Quantifying groundwater discharge to a small perennial stream in southern Ontario, Canada

A study of the interaction between groundwater and surface water was undertaken within a small agricultural watershed in southern Ontario, Canada. Groundwater contributions to streamflow were measured along a section of stream during baseflow conditions and during rainfall events. Four techniques were used to estimate the contribution of groundwater to the stream along a 450 m reach (three during baseflow and one during stormflow conditions). Under baseflow conditions, streamflow measurements using the velocity–area technique indicated that the net groundwater flux to the stream during the summer months was 10 ml s⁻¹ m⁻¹. Hydrometric measurements (i.e. hydraulic gradient and hydraulic conductivity) taken using mini-piezometers installed in the sediments beneath the stream resulted in net groundwater flux estimates that were four to five times lower. Seepage meters failed to provide any measurements of water flux into or out of the stream. Therefore, based on these results, the velocity–area technique gives the best estimate of groundwater discharge. Hydrograph separations were conducted using isotopic ratios and electrical conductivity on two large rainfall events with different antecedent moisture conditions in the catchment. Both events showed that pre-event water (generally considered groundwater) dominated streamflow and tile drain flow with 64%–80% of the total discharge contributed by pre-event water. High water table conditions within the catchment resulted in greater stream discharge and a greater contribution of event water in the streamflow than that observed under low water table conditions for similar intensity storm events. The results also showed that differences in riparian zone width, vegetation and surface saturation conditions between the upper and lower catchment can influence the relative magnitude of streamflow response from the two catchment areas.     

Cleavage-fold relationships and their implications for transected folds: an example from southwest Virginia,U.S.A.

A non-coaxial deformation involving pre-folding initiation of cleavage perpendicular to bedding is proposed to explain non-axial planar cleavage associated with mesoscopic folds in part of the Appalachian foreland thrust-belt of southwest Virginia. Folds are gently plunging, asymmetric, upright to slightly inclined, sinusoidal forms with non-axial fanning cleavage. They show extreme local variations in type and degree of transection and the consistency of transection direction. These relations are further complicated by hinge migration.Cleavage-fan angles, bedding-cleavage angles and δ transection values appear influenced by fold tightness, and in part by fold flattening strain. Fold flattening increments are considered simultaneous with folding. Axial surface traces, and not cleavage traces, coincide with the principal extension direction in fold profiles. Geometric modelling of cleavage fanning and bedding-cleavage angle variations for various theoretical folding modes suggest that folding in limestone and sandstone layers was by tangential longitudinal strain. Significant shape modification and change in bedding-cleavage relations occurred after limb dips of 40 and 50° were attained in limestone and sandstone respectively. Mud-rock class 1C folds with convergent cleavage fans show features transitional between buckling and flexural flow. Initiation of ‘cleavage’ fabrics during layer-parallel shortening prior to significant folding may be important for cleavage evolution in some deformed rocks.     

The socioeconomic impacts of nuclear generating stations: An analysis of the Rancho Seco and peach bottom facilities

This paper presents the results of a comparative analysis of the socioeconomic impacts of the construction and operation of two nuclear generating stations. Although the construction of nuclear power plants is typically a multiyear process utilizing large numbers of workers and requiring large expenditures for equipment and materials, the socioeconomic changes in the areas in which the plants are located were small and temporary. The extent and size of the changes were found to be related to the size of the work force residing in the local area, the magnitude of local utility and contractor purchases, the amount of tax payments resulting from the plant, and the level of involvement of area groups over plant-related issues.     

Relation of lava compositions to volcano size and structure in El Salvador

Most of the lavas at the nine volcanic centers along the volcanic front of El Salvador are basalts, basaltic andesites and andesites. The compositional variation within and among these centers can be explained by fractionation processes within the crust. Cognate gabbroic inclusions found in the lavas have appropriate mineralogy (plagioclase, olivine, magnetite and augite) to be cumulates formed by fractional crystallization. Two main variation trends occur, depending on the proportion of plagioclase removal. The more common, or normal, trend has a high (> 55%) proportion of plagioclase being removed. A less common, Al-rich, trend has a low (40%) proportion of plagioclase being removed. The Al-rich trend is found only at volcanoes that lack large negative Bouguer gravity anomalies. These volcanoes are unlikely to have large shallow magma chambers and fractionation probably occurs deeper in the crust where plagioclase removal is inhibited.The incompatible element (Na₂O, K₂O, Rb, Ba) contents of lavas vary systematically with the volume of the volcanic centers. At the same level of SiO₂, large volcanic centers have higher incompatible element contents than small volcanic centers. This suggests that open system fractionation in a periodically refilled chamber is the controlling factor. The large difference in Ba contents of lavas between eastern (low) and western (high) El Salvador suggests a difference in the mantle source region.     

