Wrench tectonics flip at oblique subduction. A model from New Zealand

In eastern North Island New Zealand, oblique subduction of the Pacific Plate beneath the Australian Plate is associated with strain partitioning. Dextral along-strike component of displacement occurred first at Early Miocene major faults within the eastern fore-arc domain. These faults were active from Early Miocene to Pliocene times. Since Pliocene times, most of the movement occurs at western faults such as the Wellington Fault. The latter joins the back-arc domain to the north. The jump of wrench faulting is related to the oblique opening of the back-arc domain. Both phenomena are impeded southwards by the Hikurangi oceanic plateau entering the subduction zone. To cite this article: J. Delteil et al., C. R. Geoscience 335 (2003).     

Experiments on the effect of inflow and outflow sequences on suspended sediment exchange rates

In laboratory experiments, the influence of inflow and outflow sequences on the behavior of fine sedi-ment was investigated. The experimental set-up consisted of two interconnected rectangular basins, between which water was moved back and forth. Suspended sediment concentration in the main basin as well as the sediment exchange rates were derived from turbidity measurements.The suspended sediment ratio, SSR, and sediment exchange rates (influx sediment rate, ISR, and evacuated sediment rate, ESR) were measured. In twenty test runs, a parametric study on the magnitude and frequency of inflow and outflow cycles, the relative duration between inflow and outflow sequences, the initial sediment concentration, and the intake position was done. An initial test with stagnant water described the set-tling behavior of fine sediment and served as a reference scenario.The test results show that settling of fine particles near the intake/outlet structure can be considerably reduced by the nature of the inflow and outflow sequences. High cycle magnitude and frequency lead to maximum suspended sediment ratio in the system. For low discharges, the evolution of suspended sediment concentration cannot be directly correlated to the inflow and outflow cycles. However, compared to"no operation"conditions, the suspended sediment ratio could be increased by 10%to 40%locally. For high discharge, the evolution of suspended sediment concentration correlated with discharge cycles and suspended sediment ratios between 50%and 80%higher than for stagnant water could be achieved. Similar ratios could be obtained when the intake is located closer to the bottom or to the free water surface.Meanwhile, the overall sediment balance remained in equilibrium over the test period, indicating that the influx and evacuated sediment rates are not significantly influenced by the inflow and outflow cycles.     

Surface sensible heat flux over a deep moist convective region and its interplay with synoptic and mesoscale features

The surface parameters are being evaluated using a methodology which considers the vertical temperature structure of MONTBLEX ’90. For this 30 metre micrometeorological tower data are utilised. In this process, a concept of isolated layers has been introduced. The parameters have been evaluated following two successive iterative processes to give a consistent value both in the flux-profile relation and the related similarity relation. The heat flux obtained using the present methodology, is then utilised to examine its interplay with the synoptic as well as mesoscale features. The existence of such an interplay is observed.     

Ilmenite composition in the Tellnes Fe–Ti deposit,SW Norway: fractional crystallization,postcumulus evolution and ilmenite–zircon relation

Major and trace element XRF and in situ LA-ICP-MS analyses of ilmenite in the Tellnes ilmenite deposit, Rogaland Anorthosite Province, SW Norway, constrains a two stage fractional crystallization model of a ferrodioritic Fe-Ti-P rich melt. Stage 1 is characterized by ilmenite-plagioclase cumulates, partly stored in the lower part of the ore body (Lower Central Zone, LCZ), and stage 2 by ilmenite-plagioclase-orthopyroxene-olivine cumulates (Upper Central Zone, UCZ). The concentration of V and Cr in ilmenite, corrected for the trapped liquid effect, (1) defines the cotectic proportion of ilmenite to be 17.5 wt% during stage 1, and (2) implies an increase of D _V^Ilm during stage 2, most likely related to a shift in fO₂. The proportion of 17.5 wt% is lower than the modal proportion of ilmenite (ca. 50 wt%) in the ore body, implying accumulation of ilmenite and flotation of plagioclase. The fraction of residual liquid left after crystallization of Tellnes cumulates is estimated at 0.6 and the flotation of plagioclase at 26 wt% of the initial melt mass. The increasing content of intercumulus magnetite with stratigraphic height, from 0 to ca. 3 wt%, results from differentiation of the trapped liquid towards magnetite saturation. The MgO content of ilmenite (1.4–4.4 wt%) is much lower than the expected cumulus composition. It shows extensive postcumulus re-equilibration with trapped liquid and ferromagnesian silicates, correlated with distance to the host anorthosite. The Zr content of ilmenite, provided by in situ analyses, is low (<114 ppm) and uncorrelated with stratigraphy or Cr content. The data demonstrate that zircon coronas observed around ilmenite formed by subsolidus exsolution of ZrO₂ from ilmenite. The U-Pb zircon age of 920 ± 3 Ma probably records this exsolution process. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Distribution of dissolved labile and particulate iron and copper in Terra Nova Bay polynya (Ross Sea,Antarctica) surface waters in relation to nutrients and phytoplankton growth

