The passivation of calcite by acid mine water. Column experiments with ferric sulfate and ferric chloride solutions at pH 2

Column experiments, simulating the behavior of passive treatment systems for acid mine drainage, have been performed. Acid solutions (HCl or H₂SO₄, pH 2), with initial concentrations of Fe(III) ranging from 250 to 1500 mg L⁻¹, were injected into column reactors packed with calcite grains at a constant flow rate. The composition of the solutions was monitored during the experiments. At the end of the experiments (passivation of the columns), the composition and structure of the solids were measured. The dissolution of calcite in the columns caused an increase in pH and the release of Ca into the solution, leading to the precipitation of gypsum and Fe–oxyhydroxysulfates (Fe(III)–SO₄–H⁺ solutions) or Fe–oxyhydroxychlorides (Fe(III)–Cl–H⁺ solutions). The columns worked as an efficient barrier for some time, increasing the pH of the circulating solutions from 2 to 6–7 and removing its metal content. However, after some time (several weeks, depending on the conditions), the columns became chemically inert. The results showed that passivation time increased with decreasing anion and metal content of the solutions. Gypsum was the phase responsible for the passivation of calcite in the experiments with Fe(III)–SO₄–H⁺ solutions. Schwertmannite and goethite appeared as the Fe(III) secondary phases in those experiments. Akaganeite was the phase responsible for the passivation of the system in the experiments with Fe(III)–Cl–H⁺ solutions.     

Effectiveness of sulfate-reducing passive bioreactors for treating highly contaminated acid mine drainage: II. Metal removal mechanisms and potential mobility

Column bioreactors were used for studying mechanisms of metal removal, assessment of long-term stability of spent reactive mixtures, as well as potential metal mobility after treating highly contaminated acid mine drainage (AMD; pH 2.9–5.7). Several physicochemical, microbiological, and mineralogical analyses were performed on spent reactive mixtures collected from 4 bioreactors, which were tested in duplicate for two hydraulic retention times (7.3d and 10d), with downward flow over an 11-month period. Consistent with the high metal concentrations in the AMD feed, and with low metal concentrations measured in the treated effluent, the physicochemical analyses indicated very high concentrations of metals (Fe, Mn, Cd, Ni, and Zn) in the top and bottom layers of the reactive mixtures from all columns. Moreover, the concentrations of Fe (50.8–57.8 g/kg) and Mn (0.53–0.70 g/kg) were up to twice as high in the bottom layers, whereas the concentrations of Cd (6.77–13.3 g/kg), Ni (1.80–5.19 g/kg) and Zn (2.53–13.2 g/kg) were up to 50-times higher in the top layers. Chemical extractions and elemental analysis gave consistent results, which indicated a low fraction of metals removed as sulfides (up to 15% of total metals recovered in spent reactive mixtures). Moreover, Fe and Mn were found in a more stable chemical form (residual fraction was 42–74% for Mn and 30–77% for Fe) relative to Cd, Ni or Zn, which seemed more weakly bound (oxidisable/reducible fractions) and showed higher potential mobility. Besides identifying (oxy)hydroxide and carbonate minerals, the mineralogical analyses identified metal sulfides containing Fe, Cd, Ni and Zn. Metal removal mechanisms were, therefore, mainly adsorption and other binding mechanisms with organic matter (for Cd, Ni and Zn), and the precipitation as (oxy)hydroxide minerals (for Fe and Mn). After 15 months, however, the column bioreactors did not lose their capacity for removing metals from the AMD. Although the metals were immobile during the bioreactor treatment, their mobility could increase from spent reactive mixtures, if stored inappropriately. Metal recovery by acidic leaching of spent substrates at the end of bioreactor operation could be an alternative.     

