the Macroinfauna to Physical Factors over a Range of Exposed Sandy Beaches in South-central Chile

Ten exposed sandy sites covering a range from reflective to dissipative beaches were sampled in south-central Chile to evaluate: (1) spatial changes in species richness, abundance and biomass of the intertidal macroinfauna in response to changes in mean grain size, beach face slope and beach type, and (2) spatial changes in abundance, biomass and body sizes of the most abundant species in response to changes in the physical factors. The number of species, abundance and biomass per beach in general decreased with increasing particle size and beach face slope (steeper beaches) and increased from reflective to dissipative conditions. The best fit for number of species was with Dean's parameter, a measure of beach type, whereas for abundance and biomass the best fits were found with particle size. The isopod Excirolana braziliensis and the anomuran Emerita analoga increased in abundance and biomass towards dissipative conditions, whereas Excirolana hirsuticauda showed the opposite trend in biomass and was significantly larger in beaches with steeper profiles. It is concluded that responses to changes in beach type are more pronounced at community level than within species populations.     

Quaternary geology of the Amazonian Lowland

The Quaternary history of the Amazon lowlands is characterized by deposition of sediments of Andean provenance and by the influences of changing sea levels. Areas well above the present water tables were not reached by Pleistocene high-water stages. These areas have been intensively weathered since the Tertiary, forming hard lateritic weathering horizons. These weathering horizons are best explained by the relatively constant, humid tropical climate throughout the Quaternary. In the western Amazonian Lowland, flood plains corresponding to the different Pleistocene sea-level heights were formed. During low sea level, erosion in the drainage areas increased and the water levels of the central Amazon River system were lowered. Valleys drowned and lakes formed in the lower reaches of rivers and creeks during high sea-level stages. These lakes (ria lakes) remained in the valleys with rivers having a low sediment load. Seismic profiling (3.5 kHz) in some of these lakes clearly showed deposits of the three last periods of Quaternary high sea-level stages.