湖北清江画面石图案的纹理类型及其地质成因

清江画面石是近二十年来出现的一种新的观赏石石种,原石主要为中泥盆统云台观组灰白色石英砂岩.清江画面石具有观赏价值的关键因素是构成画面的各类图案.本文将画面石图案的纹理类型划分为三种类型——线型、条带型和梳型,并对每种类型进行了详细描述.在野外调查基础上,通过岩石特征、微观结构构造、地球化学特征等综合对比分析,对三种类型的清江画面石图案的地质成因进行初步讨论,认为线型（即裂隙）的形成可能与燕山期或之后区域构造活动有关,条带型（即层理）形成于泥盆纪的原生沉积构造,而梳型则可能是由于外来物质在成岩期后沿着层理面或纹层面向下渗流而成,推测形成于燕山期之前,但需进一步研究确定.三种图案中的不同颜色,是由含有铁锰质氧化物的地下水或地表径流水等沿裂隙、层理面或渗流面浸染或部分交代填隙物而成,在现代河流下切作用下,崩落入水,经过流水搬运、冲刷,最终形成了清江画面石.     

深水油气浅层钻井的“三浅”地质灾害

深水浅层钻井过程中可能遇到浅水流、浅层气以及天然气水合物层分解等3种浅层地质灾害（简称＂三浅＂）。要规避这些风险,必须需要开展浅水流、浅层气和天然气水合物成因机理、识别特征及工程危害等方面的研究。国外利用地球物理识别技术和数值模拟方法,结合深水油气钻井测井开展了这方面的研究,在＂三浅＂地质灾害的形成机理和控制因素方面取得了较为重要的研究进展。目前国内学者利用地球物理方法在南海北部深水区LW3-1大气田的周围发现了超压系统、浅层气和天然气水合物。深水水道砂体的发现也推断南海北部深水区具有＂三浅＂地质灾害发育的地质条件。随着深水油气勘探开发的不断深入,评估和预测南海北部深水钻井的＂三浅＂地质灾害十分迫切。     

Thermally driven hydromagnetic instabilities in a non-constantly stratified layer

Summary The convection in a rapidly rotating electrically conducting, fluid horizontal layer of non-constant stratification, permeated by an inhomogeneous magnetic field, is studied. In this connection, a temperature model of the layer is constructed, which creates a structure such that part of the layer is unstably and a part stably stratified. The results obtained are applied to the conditions in the fluid Earth's core.

---

¶rt;m u m aa mn¶rt; u¶rt;uma , m um nm mamuuau u a¶rt;um ¶rt;¶rt; aum n. uaa nu m mna ¶rt; nu¶rt;um uu ma mm, nu m am mamuuum mau, a am — mau. mam unm ¶rt; aaua n, nu¶rt;u u¶rt; ¶rt; u.

     

Tracing leachates at waste sites using geophysical and geochemical modelling

Tracing leachates at landfills is usually carried out using either geophysical methods or chemical analyses of groundwater. There are often problems with fingerprinting pollution sources or clarifying the spreading pattern due to a wide variety of possibilities giving similar anomalies. The aims of the project were to evaluate the advantages of combining results from multigeophysical modelling and statistical/chemical modelling in order to identify pollution sources and the spreading pattern and to test a new technique for chemical fingerprinting. The project was carried out at a landfill in central Sweden using geophysical measurements and modelling of CVES, GPR and VLF as well as chemical modelling using M3 (multivariate mixing and mass balance calculations). The results indicate that by combining geophysical modelling and chemical calculations, the possibilities of fingerprinting the origin of pollution as well as delineating the spreading pattern are significantly increased.     

Assessment of Marine Clay Improvement Under Reclamation Fills by in-situ Testing Methods

In ground improvement projects with prefabricated vertical drains, the duration of the preloading period is set in advance based on the predetermined time rate of consolidation of the compressible layer. If prediction is accurately done, the required degree of consolidation is met at the pre-determined preloading time. As such, there is a requirement for in-situ tests to be carried out just prior to the removal of surcharge to assess the degree of consolidation of the improved ground. In-situ tests were carried out after 23 months of surcharge loading at the In-Situ Test Site within the Changi East Reclamation Project in the Republic of Singapore. In-situ testing works in this research study comprises the use of field vane shear, piezocone, flat dilatometer and self-boring pressuremeter. The in-situ tests were carried out to determine the shear strength and degree of consolidation of the Singapore marine clay at Changi after 23 months of surcharge loading. The In-Situ Test Site consisted of a Vertical Drain Area as well as an untreated Control Area. Both areas were located adjacent to each other and were surcharged simultaneously to the same level and surcharge left in place for a period of 23 months. Comparison was made between the in-situ test results of the Vertical Drain Area and the untreated Control Area.     