Short-Term Benthic Recolonization after Dredging in the Harbour of Ceuta, North Africa

Abstract. The benthic recovery after dredging (area: 2625 m²) was studied in a polluted and enclosed area of the harbour of Ceuta, in which the recolonization through the water column (larvae and adult bedload transport) could be limited by the lack of renewal. The benthos was sampled at two sites (control and dredged) using a van Veen grab and adopting a BACI (Before, After, Control, Impacted) approach. Five samplings were conducted after dredging (3, 15, 30, 90, 180 days). The proportion of gravel in the sediment of the dredged site increased after dredging, while the organic matter decreased. The impact on the community was estimated at species level, using both univariate and multivariate analyses. The maximum negative effect on benthic macrofauna was a reduction by 65% for species richness (15 days after dredging) and by 75% for abundance (3 days after dredging). Between 15 and 30 days after dredging, the abundance of some species such as the molluscs Parvicardium exiguum and Retusa obtusa and the polychaete Pseudomalacoceros tridentata increased considerably in the dredged site, while typical ‘opportunistic’ species such as Capitella capitata were disfavoured by the disturbance. For this small‐scale dredging, about 6 months are required for the disturbed area to re‐establish a sediment structure and a macrobenthic community similar to the undisturbed area. Small‐patch dredging operations are proposed in harbour management whenever possible, since they allow a quick re‐adjustment of the initial sediment structure and benthic communities.     

Retention of arsenic and phosphorus in iron-rich concretions of Tagus salt marshes

Iron-rich concretions are frequently found around plant roots in Tagus estuary (Portugal) where radial delivery of O₂ takes place. Salt marsh sediments exhibit cracks that are an additional feature to introduce O₂ and other solutes in the upper sediments. Metal concentrations in salt marsh sediments are clearly above the background levels reflecting the anthropogenic sources from a large city with 2.5 million inhabitants, and several industrial centres. In order to evaluate how both oxidised structures influences the redistribution of redox sensitive elements in salt marsh sediments, concretions were collected from roots of Halimione portucaloides below the oxygenated zone. These tubular cylindrical structures were analysed for Fe, Al, Mn, As, and P along 1-cm radial transect in a millimetre scale from the inner part to the adjacent anoxic sediment. In addition, oxidised cracks were analysed for the same spatial resolution, from the sediment–water interface to anoxic layers (2-cm transept). The parallelism between Fe, As, and P concentrations at this microscale is the most noticeable aspect. Iron and As presented very high concentrations in the 4-mm concretions (3.4 mmol g⁻¹ and 3.1 μmol g⁻¹, respectively) and decreased sharply to the host sediment. Oxygen released from roots oxidise the solid sulphides, and the reduced Fe and As are transported towards the root by both diffusion and pore water flow associated with the root water uptake. Subsequently, Fe(III) precipitates and As is retained by sorption and/or coprecipitation. These elements are also enriched in the first 2-mm of oxidised cracks, but in lower concentrations (50% and 30%, respectively). Manganese concentrations in concretions were low (11.8 μmol g⁻¹), indicating that Fe dominates the sediment chemistry. Phosphorus and iron concentrations in the ascorbate fraction were higher in the oxidising surfaces of concretions (10.7 μmol g⁻¹ and 1.6 mmol g⁻¹, respectively) and of cracks (5.1 μmol g⁻¹ and 0.47 mmol g⁻¹). The parallelism of Fe and As distributions includes not only their similar redox chemistries, but also that to phosphate, including control by coprecipitation of the host iron phases. The mechanisms involved in the mobilisation of As and P are however different, whereas As comes from the oxidation of iron sulphides; dissolved P derives from reduction of ferri-hydroxide phases.     

Reliability-based comparative study for mooring lines design criteria

The characteristic environmental load effect for the design of mooring systems of floating units can be defined by means of three procedures: (a) the one associated to an extreme sea state with a given return period, (b) the worst one from a set of sea states on a contour line associated to a return period or (c) the extreme one based on response statistics for a long-term period. This work presents the result of a reliability-based partial safety factor calibration study for a LRFD mooring line design criteria considering the three approaches mentioned above. The calibration exercise is applied to three FPSOs considering North Sea environmental conditions and different water depths: 200, 800 and 3000 m. The mooring systems investigated take into account mooring lines made up of chains and polyester ropes. It is shown that, among all cases investigated, the design procedure based on the long-term response is the one that presents less scattered reliability indices around the target level.     

