Composition and Useful Properties of Tailings of Marine Manganese Nodules and Crusts

ABSTRACT

Marine manganese nodules and crusts, when processed, yield tailings which may be utilized for environmental and economic benefit. The key to the reasonable and effective utilization of these tailings lies in making a systematic appraisal of their composition and properties. This article gives an introduction to the investigation of manganese tailings properties. The tailings have a high iron and/or manganese content, high surface area, high porosity, and fine grain size. Some tailings have a high rare earth element content which is valuable. They may also have high SO₃, arsenic, and uranium contents which are harmful. Depending on the process used to produce the tailings, there will likely be some differences in chemical composition, mineral assemblages, surface area and adsorption capability, pore diameter and volume, density and pH. In assigning potentially beneficial applications for these tailings, these differences should be taken into account to optimize utilization.     

Two New Hydrothermal Fields at the Mid-Atlantic Ridge

Two new major hydrothermal fields have been discovered in the rift valley of the MAR at 13°N (Ashadze) and l6°38′N (Krasnov). The Ashadze field consists of a cluster of active hydrothermal sites associated with ultramafic rocks and located at the greatest depth in the ocean (4,200 m). By contrast, the Krasnov field consists of inactive sulfide mounds hosted in basalts. The Krasnov is the largest hydrothermal deposit on the MAR (17.4 Mt) so far discovered with iron sulfide as the principal mineral type. By contrast, Cu-Zn sulfides are the major minerals in the Ashadze deposits, which are also enriched in gold and several other metals.     

Wave‐induced pore pressure in relation to ocean floor stability of cohesionless soils

One of the important geotechnical considerations for many engineering installations, such as pipelines and anchors, in an oceanic environment involving sand deposits is that of potential ocean floor instability due to the development of high pore pressures caused by the direct action of waves. This article presents a procedure for evaluating the magnitude and distribution of wave‐induced pore pressures in ocean floor deposits. The method takes into account the distribution of wave‐induced pore pressures in ocean floor deposits. The method takes into account the distribution of cyclic shear stresses in the soil profile as well as the important factor of pore‐pressure dissipation. The variation of properties within the soil profile can also be easily incorporated into the analytical procedure. The analysis provides the complete time history of pore‐pressure response and shows clearly that failure to include the pore‐pressure dissipation effects would lead to radically conservative design. The results also provide a basis for designing remedial measures, if required, to avert the development of high pore pressures and their deleterious effects.     

Probabilistic analysis for wave‐induced submarine landslides

Abstract

When waves propagate over the ocean floor, they induce a change of hydrodynamic pressure, positive under the crest and negative under the trough. These pressure changes may cause shear failure in soft sediments and lead to submarine landslides. This paper presents a general analytical procedure for evaluating the probability of wave‐induced failure in offshore clay sediments. Both the wave and the un‐drained shear strength of clay sediments are considered random. Numerical results of some analyses are also presented.     

Geotechnical characterization of slump scars,eroded slopes,and correlated deposits on continental margins: Gulf of Lions,Western Mediterranean sea

Abstract

Vertical variations of geotechnical properties in the uppermost sediment layers characterize the main sedimentary processes acting on the construction and destruction of progressive‐type continental slopes. In the Gulf of Lions, the original thicknesses and distribution of the uppermost sedimentary layers of the continental slope and rise, which consist of Holocene muds overlying Pleistocene muds, have been greatly modified by erosion and several kinds of slope failure processes. Each process is typified through sets of geotechnical properties measured in the eroded or slumped sections and in the associated sediment accumulations.

In slump scars, the water‐rich Holocene muds lie on fine, overconsolidated, Pleistocene muds with high plasticity and low shear strength. In bottom current‐eroded slopes, where modern sedimentation is extremely reduced, the Pleistocene muds frequently outcrop and may sometimes be overlain by a very thin layer of Holocene muds. The Pleistocene muds of eroded slopes are overconsolidated and more silty and less plastic than the Pleistocene muds from slopes affected by slope failure, their shear strength being 10 times greater.

Deposits at the toe of slumps are very often formed by several superposed three‐layer units (triplets of interstratified Holocene, transitional, and Pleistocene layers) issued from retrogressive slumping occurring in the slump scars above their head area. The main body of each layer is then relatively undisturbed, showing the usual burial geotechnical gradients due to overburden pressure (i.e., decrease of water content and increase of unit weight and shear strength). At the toe of bottom current‐eroded slopes, a thick and homogeneous layer of Holocene muds overlies the Pleistocene muds; this Holocene layer has unappreciable burial depth gradient of its geotechnical parameters because of a high rate of modem and continuous deposition.     

Evaluation of Liquefaction Potential Index Along Western Coast of South Korea Using SPT and CPT

For South Korea, liquefaction potential along the western coast has not been widely assessed because South Korea is considered to be a low seismic hazard. However, recent earthquake events and historical records indicate that the seismic hazard of South Korea should not be ignored. Moreover, as artificial fills are extensively used along the western coast for development, liquefaction evaluation of the soils in this area is necessary. In this paper, we present: (1) the seismic characteristics of the study area; (2) procedures for evaluating liquefaction potential, focusing on the liquefaction potential index (LPI) approach; and (3) LPI distributions at several representative locations along the western coast of South Korea under various seismic scenarios. The liquefaction potential index represents the liquefaction potential over the upper 20 m of a boring or sounding. Using cone penetration test (CPT) and standard penetration test (SPT) data from two coastal sites, we compare and discuss CPT-based and SPT-based LPI values, particularly values computed in nonplastic, silt-rich soils. In these soils, it appears that the CPT yields lower liquefaction resistance, resulting in large LPI values. Finally, discussion and suggestions are provided for CPT- and SPT-based liquefaction assessment of low plasticity and high fines content soils.     