The distribution of the dissolved labile and of the particulate Fe and Cu together with dissolved oxygen, nutrients, chlorophyll a and total particulate matter was investigated in the surface waters of Terra Nova Bay polynya in mid-January 2003. The measurements were conducted within the framework of the Italian Climatic Long-term Interactions of the Mass balance in Antarctica (CLIMA) Project activities. The labile dissolved fraction was operationally defined by employing the chelating resin Chelex-100, which retains free and loosely bound trace metal species. The dissolved labile Fe ranges from below the detection limit (0.15 nM) to 3.71 nM, while the dissolved labile Cu from below the detection limit (0.10 nM) to 0.90 nM. The lowest concentrations for both metals were observed at 20 m depth (the shallowest depth for which metals were measured). The concentration of the particulate Fe was about 5 times higher than the dissolved Fe concentration, ranging from 0.56 to 24.83 nM with an average of 6.45 nM. The concentration of the particulate Cu ranged from 0.01 to 0.71 nM with an average of 0.17 nM. The values are in agreement with the previous data collected in the same area. We evaluated the role of the Fe and Cu as biolimiting metals. The N:dissolved labile Fe ratios (18,900–130,666) would or would not allow a complete nitrate removal, on the basis of the N:Fe requirement ratios that we calculated considering the N:P and the C:P ratios estimated for diatoms. This finding partially agrees with the Si:N ratio that we found (2.29). Moreover we considered a possible influence of the dissolved labile Cu on the Fe uptake process.     

Evolution of sand waves in the Messina Strait, Italy

In the present paper the morphodynamics of sand waves in the Messina Strait, Italy, is analysed by comparing data gathered during two different surveys carried out in 1991 and 2001, respectively. In particular, a morphometric analysis on the most recent data and a qualitative analysis of the differences between bottom bedform patterns, are carried out. At locations characterised by greater depths, only minor changes to the planimetric configuration of the field, i.e. crest orientation (which is seen to be orthogonal to the direction of net gross sand transport) and wave length are observed, while differences in wave length and crest direction are more evident in more shallow areas. On the other hand, wave height has significantly increased in the whole field. A possible explanation of such a change, based on the previsions of a theory which relates sand-wave growth and migration to the main components of the tidal ellipse, is provided.Responsible Editor: Jens Kappenberg     

Dissociation constants of protonated cysteine species in seawater media

The dissociation constants (pK₁, pK₂ and pK₃) for cysteine have been measured in seawater as a function of temperature (5 to 45 °C) and salinity (S = 5 to 35). The seawater values were lower than the values in NaCl at the same ionic strength. In an attempt to understand these differences, we have made measurements of the constants in Na–Mg–Cl solutions at 25 °C. The measured values have been compared to those calculated from the Pitzer ionic interaction model. The lower values of pK₃ in the Na–Mg–Cl solutions have been attributed to the formation of Mg²⁺ complexes with Cys²⁻ anions

