Is there an oblique magnetic rotator inside the Sun?

The size of the rotational splitting recently observed (Claverie et al., 1981) is correlated with the 12.2^d variation in the measurements of solar oblateness observed by Dicke (1976) and implies a convection zone of depth of 0.1 R . The near equality of amplitudes of global velocity oscillations (Claverie et al., 1981) of the various m components of the l = 1 and l = 2 modes as seen from the Earth viewing the Sun nearly along the equator is unexpected for pure rotational splitting. It is suggested that a magnetic perturbation is present and an oblique asymmetric magnetic rotator with magnetic fields of a few million gauss is responsible. A more detailed account was submitted to Nature.Proceedings of the 66th IAU Colloquium: Problems in Solar and Stellar Oscillations, held at the Crimean Astrophysical Observatory, U.S.S.R., 1–5 September, 1981.     

Preliminary observations of solar radio sources with the Culgoora radioheliograph operating at four frequencies

The Culgoora radioheliograph has been modified for observing at 327.4 MHz, which is in addition to the three frequencies (43.25, 80, and 160 MHz) previously available. At the new frequency the array beamwidth is 56, which represents the highest resolution yet available for metre-wavelength solar mapping.At 327.4 MHz the sources of radio emission are mainly in the lowest layers of the corona. Some preliminary four-frequency observations have been made of type I storms. It is found that the source size generally decreases with increasing observing frequency. This result confirms earlier suggestions that the sources of both type I and type III emission are contained in structures whose boundaries diverge outwards in the corona.     

Asymmetrically zoned reaction rims: assessment of grain boundary diffusivities and growth rates related to natural diffusion-controlled mineral reactions

This study explores garnet coronas around hedenbergite, which were formed by the reaction plagioclase + hedenbergite→garnet + quartz, to derive information about diffusion paths that allowed for material redistribution during reaction progress. Whereas quartz forms disconnected single grains along the garnet/hedenbergite boundaries, garnet forms ～20‐μm‐wide continuous polycrystalline rims along former plagioclase/hedenbergite phase boundaries. Individual garnet crystals are separated by low‐angle grain boundaries, which commonly form a direct link between the reaction interfaces of the plagioclase|garnet|hedenbergite succession. Compositional variations in garnet involve: (i) an overall asymmetric compositional zoning in Ca, Fe²⁺, Fe³⁺ and Al across the garnet layer; and (ii) micron‐scale compositional variations in the near‐grain boundary regions and along plagioclase/garnet phase boundaries. These compositional variations formed during garnet rim growth. Thereby, transfer of the chemical components occurred by a combination of fast‐path diffusion along grain boundaries within the garnet rim, slow diffusion through the interior of the garnet grains, and by fast diffusion along the garnet/plagioclase and the garnet/hedenbergite phase boundaries. Numerical simulation indicates that diffusion of Ca, Al and Fe²⁺ occurred about three to four, four and six to seven orders of magnitude faster along the grain boundaries than through the interior of the garnet grains. Fast‐path diffusion along grain boundaries contributed substantially to the bulk material transfer across the growing garnet rim. Despite the contribution of fast‐path diffusion, bulk diffusion through the garnet rim was too slow to allow for chemical equilibration of the phases involved in garnet rim formation even on a micrometre scale. Based on published garnet volume diffusion data the growth interval of a 20‐μm‐wide garnet rim is estimated at ～10³–10⁴ years at the inferred reaction conditions of 760 ± 50 °C at 7.6 kbar. Using the same parameterization of the growth law, 100‐μm‐ and 1‐mm‐thick garnet rims would grow within 10⁵–10⁶ and 10⁶–10⁷ years respectively.     

The role of heterogeneous strain in the development and preservation of a polymetamorphic record in high-P granulites, western Canadian Shield

Mafic rocks in the Chipman domain of the Athabasca granulite terrane, western Canadian Shield, provide the first well‐documented record of two distinct high‐P granulite facies events in the same domain in this region. Textural relations and the results of petrological modelling (NCFMASHT system) of mafic granulites are interpreted in terms of a three‐stage tectonometamorphic history. Stage 1 involved development of the assemblage Grt + Cpx + Qtz ± Pl (M₁) from a primary Opx‐bearing igneous precursor at conditions of 1.3 GPa, 850–900 °C. Field and microstructural observations suggest that M₁ developed synchronously with an early S₁ gneissic fabric. Stage 2 is characterized by heterogeneous deformation (D₂) and synkinematic partial retrogression of the peak assemblage to an amphibole‐bearing assemblage (M₂). Stage 3 involved a third phase of deformation and a return to granulite facies conditions marked by the prograde breakdown of amphibole (Amph₂) to produce matrix garnet (Grt_3a) and the coronitic assemblage Cpx_3b + Opx_3b + Ilm_3b + Pl_3b (M_3b) at 1.0 GPa, 800–900 °C. M₁ and M_3b are correlated with 2.55 and 1.9 Ga metamorphic generations of zircon, respectively, which were dated in a separate study. Heterogeneous strain played a crucial role in both the development and preservation of these rare examples of multiple granulite facies events within single samples. Without this fortuitous set of circumstances, the apparent reaction history could have incorrectly led to an interpretation involving a single‐cycle high‐grade event. The detailed P–T–t–D history constructed for these rocks provides the best evidence to date that much of the east Lake Athabasca region experienced long‐term lower crustal residence from 2.55 to 1.9 Ga, and thus the region represents a rare window into the reactivation and ultimate stabilization processes of cratonic lithosphere.     

