A new high-quality set of orbital parameters for the O-type spectroscopic binary HD 93205 has been obtained combining échelle and coudé CCD observations. The radial velocity orbits derived from the He ii λ 4686 Å (primary component) and He i λ 4471 Å (secondary component) absorption lines yield semi-amplitudes of 133±2 and 314±2 km s−1 for each binary component, resulting in minimum masses of 31 and 13 M⊙ ( q =0.42) . We also confirm for the binary components the spectral classification of O3 V+ O8 V previously assigned. Assuming for the O8 V component a 'normal' mass of 22–25 M⊙ we would derive for the primary O3 V a mass of 'only' 52–60 M⊙ and an inclination of about 55° for the orbital plane. We have also determined for the first time a period of apsidal motion for this system, namely 185±16 yr using all available radial velocity data sets of HD 93205 (from 1975 to 1999). Phase-locked variations of the X-ray emission of HD 93205 consisting of a rise of the observed X-ray flux near periastron passage are also discussed. 相似文献
The 1356 Basel earthquake was the strongest event to have shaken NW Europe in the last thousand years. The peculiar location of this historical event makes it possible to relate it to normal faulting along the edges of the Rhine Graben, as well as to reverse faulting along the Jura frontal thrust or to fault reactivation within the Hercynian basement. Alternate hypotheses are discussed and their implications compared taking into account available structural data and results of the morphotectonic study performed in the epicentral area. This study combines field observations with the analysis of SPOT satellite imagery, aerial photographs, and detailed topography. It is concluded that the Basel earthquake most probably reactivated a basement fault (reverse or wrench fault) beneath the shallow-depth aseismic detachment that underlies the Jura Mountains. 相似文献
We describe the geological, morphological, and climatic settings of two new meteorite collections from Atacama (Chile). The “El Médano collection” was recovered by systematic on‐foot search in El Médano and Caleta el Cobre dense collection areas and is composed of 213 meteorites before pairing, 142 after pairing. The “private collection” has been recovered by car by three private hunters and consists of 213 meteorites. Similar to other hot desert finds, and contrary to the falls and Antarctica finds, both collections show an overabundance of H chondrites. A recovery density can be calculated only for the El Médano collection and gives 251 and 168 meteorites larger than 10 g km?2, before and after pairing, respectively. It is by far the densest collection area described in hot deserts. The Atacama Desert is known to have been hyperarid for a long period of time and, based on cosmic‐ray exposure ages on the order of 1–10 Ma, to have been stable over a period of time of several million years. Such a high meteorite concentration might be explained invoking either a yet unclear concentration mechanism (possibly related to downslope creeping) or a previously underestimated meteorite flux in previous studies or an average terrestrial age over 2 Myr. This last hypothesis is supported by the high weathering grade of meteorites and by the common terrestrial fragmentation (with fragments scattered over a few meters) of recovered meteorites. 相似文献
Groundwater–surface water (GW–SW) interactions cover a broad range of hydrogeological and biological processes and are controlled by natural and anthropogenic factors at various spatio-temporal scales, from watershed to hyporheic/hypolentic zone. Understanding these processes is vital in the protection of groundwater-dependent ecosystems increasingly required in water resources legislation across the world. The use of environmental tracers and indicators that are relevant simultaneously for groundwater, surface water and biocenoses–biotope interactions constitutes a powerful tool to succeed in the management task. However, tracer type must be chosen according to the scale of interest and tracer use thus requires a good conceptual understanding of the processes to be evaluated. This paper reviews various GW–SW interaction processes and their drivers and, based on available knowledge, systemises application of conservative tracers and semi-conservative and reactive environmental indicators at different spatial scales. Biocenoses–biotopes relationships are viewed as a possible transition tool between scales. Relation between principal application of the environmental tracers and indicators, examples and guidelines are further proposed for examining GW–SW interactions from a hydrogeological and biological point of view by demonstrating the usability of the tracers/indicators and providing recommendations for the scientific community and decision makers. 相似文献
