Production of selected cosmogenic radionuclides by muons: 2. Capture of negative muons

We have determined the production yields for radionuclides in Al₂O₃, SiO₂, S, Ar, K₂SO₄, CaCO₃, Fe, Ni and Cu targets, which were irradiated with slow negative muons at the Paul Scherrer Institute in Villigen (Switzerland). The fluences of the stopped negative muons were determined by measuring the muonic X-rays. The concentrations of the long-lived and short-lived radionuclides were measured with accelerator mass spectrometry (AMS) and γ-spectroscopy, respectively. Special emphasis was put on the radionuclides ¹⁰Be, ¹⁴C and ²⁶Al produced in quartz targets, ²⁶Al in Al₂O₃ and S targets, ³⁶Cl in K₂SO₄ and CaCO₃ targets, and ⁵³Mn in Fe₂O₃ targets. These targets were selected because they are also the naturally occurring target minerals for cosmic ray interactions in typical rocks. We also present results of calculations for depth-dependent production rates of radionuclides produced after cosmic ray μ⁻ capture, as well as cosmic ray-induced production rates of geologically relevant radionuclides produced by the nucleonic component, by μ⁻ capture, by fast muons and by neutron capture.     

Modelling Seismic Waves Around Underground Openings in Fractured Rock

—?The potential for large excavation-induced seismic events may be recognised, even if the timing of an event may be inherently unpredictable. In this case, modelling the wave propagation from a potential event could allow the dynamic motions around an excavation to be projected, and for areas of danger to be anticipated. However, the above and other potential applications require accurate models of wave interaction with the openings, as well as with the fractured rock which surrounds such excavations. This paper considers real recorded waveforms and how well these waveforms are modelled by explicit mechanical models of the source, the medium and the excavation. Models of experiments at three different scales of the problem are presented: small and large amplitude waveforms recorded around a deep-level mining tunnel in a synthetic rockburst experiment; waveforms from laboratory experiments of waves through plates of steel representing fractures; waveforms from active pulses in an acoustic emission experiment in a small volume of fractured rock at the surface of an underground excavation. The results show that elastic wave propagation around an excavation was a first approximation for small amplitude waves, but was less successful for modelling large amplitude waves and more fractured rock. Fractures in the models were represented explicitly with displacement discontinuities. Waveforms through known fracture geometries were particularly well-reproduced, and indicate the importance of fracture stiffness, the in situ stress state, and stress-dependence of the fractures in such models. Overall, the models are sufficiently successful at representing recorded behaviour, to be encouraging for the goal of representing accurate wave motions around excavations.     

Sedimentary Deposits from the 17 July 2006 Western Java Tsunami,Indonesia: Use of Grain Size Analyses to Assess Tsunami Flow Depth,Speed, and Traction Carpet Characteristics

The 2006 western Java tsunami deposited a discontinuous sheet of sand up to 20 cm thick, flooded coastal southern Java to a depth of at least 8 m and inundated up to 1 km inland. In most places the primarily heavy mineral sand sheet is normally graded, and in some it contains complex internal stratigraphy. Structures within the sand sheet probably record the passage of up to two individual waves, a point noted in eyewitness accounts. We studied the 2006 tsunami deposits in detail along a flow parallel transect about 750 m long, 15 km east of Cilacap. The tsunami deposit first becomes discernable from the underlying sediment 70 m from the shoreline. From 75 to 300 m inland the deposit has been laid down in rice paddies, and maintains a thickness of 10–20 cm. Landward of 300 m the deposit thins dramatically, reaching 1 mm by 450 m inland. From 450 m to the edge of deposition (around 700 m inland) the deposit remains <1 mm thick. Deposition generally attended inundation—along the transect, the tsunami deposited sand to within about 40 m of the inundation limit. The thicker part of the deposit contains primarily sand indistinguishable from that found on the beach 3 weeks after the event, but after about 450 m (and roughly coinciding with the decrease in thickness) the tsunami sediment shifts to become more like the underlying paddy soil than the beach sand. Grain sizes within the deposit tend to fine upward and landward, although overall upward fining takes place in two discrete pulses, with an initial section of inverse grading followed by a section of normal grading. The two inversely graded sections are also density graded, with denser grains at the base, and less dense grains at the top. The two normally graded sections show no trends in density. The inversely graded sections show high density sediment to the base and become less dense upward and represents traction carpet flows at the base of the tsunami. These are suggestive of high shear rates in the flow. Because of the grain sorting in the traction carpet, the landward-fining trends usually seen in tsunami deposits are masked, although lateral changes of mean sediment grain size along the transect do show overall landward fining, with more variation as the deposit tapers off. The deposit is also thicker in the more seaward portions than would be produced by tsunamis lacking traction carpets.     

Geochemistry and petrography of basalt grindstones from the Karak Plateau,central Jordan

Seventeen basalt grindstone fragments from central Jordan's Karak Plateau were studied. Most of these artifacts are vesicular or amygdaloidal with calcite as the dominant mineral filling the voids. The major minerals are olivine (with iddingsite rims), plagioclase, clinopyroxene, magnetite, and apatite. Glass is present in some samples. One basalt fragment is quite different in appearance and composition and may have come from flows closer to the Dead Sea. Grindstone fragment compositions plot in the tephrite‐basanite and basalt fields. A plot of the concentrations of niobium, zirconium, and yttrium reveal that the sample compositions plot in the “within‐plate alkali basalt” and “within‐plate tholeiite” fields. The acquisition of basalts for preparing such implements appears to have been random. Some may have been introduced through trade and migration. Archaeological and environmental studies on the Karak Plateau are urgently needed because Jordan's population growth and economic development are destroying many sites and their environmental contexts. © 2004 Wiley Periodicals, Inc.     

The earthquake sequence of May 1951 at Jucuapa, El Salvador

Three earthquakes that happened over two days in May 1951 caused extensive damage to villages in a small area of eastern El Salvador (Central America). Contemporary hypocentral solutions indicated focal depths, confirmed by re-calculations using available seismic data, of the order of 90 km, suggesting events associated with the subducted Cocos plate. Macroseismic observations strongly indicate that the earthquakes were of very shallow focus and this is supported by wave-form modeling and the appearance of seismograms recorded in Guatemala. A re-evaluation of the location and source characteristics for these events is presented, together with a fault plane solution and additional macroseismic evidence. The implications for seismic hazard and risk assessment in Central America, where shallow earthquakes of moderate magnitude, frequently occurring in clusters, pose the greatest threat to settlements which, like the area affected by these events, are concentrated along the axis of Quaternary volcanoes.