PAN－S光度法测定水和河泥中微量锰

本文研究了ＰＡＮ－Ｓ与锰的显色反应。配合物的最大吸收峰位于５３８ｎｍ波长处，表观摩尔吸光系数为２．９×１０￣４Ｌ·ｍｏｌ￣（－１）·ｃｍ￣（－１），锰量在０─１．６μｇ／ｍｌ范围内符合比尔定律，方法用于水和河泥中微量锰的测定，结果良好。     

离子色谱法检测土壤样品水溶态中的七种阴离子

采用离子色谱法测定土壤样品水溶态中的F^-、Cl^-、NO2^-、SO4^2-、Br^-、NO3^-、PO4^3-。通过优化提取条件,得出最优条件下7种阴离子的加标回收率为94.4%～102.5%,精密度为3.1%～4.6%。对实际样品进行测试,结果表明,该方法适用于土壤样品水溶态中7种阴离子的定性、定量分析。     

含充填节理岩体相似材料试件单轴压缩试验及断裂损伤研究

研究了单轴压缩条件下裂隙含充填与否对节理岩体力学性能的影响。以相似材料模拟脆性岩石材料制作含预置裂隙试件,在刚性试验机上对试件进行单轴压缩试验,研究了裂隙充填与否对节理岩体强度峰值及峰后塑性变形能力的影响;用有限元软件ABAQUS对试件进行断裂及损伤分析,研究了裂隙充填与否对节理岩体应力强度因子及损伤因子的影响。研究表明,在单轴压缩情况下,裂隙中含充填与不含充填相比,裂隙含充填岩体峰值强度提高、峰后塑性变形能力增强、总应变能释放率Gc降低,增大了节理岩体抵抗开裂的能力;裂隙含充填岩体环向拉应力场从分布区域及峰值都小于无充填裂隙试件;在同样外荷载作用下,裂隙含充填岩体损伤度小于无充填岩体。     

Mineralogy,Fluid Inclusion,and Hydrogen and Oxygen Isotope Studies of the Intrusion‐Related Yangla Cu Deposit in the Sanjiang Region,SW China: Implications for Metallogenesis and Deposit Type

The Yangla deposit is an intrusion‐related Cu deposit in the Jinshajiang tectonic belt (eastern Sanjiang region, SW China). Despite extensive studies that have been conducted on this deposit, the relationship between the granitic magma and Cu mineralization is still unclear, and hence, the genesis is debated. To answer this question, we conducted an integrated study of mineralogy, fluid inclusions (FIs), and hydrogen and oxygen (H‐O) isotopes. Three mineralization stages were identified based on the ore textures, alteration zonation, and crosscutting relationships: (i) pre‐ore prograde skarn (stage I), with the garnet and pyroxene dominated by andradite and diopside, respectively; (ii) syn‐ore retrograde alteration (stage II), which is subdivided into the early syn‐ore stage (stage IIa) marked by retrograde hydrated mineral assemblages and significant Fe‐Cu‐Mo‐Pb‐Zn sulfide mineralization, and the late syn‐ore stage (stage IIb) featured by quartz‐calcite veins; and (iii) late supergene mineralization (stage III), which is characterized by secondary azurite and malachite. These results of mineralogy, FIs, and H‐O isotopes indicate that: (i) Cu mineralization has a close temporal, spatial, and genetic relationship with skarn alteration; (ii) the ore fluids were magmatic dominated with late‐stage meteoric water incursion; and (iii) Type‐S (halite‐bearing) and Type‐V (vapor‐rich) FIs coexisted in garnet and clinopyroxene of stage I, indicating that fluid boiling might have occurred during this stage. From stage I to stage IIa, the FI type transformed from Type‐S + Type‐V + Type‐L (liquid‐rich) to Type‐V + Type‐L with the conduct of mineralization and was accompanied by the disappearance of Type‐S, and homogenization temperature and salinity also tended to decrease dramatically, which may be caused by the deposition of skarn minerals. At stage IIa, boiling of the ore fluids still continued due to the change from lithostatic to hydrostatic pressure, which triggered the precipitation of abundant quartz‐Cu‐Mo‐Fe sulfides. Furthermore, fluid mixing between a high‐temperature magmatic fluid and a low‐temperature meteoric water might cause a considerable drop in temperature and the deposition of Cu‐bearing quartz/calcite veins during stage IIb. Hence, we consider the Yangla deposit to be of a skarn type, genetically related to the Mesozoic magmatism in the Sanjiang region.