The Effect of Human Exclusion on the Population Structure of Key-Hole Limpets Fissurella crassa and F. limbata on the Coast of Central Chile

Abstract. We describe the basic ecology of two key-hole limpets, Fissurella crassa and Fissurella limbata , which are heavily harvested by coastal shellfishermen (mariscadores) at the rocky intertidal of central Chile. The ecological role of human predation on these species was assessed. Anthropic exclusion from a stretch of the rocky intertidal at Las Cruces (non-harvested area) for about two and a half years resulted in changes of the densities and size distributions of these fissurelid species as compared to populations in control zones (harvested area). Differential human predation generates, on key-hole limpets, responses of different intensities related to the accessibility of man to the mesohabitats (sheltered platforms, exposed platforms and vertical walls) and fringes of the intertidal (mid-low intertidal and Lessonia nigrescens fringe). Thus, size distributions and mean densities of both fissurelids differ widely between the harvested and non-harvested areas on both platform habitats but not on vertical walls. In the mid-low intertidal fringe, differences are greater than in the less accessible L. nigrescens intertidal fringe. Moreover, we discuss the way in which other species, directly harvested by mariscadores (i. e., the mollusc Concholepas concholepas) can affect the keyhole limpet populations of central Chile rocky shores. Finally, we highlight the ecological role of these limpets on the dynamics of intertidal ecosystems and how they can modify community landscape.     

Estimates of heat flow and heat production and a thermal model of the São Francisco craton

An updated analysis of geothermal data from the highland area of eastern Brazil has been carried out and the characteristics of regional variations in geothermal gradients and heat flow examined. The database employed includes results of geothermal measurements at 45 localities. The results indicate that the Salvador craton and the adjacent metamorphic fold belts northeastern parts of the study area are characterized by geothermal gradients in the range of 6–17°C/km. The estimated heat flow values fall in the range of 28–53 mW/m², with low values in the cratonic area relative to the fold belts. On the other hand, the São Francisco craton and the intracratonic São Francisco sedimentary basin in the southwestern parts are characterized by relatively higher gradient values, in the range of 14–42°C/km, with the corresponding heat flow values falling in the range of 36–89 mW/m². Maps of regional variations indicate that high heat flow anomaly in the São Francisco craton is limited to areas of sedimentary cover, to the west of the Espinhaço mountain belt. Crustal thermal models have been developed to examine the implications of the observed intracratonic variations in heat flow. The thermal models take into consideration variation of thermal conductivity with temperature as well as change of radiogenic heat generation with depth. Vertical distributions of seismic velocities were used in obtaining estimates of radiogenic heat production in crustal layers. Crustal temperatures are calculated based on a procedure that makes simultaneous use of the Kirchoff and Generalized Integral Transforms, providing thereby analytical solutions in 2D and 3D geometry. The results point to temperature variations of up to 300°C at the Moho depth, between the northern Salvador and southern São Francisco cratons. There are indications that differences in rheological properties, related to thermal field, are responsible for the contrasting styles of deformation patterns in the adjacent metamorphic fold belts.     

Dwarf elliptical galaxies

Dwarf elliptical (dE) galaxies, with blue absolute magnitudes typically fainter than _MB =?16, are the most numerous type of galaxy in the nearby universe. Tremendous advances have been made over the past several years in delineating the properties of both Local Group satellite dE's and the large dE populations of nearby clusters. We review some of these advances, with particular attention to how well currently available data can constrain

1. models for the formation of dE's
2. the physical and evolutionary connections between different types of galaxies (nucleated and nonnucleated dE's, compact E's, irregulars, and blue compact dwarfs) that overlap in the same portion of the mass-spectrum of galaxies
3. the contribution of dE's to the galaxy luminosity functions in clusters and the field
4. the star-forming histories of dE's and their possible contribution to faint galaxy counts, and
5. the clustering properties of dE's.

In addressing these issues, we highlight the extent to which selection effects temper these constraints, and outline areas where new data would be particularly valuable.