Mineralization of groundwater in volcanic aquifers is partly acquired through silicates weathering. This alteration depends on the dissolution of atmospheric, biogenic, or mantellic gaseous CO2 whose contributions may depend on substratum geology, surface features, and lava flow hydrological functionings. Investigations of $ {\text{P}}_{{{\text{CO}}_{ 2} {\text{eq}}}} $ and δ13CTDIC (total dissolved inorganic carbon) on various spatiotemporal scales in the unsaturated and saturated zones of volcanic flows of the Argnat basin (French Massif Central) have been carried out to identify the carbon sources in the system. Mantellic sources are related to faults promoting CO2 uplift from the mantle to the saturated zone. The contribution of this source is counterbalanced by infiltration of water through the unsaturated zone, accompanied by dissolution of soil CO2 or even atmospheric CO2 during cold periods. Monitoring and modeling of δ13CTDIC in the unsaturated zone shows that both $ {\text{P}}_{{{\text{CO}}_{ 2} {\text{eq}}}} $ and δ13CTDIC are controlled by air temperature which influences soil respiration and soil-atmosphere CO2 exchanges. The internal geometry of volcanic lava flows controls water patterns from the unsaturated zone to saturated zone and thus may explain δ13C heterogeneity in the saturated zone at the basin scale. 相似文献
NWA2268 is a polymict eucrite discovered in the Sahara, at southwest Algeria, close to the region of Tindouf. This meteorite weighs 65 g and presents a thin black fusion crust. The rock is fine- to medium-grained breccia and contains mineral fragments of plagioclases, pyroxenes, spinel, olivine and silica. The rock contains some basaltic fragments with sub-ophitic or cumulative textures, constituted by plagioclases and exsolved pigeonite. Pyroxferroite grains are present and locally destabilised in an association of hedenbergite, fayalite and silica. It also presents unequilibrated eucritic clast with heterogeneous pyroxenes and plagioclases compositions. Pyroxenes in the all of the other clasts have equilibrated composition, with exolved pigeonites with augite lamellaes. This polymict eucrite contains also partially devitrified glass that represents impact melts linked to impact event. None recrystallization of this glass confirms a lack of post-brecciation metamorphism. Diogenitic fragments are less abundant than 10 %. The oxygen isotopic composition of NWA2268 is Δ17O (?0.43). This meteorite is interpreted as belonging to the HED group attributed to the 4-Vesta asteroid. 相似文献
This paper presents empirical correlations between amplification factors and simple site parameters derived from a large subset
of the KiK-net data. The amplification factor is estimated from the ratios between the surface and down-hole horizontal response
spectra, corrected for the varying depths and impedance of the down-hole sites (Cadet et al. in Site effect assessment using
KiK-net data—part 1—a simple correction procedure for surface/downhole spectral ratios, 2011). Several site parameters are selected on the basis of their simplicity and availability at relatively low cost. They are
the shallow time-average velocities VSZ, with z equal to 5, 10, 20 and 30 m, and the fundamental frequency f0. The amplification factors are then correlated with each of the individual site parameters; four other “twin-parameter”—couples
(f0, VSZ)—are also considered and the correlation with amplification factors is performed through a normalization of the frequencies
by each site fundamental frequency. The quality of the correlations is given by a misfit compared with the original data variance.