Impact evaluation on groundwater of the infiltration of an urban wastewater geopurification system placed over a detrital aquifer in a semiarid region (Spain)

Over a period of 4 years and 4 months, the geopurification installations at Dehesas de Guadix (Granada, Spain) were monitored to determine the impact on soil and groundwater of the controlled discharge of urban wastewater, and also to identify the best indicators of the entry of the recharged water into the aquifer. The installations are located in an area where the climate is Mediterranean sub-arid, with an average precipitation of less than 287 mm/year, and a rate of evapotranspiration that is almost three times greater. The system was controlled by determining the balance of majority nutrients and boron in the soil and in the groundwater, both at the points affected directly by the wastewater discharge and at others. The quantity of mass discharged was relatively large (COD 14,656 g/m², NO₃ 85 g/m², NO₂ 4 g/m², NH₄ 2,425 g/m², PO₄ 1,143 g/m², K 1,531 g/m², B 63 g/m²). It was observed that the elimination of nutrients within the soil (COD 97.5%, PO₄ 94.4%, K 59.17%, N _total 18.8%, B 12.69%) was very efficient except for the nitrogen, which nevertheless did not reach the groundwater, as it was eliminated at deep levels of the unsaturated zone. Only 12.69% of the boron was removed, and appreciable, increasing amounts of this element did reach the groundwater. Unexpectedly, none of the majority nutrients behaved as a reliable indicator of the impact on groundwater; despite this, the boron and the bicarbonate did clearly reflect the arrival of the recharged water, and are proposed as the best indicators.     

Controls on porphyroblast size along a regional metamorphic field gradient

Garnet-bearing schists from the Waterville Formation of south-central Maine provide an opportunity to examine the factors governing porphyroblast size over a range of metamorphic grade. Three-dimensional sizes and locations for all garnet porphyroblasts were determined for three samples along the metamorphic field gradient spanning lowest garnet through sillimanite grade, using high-resolution X-ray computed tomography. Comparison of crystal size distributions to previous data sets obtained by stereological methods for the same samples reveals significant differences in mode, mean, and shape of the distributions. Quantitative textural analysis shows that the garnets in each rock crystallized in a diffusion-controlled nucleation and growth regime. In contrast to the typical observation of a correlation between porphyroblast size and position along a metamorphic field gradient, porphyroblast size of the lowest-grade specimen is intermediate between the high- and middle-grade specimens’ sizes. Mean porphyroblast size does not correlate with peak temperatures from garnet-biotite Fe-Mg exchange thermometry, nor is post-crystallization annealing (Ostwald Ripening) required to produce the observed textures, as was previously proposed for these rocks. Robust pseudosection calculations fail to reproduce the observed garnet core compositions for two specimens, suggesting that these calc-pelites experienced metasomatism. For each of these two specimens, Monte Carlo calculations suggest potential pre-metasomatism bulk compositions that replicate garnet core compositions. Pseudosection analyses allow the estimation of the critical temperatures for garnet growth: ∼481, ∼477, and ∼485°C for the lowest-garnet-zone, middle-garnet-zone, and sillimanite-zone specimens, respectively. Porphyroblast size appears to be determined in this case by a combination of the heating rate during garnet crystallization, the critical temperature for the garnet-forming reaction and the kinetics of nucleation. Numerical simulations of thermally accelerated, diffusion-controlled nucleation, and growth for the three samples closely match measured crystal size distributions. These observations and simulations suggest that previous hypotheses linking the garnet size primarily to the temperature at the onset of porphyroblast nucleation can only partially explain the observed textures. Also important in determining porphyroblast size are the heating rate and the distribution of favorable nucleation sites.     