Accurate GPS measurement of the location and orientation of a floating platform

Abstract

This article describes the design and initial tests of the GPS portion of a system for making seafloor geodesy measurements. In the planned system, GPS antennas on a floating platform will be used to measure the location of an acoustic transducer, attached below the platform, which interrogates an array of transponders on the seafloor. Since the GPS antennas are necessarily some distance above the transducer, a short‐baseline GPS interferometer consisting of three antennas is used to measure the platform's orientation.

A preliminary test of several crucial elements of the system was performed at the Scripps Institution of Oceanography (SIO) in December 1989. The test involved a fixed antenna on the pier and a second antenna floating on a buoy about 80 m away. GPS measurements of the vertical component of this baseline, analyzed independently by two groups using different software, agree with each other and with an independent measurement within a centimeter.

The first test of an integrated GPS/acoustic system took place in the Santa Cruz Basin off the coast of southern California in May 1990. In this test a much larger buoy, designed and built at SIO, was equipped with three GPS antennas and an acoustic transducer that interrogated a transponder on the ocean floor. Preliminary analysis indicates that the horizontal position of the transponder can be determined with a precision of about a centimeter. Further analysis will be required to investigate the magnitude of systematic errors.     

Measuring the benefits and costs of community education and outreach in marine protected areas

Conservation organizations often invest considerable resources in education and outreach activities in and around marine protected areas (MPAs). The expectation is that such efforts will change local knowledge, attitudes and ultimately behavior. This is one of the first studies to assess the efficacy of using education and outreach activities to improve community knowledge and attitudes about an MPA. Random sample surveys in 2005 and 2010 (n=1213) before and after education and outreach activities are compared. Program budgets for the same period give the investment levels. With an investment level averaging US$24 per capita/year, the result was an average increase of 33% in “yes” responses across 15 indicators of knowledge and attitudes towards marine conservation. The increase in knowledge and positive attitudes was associated with a large decrease in “not sure” responses, suggesting that community members with fewer initial preconceptions are the most effective target for education and outreach activities. This study demonstrates that investments in MPA education and outreach can generate increases in local knowledge and positive attitudes, and changing knowledge and attitudes is expected to contribute to the long-term compliance with MPA regulations.     

Long‐term nitrogen and phosphorus fertilization effects on N2 fixation rates and nifH gene community patterns in mangrove sediments

The bioavailability of nutrients is important in controlling ecological processes and nitrogen cycling in oligotrophic mangrove forests, yet the variation of diazotrophic community structure and activity with nutrient availability in sediments remains largely unexplored. To investigate for the first time how nutrients in sediments affect spatial and temporal patterns of diazotrophic community structure and activity, the sedimentary environment of Twin Cays, Belize, was examined with respect to the effects of long‐term fertilization [treatments: control (Ctrl), nitrogen (N), and phosphorus (P)] on N₂ fixation rates and nifH gene community structure. We found that N₂ fixation rates were significantly higher at the P‐treatment, intermediate at the Ctrl‐treatment and lower in the N‐treatment (P: 4.2 ± 0.5, Crtl: 0.8 ± 0.1, N: 0.4 ± 0.1 nmol·N·g^?1·h^?1; P < 0.001) with spatial (Ctrl‐ and P‐treatments) and temporal (only P‐treatment) variability positively correlated with live root abundance (r² = 0.473, P < 0.001) and concentration (r² = 0.458, P < 0.0001). The community structure of diazotrophs showed larger spatial and temporal variability in the fertilized treatments than in the Ctrl‐treatment, with the relative abundance of OTUs (nifH operational taxonomic units) at the fertilized treatments inversely related to live root abundance. Overall, long‐term fertilization (with either N or P) affects not only nutrient levels in mangrove sediments directly, but also spatial and temporal patterns of both community structure and activity and likely plant‐microbe interactions as well. Our findings suggest that the maintenance of natural nutrient conditions in mangrove sediments is important to ensure the stability of microbial functional groups like diazotrophs.     

Late Devonian rifting in the central North Sea: Evidence from altered felsic volcanic rocks in the Embla oil field

In the Embla oil field on the northern flank of the Mid North Sea High, the central North Sea, multiple quartz porphyric volcanic beds at ca. 4600 m depth form part of a volcano-sedimentary interval above the Caledonian basement as interpreted from seismic data. Zircon U–Pb laser ablation ICPMS date one bed to 374 ± 3 Ma, indicating that the volcanic rocks and interbedded sediments are early Famennian and correlate to the Buchan Formation. The volcanic rocks have been extensively clay and carbonate altered in a near-surface environment, but high field strength element data show that the protoliths were alkali rhyolites, yielding intra-plate signatures in tectonic discrimination diagrams. Famennian quartz porphyric volcanic rocks have also been reported from well A17-1 on the southern flank of the Mid North Sea High. The Famennian volcanism on the northern and southern flanks testify to an active magmatic environment in the central North Sea in the early Famennian, supporting the existence of a late Devonian proto-Central Graben rift extending northwards into the central North Sea. The rift is likely an early example of strain localisation to a zone of reduced crustal strength along the Caledonian suture between Avalonia and Baltica.