The largest variance reduction is obtained with twin-parameter characterizations, out of which the couple (f0, VS30) proves to provide the lower misfit. The performance of single parameter correlations is relatively lower; however, the best
single parameter proves to be the fundamental frequency, which provides smaller misfit than the Vsz parameters. A comparison
is also performed with the amplification factors recommended in European regulations, showing that it is possible right now
to significantly improve both the site characterization criteria and the associated amplification factors, for use in building
codes and microzonation studies. 相似文献
Despite the abundance of large wood (LW) river studies there is still a lack of understanding of LW transport dynamics on large low gradient rivers. This study used 290 radio frequency identification tagged (RFID) LW and 54 metal (aluminum) tagged LW, to quantify the percent of in‐channel LW that moves per year and what variables play a role in LW transport dynamics. Aluminum tags were installed and monitored on LW in‐transit during the rising limb of a flood, the mean distance traveled by those pieces during the week was 13.3 river kilometers (km) with a maximum distance of 72 km. RFID tagged LW moved a mean of 11.9 km/yr with a maximum observed at 101.1 km/yr. Approximately 41% of LW low on the bank moves per year. The high rate of transport and distance traveled is likely due to the lack of interaction between LW floating in the channel and the channel boundaries, caused primarily by the width of the channel relative to length of the LW. Approximately 80% of the RFID tags moved past a fixed reader during the highest 20% of river stage per year. LW transport and logjam dynamics are complicated at high flows as pieces form temporary jams that continually expand and contract. Unlike most other studies, key members that create a logjam were defined more by stability than jam size or channel/hydrologic conditions. Finally, using an existing geomorphic database for the river, and data from this study, we were able to develop a comprehensive LW budget showing that 5% of the in‐channel LW population turns over each year (input from mass wasting and fluvial erosion equals burial, decomposition, and export out of system) and another 16% of the population moving within the system. Published 2013. This article is a U.S. Government work and is in the public domain in the USA. 相似文献
This paper studies the effect of interfacial areas (air–water interfaces and solid–water interfaces) on material strength of unsaturated granular materials. High-resolution X-ray computed tomography technique is employed to measure the interfacial areas in wet glass bead samples. The scanned 3D images are trinarized into three phases and meshed into representative volume elements (RVEs). An appropriate RVE size is selected to represent adequate local information. Due to the local heterogeneity of the material, the discretized RVEs of the scanned samples actually cover a very large range of degree of saturation and porosity. The data of RVEs present the relationship between the specific interfacial areas and degree of saturation and gives boundaries where the interfacial area of a whole sample should fall in. In parallel, suction-controlled direct shear tests have been carried out on glass beads and the material strength has been corroborated with two effective stress definitions related to the specific air–water interfacial areas and fraction of wetted solid surface, respectively. The comparisons show that the specific air–water interfacial area reaches the peak at about 25% of saturation and contributes significantly to the material strength (up to 60% of the total capillary strength). The wetted solid surface obtained from X-ray CT is also used to estimate Bishop’s coefficient χ based on the second type of effective stress definition, which shows a good agreement with the measured value. This work emphasizes the importance to include interface terms in effective stress formulations of unsaturated soils. It also suggests that the X-ray CT technique and RVE-based multiscale analysis are very valuable in the studies of multiphase geomaterials.
The significance of late-stage fracturing in the European Alps in a large geodynamic context is reappraised by studying brittle deformations over the entire belt. In the internal Western Alps, paleostress datasets display a major occurrence of orogen-parallel extension resulting in normal faulting and associated strike-slip mode. There the direction of subhorizontal extension rotates with the bending of the Alpine belt. In the Central Alps, paleostress tensors also indicate orogen-parallel extensional regimes, both in the Bergell area and the Lepontine Dome, where the brittle structures are associated with ductile structures related to the formation of large-scale upright folds that accommodate most of the collisional shortening due to the north-directed component of the movement of the South-Alpine indenter. This brittle deformation phase is of Miocene age and is coeval with the propagation of the Alpine front toward the external Alpine domains. In the Eastern Alps, brittle deformation of the Tauern Window displays an overwhelming occurrence of orogen-parallel normal faulting and associated strike-slip regimes again, which is inferred to be driven by lateral extrusion of the orogenic wedge toward the Pannonian basin, partly due to indentation on the Dolomites indenter. The major orogen-parallel extensional signal of the brittle Cenozoic deformations appears remarkably stable all over the internal Alps. Extensional brittle structures are part of a late phase of collisional deformation, during which the propagation of the Alpine front of the Western Alps and the northward movement of the Southern Alpine and the Dolomites indenters in the Central and Eastern Alps were accommodated by orogen-parallel extension in the inner zones, at the scale of the entire chain. 相似文献