Low-oxygen and chemical kinetic constraints on the geochemical niche of neutrophilic iron(II) oxidizing microorganisms

Neutrophilic iron oxidizing bacteria (FeOB) must actively compete with rapid abiotic processes governing Fe(II) oxidation and as a result have adapted to primarily inhabit low-O₂ environments where they can more successfully compete with abiotic Fe(II) oxidation. The spatial distribution of these microorganisms can be observed through the chemical gradients they affect, as measured using in situ voltammetric analysis for dissolved Fe(II), Fe(III), O₂, and FeS_(aq). Field and laboratory determination of the chemical environments inhabited by the FeOB were coupled with detailed kinetic competition studies for abiotic and biotic oxidation processes using a pure culture of FeOB to quantify the geochemical niche these organisms inhabit. In gradient culture tubes, the maximum oxygen levels, which were associated with growth bands of Sideroxydans lithotrophicus (ES-1, a novel FeOB), were 15-50 μM. Kinetic measurements made on S. lithotrophicus compared biotic/abiotic (killed control) Fe oxidation rates. The biotic rate can be a significant and measurable fraction of the total Fe oxidation rate below O₂ concentrations of approximately 50 μM, but biotic Fe(II) oxidation (via the biotic/abiotic rate comparison) becomes difficult to detect at higher O₂ levels. These results are further supported by observations of conditions supporting FeOB communities in field settings. Variablity in cell densities and cellular activity as well as variations in hydrous ferrous oxide mineral quantities significantly affect the laboratory kinetic rates. The microbial habitat (or geochemical niche) where FeOB are active is thus largely controlled by the competition between abiotic and biotic kinetics, which are dependent on Fe(II) concentration, P_O2, temperature and pH in addition to the surface area of hydrous ferric oxide minerals and the cell density/activity of FeOB. Additional field and lab culture observations suggest a potentially important role for the iron-sulfide aqueous molecular cluster, FeS_(aq), in the overall cycling of iron associated with the environments these microorganisms inhabit.     

The Fe-C system at 5 GPa and implications for Earth’s core

Earth’s core may contain C, and it has been suggested that C in the core could stabilize the formation of a solid inner core composed of Fe₃C. We experimentally examined the Fe-C system at a pressure of 5 GPa and determined the Fe-C phase diagram at this pressure. In addition, we measured solid metal/liquid metal partition coefficients for 17 trace elements and examined the partitioning behavior between Fe₃C and liquid metal for 14 trace elements. Solid metal/liquid metal partition coefficients are similar to those found in one atmosphere studies, indicating that the effect of pressure to 5 GPa is negligible. All measured Fe₃C/liquid metal partition coefficients investigated are less than one, such that all trace elements prefer the C-rich liquid to Fe₃C. Fe₃C/liquid metal partition coefficients tend to decrease with decreasing atomic radii within a given period. Of particular interest, our 5 GPa Fe-C phase diagram does not show any evidence that the Fe-Fe₃C eutectic composition shifts to lower C contents with increasing pressure, which is central to the previous reasoning that the inner core may be composed of Fe₃C.     

Thermodynamic model for arsenic speciation in sulfidic waters: A novel use of ab initio computations

Recent discoveries demonstrate that the chemistry of arsenic in sulfidic waters is much more complex that previously believed. One implication is that all earlier thermodynamic data on stabilities of As thioanions require revision. Previously used experimental approaches for determining As thioanion stabilities may be inadequate to deal with the full range of complexity. Here we use computational as well as empirical information to construct a provisional model for equilibrium As thioanion distributions in sulfidic waters. Whereas previous authors have argued for either As(III) or As(V) thioanions, the new model predicts that both are important and can occur simultaneously under commonly encountered pH and ΣS^−II conditions. At the order of magnitude level, the model reasonably predicts the solubility of As₂S₃ in sulfidic solutions, provides tentative peak assignments for published Raman spectroscopic data and plausibly accounts for how sulfide modifies the bacterial toxicity of As. The model yields a thermodynamic justification for how sulfide, which is usually regarded as a reducing agent, can counter-intuitively drive oxidation of As(III) to As(V), as has been observed both in the laboratory and in the field. Despite its uncertain accuracy, the model serves as a useful source of new, testable hypotheses about As geochemistry and highlights crucial experimental data needs.     

An Attempt to Predict the Failure Time of Abandoned Mine Pillars

Summary  Left in place pillars of abandoned mines are subject to weathering (e.g action of water, bacteria) that degrades their mechanical strength and eventually leads to collapse. A simple weathering model is proposed, that is governed by two parameters: the rate of progression of weathered front and the rate of degradation of the compressive strength with time. Both plane strain and axisymmetric analyses are performed and closed form solutions of the variation with time of the bearing capacity of the pillar are given. Experimental data of the tests conducted on gypsum and anhydrite specimens attacked by water are presented. It is shown that in order to fit the experimental data a third parameter must be introduced. New closed form solutions are given and the data are used for estimating the time to failure of abandoned gypsum mines in Northern Italy. Authors’ address: Dr. Riccardo Castellanza, Research Assistant, Department of Structural Engineering, Milan University of Technology (Politecnico), Piazza Leonardo da Vinci 32, 20133 Milan, Italy