Mg²⁺ + Cys²⁻ = MgCys

The stability constants have been fitted to

after corrections are made for the interaction of Mg²⁺ with H⁺.The pK₁ seawater measurements indicate that H₃Cys⁺ interacts with SO₄²⁻. The Pitzer parameters β⁰(H₃CysSO₄), β¹(H₃CysSO₄) and C(H₃CysSO₄) have been determined for this interaction. The formation of CaCys as well as MgCys are needed to account for the values of pK₂ and pK₃ in seawater.The consideration of the formation of MgCys and CaCys in seawater yields model calculated values of pK₁, pK₂ and pK₃ that agree with the measured values to within the experimental error of the measurements. This study shows that it is important to consider all of the ionic interactions in natural waters when examining the dissociation of organic acids.     

Prolonged Magmatic and Tectonic Development of the Caribbean Igneous Province Revealed by a Diving Submersible Survey

Using the diving submersible survey NAUTICA we investigated the central part of the Caribbean large igneous province (CLIP) to observe and sample internal portions of this proposed oceanic plateau. Most of the samples are gabbroic and doleritic rocks; basalts are scarce. Radiometric dating by ⁴⁰Ar/³⁹Ar incremental heating experiments indicate that the intrusive rocks are Campanian in age (81–75 Ma). In some places these intrusive rocks underlie older Santonian (85–83 Ma) extrusive basaltic rocks, suggesting that the Campanian rocks represent a sill injection and an underplating episode. Results of the diving program supplemented by information from ODP and DSDP drilling sites document a 20 m.y. period (94–75 Ma) of igneous activity in the submerged portion of the Caribbean large igneous province (CLIP). In the northern part of the Beata Ridge late Campanian and/or post Campanian uplift is documented by prominent Maastrichtian (71–65 Ma) erosion and the establishment of a Paleocene-middle Eocene (65–49 Ma) carbonate platform. During and after the uplift an extensional period is indicated by seismic images and the subsidence (3 km depth) of the carbonate platform. Paleocene ages (55–56 Ma) determined on some volcanic samples are attributed to localised decompression mantle melting that accompanied the extension. We document a prolonged period of magmatic and tectonic events that do not fit with the current models of short-lived plateau formation during mantle plume initiation but shares many similarities with the constructional histories of other oceanic large igneous provinces.     

Seismic evidence of small-scale lacustrine drifts in Lake Baikal (Russia)

High resolution, single-channel seismic sparker profiles across the Akademichesky Ridge, an intra-basin structural high in Lake Baikal (Russia), reveal the presence of small sediment mounds and intervening moats in the upper part of the sedimentary cover. Such features interrupt the generally uniform and even acoustic facies and are not consistent with the hemipelagic sedimentation, which is expected on such an isolated high and which would produce a uniform sediment drape over bottom irregularities. The influence of turbidity currents is excluded since the ridge is an isolated high elevated more than 600-1000 m above adjacent basins. The mounded seismic facies, including migrating sediment waves and non-depositional/erosional incisions, strongly suggest that sediment accumulation was controlled by bottom-current activity. We interpret the mounds as small-scale (< few tens of km² in area) lacustrine drifts. Four basic types of geometry are identified: 1) slope-plastered patch sheets; 2) patch drifts; 3) confined drifts; 4) fault-controlled drifts. The general asymmetry in the sedimentary cover of the ridge, showing thicker deposits on the NW flank, and the common location of patch drifts on the northeast side of small basement knolls indicate that deposition took preferentially place at the lee sides of obstacles in a current flowing northward or sub-parallel to the main contours. Deep-water circulation in the ridge area is not known in detail, but there are indications that relatively cold saline water masses are presently flowing out of the Central Basin and plunging into the deep parts of the North Basin across the ridge, a process that appears to be driven mainly by small differences in salinity. We infer that the process responsible for the observed bottom-current-controlled sedimentary features has to be sought in these large-scale water-mass movements and their past equivalents. The age of the onset of the bottom-current-controlled sedimentation, based on an average sedimentation rate of 4.0 cm/ky, is roughly estimated to be as least as old as 3.5 Ma, which is generally regarded as the age of the onset of the last major tectonic pulse of rift basin development in the Baikal region.