Generation and dispersal of fine ash and dust by volcanic eruptions

The volcanic eruptions which generate the greatest quantities of fine ash and dust are those of ignimbrite-forming, plinian, vulcanian and phreatomagmatic types; these are also the eruptions which produce the widest dispersal of this material, attributed to the superior height attained by their eruptive columns. However, much of the fine ash and dust may be rapidly flushed out of the eruptive plume by water, particularly in phreatomagmatic eruptions. Recent studies made on the dispersal and grain-size of pyroclastic deposits produced by examples of plinian and phreatomagmatic types, have yielded estimates of the quantities of material generated in each grain-size class, besides the extent of their dispersal. Not all of the fine volcanic particles are produced by fragmentation at the eruptive vent; in ignimbrite eruptions, there is good evidence for their large-scale generation in and loss from the moving ash flows.     

Exposed cross-sections through the continental crust: implications for crustal structure,petrology, and evolution

The continental crust is exposed in cross-section at numerous sites on the earth's surface. These exposures, which appear to have formed by obduction along great faults during continental collision, may be recognized by exposures of deep crustal rocks exhibiting asymmetric patterns of metamorphic grade and age across the faults and by distinctive Bouguer anomaly patterns reflecting dipping basement structure and an anomalously deep mantle. From an examination of five complexes which meet these criteria, it is concluded that the most prominent layering in the crust is not compositional but metamorphic. The lower crust consists of granulite facies rocks of mafic to intermediate composition while the intermediate and shallow levels consist predominantly of amphibolite facies gneisses and greenschist facies supracrustal rocks, respectively. Post-metamorphic granitic intrusions are common at intermediate to shallow levels. Position of discontinuities in refraction velocity, where present, commonly correspond to changes in composition or metamorphic grade with depth. The continental crust is characterized by lateral and vertical heterogeneities of varying scale which are the apparent cause of the complex seismic reflections recorded by COCORP. Field observations, coupled with geochemical data, indicate a complex evolution of the lower crust which can include anatexis, multiple deformation, polymetamorphism and reworking of older crustal material. The complexity of the crust is thus the result of continuous evolution by recycling and metamorphism through time in a variety of tectonic environments.     

An island arc origin for the Canyon Mountain ophiolite complex,eastern Oregon,U.S.A.

The Canyon Mountain ophiolite, Oregon, is exceptional in lacking sheeted dikes, basaltic pillow lavas, and sediments that are characteristic of many other ophiolites. Instead, the uppermost portion of the complex consists of a significant volume of plagiogranites, which, in addition to minor basalts, intrude a large section of keratophyres believed to be of volcanic origin. The trend of intrusive rocks and of bedding in the keratophyres is mostly parallel to layering in the underlying gabbroic cumulates and to contacts between units in the remainder of the ophiolite. It is suggested that the plagiogranites, basalts, and keratophyres comprise a sill complex. Both the plagiogranites and the keratophyres are similar, respectively, to low-K₂O plutonic and extrusive rocks of island arcs. The mineralogy and penetrative deformation structures of the ultramafic and some of the gabbroic rocks of the ophiolite indicate greater depth of formation, related to magmatism and diapirism above a Benioff zone. Radiometric age dates of plagiogranites confine the minimum age of the complex to the Early Permian. The Canyon Mountain ophiolite may thus be correlative with other fragments of a Lower Permian arc terrane throughout northeastern Oregon which were chaotically mixed during renewed subduction in middle to late Triassic time.     

A study of conditions at the inner core boundary of the earth

A study is made of the thermal and compositional conditions which the liquid outer core must satisfy at the inner core boundary, assuming the inner core to be growing by continual solidification of the heavy component of the liquid alloy in the outer core. It is found that the outer core is strongly destabilized by the compositional gradients driven by the separation process associated with the freezing. Further, it is argued that all the freezing necessary for the growth of the solid inner core cannot occur on a flat interface; most of it must occur above the solid boundary in a region labeled the slurry layer.